• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2004년도 하계학술대회 논문집 Vol.5 No.1
• /
• pp.353-356
• /
• 2004

This paper discribes the analysis of the I-V characteristics of 4H-SiC DiMOSFET with single epi-layer Silicon Carbide has been around for over a century. However, only in the past two to three decades has its semiconducting properties been sufficently studied and applied, especially for high-power and high frequency devices. We present a numerical simulation-based optimization of DiMOSFET using the general-purpose device simulator MINIMIS-NT. For simulation, a loin thick drift layer with doping concentration of $5{\times}10^{15}/cm^3$ was chosen for 1000V blocking voltage design. The simulation results were used to calculate Baliga's figure of Merit (BFOM) as the criterion structure optimization and comparison.

• Transactions on Electrical and Electronic Materials
• /
• 제14권6호
• /
• pp.291-294
• /
• 2013

When subjected to a change in dimensions, the device performance decreases. Multi-gate SOI devices, viz. the Double Gate MOSFET (DG-MOSFET), are expected to make inroads into integrated circuit applications previously dominated exclusively by planar MOSFETs. The primary focus of attention is how channel engineering (i.e. Graded Channel (GC)) and gate engineering (i.e. Dual Insulator (DI)) as gate oxide) creates an effect on the device performance, specifically, leakage current ($I_{off}$), on current ($I_{on}$), and DIBL. This study examines the performance of the devices, by virtue of a simulation analysis, in conjunction with N-channel DG-MOSFETs. The important parameters for improvement in circuit speed and power consumption are discussed. From the analysis, DG-DI MOSFET is the most suitable candidate for high speed switching application, simultaneously providing better performance as an amplifier.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2018년도 전력전자학술대회
• /
• pp.332-333
• /
• 2018

This paper presents an advanced abnormal over-current protection with $SuperFET^{(R)}$ 800V MOSFET in Flyback converter. In advanced abnormal over-current protection, digital pattern generator is proposed to detect a steep di/dt current condition when secondary rectifier diode or the transformer is shorted. If current sensing signal is larger than current limit during consecutive switching cycle, Gate signal will be stopped for 7 internal switching periods. If the abnormal over-current maintains pattern, the controller goes into protection mode. The Advanced over-current protection has been implemented in a 0.35um BCDMOS process (ON Semiconductor process).

• 전력전자학회논문지
• /
• 제26권3호
• /
• pp.214-221
• /
• 2021

SiC MOSFETs require a faster and more reliable short-circuit protection circuit than conventional methods due to narrow short-circuit withstand times. Therefore, this research proposes a short-circuit protection circuit using a current-sensing circuit based on Rogowski coil. The method of designing the current-sensing circuit, which is a component of the proposed circuit, is presented first. The integrator and input/output filter that compose the current-sensing circuit are designed to have a wide bandwidth for accurately measuring short-circuit currents with high di/dt. The precision of the designed sensing circuit is verified on a double pulse test (DPT). In addition, the sensing accuracy according to the bandwidth of the filters and the number of turns of the Rogowski coil is analyzed. Next, the entire short-circuit protection circuit with the current-sensing circuit is designed in consideration of the fast short-circuit shutdown time. To verify the performance of this circuit, a short-circuit test is conducted for two cases of short-circuit conditions that can occur in the half-bridge structure. Finally, the short-circuit shutdown time is measured to confirm the suitability of the proposed protection circuit for the SiC MOSFET short-circuit protection.

• 센서학회지
• /
• 제9권2호
• /
• pp.113-119
• /
• 2000

정류수 내 수소 가스를 감지할 수 있는 Pd 박막을 가진 Pd/Pt 게이트 MISFET 수소센서를 제조하였다. 감지게이트 MISFET와 기준 게이트 MISFET의 차동형 센서로 제작하여 MOSFET 고유의 드리프트를 최소화하였다. 수소유입으로 인한 드리프트는 $Si_3N_4/SiO_2$의 이중 게이트 절연막으로 줄였고, 수소에 의한 Pd의 격자 팽창에 의해 생기는 블리스터는 Pt을 넣어서 제거하였다. Pd 박막을 수소 여과기로 사용한 Pd/Pt 게이트 MISFET 센서로 측정한 결과 $0{\sim}500\;ppm$ 사이에서 선형적인 출력 특성을 얻을 수 있었다. 30 일간 $50^{\circ}C$의 정류수 속에서 장기안정도를 측정하였다. 전체적으로 감지 FET의 게이트 전압은 35 mV 상승하였고, 기준 FET는 48 mV 상승하여 안정한 특성을 나타내었다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1997년도 하계학술대회 논문집 F
• /
• pp.2234-2236
• /
• 1997

The SIT, a Static Induction Transistor, is a semiconductor switch that is also called the power junction field-effect transistor (power JFET). Its characteristics are similar to a MOSFET except that its power level is higher and its maximum frequency of operation is lower. The normal method to protect against internal circuit transients of the form of di/dt or dv/dt is the use of snubber circuits. However, the limits of di/dt and dv/dt are high enough for the SIT that it is possible to operate without snubber circuits. SITs can be connected in parallel in order to cope with higher load currents that the value of an individual device rating. The purpose of this study is to investigate the parallel operation of SITs. In this experiment, we used a half-bridge inverter, the output of inverter is up to almost 1MHz and 2kW. Experimental results show that the operation of parallel connected SITs are facilitated individually good current sharing. The reason is the positive temperature coefficient of resistance of the SIT.

• Journal of Power Electronics
• /
• 제15권6호
• /
• pp.1489-1498
• /
• 2015

Gallium nitride (GaN)-based power switching devices, such as high-electron-mobility transistors (HEMT), provide significant performance improvements in terms of faster switching speed, zero reverse recovery, and lower on-state resistance compared with conventional silicon (Si) metal-oxide-semiconductor field-effect transistors (MOSFET). These benefits of GaN HEMTs further lead to low loss, high switching frequency, and high power density converters. Through simulation and experimentation, this research thoroughly contributes to the understanding of performance characterization including the efficiency, loss distribution, and thermal behavior of a 160-W GaN-based synchronous boost converter under various output voltage, load current, and switching frequency operations, as compared with the state-of-the-art Si technology. Original suggestions on design considerations to optimize the GaN converter performance are also provided.

• 한국산업정보학회논문지
• /
• 제18권5호
• /
• pp.59-65
• /
• 2013

저전력 설계를 요구하는 디지털 시스템에서는 동적 전력(dynamic power)과 누설 전력(leakage power) 사이의 균형을 이루는 점에 근접하는 매우 낮은 전압에서 작동하는 디지털 설계 방식을 요구하지만, 기존의 동기방식의 회로는 낮은 전압에서 지연(delay)이 급격히 증가하여 시스템의 전체 성능을 유지할 수 없을 뿐만 아니라, 공정, 전압, 온도 변이 (PVT variation) 등에 크게 영향을 받아서 올바른 동작을 기대할 수 없다. 따라서 본 논문에서는 낮은 전압에서 여러 가지 변이들에 영향을 받지 않는 비동기회로 설계 방식 중에 타이밍 분석이 요구되지 않고, 설계가 간단한 NCL (Null Convention Logic) 방식을 사용한 저전력 산술논리 연산장치 (ALU) 회로를 매그나칩-SK하이닉스 0.18um 공정으로 설계하고, 기존의 파이프라인 방식의 ALU와 스피드와 전력에 관해서 비교하였다.