• Science of Emotion and Sensibility
• /
• v.14 no.2
• /
• pp.191-196
• /
• 2011

Fabric extraction force measured through nozzle tester reflects a comprehensive fabric handle. Nozzle tester takes advantage of low cost, and simple and fast operating procedure compared with KES system. The paper is to develop the semi-emprical equation for assessment of the fabric handle measured with nozzle tester on the basis of friction law. The variables considered in the equation arc fabric's frictional coefficient and drape coefficient which is determined in terms of fabric bending length and shear strain. The experiment of 12 different cotton and polyester fabrics and comparisons between experimental and theoretical results were conducted. Fabrics of high frictional coefficients, high bending length, and low shear strain showed high fabric handle forces (low handle values). The handle forces predicted from the equation agreed well with those measured, which indicates that the equation can be used to objectively evaluate fabric handle with respect to fabric's own properties and also provide an information for fabric design to improve the handle performance.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.58 no.4
• /
• pp.632-632
• /
• 2009

The purpose of this study is to present the range of defects mentioned in the Product Liability (PL) and to establish an objective basis and grounds for the analysis of accidents expected to happen by analyzing and presenting the external flame pattern and electrical characteristics of an LED streetlight lamp, a new lighting lamp. From the analysis of the cross-section of a cable carbonized by an external flame, it was observed that the wire's strand and insulation material had solidly adhered, and that greater voids were formed at the surface than at the center. Irregular carbide lumps were formed in the globe directly exposed to the flame, and the globe carbonized by the indirect flame showed characteristics that they had melted and flowed downward. It was found that the forward and backward resistances of the normal LED were approximately 1.74 [$M{\Omega}$] and 140 [$M{\Omega}$], respectively. The lamp burnt by the strong flame exhibited infinite forward and backward resistances and the LED did not emit light. The carbonized LED lamp was gray and exhibited fine delaminations. According to the Product Liability, a product defect signifies a simple product defect. Most of the defects were caused by the lack of stability, and the defect of the product itself occurred during the design and manufacture. The defects in warnings and markings include an insufficiency of handling manuals and warnings, expressive warranty violations, defective markings, etc. In order to prevent an accident resulting from a product, it is necessary to prepare safety warnings and documentation, establish clear-cut lines of liabilities, and subscribe insurances. However, it could be seen that important factors against the Product Liability were product improvement, response to compensation requests and law suits, credit restoration, etc.

• Wind and Structures
• /
• v.26 no.6
• /
• pp.369-382
• /
• 2018

Tornadoes are vertical swirling air formed because of the existence of layers of air with contrasting features of temperature, wind flow, moisture, and density. Tornadoes induce completely different wind forces than a straight-line (SL) wind. A suitably designed building for an SL wind may fail when exposed to a tornado-wind of the same wind speed. It is necessary to design buildings that are more resistant to tornadoes. In tornado-damaged areas, dome buildings seem to have less damage. As a dome structure is naturally wind resistant, domes have been used in back yards, as single family homes, as in-law quarters, man caves, game rooms, storm shelters, etc. However, little attention has been paid to the tornadic wind interactions with dome buildings. In this work, the tornado forces on a dome are computed using Computational Fluid Dynamics (CFD) for tornadic and SL wind. Then, the interaction of a tornado with a dome and a prism building are compared and analyzed. This work describes the results of the tornado wind effect on dome and prism buildings. The conclusions drawn from this study are illustrated in visualizations. The tornado force coefficients on a dome building are larger than SL wind forces, about 120% more in x- and y-directions and 280% more in z-direction. The tornado maximum pressure coefficients are also higher than SL wind by 150%. The tornado force coefficients on the prism are larger than the forces on the dome, about 100% more in x- and y-directions, and about 180% more in z-direction. The tornado maximum pressure coefficients on prism also are greater those on dome by 150% more. Hence, a dome building has less tornadic load than a prism because of its aerodynamic shape.

• Journal of Advanced Navigation Technology
• /
• v.4 no.2
• /
• pp.103-113
• /
• 2000

There are several methods in the mathematical modeling of a satellite with flexible appendages. In this paper, the hybrid Lagrange's equations of motion using assumed modes method are derived. The assumed modes method is one of approximate methods which have shorter calculation time due to low-dimension compare with FEM. These consist of three-equations about angular velocities and two-equations about flexible deformations, and physically represent interaction between hub and solar panel. In an attitude control, a control law is designed to minimize a given performance index considering not only control input but also vibration suppression. For these purpose, this paper applies LQG and LQG/LTR schemes to this model and finally show the capability for attitude control including vibration suppression. Especially, this paper shows the method of assumption as nonsingular system through singular value division for LQG/LTR design.

• Journal of Advanced Navigation Technology
• /
• v.20 no.5
• /
• pp.387-393
• /
• 2016

To perform realistic air traffic control (ATC) simulation in various air traffic situations, an aircraft dynamic model that is accurate and efficient is required. In this research, an improved five degree of freedom (5-DOF) dynamic model with feedback control and guidance law is developed, which utilizes selected performance data and operational specifications from the base of aircraft data (BADA) and estimations using aircraft design techniques to improve the simulation fidelity. In addition, takeoff weight is estimated based on the aircraft type and flight plan to improve simulation accuracy. The dynamic model is validated by comparing the simulation results with recorded flight trajectories. An ATC simulation system using this 5-DOF model can be used for various ATC related research.

• Women's Health Nursing
• /
• v.16 no.3
• /
• pp.288-296
• /
• 2010

Purpose: The study was to compare the factors of life satisfaction between grandmothers parenting and not parenting their grandchildren. Methods: A descriptive design with a convenience sampling was used for this study. From communities in S and U city, 85 parenting grandmothers (PG) and 103 non-parenting grandmothers (NPG) were recruited. The PG were those grandmothers who cared for preschooler grandchildren for their daughter or daughter-in-law who was employed. Results: The demographics of the two groups were similar, however the value of grandparenting was significantly higher in the PG than the NPG (t=4.56, p<.001). In the PG, strong and significant correlations were found among the value of grandparenting, health status, quality of relations with adult children, and life satisfaction. However, demographics were more related to health status and life satisfaction in the NPG. The value of grandparenting, health status, and quality of grandmother-adult children relations were found to be significant factors of life satisfaction (F=20.75, p <.001) explaining 42% of the variances. In the NPG, only health status was a significant factor (F=50.66, p <.001) explaining 33% of the variances. Conclusion: This study shows that grandmothers' perceptions of grandparenting and family relationships need to be incorporated into the lifestyle in order to support parenting grandmothers' life satisfaction while grandmothers' health is the common concern of elderly women's life satisfaction.

• Journal of Satellite, Information and Communications
• /
• v.10 no.2
• /
• pp.86-89
• /
• 2015

Formula acoustic characteristics of the room with a double layer, are compared through simulation and actual measurement. The rear area of the under- balcony speakers will cause a delay difference between the main speaker. In the mid / bass parts do not generate sufficient pressure is lowered and comb-Filtering phenomenon occurs significantly. The lower right area of the under- balcony speakers and speaker distance is the sound pressure of the under- balcony speakers to around 2 ~ 3m bigger than the main speakers and the sound image matches the pulpit is broken. Also, under area is more than 5 ~ 6m from the balcony outside speakers and causes differ by more than 10dB lower than the under- balcony speakers depending on the local laws of Translator wins Well, the main speaker at mid / high frequency sounds do not enter the sound pressure variations will drop by a significant. Appropriate arrangement and the output of the speaker according to the position under the balcony, and output of the main speakers are requested to minimize this problem sound. The proper sound design direction for the under- balcony speakers must be presented in order to improve the lower balcony area more pleasant acoustic environment.

• Journal of Distribution Science
• /
• v.15 no.12
• /
• pp.53-60
• /
• 2017

Purpose - This paper analyzes the effect of the handset subsidy and the Mobile Number Portability subscriber subsidy regulation, which are the main regulation adopted in "Law on the Improvement of the Mobile Terminal Distribution System" (Mobile Terminal Distribution Act), on the social surplus, the consumer surplus and profits of telecommunications carriers. We focus our analysis on whether the service charge competition is stimulated enough so that it can compensate for the loss of subsidies. Research design, data, and methodology - We use simple economic model to assess the impact of the handset subsidy and the Mobile Number Portability subscriber subsidy regulation. Unlike the former researches on this topic, we depart from using Hotelling model, and instead use the switching cost model, which uses switching cost as a parameter of market powers of telecommunications carriers. We also study the effect of the two different regulations when they are adopted both independently and concurrently. Results - If the market powers of telecommunications carriers are over certain threshold, contrary to the regulatory agency's assertion, the service charge competition would not be stimulated enough to compensate for the deduction in the subsidies, and thus the consumer surplus is compromised. Number Portability subsidy, especially, undermines the rival's market power and thus reduces the service charge. On the other hand, the regulations will also increase the profits of telecommunications carriers. However, social surplus is maximized when both of the regulations are present because the regulations reduces the frequency of switching handsets inefficiently. Conclusions - In enacting the Mobile Terminal Distribution Act, the telecommunications regulatory agency asserted that the regulation on subsidies will stimulate service charge competition, and in the long run, enhance the consumer surplus. However, contrary to the regulatory agency's assertion, subsidy regulation, especially the regulation on Number Portability subsidy, reduces consumer surplus. On the other hand, the Mobile Terminal Distribution Act can also increase the profits of telecommunications carriers because it decreases competition among the telecommunications carriers. However, the Mobile Terminal Distribution Act can increase the social surplus because it reduces inefficient switching of handsets.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.12
• /
• pp.2274-2281
• /
• 2016

In the long-term ecological research community, personal information is an important factor for the collaboration of data management and data usage in international long-term ecological research as well as on the national level. If lots of personal information was disclosed, collaborative researchers are useful to carry out research cooperation, whereas, information providers tend to be burdened to disclose it. LTER system should be considered to provide both maximum personal information required by a community and minimum personal information to be provided to unrelated people due to the scale of personal information and a number of the constraints on disclosure in the aspect of information distribution of the laws associated with personal information protection. In this article, we analyze international ecological metadata standard, EML, and trends in personal information management throughout international long-term ecological research platforms and propose a system model capable of managing personal information based on related domestic laws for the international data exchange through design and implementation.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.38 no.3
• /
• pp.228-235
• /
• 2010

This paper deals with an autonomous flight controller design problem for a tilt-rotor aircraft in rotary-wing mode. The inner-loop algorithm is designed using the output-based approximate feedback linearization. The model error originated from the feedback linearization is cancelled within allowable tolerance by using single-hidden-layer neural network. According to Lyapunov direct stability theory, the adaptive update law is derived to run the neural network on-line, which is based on the linear observer dynamics. Moreover, the outer-loop algorithm is designed to track the trajectory generated from way-point guidance. Especially, heading and flight-path angle line-of-sight guidance are applied to the outer-loop to improve accuracy of the landing tracking performance. The 6-DOF nonlinear simulation shows that the overall performance of the flight control algorithm is satisfactory even though the collective input response shows instantaneous actuator saturation for a short time due to the lack of the neural network and the saturation protection logic in that loop.