• Journal of the Korean Solar Energy Society
• /
• v.25 no.4
• /
• pp.93-100
• /
• 2005

Character and illuminance distribution of daylighting is very important for the architectural plan in museum. Those data show bases for exhibition space design with daylighting and play a decisive role in visual perception of articles and space aesthetic. The goal of this paper was therefore to analyze the illuminance distribution in fine art museum with 3 typical girdle skylight types which are devided according to the art of protection from glare. This Experiment proved that they had a striking contrast with regard to the ratio of daylight illumination and illuminance distribution in spite of the same purpose of those development. The girdle skylight with a translucent glass showed the strongest value of the ratio of daylight illumination, but inequable illuminance distribution in space, excepting the area of the wall. However, the latticed reflector of light refracted daylight in the direction of wall and made illuminance distribution very equable in whole space. The ratio of daylight illumination at the girdle skylight which was located at the verge of the ceiling, was highest at the upper part of the wall and was reduced gradually from there, by way of the middle and under part of the wall, to the center of space.

• Journal of Korea Water Resources Association
• /
• v.36 no.2
• /
• pp.325-343
• /
• 2003

In this study, several types of rainfall time distribution of the probabilistic rainfall amount have been applied to the Sihwa Lake, located in Gyounggi Province, Korea and their runoff characteristics, obtained by the Hec-Hms program, according to the rainfall distribution types, were compared and analysed. And then, the influences of the above rainfall distribution types of the highest water level of the reservoir, computed through the reservoir flood routing, were analysed. The tidal variation was considered, performing the flood routing and, in addition, the new program, called “IWSEA”, which can compute the reservoir water level, was developed. To conclude, when the Mononobe type of the rainfall distribution was used, the largest inflow flood discharge into the reservoir was performed and the highest reservoir water level was obtained when the Pilgrim-Cordery type of the rainfall distribution was applied.

• Journal of Electrical Engineering and Technology
• /
• v.9 no.4
• /
• pp.1154-1162
• /
• 2014

In the restructured electricity market, Performance-Based Regulation (PBR) regime has been introduced to the distribution network. To ensure the network stability, this regime is used along with quality regulations. Quality regulation impose new financial risks on distribution system operators (DSOs). The poor quality of the network will result in reduced revenues for DSOs. The mentioned financial risks depend on the quality indices of the system. Based on annual variation of these indices, the cost of quality regulation will also vary. In this paper with regard to reclosing fault in distribution network, we develop a risk-based method to assess the financial risks caused by quality regulation for DSOs. Furthermore, in order to take the stochastic behavior of the distribution network and quality indices variations into account, time-sequential Monte Carlo simulation method is used. Using the proposed risk method, the effect of taking reclosing time into account will be examined on system quality indicators and the cost of quality regulation in Swedish rural reliability test system (SRRTS). The results show that taking reclosing fault into consideration, affects the system quality indicators, particularly annual average interruption frequency index of the system (SAIFI). Moreover taking reclosing fault into consideration also affects the quality regulations cost. Therefore, considering reclosing time provides a more realistic viewpoint about the financial risks arising from quality regulation for DSOs.

• Journal of Korean Physical Therapy Science
• /
• v.19 no.3
• /
• pp.9-15
• /
• 2012

Background : The purpose of this study was to compare the effects of functional electrical stimulation(FES) on weight distribution and synchronization of the lower extremity of patients with post-stroke. Methods : They were randomly divided into two groups, 8 people in the experimental group and 7 people in the control group. A total of 15 subjects volunteered to participate in this study. experimental groups were treatment FES training on parallel bars and control groups were FES training on chair. They was performed for 15 minute, three times in a week, for the 6 weeks. Result : The experimental group The weight distribution A, B, C, D and synchronization AB, CD, AD, BC indicating changes in statistical significance(p<.05). However, the control group only showed significantly increased weight distribution A, C(p<.05). In a variation, experimental and control groups showed significantly increased weight distribution A, B, C and synchronization AD. Conclusion : These findings suggest that the FES training on parallel bars are effective in improving the weight distribution and synchronization of lower extremity of patients with post-stroke. Further study will be continued in this method of therapeutic exercise and additional physical therapy program.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.35 no.12
• /
• pp.1486-1496
• /
• 2011

The present study analyzed the consumer acceptance of labels, satisfaction with cosmetics after purchase, the relationship between consumer acceptance of cosmetics labels and satisfaction with cosmetics as viewed by type of distribution channel. The study was implemented through a descriptive survey method based on a self-administered questionnaire. The sample consisted of 759 women between the ages of 21 and 49, residing in the area of Seoul, Gwangju, and Gyeonggi Province. There were significant differences in the levels of consideration of labels among consumers from each type of distribution channel. Consumers that prefer door-to-door sales consider the information about ingredients more crucial than consumers who prefer other types of distribution channels, department store consumers consider manufacturer information more important, and consumers who prefer specialty stores/chains and discount stores consider the date of manufacture less important than other types of distribution channels. Significant differences were found in consumer satisfaction with cosmetics after purchasing among consumers from each type of distribution channels. A significant relationship was found between the level of considering the product information listed on the labels and the satisfaction with the cosmetics. With respect to most of the factors, a higher level of label consideration was correlated with a higher satisfaction with cosmetics after purchase.

• International Journal of Automotive Technology
• /
• v.8 no.5
• /
• pp.575-581
• /
• 2007

As current and future automobile emission regulations become more stringent, the research on flow distribution for an exhaust manifold and close-coupled catalyst(CCC) has become an interesting and remarkable subjects. The design of a CCC and exhaust manifold is a formidable task due to the complexity of the flow distribution caused by the pulsating flows from piston motion and engine combustion. Transient flow at the exhaust manifold can be analyzed with various computational fluid dynamics(CFD) tools. However, the results of such simulations must be verified with appropriate experimental data from real engine operating condition. In this study, an experimental approach was performed to investigate the flow distribution of exhaust gases for conventional cast types and stainless steel bending types of a four-cylinder engine. The pressure distribution of each exhaust sub-component was measured using a simulated dynamic flow bench and five-hole pitot probe. Moreover, using the results of the pitot tube measurement at the exit of the CCC, the flow distribution for two types of manifolds(cast type and bending type) was compared in terms of flow uniformity. Based on these experimental techniques, this study can be highly applicable to the design and optimization of exhaust for the better use of catalytic converters to meet the PZEV emission regulation.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.29 no.5
• /
• pp.71-79
• /
• 2015

Recently, new Low Voltage DC (LVDC) power distribution systems have been constantly researched as uses of DC in end-user equipment are increased. As in conventional AC distribution system, High Impedance Fault (HIF) which may cause a failure of protective relay can occur in LVDC distribution system as well. It, however, is hard to be detected since change in magnitude of current due to the fault is too small to detect the fault by the protective relay using overcurrent element. In order to solve the problem, this paper presents an algorithm for detecting HIF using accumulated energy in LVDC distribution system. Wavelet Singular Value Decomposition (WSVD) is used to extract abnormal high frequency components from fault current and accumulated energy of high frequency components is considered as the element to detect the fault. LVDC distribution system including AC/DC and DC/DC converter is modeled to verify the proposed algorithm using ElectroMagnetic Transient Program (EMTP) software. Simulation results considering various conditions show that the proposed algorithm can be utilized to effectively detect HIF.

• Journal of Korea Water Resources Association
• /
• v.31 no.3
• /
• pp.327-335
• /
• 1998

The distribution network is an essential part of all water supply systems. The cost of this portion of any sizable water supply system may amount to most of the entire cost of the project. This study tried to reduce the cost of the distribution system through optimization in system design. To determine pipe diameter considered in water distribution system design, a iterative procedure linked the flow analysis model and optimization model was used. Linear theory was introduced to analyze flowrate and revised-simplex method based on linear programming is used to optimize pipe diameter. This model was applied to wter distribution system with 22 and 35 pipes, and rapidly determine optimized commercial pipe diameters. Keywords : water distribution system, revised simplex method, optimum pipe diameters.

• Journal of the Korean Society of Industry Convergence
• /
• v.4 no.2
• /
• pp.157-166
• /
• 2001

The purpose of this study is to examine the accuracy of the code provisions on lateral load distribution factors of prestressed concrete girder bridges. Most designers in Korea use the lever method or lateral load distribution formula in the existing design codes. However, the methods do not account for the effect of bridge skew or direction of diaphragm. Therefore, this study analysed the prestressed concrete girder bridge with grillage model for various girder spacings, directions of diaphragms, span lengths, and skews, and compared the results with those of existing design code. It has been found that lateral load distribution factors were proportional to the girder spacing while they were not significantly affected by the change of span length, direction of diaphragm, and skew. For bending moments, lateral load distribution factors from the grillage analysis were 60%~68% of those from Korean bridge design code. Therefore, the code provisions result in very conservative design. For support reactions, however, lateral load distribution factors from the grillage analysis were slightly greater than those from Korean bridge design code. Therefore, the capacity of bearings of the bridge with a large skew should be determined by grillage analysis.

• Journal of Distribution Science
• /
• v.19 no.12
• /
• pp.57-69
• /
• 2021

Purpose: This study aims to measure whether the business performance of Padang restaurants in North Jakarta is primarily affected by service distribution strategy and other factors, specifically the local-based organizational culture and entrepreneurial orientation. Research design, data and methodology: This quantitative research has used Structural Model-Partial Least Square (PLS-SEM) with SMART PLS 3.0 as the analytical tool. The study's sample focus is the owner or person in charge of the Padang restaurant business in North Jakarta. Data has been collected using a questionnaire instrument with a Likert scale scale ('1-strongly disagree' to '5-strongly agree'). A total of 86 samples with a random technique were obtained from three areas in North Jakarta: Kelapa Gading, Pademangan, and Penjaringan. Results: Interestingly, this research finds that service distribution strategy does not affect business performance, either directly or indirectly. Business performance in this study is affected by entrepreneurial orientation. In additional results, the local organizational culture significantly affects the entrepreneurial orientation, but does not affect the business performance in terms of management process. Conclusions: This study provides practical implications for restaurant businesses regarding the use of local cultural concepts to consider strategies for survival in today's challenging times while continuing operations during limitations.