• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.40 no.4
• /
• pp.54-59
• /
• 2003

In this paper, a cylindrical dielectric antenna with dielectric clad is designed and analyzed. Design parameters of a cylindrical dielectric resonator antenna are calculated from the wave equation of cylindrical dielectric. The variations of characteristics of the antenna are analyzed as varying the thickness and the relative permittivity of its clad. From the results, when the ratio of the outside radius of the dielectric clad to the radius of the cylindrical dielectric is 1.3 and the relative permittivity of the dielectric clad is one-third of the cylindrical dielectric resonator antenna, the relative bandwidth of the antenna is 49%, which is improved by 2.3 times than the cylindrical dielectric resonator antennas. However, the thickness and the relative permittivity of the dielectric clad have not effect on the radiation pattern, beamwidth and gain of the antenna.

• Journal of the Korean Ceramic Society
• /
• v.33 no.9
• /
• pp.977-984
• /
• 1996

This paper analyzes the performance of a rectangular dielectric ceramic antenna by the theoretical cavity model such as input impedance resonant frequency quality factor efficiency and bandwidth. Through a compu-ter simulation variation of the antenna characteristics is found as a function of the antenna parametes. (permit-tivity permeability antenna size etc) Based on the results we propose a new design method for the dielectric ceramic antenna to be employed in Global Positioning Systems.

• International Journal of Computer Science & Network Security
• /
• v.23 no.10
• /
• pp.67-72
• /
• 2023

This paper portrays the design and optimization of a wideband four element triangular dielectric resonator antenna (TDRA) using PSO. The proposed antenna's radiation characteristics were extracted using Ansoft HFSS software. At a resonant frequency of 5-7 GHz, the four element antenna provides nearly 21 percent bandwidth and the optimized gives 5.82 dBi peak gain. The radiation patterns symmetry and uniformity are maintained throughout the operating bandwidth. for WLAN (IEEE 802.16) and WiMAX applications, the proposed antenna exhibits a consistent symmetric monopole type radiation pattern with low cross polarisation. The proposed antenna's performance was compared to that of other dielectric resonator antenna (DRA) shapes, and it was discovered that the TDRA uses a lot less radiation area to provide better performance than other DRA shapes and PSO optimized antenna increases the gain of the antenna

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2005.11a
• /
• pp.323-328
• /
• 2005

The paper describes a meander antenna using magneto-dielectric composite for 433.92 MHz band. The antenna with magneto-dielectric material in this paper is suggested for miniaturization of antenna size. The return loss of meander antenna is achieved by optimizing the permittivity, $\varepsilon_r$=1.71-j0.004 and permeability, $\mu_r$=2.39+j2.58. Over all dimension of the antenna is $51\times11\times1.6mm$. The return loss and gain are -41 dB, -5dBi, respectively at 433.92 MHz.

• Journal of the Korean Ceramic Society
• /
• v.45 no.4
• /
• pp.208-213
• /
• 2008

In this study, helical antenna with microwave ZST ceramics was designed using finite element method and developed. Studied parameters are relative dielectric constant of the dielectric core and the width of the conduction metal band of the antenna. As shown in the results, the center frequency of the antenna was decreased as the dielectric constant increased. Also beam width of the antenna increased as both the dielectric constant and the conduction band width increased. Based on the designed optimal shape, the manufactured antenna has the good beam width at center frequency 1.58 GHz.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.2
• /
• pp.223-230
• /
• 2008

A CRLH-TL based compact metamaterial antenna on a magneto-dielectric material is proposed. The proposed antenna is composed of two patches and vias, which is loaded by a magneto-dielectric material constructed by SRRs. The characteristic of SRRs is studied, and the size reduction of the antenna by using the magneto-dielectric material is confirmed. The simulated resonant frequency of the antenna has showed a decrease of 7.13 % at - 1st-order resonant mode, and 23.9 % at zeroth-order resonant mode. A zeroth-order resonant antenna is fabricated and measured, which has a resonant frequency of 1.888 GHz, a bandwidth of 0.48 %, a gain of 0.534 dBi, and an efficiency of 51.7 %.

• Journal of electromagnetic engineering and science
• /
• v.7 no.3
• /
• pp.122-128
• /
• 2007

In this paper, we present the design and measurement of a side-fed circularly-polarized patch antenna with a dielectric loading. The antenna consists of a comer-truncated rectangular patch, an L-shaped ground plane, a dielectric loading material, and a coaxial probe. An antenna operating at the UHF band (910 MHz) for the RFID reader applications is optimized using a commercial software. The size of the patch is reduced by a factor of 1.73 by loading the patch with mono-cast(MC) nylon. Measurements of the fabricated antenna show performance characteristics comparable to those of much larger commercial RFID reader antennas.

• Journal of Electrical Engineering and Technology
• /
• v.10 no.4
• /
• pp.1738-1745
• /
• 2015

Radiation characteristics of a probe-fed rectangular microstrip patch antenna printed on a finite grounded high permittivity substrate are investigated systematically for various square grounded dielectric substrate sizes with several thicknesses and dielectric constants by experiment and full wave simulation. The effect of the substrate size on the radiation characteristics of a rectangular patch antenna is mainly determined by the effective dielectric constant of surface waves on a grounded dielectric substrate. As the effective dielectric constant of surface waves increases, the substrate sizes for the maximum broadside gain and the required onset for a large magnitude of squint angle decrease, while the variations of the broadside gain, the front-to-back ratio, and the magnitude of squint angle versus the substrate size increase due to the increase of the power of the surface wave.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2005.11a
• /
• pp.367-370
• /
• 2005

In this paper, we made a Singly Fed patch which is the fittest at the feeding part. And we found out return loss and radiation pattern about dielectric rod array antenna which has six's passive element to shape FTEP(Flat-topped element pattern) after we analyzed the characters of singly dielectric rod antenna. We show the conclusion that has the optimum return loss and more flat radiation pattern.

• Journal of electromagnetic engineering and science
• /
• v.6 no.3
• /
• pp.165-170
• /
• 2006

In this paper, magneto-dielectric material is proposed to use for minimizing antenna size. One examle of very small antenna is presented to prove this with antenna's area of $0.078\lambda_0\times0.016\lambda_0$, and just moderate values of permittivity and permeability while the return loss can reach - 38 dB at the resonant frequency. The parameters of dielectric material for that best performance are $\varepsilon_r=1.71-j0.004$, and $\mu_r=2.39-j2.58$. Besides, this material also has ability to control the trade-off between the gain and bandwidth while keeping the antenna size unchanged.