• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2002년도 하계종합학술대회 논문집(2)
• /
• pp.57-60
• /
• 2002

In this paper, transmission lines with low and high characteristic impedance (Z$_{0}$) are fabricated and analyzed. The transmission lines are fabricated on the benzo-cyclo-butene (BCB) films of a low dielectric constant. For the low Z$_{0}$, two types of coplanar waveguide (CPW) structures are fabricated, which include bottom-ground and double-ground type. Measurement shows that Z$_{0}$ values for each CPW type are 7.3 and 9.4$\Omega$, respectively, at a signal line width of 100 #m. Whit the ratio between the spacing of bottom-ground and the signal line with becomes greater than 2.5, the Z$_{0}$ is nearly saturated. In addition, thin film microstrip lines fabricated using the BCB insertion layers show very low Z$_{0}$ of 25.5$\Omega$, and this impedance is ~64 % of the values obtained from the BCB-based CPW structures of the same line width. Measurement result of CPW on BCB layer is 100.5 Ω.s 100.5 Ω.

• 대한전자공학회논문지
• /
• 제16권1호
• /
• pp.26-32
• /
• 1979

실리콘의 dry oxidation과 wet oxidation공정의 특성을 실험적으로 조사하였다. 산화온도는1,100℃, 1.150℃, 1.200℃를 사용하였고, 산소의 유량은 0.2 liter/min으로 부터 2.8 liter/min까지 변화시켰다. 산화막의 두께를 측정하여 0.1μ ∼ 1.0μ 을 성장시키는데 필요한 온도, 시간, 산소의 유량을 도표로 나타냈다. 산화막의 특성을 조사하기 위하여 유전 상수 절연파괴 전압, fixed surface charge density (Qss/q), mobile ciarge densify (Q /q)를 측정하였다. 측정 결과로부터 산화막이 MOS transistor에도 적합한 양질이라는 결론을 얻었다.

• 전기전자학회논문지
• /
• 제7권1호
• /
• pp.16-21
• /
• 2003

유효 유전체 해석법에 기초한 정확한 모드 전송선로 이론이 세 채널 rib형 광 방향성 결합기의 편파된 빔 분리를 분석하기 위하여 소개되고 발전되었다. 또한, 본 논문에서 제안한 방법의 타당성을 보이기 위하여 상용 소프트웨어인 BeamPROP를 이용하여 그 결과들을 비교 검토하였다. 분석결과, 하나의 채널을 통하여 rib형 광 방향성 결합기에 입사된 혼성(hybrid) 모드들은 임의의 편파거리를 진행한 후에 상, 하 채널을 통하여 잘 분리됨을 알 수 있었다.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2009년도 춘계학술대회 논문집
• /
• pp.45-46
• /
• 2009

We have fabricated advanced metal-oxide-semiconductor (MOS) capacitors with thin (${\approx}10\;nm$) Inductive-Coupled Plasma (ICP) CVD $Si_xN_y$ dielectric layers and investigated electrical properties of nitrided $SiO_2$/4H-SiC interface after oxidizing the $Si_xN_y$ in dry oxidation and/or $N_2$ annealing. An improvement of electrical properties have been revealed in capacitance-voltage (C-V) and current density-electrical field (J-E) measurements if compared with non-annealed oxidized-SiN. The improvements of SiC MOS capacitors formed by oxidized-SiN have been explained in this paper.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2014년도 제46회 동계 정기학술대회 초록집
• /
• pp.303.2-303.2
• /
• 2014

The oxides of group IV transition metals such as titanium, zirconium, hafnium have many important current and future application, including protective coatings, sensors and dielectric layers in thin film electroluminescent (TFEL) devices. Recently, group IV transition metal oxide films have been intensively investigated as replacements for SiO2. Due to high permittivities (k~14-25) compared with SiO2 (k~3.9), large band-gaps, large band offsets and high thermodynamic stability on silicon. Herein, we report the synthesis of new group IV transition metal complexes as useful precursors to deposit their oxide thin films using chemical vapor deposition technique. The complexes were characterized by FT-IR, 1H NMR, 13C NMR and thermogravimetric analysis (TGA). Newly synthesised compounds show high volatility and thermal stability, so we are trying to deposit metal oxide thin films using the complexes by Atomic Layer Deposition (ALD).

• 한국재료학회지
• /
• 제9권5호
• /
• pp.441-445
• /
• 1999

Alkaline earth metal oxides were added to the conventional MgO films as a protective layer for dielectric materials to have lower firing voltage(Vf) of the plasma display panel(PDP). Panels with various protective layers of MgO-alkaline earth metal oxides were prepared on glass by using e-beam evaporation and its effect on firing voltage characteristics were investigated. (Ba-Mg)O films had poor voltage characteristics because of higher activation energy of BaO. But, (Sr-Mg)O, (Ca-Mg)O and (Ca-Sr-Mg) O had better voltage characteristics than the conventional MgO. A mixture film of (Mg-Ca-Sr)O show the lowest firing voltage which is less than that of MgO by 20V. The chemical composition to have lowest firing voltage is MgO:SrO:CaO ratio of 6:2:2. The mixture of MgO-Alkaline earth metal oxides films showed good transmittance properties within the visual range.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2002년도 International Meeting on Information Display
• /
• pp.594-597
• /
• 2002

We studied the effect of secondary electron emission from the back plate of AC-PDP, on the ramp waveform driving of the system, using two-dimensional PDP cell discharge simulator. It is found that the secondary electron emission from back plate plays a significant role in getting a stable weak discharge during the ramping up of X-Y electrode voltage. This is because grounded address electrode acts as a cathode during the setup of surface charge, and the secondary electron emission from phosphor in the back plate must be large enough to accumulate surface charges on the dielectric layers without strong plasma discharge. We have concluded that the secondary electron emission coefficient(${\gamma}$) of phosphor, besides MgO, must be known to understand the characteristics of the PDP system. A few suggestions for improvement of the system is also made and tested.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 추계학술대회 논문집 Vol.14 No.1
• /
• pp.34-37
• /
• 2001

In this study, the capacitance-voltage properties of $(Sr_{1-x}\cdot Ca_x)TiO_3(0.05{\leq}x{\leq}0.20)$-based grain boundary layer ceramics were investigated. The ceramics were fabricated by the conventional mixed oxide method. The sintering temperature and time were $1480\sim1500^{\circ}C$ and 4 hours. respectively. The 2nd phase formed by the thermal diffusion of CuO from the surface leads to very excellent dielectric properties, that is, ${\varepsilon}_r$ >50000, tan$\delta$ <0.05, ${\Delta}C$ < ${\pm}10%.$ The capacitance is almost unchanged below about 20[V] but it decreases slowly about 20[V]. The results of the capacitance-voltage properties indicated that the grain boundary was composed of the continuous insulating layers.

• 한국정밀공학회:학술대회논문집
• /
• 한국정밀공학회 2006년도 춘계학술대회 논문집
• /
• pp.595-596
• /
• 2006

The flexible organic thin film transistor (OTFT) array to use as a switching device for an organic light emitting diode (OLED) was designed and fabricated in the microcontact printing and low-temperature processes. The gate, source, and drain electrode patterns of OTFT were fabricated by microcontact printing which is high-resolution lithography technology using polydimethylsiloxane(PDMS) stamp. The OTFT array with dielectric layer and organic active semiconductor layers formed at room temperature or at a temperature tower than $40^{\circ}C$. The microcontact printing process using SAM(self-assembled monolayer) and PDMS stamp made it possible to fabricate OTFT arrays with channel lengths down to even nano size, and reduced the procedure by 10 steps compared with photolithography. Since the process was done in low temperature, there was no pattern transformation and bending problem appeared. It was possible to increase close packing of molecules by SAM, to improve electric field mobility, to decrease contact resistance, and to reduce threshold voltage by using a big dielecric.

• Applied Science and Convergence Technology
• /
• 제24권2호
• /
• pp.33-40
• /
• 2015

$ZrO_2$ and Al-Zr composite oxide film was prepared by vacuum assisted sol-gel dip coating method and anodizing. $ZrO_2$ films annealed above $400^{\circ}C$ have tetragonal structure. $ZrO_2$ layers inside etch pits were successfully coated from the $ZrO_2$ sol. The double layer structures of samples were obtained after being anodized at 100 V to 600 V. From the TEM images, it was found that the outer layer was $Al_2O_3$, the inner layer was multi-layer of $ZrO_2$, Al-Zr composite oxide and Al hydrate. The capacitance of $ZrO_2$ coated foil exhibited about 28.3% higher than that of non-coating foil after being anodized at 100 V. The high capacitance of $ZrO_2$ coated foils anodized at 100 V can be attributed to the relatively high percentage of inner layer in total thickness. The electrical properties, such as withstanding voltage and leakage current of coated and non-coated Al foils showed similar values. From the results, $ZrO_2$ and Al-Zr composite oxide is promising to be used as the partial dielectric of high voltage capacitor to increase the capacitance.