• Journal of Power Electronics
• /
• v.11 no.3
• /
• pp.271-278
• /
• 2011

This paper presents a LLC resonant controller IC for secondary side control without external active devices to achieve low profile and low cost LED back light units. A gate driving transformer is adopted to isolate the primary side and the secondary side instead of an opto-coupler. A new integrated dimming circuitry is proposed to improve the dynamic current control characteristic and the current density of a LED for the brightness modulation of a large screen LCD. A dual-slope clock generator is proposed to overcome the frequency error due to the under shoot in conventional approaches. This chip is fabricated using 0.35 ${\mu}m$ BCD technology and the die size is $2{\times}2\;mm^2$. The frequency range of the clock generator is from 50 kHz to 500 kHz and the range of the dead time is from 50 ns to 2.2 ${\mu}s$. The efficiency of the LED driving circuit is 97 % and the current consumption is 40 mA for a 100 kHz operation frequency from a 15 V supply voltage.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.35D no.1
• /
• pp.79-83
• /
• 1998

We analyzed dynamic-strain perturbations applied to a fiber Bragg grating. The fiber Mach-Zehnder interferometer was used, and by analyzing the interference signal wecould obtain the frequency and relative amplitude information of the dynamic-perturbation. The minimum detectable dynamic-strain using the system was ~9.5 nstrain RMS/.root.(Hz) at 500 Hz. Also we proposed and demonstrated a new method which uses a temperature-discriminating dual-trating sensor head. With the method, we could measure the dynamic -strain as well as static-static-strain even for the case in which the optical pathe difference modulation was applied.

• BMB Reports
• /
• v.35 no.4
• /
• pp.384-388
• /
• 2002

A method for the ratiometric pH sensing using LysoSensor DND-192 is presented in this paper. It works in the physiological pH range. It is based on the use of two fluorophores which differ significantly in their lifetimes. As the discrimination of their emissions is performed through two different frequencies, this method can allow significant overlap of the emission spectra. A simple long-pass filter, or a combination of long-and short-pass filters, was used instead of narrow-bandpass devices. Importantly, the measurements were carried out under strong ambient light. The method could be used in a wide variety of applications, such as intracellular measurements, microscopy, bioprocess monitoring, etc.

• Phonetics and Speech Sciences
• /
• v.15 no.4
• /
• pp.11-16
• /
• 2023

The present study examines how a cognitive attention affects Korean learners of English (L2) in perceiving the English stop voicing distinction (/d/-/t/). This study tested the effect of attentional distractor on primary and non-primary acoustic cues, focusing on the role of Voice Onset Time (VOT) and fundamental frequency (F0). Using the dual-task paradigm, 28 Korean adult learners of English participated in the stop identification task carried with (distractor) and without (no-distractor) arithmetic calculation. Results showed that when distracted, Korean learners' sensitivity to VOT decreased as priorly reported with native English speakers. Furthermore, as F0 is a primary cue for a L1 Korean stop laryngeal contrast, its role in L2 English voicing distinction was also affected by a distractor, without compensating for the reduced VOT sensitivity. These findings suggest that flexible use of multiple cues in L1 is not necessarily beneficial for L2 phonological processing when coping with a adverse listening condition.

• Korean Journal of Optics and Photonics
• /
• v.18 no.1
• /
• pp.56-65
• /
• 2007

The effect of gain dispersion on the self-pulsation (SP) characteristics due to the mode beating of two modes emitted in a multisection DFB laser composed of two complex-coupled DFB sections and a phase control section is investigated. When the peak wavelength, ${\lambda}_{p}$, of the gain spectrum of the DFB section is positioned in the center of the lasing wavelengths or the Bragg wavelengths of the two DFB sections, the maximum SP frequencies are higher and the modulation index has better characteristics compared to those cases for ${\lambda}_{p}$ fixed at the lasing wavelength or Bragg wavelength of one DFB section, when the difference between the Bragg wavelengths of the two DFB sections, ${\Dalta}{\lambda}_{B}$, is varied. When ${\lambda}_{p}$ is positioned in the renter of the Bragg wavelengths of the two DFB sections, the maximum SP frequency is higher and of the modulation index has better characteristics compared to those of the case for ${\lambda}_{p}$ positioned in the center of the lasing wavelengths of the two DFB sections.

• Journal of Power Electronics
• /
• v.19 no.1
• /
• pp.119-133
• /
• 2019

Although the dual modulation wave method can solve the low-frequency neutral point potential (NPP) fluctuation problem for three-level neutral point clamped converters, it also increases the switching frequency and limits the zero-sequence voltage. That makes it harmful when dealing with the NPP drift problem if the converter suffers from a long dead time or asymmetric loads. By introducing two degrees of freedom (2-DOF), an NPP control based on a search optimization method can demonstrate its ability to cope with the above mentioned two types of NPP problems. However, the amount of calculations for obtaining an optimal 2-DOF is so large that the method cannot be applied to certain industrial applications with an inexpensive digital signal processor. In this paper, a novel optimal 2-DOF-based NPP control is proposed. The relationships between the NPP and the 2-DOF are analyzed and a method for directly determining the optimal 2-DOF is also discussed. Using a direct calculation method, the amount of calculations is significantly reduced. In addition, the proposed method is able to maintain the strongest control ability for the two types of NPP problems. Finally, some experimental results are given to confirm the validity and feasibility of the proposed method.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.7
• /
• pp.68-73
• /
• 2009

This paper describes design and implementation of a spread spectrum clock generator (SSCG) for the DisplayPort. The proposed architecture generates the spread spectrum clock using a sigma-delta fractional-N PLL. The SSCG uses a digital End order MASH 1-1 sigma-delta modulator and a 9bit Up/Dn counter. By using MASH 1-1 sigma-delta modulator, complexity of circuit and chip area can be reduced. The advantage of sigma-delta modulator is the better control over modulation frequency and spread ratio. The SSCG generates dual clock rates which are 270MHz and 162MHz with 0.25% down-spreading and triangular waveform frequency modulation of 33kHz. The peak power reduction is 11.1dBm at 270MHz. The circuit has been designed and fabricated using in 0.18$\mu$m CMOS technology. The chip occupies 0.620mm$\times$0.780mm. The measurement results show that the fabricated chip satisfies the DispalyPort standard.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.9 no.3
• /
• pp.674-680
• /
• 2008

An SDR (Software Defined Radio) system based on general purpose computing platform has benefits of ease of software development process, high degree of software compatibility, and cost-effectiveness of general purpose processors. This paper discusses design and implementation of a dual-mode SDR system that supports both cordless phone and walkie-talky system running on Linux-based general purpose computing platform. For this purpose, we designed modulation and demodulation software on open source-based GNU radio middleware. We also designed a customized RF front-end hardware which performs frequency conversion between RF and IF. The proposed SDR system successfully exhibited its ability to operate both cordless phone and walkie-talky communication on Intel processor-based general purpose computing platform. But experience with the prototype SDR system shows that further research is required for run-time software reconfiguration and efficient integration with conventional TCP/IP protocol stacks.

• Journal of Korea Society of Industrial Information Systems
• /
• v.10 no.1
• /
• pp.1-8
• /
• 2005

Multicarrier code division multiple access(MC-CDMA) Is a scheme that combines multicarrier modulation with CDMA. It offers robustness to frequency selective fading and can support higher rate data transmission with higher spectral efficiency. The objective of this article to proposed a new asynchronous ME-CDMA system to implement multiple data rate communications. It can be accomplished by changing the number of parallel branch(.p). For the analysis of average BER performance, numerical method and computer simulation were used. After MAI power of received signal calculated, the average BER can be acriuired using Gaussian approximation to MAI. We also compare the system performance with that of a single rate MC-CDMA system.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.7
• /
• pp.1344-1349
• /
• 2012

The Korean DGPS station transmits the 200 bps GPS enhancement signal using the MSK modulation in frequency range of 283.5 kHz to 325 kHz. The land-based stations of 6 sites provide the service area of 80 km with the output power of 500 W. The ocean-based stations of 11 sites provide the output power of 300 W, which provide the DGPS service to 185 kM. Some places are serviced from two or three DGPS stations. The interferences among the DGPS stations using the high power can be occurred. Also, the performances of the user terminasl in dual service area can be degraded. In this paper, the protection ratios for the DGPS service are defined. Using the MF wave propagation model, the interferences among the DGPS stations and the adjacent wireless ground stations are analyzed. Also, the performances of DGPS user terminals are analyzed in the viewpoint of interference.