• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.10 no.1
• /
• pp.115-123
• /
• 1990

The purpose of this study was to examine the uses of coal ash as a type of construction material. The methods of examination were chemical anlysis, soil laboratory test and the soil vibration test. Materials used were coal ash obtained as a by-product from 5 thermal power plants in Yongdong, Yongwol, Sochon(anthracite coal) and in Samchonpo and Honam (bituminous coal). Over 70% of the coal ash consisted of silica and alumina. The fly ash grain size showed a uniform distribution from fine-sand to silt, and that of the bottom ash showed from sand to gravel. The specific gravity and density of the coal ash were low. The long term strength increased gradually due to the self-setting property resulting from pozzolanic activity. The shear strength was higher than that of general soil. Cohesion and optimum moisture content of anthracite coal ash were higher than bituminous coal ash, whereas the maximum dry density was higher in bituminous coal ash. The coal ash dynamic Young's modulous curve range was similar to that of general soil. Of the results from the soil vibration test by car-running, the size relative acceleration level in the ash pond was higher than that of natural ground, but the damping ratio was lower than that of natural ground near the ash pond. The coal ash has more advantageous engineering properties than general soil with particles of the same size. For example, the California Bearing Ratio of the bottom ash at both Yongdong and Yongwol was 77~137%. Therefore we expect that if further study is done, coal ash can be used as a construction material when reclaiming seashore, construction embankments, road construction, making right-weight aggregate, or as a general construction material.

• 한국신재생에너지학회:학술대회논문집
• /
• 2010.11a
• /
• pp.132.1-132.1
• /
• 2010

자원고갈과 지구온난화 등으로 재생에너지의 사용 및 보급이 지속적으로 증가할 것으로 예상되지만, 세계적으로 매장량이 풍부한 석탄의 사용량은 2030년 이후에도 지속적으로 증가될 전망이다. 따라서 세계 각국은 기후변화 규제에 대응하면서도 청정하게 석탄을 사용하기 위한 기술의 개발 및 보급을 활발히 진행 중이며, 국내에서도 온실가스 감축과 동시에 국가 성장 동력화를 추진하고 있다. 석탄가스화 기술은 석탄을 가스화하여 생산된 CO, $H_2$가 주성분인 합성가스를 연료로 활용하는 기술로, 이용 효율이 높고 석탄을 천연가스 수준으로 청정하게 사용할 수 있는 차세대 석탄이용 기술이다. 본 연구에서는 pilot급 석탄 가스화기에서 생산된 합성가스에 함유된 산성가스를 고온에서 건식으로 제거하는 시스템을 구축하였으며, 석탄 합성가스를 고온 건식 정제시스템에 공급하기 위한 석탄가스화기의 운전특성을 파악하였다.

• Korean Journal of Environmental Agriculture
• /
• v.40 no.2
• /
• pp.83-91
• /
• 2021

BACKGROUND: Cultivation area using agricultural plastic film facilities in Korea is rapidly increasing every year; however, it accelerates the salt accumulation in soils due to repeated cultivation and excessive use of chemical fertilizers. Coal ash contains various trace elements and has high potential to be used in agricultural purposes. This research was aimed to improve the quality of salts-accumulated soils and crop growth grown in the plastic film facilities using the soil amendment derived from coal ash and zero-valent iron powder. METHODS AND RESULTS: Soil amendment used in the study was manufactured using coal ash with iron powder and subjected to a typical upland soil for soil quality enhancement and two salts-accumulated soils for crop growth. After one month incubation of the salts-accumulated soils treated with the soil amendment, soil pH increased significantly and soil EC decreased by approximately 50%, compared to the control or the treatment without the soil amendment. Since the soil salts' concentration is proportional to EC, the subjected soil amendment can be proposed as an effective way to overcome soil salts accumulation in agricultural plastic film facilities. For crop growth, the length of roots and stems increased by approximately 10% and the dry weight also increased by a maximum of 75%, compared to the control. CONCLUSION: The soil amendment made from waste resources such as coal ash and zero-valent iron was found to not only be effective in improving salt-accumulated soils and crop yield but also be safe against harmful heavy metals.

• Korean Chemical Engineering Research
• /
• v.48 no.2
• /
• pp.140-146
• /
• 2010

This paper addresses recent status and trends of carbon dioxide capture technologies using dry sorbents in the flue gas. The advantages of dry sorbent $CO_2$ capture technology are broader operating temperature range, less energy loss, less waste water, less corrosion problem, and natural properties of solid wastes. Recently, U.S.A. and Korea have been developing processes capturing $CO_2$ from real coal flue gas as well as sorbents improving sorption capacity to decrease total $CO_2$ capture cost. New class of dry sorbents have been developed such as chemisorbents with alkali metals of which material cost is low, amines physically adsorbed on silica supports, amines covalently tethered to the silica support, carbon-supported amines, polymer-supported amines, amine-containing solid organic resins and metal-organic framework. The breakthrough is needed in the materials on dry sorbents to decrease capture cost.

• Journal of Korean Society for Atmospheric Environment
• /
• v.25 no.2
• /
• pp.99-107
• /
• 2009

This paper reviews the current status of mercury research on exposure and contamination, mercury emissions, emission limits and control technologies, long-range transport and deposition research, and mercury management policy in Korea. According to a monitoring of the Ministry of Environment and the Ministry of Health and Welfare, blood mercury levels among Koreans are $5{\sim}8$ times higher than those of U.S. and Germany. The most dominant source of exposure to mercury is through dietary intake. Emissions of mercury from coal-fired power plants are estimated 8.93 ton/year in 2004. Emissions of mercury from other important sources, such as waste incineration, steel and cement manufacturing and non-ferrous metal smelting operations are to be further investigated. A study on long-range transport of mercury suggests that the dry deposition flux over the Yellow Sea was much greater than those for other oceans. As a whole, the amounts of wet depositions of nitrogen and sulfur were 1.9 and 1.5 times larger than the amounts of dry depositions in each species, respectively. Substantial influence from China caused by high emissions in East China and westerly wind was possibly suggested. However, the influence from nitrogen emission in Korea was also confirmed. Korean Government has already adopted stringent emission limits on mercury for incinerators and boilers in 2005. However, emission limits for coal-fired power plants and non-ferrous metal smelters are rather relaxed. As the above mentioned two sources can be two most important sources of mercury emissions, control strategy for those sources are to be considered.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.6 no.4
• /
• pp.267-274
• /
• 2018

Though the wet bottom ash has been used as a type of lightweight aggregate, dry bottom ash, new type bottom ash from coal combustion power plant, has scarcely researched. It is excellent lightweight aggregate in the view point of construction material. This study is performed to check the applicability of dry bottom ash as a fine aggregate in lightweight aggregate concrete, by analyzing various properties of fresh and hardened concrete. We get results that the slump of concrete is within the target range at less than 75% replacement rate of dry bottom ash, the air content is not affected by the replacement rate of dry bottom ash, the bleeding capacity is less than $0.025cm^3/cm^2$ at 75% under of the replacement rate of dry bottom ash, and the compressive strength of concrete show 90% or more comparing the base mix while initial strength development is a little low. Oven dry unit weight of concrete is reduced by 8.9% when replaced 100% dry bottom ash, and dry shrinkage tends to decrease depending on increase of replacement rate of dry bottom ash. Modulus of elasticity of concrete shows no decease at 50% over of the replacement rate of dry bottom ash, while modulus of elasticity of concrete decreases when the replacement rate increases further. The dry bottom ash, when used as a fine aggregate in lightweight concrete, can be used effectively without any deterioration in quality.

• Journal of the Korean Society of Groundwater Environment
• /
• v.2 no.1
• /
• pp.38-47
• /
• 1995

This study was carried out in order to provide basic information on neutralization processes of acid mine drainage (AMD) from the abandoned Donghae coal mine in the Samchuk coalfield. The contents of potentially toxic elements in stream water increase and the level of pH decreases during dry season. Hydrated lime is turned out to be the best neutralizer of the acid mine water from a technical and economic viewpoint. From the results of equilibrium calculation, Fe and Al could be precipitated as FeOOH, and Al(OH)$_3$, respectively, in the neutralization process. The sites of holding basins necessary to equalize quantity and quality of AMD are recommended by GIS analysis, and the capacities of holding basins are determined by hydrological calculation.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2003.05a
• /
• pp.61-65
• /
• 2003

Bottom ash among the coal ash is not used because of its poor properties. But encouraging the use of bottom ash as a construction material is a sensible method of utilization as it avoids the problems and costs associated with disposal and provides an alternative aggregate source. This study was aimed at using bottom ash as an alternative fine aggregate source to provide a solution to disposal and insufficient fine aggregate for the production of concrete. So properties of domestic bottom ash were estimated due to the difference of each domestic bottom ash. And compressive strength and durability were estimated as basic data to use bottom ash in building industries. As a result of the experiment, the very porous surface and angular shape of the bottom ash particles necessitate a higher apparent water-cement ratio. And due to the higher water requirement, the compressive strength and durability of mortar is lower than those of the control samples. But when 25 percent of the total dry weight of the natural fine aggregate was replaced by bottom ash, the engineering characteristics were similar.

• Journal of the Korean GEO-environmental Society
• /
• v.13 no.9
• /
• pp.5-16
• /
• 2012

In the case of using the soil materials created by cutting in-situ ground directly without adjusting particle size, it is recommendable to seek the compaction property or material constant required for filling design or density control through indoor test, and many studies on this subject have been carried out during that time. The researches conducted during that time, however, were focused on the mixed materials with different diameters that exist in a natural condition. There has been no study conducted using coal fly ash that is by-product of the thermal power plant that is actively considered as the building materials. Therefore, this study was aimed at implementing compaction test and examining the basic engineering property in order to explore the influence of crushing the particles through compacting the admixture of crushed stone and coal fly ash produced from thermal power plant on its engineering property, and then the impact of the admixture volume of each material on compaction property and material property by conducting the One-Dimensional Compression Test. As result of compaction test, the optimum moisture ratio of coal fly ash was shown to be approx. 23%. As result of compaction test in accordance with the mixed ratio of coal fly ash and crushed stone under the same compaction energy and moisture ratio, dry unit weight tended to drop when the mixed ratio of coal fly ash exceeded 30%, while it reached approx. $1.81gf/cm^3$ when the mixed ratio was 30%. As result of One-Dimensional Compression Test in accordance with the mixed ratio of crushed stone and coal fly ash, the change in void ratio by particle crushing was at the highest level in the case of coal fly ash 100%, while the lowest level in the case of crushed stone 100%. In the case of mixed materials of crushed stone and coal fly ash, compression index was at the lowest level in case of coal fly ash 30%, and therefore this ratio of mixed material was judged to be the most stable from an engineering aspect.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.7 no.2
• /
• pp.101-108
• /
• 2019

This study is analysis of the utilization as a concrete fine aggregate on CGS, a by-product of Integrated coal gasification combined cycle(IGCC). That is, in KS F 2527 "Concrete aggregate," properties of 1~12times to CGS were evaluated, focusing on quality items corresponding to natural aggregate sand(NS) and melted slag aggregate sand(MS). As a result, the distribution of grain shape, safety and expansion were all satisfied with KS standards by physical properties, but the quality was unstable at 7~12times of water absorption ratio and absolute dry density. The particle size distribution was unstable due to asymmetry distribution of coarse particles, and particles were too thick for 7~12times. The passing ratio of 0.08mm sieve was also out of the KS standard at part factor of 7~12times, but chloride content, clay contents, coal and lignite were all satisfactory. Meanwhile, chemical composition was satisfactory except for $SO_3$ in 1~6times, and content and amount of harmful substances were all within the specified value except for F in 7~12times. As a result of SEM analysis, the surface quality and porosity were 7~12times more than 1~6times, and it was the quality was degraded. Therefore, it is necessary to reduce the quality deviation by using separate measures in order to utilize it as concrete aggregate in the future, and if it is premixed with fine quality aggregate, it will contribute positively to solve aggregate supply shortage and utilize circulation resources.