• Journal of the Korean Institute of Intelligent Systems
• /
• v.22 no.1
• /
• pp.81-86
• /
• 2012

In this paper, we proposed a new design methodology of a pattern classification rule based on the local linear discriminant analysis expanded from the generic linear discriminant analysis which is used in the local area divided from the whole input space. There are two ways such as k-Means clustering method and the differential evolutionary algorithm to partition the whole input space into the several local areas. K-Means clustering method is the one of the unsupervised clustering methods and the differential evolutionary algorithm is the one of the optimization algorithms. In addition, the experimental application covers a comparative analysis including several previously commonly encountered methods.

• Journal of the Korea Institute of Information Security & Cryptology
• /
• v.10 no.4
• /
• pp.107-112
• /
• 2000

In this paper, we study a security of HEA(Hangul Encryption Algorithm) against differential cryptanalysis. HEA, which is 1,024bits input/output and 56bits key size, has the same structure as DES(Data Encyption Standard) only for Korean characters to be produced in ciphertexts. An encryption algorithm should be developed to meet certain critria such as input/ouput dependencies, correlation, avalanche effects, etc. However HEA uses the same S-Boxes as DES does and just expands the plaintext/ciphertext sizes . We analysize HEA with a differential cryptanalysis and present two results. The number of rounds of HEA has not been determined in a concrete basis of cryptanalysis and we show a chosen plintext attack of 10 round reduced HEA with a diffe- rential cryptanalysis characteristic.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.31A no.7
• /
• pp.29-35
• /
• 1994

The performance of continuous phase modulation signals is well known for the coherent demodulation. But the carrier recovery circuits of the coherent receiver have long acquisition time and the receiver experiences high error floors for fading channels. In this paper, we propose the differential demodulation of 2-h continuous phase modulation signals. The sets of modulation indices of 2-h phase codes adequate to the differential demodulation for differentially encoded input are obtained and the average bit error probability in Additive White Gaussian Noise environments is derived and analyzed.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.2A
• /
• pp.195-202
• /
• 2007

A differential space-frequency block code - orthogonal frequency division multiplexing (SFBC-OFDM) scheme as a multiple-input multiple-output (MIMO) transmission technique for next-generation digital multimedia broadcasting (DMB) is proposed in this paper. A linear decoding method for differential SFBC, which performs comparably to the ML decoding method, is derived for the cases of two or four transmit antennas. A simple table lookup method is proposed to improve the efficiency of the encoding/decoding process of DSFBC for the case of non-constant modulus constellations. A DMB MIMO channel model, developed by extending the 3GPP MIMO model to fit DMB environments, is used to compare BER performances of differential space block code schemes for various channel environments. Simulation results show that the differential SFBC-16QAM scheme using either four transmit antennas with one receive antenna or two transmit antennas with two receive antennas achieves a performance gain of 12dB than that of the conventional DQPSK scheme, even with a data rate twice faster.

• 제어로봇시스템학회:학술대회논문집
• /
• 2001.10a
• /
• pp.88.4-88
• /
• 2001

In this paper, we propose a solver for differential equations, using a multi-layer neural network. The multi-layer neural network is a transformer function originally where the function is differential and the explicit representation has been developed. The learning determines the response of neural networks; however, the response is not equal to the output values. The differential relations are also the response. The differential conditions can be also set as teaching data; therefore, there is a possibility to reach a new solver for the differential equations. Since it is unknown how to define the input data for the neural network solver during long terms, we could not derive the expressions. Recently, the analogue type neural network is known and it transforms any vector to another The "any" must be...

• Smart Media Journal
• /
• v.4 no.2
• /
• pp.55-61
• /
• 2015

A bandwidth-enhanced ultra-wide band (UWB) CMOS balun-LNA is implemented as a part of a software defined radio (SDR) receiver which supports multi-band and multi-standard. The proposed balun-LNA is composed of a single-to-differential converter, a differential-to-single voltage summer with inductive shunt peaking, a negative feedback network, and a differential output buffer with composite common-drain (CD) and common-source (CS) amplifiers. By feeding the single-ended output of the voltage summer to the input of the LNA through a feedback network, a wideband balun-LNA exploiting negative feedback is implemented. By adopting a source follower-based inductive shunt peaking, the proposed balun-LNA achieves a wider gain bandwidth. Two LNA design examples are presented to demonstrate the usefulness of the proposed approach. The LNA I adopts the CS amplifier with a common gate common source (CGCS) balun load as the S-to-D converter for high gain and low noise figure (NF) and the LNA II uses the differential amplifier with the ac-grounded second input terminal as the S-to-D converter for high second-order input-referred intercept point (IIP2). The 3 dB gain bandwidth of the proposed balun-LNA (LNA I) is above 5 GHz and the NF is below 4 dB from 100 MHz to 5 GHz. An average power gain of 18 dB and an IIP3 of -8 ~ -2 dBm are obtained. In simulation, IIP2 of the LNA II is at least 5 dB higher than that of the LNA I with same power consumption.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.38 no.4
• /
• pp.20-30
• /
• 2001

A novel 200 MHz CMOS transconductor using translinear cells is proposed. The proposed transconductor consists of voltage followers and current followers based on translinear cells and a resistor. For wide applications, a single-input single-output, a single-Input differential-output, and a fully-differential transconductor are systematically designed, respectively. The theory of operation is described and computer simulation results are used to verify theoretical predictions. The results show that the fully-differential transconductor has a linear input voltage range of ${\pm}2.7$ V, a 3 dB frequency of 200 MHz, and a temperature coefficient of less than 41 $ppm/^{\circ}C$ at supply voltages of ${\pm}3$ V. In order to certify the applicability of the fully-differential transconductor, A ladder-type 3th-order cllitic low pass filter is also designed based on the inductance simulation method. The filter has a ripple bandwidth of 22 MHz, a pass-band ripple of 0.36 dB, and a cutoff frequency of 26 MHz.

• Journal of Power Electronics
• /
• v.17 no.4
• /
• pp.1037-1047
• /
• 2017

The Differential Power Processing (DPP) converter is a promising multi-module photovoltaic inverter architecture recently proposed for photovoltaic systems. In this paper, a DPP converter architecture, in which each PV-panel has its own DPP converter in shunt, performs distributed maximum power point tracking (DMPPT) control. It maintains a high energy conversion efficiency, even under partial shading conditions. The system architecture only deals with the power differences among the PV panels, which reduces the power capacity of the converters. Therefore, the DPP systems can easily overcome the conventional disadvantages of PCS such as centralized, string, and module integrated converter (MIC) topologies. Among the various types of the DPP systems, the feed-forward method has been selected for both its voltage balancing and power transfer to a modified H-bridge inverter that needs charge balancing of the input capacitors. The modified H-bridge multi-level inverter had some advantages such as a low part count and cost competitiveness when compared to conventional multi-level inverters. Therefore, it is frequently used in photovoltaic (PV) power conditioning system (PCS). However, its simplified switching network draws input current asymmetrically. Therefore, input capacitors in series suffer from a problem due to a charge imbalance. This paper validates the operating principle and feasibility of the proposed topology through the simulation and experimental results. They show that the input-capacitor voltages maintain the voltage balance with the PV MPPT control operating with a 140-W hardware prototype.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.60 no.1
• /
• pp.8-13
• /
• 2011

A percentage current differential relay is widely used for transformer protection. Because many percentage current differential relays recently use modified methods instead of conventional methods for deciding the operating characteristics of the large current region, in this paper, the operating region of a percentage current differential relay is analyzed in input-output current domain instead of operating-restraint current domain. An effective method to set the operating region when a CT is saturated is proposed with a series of investigations comparing a conventional method with the proposed modified method. The performance of the proposed method is evaluated for internal and external faults of a power transformer having the voltage rating of 345/154kV. EMTP-RV is used for the relaying data collection.

• ETRI Journal
• /
• v.29 no.1
• /
• pp.45-49
• /
• 2007

The poly-Si thin film transistor (TFT) shows large variations in its characteristics due to the grain boundary of poly-crystalline silicon. This results in unacceptably large input offset of low-voltage differential signaling (LVDS) receivers. To cancel the large input offset of poly-Si TFT LVDS receivers, a full-digital offset compensation scheme has been developed and verified to be able to keep the input offset under 15 mV which is sufficiently small for LVDS signal receiving.