• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2008년도 춘계학술대회 논문집
• /
• pp.621-625
• /
• 2008

There are nine hot spring wells at Icheon hot spring area, hot springs are pumped by submersible motor. Drilling depths of hot spring wells is about 166-294 m, piezometric heads of hot springs is about 50 m below the surface. The geothermal gradient of SB-2 is about $64.00^{\circ}C$/km from the surface to depth within 300 m which is the highest value, that of SB-1 is about $45^{\circ}C$/km which is the lowest value. In addition, the average geothermal gradient of the region is calculated at approximately $54.28^{\circ}C$/km. However, it is analysed that this area has highly irregular temperature distribution because the groundwater penetrated to the depth of 720 m through the fracture rise to the surface according to the results of the data after drilling well to the depth of 996 m.

• 한국정밀공학회지
• /
• 제17권3호
• /
• pp.129-135
• /
• 2000

Air-dynamic bearings are increasingly used in supporting small high-speed rotating bodies. This study investigates the effects of design parameters on the axial stiffness of spiral-grooved air bearings of various curvatures. Design parameters are fundamental clearance, groove depth, and bearing number. The pressure distribution at the clearance between the stator and rotor of the bearing is obtained by solving the Reynolds equation, and the supporting load and the axial linear stiffness are calculated from the pressure distribution. It is found that a larger curvature increases the axial linear stiffness more and that there exist an optimal groove depth for the linear stiffness of the air bearing. It is also found that the linear stiffness has a linear relationship with the bearing number.

• 한국농공학회논문집
• /
• 제51권6호
• /
• pp.83-90
• /
• 2009

This study was carried out to evaluate the vertical stress properties in sandy soil according to changes of loading type in soil bin compacted three layers. The following conclusions and comparisons have been made based on careful analysis from theoretical and experimental methods. : When sandy soil subjected to cycle-loading, compression of foundation and diffusion of vertical stress increment(${\Delta}{\sigma}_2$) were influenced by magnitude of loading plate. When sandy soil subjected to reloading after removing of pre-loading, the distribution of ${\Delta}{\sigma}_2$ depth at one time of loading plate width was different from its distribution at more deep point cause of load hysteresis, so in case of design of structure, the effect of ${\Delta}{\sigma}_2$ as depth must be considered. The increment of vertical stress will be different as loading condition and foundation depth, the loading condition must be considered in case of structure design.

• ALGAE
• /
• 제21권1호
• /
• pp.75-82
• /
• 2006

Cyanobacteria regulate their buoyancy in response to changing environmental conditions. This process is essential for cyanobacterial development and can account for their dominance in eutrophic waters in summer. The present investigation was conducted to understand the 24-hour vertical distribution of cyanobacteria and water quality characteristics in Lake Daecheong. Water samples were collected and analyzed at depth intervals of 2 or 3 m and at an interval of three hours for a day on August 28, 2001 and September 24, 2002. In 2001 the accumulated standing crop of Microcystis spp. from surface to a depth of 6 m was 94.9%. Microcystis spp. showed no vertical migration below the thermocline. Microcystis spp. had maximum density near the surface, but shifted to 2 m depth at 2 p.m. A dense population of Anabaena spp. accumulated near the surface from 2 to 5 p.m. in 2002.

• 소성∙가공
• /
• 제8권2호
• /
• pp.152-159
• /
• 1999

This study is to investigate the effects of warm deep drawing with aluminum sheets of A1050-H16 and A5020-H32 for improving deep drawability. Experiments for producing circular cups and square cups were carried out for various working conditions, such as forming temperature and blank shapes. The limit drawing ratio(LDR) of 2.63 in warm deep drawing of circular cups in case of A5020-H32 sheet, whereas LDR of 2.25 in case of A1050-H16, could be obtained and the former was 1.4 times higher than the value at room temperature. The maximum relative drawing depth for square cups of A5020-H32 material was also about 1.92 times deeper than the depth drawn at room temperature. The effects of blank shape and forming temperature on drawability as well as thickness distribution of drawn cups were examined and discussed.

• 상하수도학회지
• /
• 제30권1호
• /
• pp.51-58
• /
• 2016

On account of the increase in water demand and climate change, droughts are in great concern for water resources planning and management. In this study, rainfall characteristics with stationary and non-stationary perspectives were analyzed using Weibull distribution model with 40-year records of annual minimum rainfall depth collected in major cities of Korea. As a result, the non-stationary minimum probable rainfall was expected to decrease, compared with the stationary probable rainfall. The reliability of ${\xi}_1$, a variable reflecting the decrease of the minimum rainfall depth due to climate change, in Wonju, Daegu, and Busan was over 90%, indicating the probability that the minimal rainfall depths in those city decrease is high.

• ALGAE
• /
• 제22권1호
• /
• pp.45-52
• /
• 2007

An intertidal marine benthic algal vegetation and vertical distribution at Kangnung and it’s vicinity, the eastern coast of Korea was investigated to clarify the community structure and vertical distribution by quadrat method. Marine algae identified from the area were 116 species; 15 green, 31 brown and 70 red algae. The dominant species were Ulva pertusa, Codium fragile, Undaria pinnatifida, Dictyota dichotoma, Gelidium amansii, Corallina pilulifera, Carpopeltis affinis, Grateloupia filicina, Pachymeniopsis elliptica and Chondrus ocellatus at study sites. The vertical distribution of intertidal marine algae was divided into three distinct zones. They were characterized by Porphyra tenera at the upper, Enteromorpha spp. and Ulva pertusa at the middle, and Sargassum thunbergii, Hizikia fusiformis and Pachymeniopsis elliptica at the lower zones, respectively. The vertical distribution of subtidal zone algae were characterized by Laminaria spp. at 15m depth and Kjellmaniella crassifolia at 15 to 25 m depths, whereas Agarum cribrosum was dominant at the lower zone than 25 m depth.

• Computers and Concrete
• /
• 제9권3호
• /
• pp.179-193
• /
• 2012

The hydration of cement contributes to the performance characteristics of concrete, such as strength and durability. In order to improve the utilization efficiency of cement and its early properties, the particle size distribution (PSD) of cement varies considerably, and the effects of the particle size distribution of cement on the hydration process should be considered. In order to evaluate effects of PSD separately, experiments testing the isothermal heat generated during the hydration of cements with different particle size distributions but the same chemical composition have been carried out. The measurable hydration depth for cement hydration was proposed and deduced based on the experimental results, and a PSD hydration model was developed in this paper for simulating the effects of particle size distribution on the hydration process of cement. First, a reference hydration rate was derived from the isothermal heat generated by the hydration of ordinary Portland cement. Then, the model was extended to take into account the effect of water-to-cement ratio, hereinafter which was referred to as PSD hydration model. Finally, the PSD hydration model was applied to simulate experiments measuring the isothermal heat generated by the hydration of cement with different particle size distributions at different water-to-cement ratios. This showed that the PSD hydration model had simulated the effects of particle size distribution and water-to-cement ratio on the hydration process of cement with satisfactory accuracy.

• 한국환경과학회지
• /
• 제28권6호
• /
• pp.535-544
• /
• 2019

We computed parameters that affect velocity distribution by applying Chiu's two-dimensional velocity distribution equation based on the theory of entropy probability and acoustic doppler current profiler (ADCP) of Jungmun-stream, Akgeun-stream, and Yeonoe-stream among the nine streams in Jeju Province between July 2011 and June 2015. In addition, velocity and flow were calculated using a surface image velocimeter to evaluate the parameters estimated in the velocity observation section of the streams. The mean error rate of flow based on ADCP velocity data was 16.01% with flow calculated using the conventional depth-averaged velocity conversion factor (0.85), 6.02% with flow calculated using the surface velocity and mean velocity regression factor, and 4.58% with flow calculated using Chiu's two-dimensional velocity distribution equation. If surface velocity by a non-contact velocimeter is calculated as mean velocity, the error rate increases for large streams in the inland areas of Korea. Therefore, flow can be calculated precisely by utilizing the velocity distribution equation that accounts for stream flow characteristics and velocity distribution, instead of the conventional depth-averaged conversion factor (0.85).

• 수산해양기술연구
• /
• 제44권4호
• /
• pp.304-311
• /
• 2008

Patagonian toothfish(Dissostichus eleginoides) was investigated in the southeastern Atlantic Ocean during the period of 19 March to 7 July 2007 by commercial bottom longliners. The number of 116 hauls were carried out individually in this study area by two bottom longliners during 111 days. The total catches were 89,559kg(9.91kg/100hooks) and 66,758kg(7.38kg/100hooks), respectively. Most Patagonian toothfishes were caught on the $46-48^{\circ}S$, $6-11^{\circ}E$ of southeastern Atlantic Ocean. Patagonian toothfish comprised 67.01-92.49%(by weight) of the catches in the southeastern Atlantic Ocean. No Antarctic toothfish (Dissostichus mawsoni) was caught during the surveys. Patagonian toothfish was found throughout the experimental area, but the density was considerably greater in the layer of 1,300-1,900m, where 49.88% of the fishes were caught. Smaller fishes were generally distributed to the shallow waters and larger fish were more frequently caught with the depth. Mean size of Patagonian toothfish increased with depth of capture. Accordingly economically profitable fishing activities for the Patagonian toothfish fishery requires an understanding of the size distribution of the Patagonian toothfish by depth.