• Journal of the Korean Ceramic Society
• /
• v.18 no.4
• /
• pp.237-246
• /
• 1981

The effects of impurities, included in the by-produced phosphogypsum from the dihydrate process, on the hydration of portland cement were studied. Six gypsums were adopted in this study; four different raw phosphogypsums from domestic fertilizer plants, a reprocessed phosphogypsum and a reagent grade pure gypsum. Cements with differing $SO_3$ content, were synthesized by grinding two different commercial clinkers and the above six gypsums together. The effects of the impurities were investigated by measuring the setting time, the non-evaporable water coatent, X-ray phase analysis of cement pastes and the compressive strength of cement mortar specimens. It was found that the soluble $P_2O_5$ known as one of injurious impurities on the hydration of portland cement, included in the demestic raw phosghoypsum cxneedigply by far the specified amounts of the Korean Industrial Standards (L9005), and retarded the setting time severely, thus the strength development of cement was delayed at the earlier stage of hydration.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.22 no.1
• /
• pp.15-18
• /
• 2012

Transparent conductive indium zinc oxide thin films were prepared by spin-coating a sol-gel solution. Zinc acetate dihydrate [$Zn(CH_3COO)_2{\cdot}2H_2O$] and indium acetate [In$(CH_3COO)_3$] were used as starting precursors, and 2-methoxyethanol with 1-propanol as solvents. Upon annealing in a temperature range from 500 to $1000^{\circ}C$, the thin film crystallizes into polycrystalline $In_2O_3$(ZnO). The lowest electrical resistivity was obtained at an annealing temperature of $700^{\circ}C$ as $2{\Omega}{\cdot}cm$. Average optical transmittances were higher than 80% at all annealing temperatures. These experimental results confirm that the sol-gel spin-coating can be a good simplified practical method for forming transparent electrodes.

• Journal of the Korean Chemical Society
• /
• v.38 no.5
• /
• pp.397-403
• /
• 1994

An activated catalyst prepared from a mixture of nickel nitrate hexahydrate with zinc in dry ethanol under reflux showed exceptional catalytic activity for the reduction of nitroarenes to the corresponding azoxy compounds exclusively in the presence of hydrazine monohydrate. However, when nickel nitrate hexahydrate was replaced by nickel chloride dihydrate with zinc, only the aminoarenes were formed in high yields. With unactivated catalyst, the reduction reaction from a mixture of nitroarenes, nickel nitrate or chloride, excess zinc and hydrazine monohydrate gave the corresponding azo, azoxy and amino compounds in much lower yields.

• Biomolecules & Therapeutics
• /
• v.7 no.2
• /
• pp.198-203
• /
• 1999

Loxoprofen-Na (sodium 2-〔4-(2-oxocyclopentylmethyl)pheny)propionate dihydrate) is a potent analgesic drug. We developed loxoprofen-Na plasters to extend duration time of analgesic activity and to reduce side effect on gastrointestinal tract. Analgesic effect of Loxoprofen-Na plasters was investigated. Loxoprofen-Na plaster had good analgesic effect in rat paw pressure test, Tail-flick latency test and acetic acid-induced writhing test. Also, it had anti-inflammatory effect on carrageenan-induced rat hind paw edema. In pharmacokinetic study of Loxoprofen-Na, plasters dosage form showed that plasma drug concentration was prolonged up to 14 hours. So, we can conclude that loxoprofen-Na plasters, when applied on skin, will be a new type of drug for controlling the various local pain or inflammation.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.08a
• /
• pp.292-292
• /
• 2010

Among the semiconducting materials, ZnO has considerably attracted attention over the past few years due to the high activities in removing organic contaminants created from industry. In this work, ZnO nanoparticles were synthesized by spray pyrolysis method using the zinc acetate dihydrate as starting material at various synthesis temperatures. The structures of the synthesized ZnO were characterized by X-ray Diffraction (XRD), Scanning Electron Microscopy (SEM), Brunauer, Emmett & Teller (BET), Fourier Transformation Infrared (FT-IR), and UV-vis spectroscopy. The Miller indices of XRD patterns indicate that the synthesized ZnO nanoparticles showed a hexagonal wurtzite structure. With increasing synthesis temperature, the mean diameter of ZnO nanoparticles increased, and their crystallinity was improved. Also, the photocatalytic activity of ZnO was studied by the photocatalytic degradation of methyleneblue (MB) under UV irradiation (365 nm) at room temperature. The results show that the photocatalytic efficiency of ZnO nanoparticles was enhanced by increasing synthesis temperature.

• Journal of the Korean Ceramic Society
• /
• v.42 no.11 s.282
• /
• pp.770-776
• /
• 2005

Hardening and hydroxyapatite(HAp) formation behavior of the bioactive cements in the system of $CaO-SiO_{2}-P_{2}O_{5}$ glasses and the corresponding glass-ceramics were studied. DCPD (Dicalcium Phosphate Dihydrate: $CaHPO_4{\cdot}2H_2O$) and DCPA (Dicalcium Phosphate Anhydrous: $CaHPO_4$) were developed when the prepared glass and glass-ceramic powders were mixed with three different solutions. The DCPD and DCPA transformed to HAp when the cement was soaked in Simulated Body Fluid (SBF), and this HAp formation strongly depended on the releasing capacity of $Ca^{2+}$ ions from the cements. The glass-ceramic containing apatite showed fast setting, but no HAp formation was observed because no $Ca^{2+}$ ions were released from this glass-ceramics. The compressive strength of the cements increased with reaction time in SBF until all DCPD and DCPA transformed to HAp.

• Elastomers and Composites
• /
• v.51 no.1
• /
• pp.10-16
• /
• 2016

Nanosized palladium particles were synthesized using palladium(II) chloride, trisodium citrate dihydrate, and sodium borohydride under stirring condition. Nanosized palladium-graphene composites were prepared from palladium nanoparticles, and graphene was enclosed with polyallylamine under stirring condition for 1 h followed by ultrasonication for 3 h. Nanosized palladium-graphene composites were heated in an electric furnace at $700^{\circ}C$ for 2 h and characterized by X-ray diffraction, scanning electron microscopy, and transmission electron microscopy. UV-vis spectrophotometry was used to evaluate the nanosized palladium-graphene composites as a catalyst in the photocatalytic degradation of various organic dyes such as methylene blue, methyl orange, rhodamine B, and brilliant green under ultraviolet light at 254 nm.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2013.02a
• /
• pp.350-350
• /
• 2013

Sol-gel법을 이용하여 p-Si 기판위에 yttrium이 도핑된 ZnO (YZO)를 성장하였다. ZnO의 precursor로는 zinc acetate dihydrate를, yttrium의 source로는 yttrium acetate hydrate를 사용하였으며, 용매와 안정제로는 각각 2-methoxy ethanol과 monoethanolamine (MEA)를 사용하였다. yttrium의 doping 농도에 따른 영향을 알아보기 위하여 1~4 at.%로 제작된 YZO sol을 각각 p-type Si 기판에 성장하였으며, 이 후 furnace를 이용하여 500oC에서 1시간 동안 열처리하였다. 성장된 YZO 박막의 표면과 두께를 SEM을 통하여 확인하였으며, XRD를 통한 구조적인 특성을 분석한 결과 모든 박막에서 뚜렷한 c-축 배양성을 갖는 ZnO (0002)피크를 확인하였다. Hall effect를 통하여 YZO는 모두 n-type 특성을 나타낸다는 것을 확인하였으며, 광학적인 특성은 PL을 통해서 분석하였다. n-YZO/p-Si 이종접합의 전류-전압 특성을 분석한 결과 뚜렷한 정류특성을 나타내었다.

• ETRI Journal
• /
• v.31 no.6
• /
• pp.636-641
• /
• 2009

ZnO nanofibers were electro-spun from a solution containing poly 4-vinyl phenol and Zn acetate dihydrate. The calcination process of the ZnO/PVP composite nanofibers brought forth a random network of polycrystalline wurtzite ZnO nanofibers of 30 nm to 70 nm in diameter. The electrical properties of the ZnO nanofibers were governed by the grain boundaries. To investigate possible applications of the ZnO nanofibers, their CO and $NO_2$ gas sensing responses are demonstrated. In particular, the $SnO_2$-deposited ZnO nanofibers exhibit a remarkable gas sensing response to $NO_2$ gas as low as 400 ppb. Oxide nanofibers emerge as a new proposition for oxide-based gas sensors.

• Korean Chemical Engineering Research
• /
• v.53 no.3
• /
• pp.350-356
• /
• 2015

The effects of the zinc oxide (ZnO) preparing process on the performance of inverted organic photovoltaic cells (OPVs) were explored. The morphology and size of ZnO nanoparticles were controlled, leading to more efficient charge collection from device and higher electron mobility compared with nanospheres. Nanosized ZnO particles were synthesized by using zinc acetate dihydrate and potassium hydroxide in methanol. Also, water was added into the reaction medium to control the morphology of ZnO nanocrystals from spherical particles to rods, and $NH_4OH$ was used to prevent the gelation of dispersion. Solution-processed ZnO thin films were deposited onto the ITO/glass substrate by using spin coating process and then ZnO films were used as an electron transport layer in inverted organic photovoltaic cells. The analyses were carried out by using TEM, FE-SEM, AFM, DLS, UV-Vis spectroscopy, current density-voltage characteristics and solar simulator.