• 한국지반신소재학회논문집
• /
• 제14권4호
• /
• pp.1-9
• /
• 2015

하천제방 건전도 평가는 하천설계기준 해설(KWRA, 2009) 및 구조물기초 설계기준과 그 해설서(MLTM, 2014와 KGS, 2009) 등 관련 기준 및 기준 해설서에 따라 수위조건 별 기초지반 및 제체를 통한 파이핑 안전성과 제내지 및 제외지 비탈면의 활동안전성 평가를 통해 수행된다. 이때 수위파형은 하천제방 건전도 평가 시 가장 중요한 수위조건 입력자료이나, 국가기준에서 합리적인 결정방법을 제시하지 못하고 있는 실정이다. 본 논문에서는 합리적인 수위파형 결정방법 제안을 위하여 평수위 상승, 홍수위 지속, 수위강하, 홍수빈도 등 수위파형 구성인자 변화에 따른 배수통문 설치 제방의 건전도 평가를 수행하였다. 평가결과, 문산배수통문 설치 제방의 설계수위파형은 최대 57 시간 이상의 평수위상승시간 및 53 시간 이상의 홍수위지속시간 등을 반영하여 설정하여야 할 것으로 평가되었다.

• 대한전기학회논문지:시스템및제어부문D
• /
• 제50권8호
• /
• pp.376-383
• /
• 2001

Factors leading to poor control of the steam generator in a nuclear power plant are nonminimum phase characteristics, unreliable of flow measurements and nonlinear characteristics, which increase more at low power(below 20%) operation. And the study of problems for water level control in the steam generator is that design water level controller only power renge, not entire. This paper introduces a model predictive control(MPC) algorithm for solving poor control factors and quadratic programming(QP) for solving input constraints. Also presents the design method of stable model predictive controller in the entire power range. The simulation results show the efficiency of proposed MPC controller by comparing with PI controller, and effect of the design parameters.

• 설비공학논문집
• /
• 제21권8호
• /
• pp.468-474
• /
• 2009

Ground water source heat pump system is the oldest one of the ground source heat pump systems. Despite of this, little formal design information has been available until recently. The important design parameters for open system are the identification of optimum ground water flow, heat exchanger selection and well pump. In this study, the capacity of 50 RT system of two well type ground water heat pump system was used. As a result, static water level was -7 m and the level during the heating operation was -32 m, cooling operation was -40 m. The initial static water level recovered within 48 hrs. The temperature of ground water is $15.6^{\circ}C$ for heating season and $16.2^{\circ}C$ for cooling season and does not depend on the outdoor temperature. Operation efficiency of the system shows that, COP 3.1 for heating and COP 4.2 for cooling.

• 한국농공학회논문집
• /
• 제58권5호
• /
• pp.19-28
• /
• 2016

This study was to design the optimal locations of the water level monitoring to quantify the agricultural water use in irrigation area supplied from an agricultural reservoir. In most of agricultural areas without TM/TC (Tele-Monitoring and Tele-Control) or monitoring network, irrigation water have been supplied on conventional experience and agricultural reservoir have been operated based on the operating simulation results by HOMWRS (Hydrological Operation Model for Water Resources System). Therefore, this study quantified the amount of agricultural water use in an irrigation area (Musu Reservoir, Jincheon-gun) by establishing water level monitoring network and analyzed the agricultural water saving effect. According to the evaluation of the economic values for water saving effect, the saving agricultural water of 1.7 million ton was analyzed to have economic values of 0.85 million won as water for living, and 1.78 million won as water for industrial use. It is identified to secure economic feasibility of the new water monitoring network by establishing one monitoring point in the entrance, irrigation area and endpoint through the economic analysis.

• 한국수자원학회논문집
• /
• 제50권9호
• /
• pp.617-625
• /
• 2017

본 연구에서는 조석의 영향을 주기적으로 받는 임진강 하류부의 계획홍수위를 보다 합리적으로 산정하는 방안을 검토해 보았다. 우선 감조하천의 특성을 감안할 수 있는 부정류모의를 수행하여 홍수위의 변동을 살펴보았고, 수위 계산에 민감한 매개변수인 조도계수를 해당지역의 특성에 맞게 현실화하여 홍수위 변화를 분석하였다. 그 결과를 2011년 임진강하천기본계획보고서에서 고시한 임진강 하구 계획홍수위와 비교하고, 감조구간에서 홍수위 산정시 유의해야 할 점들을 정리하였다. 참고로 2011년에 고시된 계획홍수위는 대규모 하상 준설 단면을 입력자료로 하여 부등류모의를 통해 산정된 바 있다. 본 연구의 결과, 임진강 하구의 경우 홍수위 산정에 있어서 조도계수를 한강하구와 동일한 값으로 할당하고, 하구 조위를 감안할 수 있는 부정류 모의를 수행하면 하상 준설을 하지 않더라도 홍수위가 제방 여유고를 만족함을 알 수 있었다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2005년도 학술대회 논문집 정보 및 제어부문
• /
• pp.328-330
• /
• 2005

Most of the water level controllers of the actual plant are PID controllers. But they have limitations in appling for tracking the set point and getting rid of disturbances, so there are some defects to apply in the actual ground even though many research works represented the resolution to solve it. In this paper, we design a fuzzy logic system (FLS) for controlling the steam generator water level in nuclear power plants. Some computer simulations reveal similar performance with the conventional PID controller.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2011년도 추계학술대회 초록집
• /
• pp.165.2-165.2
• /
• 2011

Flow with suction to water turbine must be in stable state at small hydraulic power plant. But because of water level fluctuation and water gate effect according to irregular supply of cooling water, it would happen to produce bubble and vortex and finally lead to problems in power-plant system. With utilizing the concept design of double size gate, surface water overflowed the overhead of gate for stable flow at suction. We developed the overflow condition and analyzed the design factor with existed one such as water level(overflow amount) and overhead of water gate(overflow figure). Flow test and CFD simulation say that flow have stable state around suction and 20% of wave reduction effect at surface layer after surface water overflow.

• 한국주거학회논문집
• /
• 제11권3호
• /
• pp.125-136
• /
• 2000

The purpose of this study was to analyze water consumption in each apartment buildings influenced by several factors that are the income level of inhabitants, life style, the area apartments and climate. The automation of sanitary machines or facilities in recently built apartments has caused largely increases in amount of water consumption. Therefore, the design for water supply is very important for the maintenance of the optimum level or pressure of water supply. This study is based on the offer of basic data for improving the quality of water supply and employing the sanitary machines or sanitary facilities by analysis of amount increased of water consumption rapidly. Amount of water consumption data, the change in quality of entropy to the supply water pipe was analyzed and presented to indicate the necessary to basic materials for the design of an optimal water pipe.

• 한국정보통신학회논문지
• /
• 제24권1호
• /
• pp.83-90
• /
• 2020

현재 상용화되어 있는 유량 측정 레이더 센서는 표면 유속을 이용하여 유량을 측정하는 방법을 사용한다. 이러한 방식으로는 표면 유속만으로 유량을 추정하는 것이기 때문에 단위 시간당 흐르는 물의 양을 정확하게 측정할 수 없다. 보다 정확한 측정을 위해서는 수위와 유속 정보 모두가 필요하며, 이에 따라 일부 상용 계측기는 수위와 유속을 각각 측정하는 두 개의 센서를 이용하여 유량을 산정하는 방식을 채택하고 있다. 본 논문에서는 하나의 FMCW 레이다 센서를 이용하여 수위와 유속을 동시에 측정할 수 있는 방법에 대하여 제안하고, 이를 위한 FMCW 레이다 송신 파형을 설계한다. 또한, 송신 파형을 기반으로 수신 신호를 모델링하여 수위 및 유속 측정 시 발생할 수 있는 문제점들에 대해 고찰하고자 한다.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2005년도 춘계학술대회논문집
• /
• pp.415-417
• /
• 2005

In this paper, we propose a intelligent controller design method for the water level control of the power plant drum in the form of nonminimum phase system. The proposed method is based on T. Takagi and M. Sugeno's fuzzy model. And we illustrate the improved characteristics as the simulation results, comparing with the conventional the PID and LQ controller design method