• 대한인간공학회지
• /
• 제14권1호
• /
• pp.97-104
• /
• 1995

The widespread use of VDU has improved the efficiency of information transmission between man and machine, but has caused new occupational health and ergonomics problems. In this study, we tried to construct a fuzzy hyman performance model of VDU workers in Korea. Fuzzy inferences of human perfor- mance are obtained from the fuzzy inference rule with the job difficulty, CFF, SACL, Type A. and the degree of concentration in VDU work. Eight healthy female undergraduate students at Kyungnam university for subjects aged 20 to 23 years were examined in this experiment. They calculated continuous addition, subtraction, and multiplication of 1 or 2 digit numbers that were produced randomly on the CRT. Subjects peoformed two types of a numeric operation, which easy and difficult work produced 400 and 600 problems within a 40 minute work session, respectively. Subjects were tested over two workdays according to the type of work(easy and difficult) consisting of four 40 minutes work sessions in the morning. Each work lasted for five minutes with a ten minutes rest break. 117 fuzzy inference rules were obtained from the experimental data. The value of consequent part was obtained by a descent method. The difference between real human error and estimated value of fuzzy inference was $1.8075{\pm}1.8591%(M{\pm}SD)$. The difference in easy and diffcult works were $2.69{\pm}2.13%$ and $0.92{\pm}0.93%$, respectively.

• 한국의류학회지
• /
• 제29권9_10호
• /
• pp.1241-1252
• /
• 2005

This study tried to compare and analyze the body measurements of female adults in China by various age groups. As for the study method, direct and anthropometric measurements were used on the 357 female subjects living in Yenbien and Harbin, China, consisting of 122 women in their 20's, 114 women in their 40's, and 121 women in their 60's. The results were as follows: 1. The comparison of major body measurements between Korean Chinese and Korean in land indicated that the former were shorter and plumper than the latter. Those groups in their 60's did not show any significant difference in height related measurements and revealed less differences in body measurements comparing to other age groups. 2 The comparison of Chinese anthropometric measurements among age groups of Korean Chinese indicated that, higher the age, shorter the height measurements, the leg length shorter, the upper-half body length longer, and the chest drooping due to the breast descent. 3. The comparison of indirect measurements among age groups of Koreans Chinese indicated that those in their 60's showed many items of big discrepancies in comparison with those in their 20's or 40's, with wide gap in discrepancies, thus resulting in large differences among individuals.

• 한국운동역학회지
• /
• 제20권3호
• /
• pp.311-318
• /
• 2010

This study examined the double piked dismount among the landing techniques of parallel bars based on three-dimensional motion analysis. Four male national gymnasts were the subjects. This study was performed to provide quantitative data highlighting players strengths and weaknesses to enable more stable landing technique. The variables analyzed were the position and velocity of center of gravity(CG) and angles of shoulder joints, hip joints, and trunk. The results are as follows: S1 secured the height of flight with fast vertical rise. After the easy spin in the air, he conducted a stable landing maintaining a proper hip joints angle. S2, S3, and S4, however, began the backward somersault already before leaving the bars, so they moved backward greatly making it more difficult to achieve a higher flight path. As a result, they couldn't control the velocity of their backward movement at landing. For a stable landing, they have to maintain the negative shoulder angle when rising, minimize both antero-posterioror side-to-side movements by doing a strong tap using hip joints, to secure the height of flight before the somersault. Results also show that at the descent, they should conduct rapid spinning by increasing their shoulder and hip joints to the maximum while controlling their velocity.

• 조명전기설비학회논문지
• /
• 제17권5호
• /
• pp.80-87
• /
• 2003

본 논문은 경험적인 탐색방법인 Reactive Tabu Search를 배전계통의 최적 재구성에 적용하였다. 일반적으로 Tabu search는 기울기가 감소하는 방향으로 탐색을 하기 때문에 적은 계산 시간으로 좋은 해를 얻을 수 있지만 초기의 계통 구성에 따라 수렴의 특성이 좌우되어 전역적인 최소해를 찾기가 어려운 단점이 있다 반면 RTS(Reactive Tabu search)는 reaction과 escape 메커니즘을 제공함으로써 파라미터 선정을 자동적으로 적응시키는 것이 가능하여 계통의 초기 구성에 관계 없이 전역적인 해를 적은 계산량으로도 찾을 수 있다. 렬 연구에서는 RTS의 reaction과 escape메커니즘 구현을 위하여 해싱 함수를 이용하였고 또한 제시된 방식을 32모선에 적용, 기존의 참고문헌과 비교함으로써 그 유용성을 입증하였다.

• Journal of the Korean Association of Oral and Maxillofacial Surgeons
• /
• 제43권4호
• /
• pp.214-220
• /
• 2017

Maxillary sinus lift for dental implant installation is a well-known and versatile technique; new techniques are presented based on the physiology of intrasinus bone repair. The aim of this review was to determine the status of graftless maxillary sinus lift and analyze its foundations and results. A search was conducted of the literature between 1995 and 2015 in the Medline, ScienceDirect, and SciELO databases using the keywords "maxillary sinus lift," "blood clot," "graftless maxillary sinus augmentation," and "dental implant placement." Ten articles were selected for our analysis of this technique and its results. Despite the limited information, cases that were followed for at least six months and up to four years had a 90% success rate. Published techniques included a lateral window, elevation of the sinus membrane, drilling and dental implant installation, descent of the membrane with variations in the installation of the lateral wall access and suturing. The physiology behind this new bone formation response and the results of the present research were also discussed. We concluded that this is a promising and viable technique under certain inclusion criteria.

• 대한기계학회논문집A
• /
• 제24권7호
• /
• pp.1841-1846
• /
• 2000

To examine the effect of acid fog on the corrosion fatigue behavior in structural steel, fatigue tests under acid fog atmosphere were carried out in comparison with distilled water. The corrosive c omponents contained in acid fog pile up the corrosion products on crack face and show a crack branching and crack tip blunting. Therefore, due to these workings crack growth rate was reduced by decreasing the effective stress range in crack tip rather than under distilled water. Also the effect of sulfuric acid, which is the main component of acid fog, and testing speed on fatigue crack growth were examined. It was found that corrosion behavior was remarkably dependent upon pH and Hz rather than components of acid fog. According as pH and testing speed decrease below a specific value, crack growth was accelerated in comparison with distilled water. This reveals that due to liquid having strong acidity and slow speed of test the crack face dissolution was promoted, so crack closure was disturbed in the process of stress descent.

• 대한전기학회논문지:전력기술부문A
• /
• 제54권10호
• /
• pp.480-486
• /
• 2005

This paper proposes a method to consider an aging failure probability and survival probability of power system components, though only aging failure probability has been considered in existing mean life calculation. The estimates of the mean and its standard deviation is calculated by using Weibull distribution, and each estimated parameters is obtained from Data Analytic Method (Type H Censoring). The parameter estimation using Data Analytic Method is simpler and faster than the traditional calculation method using gradient descent algorithm. This paper shows calculation procedure of the mean life and its standard deviation by the proposed method and illustrates that the estimated results are close enough to real historical data of combustion turbine generating units in Korean systems. Also, this paper shows the calculation procedures of a probabilistic failure prediction through a stochastic data analysis. Consequently, the proposed methods would be likely to permit that the new deregulated environment forces utilities to reduce overall costs while maintaining an are-related reliability index.

• 한국지능시스템학회논문지
• /
• 제7권3호
• /
• pp.21-33
• /
• 1997

본 논문에서는 바람직한 제어 방향의 학습을 통한 퍼지 제어기의 새로운 자기 구성 방법을 제안한다. 기울기 강하법에 기반하여 특성을 모르는 동적 플랜트에 대한 퍼지 제어기를 자기 구성할 때 풀어야할 문제중 하나는 오차를 줄이도록 하는 바람직한 제어입력의 변화방향을 알아내는 것이다. 이 문제를 해결하기 위한 방법으로서, 제어입력에 따른 오차의 변화 방향에 대한 대표 값을 분할된 상태영역에 할당하고, 반복적인 시행을 통해 강화 학습된 이 대표값을 이용하여 퍼지 제어 규칙을 학습하는 방법을 제안하였다. 제안된 자기구성 퍼지제어기는 간단한 구조를 가질 뿐 아니라 설계하기도 쉬운 장점을 갖는다. 제안된 방법의 타당성은 역진자 시스템에 대한 모의 실험을 통하여 검증하였다.

• Archives of Plastic Surgery
• /
• 제42권5호
• /
• pp.580-587
• /
• 2015

Background Descent of the lateral aspect of the brow is one of the earliest signs of aging. The purpose of this study was to describe an open surgical technique for lateral brow lifts, with the goal of achieving reliable, predictable, and long-lasting results. Methods An incision was made behind and parallel to the temporal hairline, and then extended deeper through the temporoparietal fascia to the level of the deep temporal fascia. Dissection was continued anteriorly on the surface of the deep temporal fascia and subperiosteally beyond the temporal crest, to the level of the superolateral orbital rim. Fixation of the lateral brow and tightening of the orbicularis oculi muscle was achieved with the placement of sutures that secured the tissue directly to the galea aponeurotica on the lateral aspect of the incision. An additional fixation was made between the temporoparietal fascia and the deep temporal fascia, as well as between the temporoparietal fascia and the galea aponeurotica. The excess skin in the temporal area was excised and the incision was closed. Results A total of 519 patients were included in the study. Satisfactory lateral brow elevation was obtained in most of the patients (94.41%). The following complications were observed: total relapse (n=8), partial relapse (n=21), neurapraxia of the frontal branch of the facial nerve (n=5), and limited alopecia in the temporal incision (n=9). Conclusions We consider this approach to be a safe and effective procedure, with long-lasting results.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제9권9호
• /
• pp.3701-3720
• /
• 2015

A system for the recognition of machine printed Arabic script is proposed. The Arabic script is shared by three languages i.e., Arabic, Urdu and Farsi. The three languages have a descent amount of vocabulary in common, thus compounding the problems for identification. Therefore, in an ideal scenario not only the script has to be differentiated from other scripts but also the language of the script has to be recognized. The recognition process involves the segregation of Arabic scripted documents from Latin, Han and other scripted documents using horizontal and vertical projection profiles, and the identification of the language. Identification mainly involves extracting connected components, which are subjected to Principle Component Analysis (PCA) transformation for extracting uncorrelated features. Later the traditional K-Nearest Neighbours (KNN) algorithm is used for recognition. Experiments were carried out by varying the number of principal components and connected components to be extracted per document to find a combination of both that would give the optimal accuracy. An accuracy of 100% is achieved for connected components >=18 and Principal components equals to 15. This proposed system would play a vital role in automatic archiving of multilingual documents and the selection of the appropriate Arabic script in multi lingual Optical Character Recognition (OCR) systems.