• Atmosphere
• /
• v.19 no.4
• /
• pp.319-329
• /
• 2009

The intensive dust observation experiment has been performed at Korea Global Atmosphere Watch Center (KGAW) in Anmyeon, Korea during each spring season from 2007 to 2009. Downward and upward hyper-spectral spectrums over the dust condition were measured to understand the hyper-spectral properties of Asian dust using both ground-based Fourier Transform Infrared Spectroscopy (FT-IR) and space-borne AIRS/Aqua. To understand the impact of the Asian dust, a Line-by-Line radiative transfer model runs to calculate the high resolution infrared spectrum over the wave number range of $500-500cm^{-1}$. Furthermore, the radiosonde, a $PM_{10}$ Sampler, a Micro Pulse Lidar (MPL), and an Aerodynamic Particle Sizer (APS) are used to understand the vertical profile of temperature and humidity and the properties of Asian dust like concentration, altitude of dust layer, and size distribution. In this study, we found the Asian dust distributed from surface up to 3-4 km and volume concentration is increased at the size range between 2 and $8{\mu}m$ The observed dust spectrums are larger than the calculated clear sky spectrums by 15~60K for downward and lower by around 2~6K for upward in the wave number range of $800-1200cm^{-1}$. For the characteristics of the spectrum during the Asian dust, the downward spectrum is revealed a positive slope for $800-1000cm^{-1}$ region and negative slope over $1100-1200cm^{-1}$ region. In the upward spectrum, slopes are opposed to the downward one. It is inferred that the difference between measured and calculated spectrum is mostly due to the contribution of emission and/or absorption of the dust particles by the aerosol amount, size distribution, altitude, and composition.

• Ocean and Polar Research
• /
• v.32 no.4
• /
• pp.351-359
• /
• 2010

This study examined extensive patches of floating green macroalgal (Ulva prolifera) mats in the northern East China Sea (ECS) using satellite images from mid May through July 2008 and field observation made during early August 2008 cruise. It was previously reported that the massive macroalgal blooms occurred in the coastal areas of Qingdao in China. During our field survey, researchers noticed widely distributed floating patches of macroalgal mats ranging in size from tens of centimeters to a few hundred meters in diameter. Meteorological data in the northern ECS showed high irradiance, high air-temperature, and predominant southerly winds in summer. In the study area during the survey period, surface waters were characterized by the Changjiang Diluted Water (CDW) mass, which contained high concentrations of nitrate and phosphate. The internal transcribed spacer (ITS) sequence of U. prolifera found in the northern ECS was the same as those of U. prolifera sampled from Qingdao blooms, suggesting a possibility that U. prolifera found in two regions would be derived from the same origin. We suggest that U. prolifera in the nearshore Jiangsu Province drifted into the northern ECS and proliferated under favorable meteorological and oceanographic conditions during the summer of 2008.

• Journal of Pharmaceutical Investigation
• /
• v.38 no.1
• /
• pp.23-29
• /
• 2008

Red ginseng is made of white ginseng through the steaming and drying procedure. In this process, the amounts of toxic elements of ginseng are decreased and those of effective components, ginsenosides are increased. In order to identify the components alteration of white ginseng by processing time, we applied HPLC-based metabolomics approach combined with the principal component analysis (PCA) multivariate analysis. White ginsengs were steamed at 0, 1, 2, 4, 8 and 16 h, respectively and followed by drying process at moderate temperature. Then the steamed ginsengs and the commercial red ginsengs were analyzed by HPLC. On the basis of HPLC results, PCA multivariate analysis was applied for evaluating the quality of red ginseng, which showed the processed ginsengs are grouped by processed time because less polar ginsenosides were increased in proportion as the steaming time was increased. The purchased red ginsengs were distributed in the range of $0{\sim}1$ hour steaming time. This pilot experiment suggests that HPLC-based metabolomics approach is able to allow the quality of herbal medicines to be controlled with a simple and economic method.

• Tunnel and Underground Space
• /
• v.25 no.2
• /
• pp.133-143
• /
• 2015

Gas hydrate is a solid substance composed of natural gas constrained in water molecules under low temperature and high pressure conditions. The existence of hydrates has been reported to be world-widely distributed, mainly at permafrost and deep ocean floor. Test productions of small amount of natural gas from the on-shore permafrost have been accomplished in U.S.A and Canada, but, world-first and the only production case from off-shore hydrate bearing sediments was in Nankai trough, Japan. In this study, we introduce key technologies in gas production from hydrates by analyzing the Japanese off-shore gas production project in Nankai trough in terms of depressurization- induced dissociation so as to utilize planned domestic gas production test in Ulleung basin.

• Journal of Energy Engineering
• /
• v.21 no.2
• /
• pp.144-151
• /
• 2012

A district heating system produces thermal energy and supplies it to a large region. District heating systems can provide higher efficiencies and better pollution control than localized boilers. The heat generated by a district heating system is distributed to the customer via a network of insulated pipes. For the optimal operation of a district heating system, it is important to predict the distributions of pressure, flow rate and temperature of heating fluid within the network of pipes at various operating conditions. In this work, a mathematical modeling was performed to predict the dynamic hydraulic-thermal behaviors of heating fluid in the network of pipes for a district heating system. The mathematical model accounts for the conservations of mass, momentum and energy. In order to verify the validity of modeling, the modeling results were compared with the monitoring data of Gang-nam Branch of District Heating.

• 한국해양학회지
• /
• v.4 no.1
• /
• pp.1-8
• /
• 1969

Phytoplankton samples, collected about twenty day interval on May of 1967, at same twenty-one stations located in the north-eastern Korea Strait were examined in an attempt to determine the specific distribution and abundance of phytoplankton. Water bottle samples preserved with neutralized formula were used for the phytoplankton study. In May, water temperature and salinity show both lower at the sea of Korea side than that of Japan side, and both indicate gradually higher to the sea of Japan side. Fourty-six species of diatoms and three species of dinoflagellates in early May, and thirty-six species of diatoms and six species of dinoflagellates in the May were detected. Among them thirty species of diatoms and two species of dinoflagellates were appeared commonly in both cruise. Chaetoceros curvisetus and Rhizosolenia castracanei were wide distributed species, and Leptocylindrus danicus was the most numerous species at this sea in May. In generally, the sea of Korea side was more rich in species and numbers of phytoplankton.

• Proceedings of the KWS Conference
• /
• 2009.11a
• /
• pp.55-55
• /
• 2009

FGB(Flexible Glasswool Backing) Submerged Arc Welding has been one of the main welding processes for one side butt welding in shipbuilding industries, which can efficiently improve the welding productivity by the addition of a supplementary filler metal into the molten weld pool. As recent ships have become larger in size, the application of high tensile and higher grade of steels has been continuously increased. Single pass FGB SA welding process accompanies such a high heat input when welding thick plates that the mechanical properties of weld metal can be dramatically degraded. This study has been performed in order to obtain high toughness and tensile properties of high heat input FGB SA welds, and to evaluate the effect of alloy elements on their mechanical properties. To complete welding 25mm-thick EH36 grade steel plate by single pass, 1.2mm diameter and 1.0mm long cut wires has been distributed in the groove before welding, and three different test coupons have been made using C-1.5%Mn, C-1.8%Mn-0.5%Mo, and C-1.4%Mn-1.7%Ni cut wires to investigate the influence of nickel(Ni) and molybdenum(Mo) on the mechanical properties of welds. Test results showed that the addition of Ni and Mo effectively promotes the formation of Acicular Ferrite(AF), while significantly reducing the amount of Grain Boundary Ferrite(GBF) in weld metal microstructures, which resulted in a beneficial effect on low temperature impact toughness and strength.

• Journal of Life Science
• /
• v.18 no.6
• /
• pp.759-763
• /
• 2008

Halophila ovalis (R. Br.) Hook. fil. was first collected from the Ando, Yeosu, Korea in 2007. H. ovalis is Widely distributed from sub-tropical to even tropical areas and produces the seeds using bisexual reproduction. Its leaf shape was oblong to ovate. Its leaf blades were rigid in texture, with a strong support to the leaf. Erect shoots arose at irregular intervals along the rhizome. The distance between the intramarginal vein and leaves margin was small. Nucleotides in ITS 1 and ITS 2 regions between the Korean and Japanese H. ovalis were found to be 100% similar, whereas Korean H. ovalis was found to have four nucleotides in the positions of 202 bp to 206 bp for 5.8S. In the analysis of the phylogenetic relationship using NJ method, Korean H. ovalis had a monophyletic genetic tree with Japanese H. ovalis, but no phylogenetic relationship with types from the Philippines, Australia, Malaysia, and Vietnam. The first occurrence of H. ovalisin Korea was associated with a strong migration of gene flow from Japan and high water temperature caused by the variations in climate.

• Parasites, Hosts and Diseases
• /
• v.35 no.3
• /
• pp.149-154
• /
• 1997

A storage mite, Tyrophcgus putrescentiae, is recently known to be widely distributed in Korea, being commonly found in house dust, and may, therefore, be allergenically important. The purpose of this study was to develop mass rearing techniques for supplying a large quantity of allergens. The laboratory mouse food powder gave the highest yield, showing 1,251.5-fold increase in number after 10 weeks, and the mixed powder of laboratory mouse food and yeast (1 : 1) also gave same level of the production (1.203 1-fold increase in week 10). Several different combinations of temperature and relative humidity conditions were compared, and the maximum propagation was obtained at $25^{\circ}C$ and 64% RH, showing 960-fold increase in number. When the same amount of culture media was used the size of the culture container did not significantly influence the quantitative yield of T. putrescentice mites.

• Journal of the Korean Wood Science and Technology
• /
• v.34 no.1
• /
• pp.68-78
• /
• 2006

The purpose of this study was to estimate the identification of thermophilic hacterial with fermentation of pig manure. To identify the characters of thermophilic bacteria related to fermentation at a high temperature condition, we selected 28 different kinds of original settling thermophilic bacteria that were sampled at different 23 areas. They were distributed 1$1{\times}10^5{\sim}10^8CFU$ at medium and the enzyme activity at $55^{\circ}C$ incubation condition, especially cellulase and a-amylase, were higher than those of $30^{\circ}C$. Partial sequencing data for 165 rDNA region were obtained from 28 samples representing 15 different genera. Bacillus subcilis, one of those bacteria, has endodermic spores at high fermented condition.