• Journal of the Korean earth science society
• /
• v.33 no.3
• /
• pp.280-293
• /
• 2012

In order to clarify the characteristics of dispersion of volcanic tephra emitted from the Mt. Baegdu with various eruption environment, numerical analysis were performed using numerical models, Weather Research and Forecast (WRF) and FLEXPART. Synoptic conditions at 12 October 2010 was adopted because the volcanic ash of Mt. Baegdu can reach the Korean peninsula and its dispersion pattern was compared with different Volcanic Explosivity Index (VEI) and particle size. Predominant size of falling out ash flowing in the peninsular is smaller than 0.5 mm and the ash large than the size is difficult to get in the peninsular due to the its weak ability of truculent diffusion. the difference of ash distribution with various VEI scenarios is not so much but number density of ash in the air is dramatically changed. Volcanic ash tends to be deposited easily in eastern coastal area such as Gangneung and Busan, because of the inflow of ash from East Sea and barrier effect of the Taeback mountains along the east coast of the Korean Peninsula. Accumulated amount of ash deposition can be increased in short period in several urban areas.

• Journal of Korea Water Resources Association
• /
• v.49 no.8
• /
• pp.693-705
• /
• 2016

In this study, the effects of sediment supply on the downstream of a large dam are investigated using a numerical model. The model simulation shows a good agreement with laboratory experiment results of sediment transport and diffusion from sediment pulses. The water surface changes from the various sediment bed elevations are also simulated using the model. The site which has a relatively stiff bed slope and meandering of a channel is selected as an appropriate location for sediment supply because of its shear stress enough to supply the sediment downstream. The model simulation shows the decrease of channel bed elevation through the simulation period with time. The well-deposition of sediment supplied from the downstream of dam is found in the location where the flow rate is relatively low. A bed relief index is increased with time and it is relatively greater in downstream compared to upstream. The channel bed variability increases as flow rate increases with a greater bed relief index. The results of this study demonstrate the importance of increasing water discharge of a large dam to increase the dynamic of channel bed and thus to enhance the efficiency of channel bed restoration by sediment supply.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.32 no.3B
• /
• pp.153-159
• /
• 2012

In this study, we proposed modified settling basins transformed by substituting the downstream sill for low head weirs such as generic labyrinth weir and inclined crest labyrinth weir worked as internal baffles. Laboratory experiments were carried out to understand hydraulic characteristics inside of the settling basin to improve the efficiency of sedimentation rate. For a quantitative analysis, we suggested the headwater ratio($H_t/P$), the magnification ratio(L/W) and the inflow rate per total crest length($q_L$) as primary analysis indexes for sedimentation efficiency. Six different types of settling basin were used for labscaled pilot tests by distinguishing with internal structures. Based on results, the variation of headwater ratio with the change of magnification ratio would highly affect the deposition efficiency(%) and it was improved under specific condition that repeating arrange number(N) of labyrinth weir was between 2 and 4. Also, the regression analysis showed that initial condition and shape for improving sedimentation efficiency were plotted on the graph for both $q_L{\geq}3.5cm^2/s$ and $L/W{\leq}3.5$. It would be expected that the geometrically optimized labyrinth settling basin could be designed with proper deposition efficiency for inflow rates of influent and required area of settling basin utilizing the proposed analysis index in this study.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.17 no.4
• /
• pp.145-150
• /
• 2007

The $SiO_2$ and $TiO_2$ thin films for the multilayer interference filter application were manufactured by electron beam process. In case of electron beam process with ion source, the anode current was controlled by gas volume ratio of $O_2$ and Ar. Substrate temperature of electron beam deposition without ion source was increased from 100 to $250^{\circ}C$ with $50^{\circ}C$ increment. The surface roughness values of $SiO_2$ thin films was most low value at $200^{\circ}C$ substrate temperature and 0.2 A anode current respectively. And the surface roughness values of $TiO_2$ thin films was most low value at room temperature and 0.2 A anode current repectively. The refractive index of $SiO_2$ and $TiO_2$ thin films to be deposited with ion source was usually lower than that of thin films without ion source.

• Asian Pacific Journal of Cancer Prevention
• /
• v.17 no.5
• /
• pp.2565-2571
• /
• 2016

A cross-sectional survey was conducted among 730 participants from 4 rural districts of Nakhon Ratchasima province, Thailand, with a reported high incidence of liver fluke infection. This study was aimed to examine and evaluate the nutritional status in relation to Opisthorchis viverrini infection. Participants were purposive selected from Chum Phuang, Mueang Yang, Bua Yai, and Kaeng Sanam Nang districts. Stool samples were prepared by Kato Katz technique and then assessed by microscopy. Anthropometry was evaluated according to the body mass index from weight and height. Descriptive statistics and Spearman rank correlation coefficients were used to evaluate the association between the nutritional status and O. viverrini infection. Of 1.64% infected with O. viverrini the highest proportions were found in age groups ${\geq}61$ and 41-50 years old, Mueang Yang district. The majorities of participants had normal weight (32.2%), followed by class II obesity (28.1 %), class I obesity (21.8%), underweight (10.3%), and class III obesity (8.63%). Nutritional status with class II obesity (rS=0.639, p<0.01) and class I obesity (rS=0.582, p<0.05), had moderately statistical significant correlations with O. viverrini infection. Meanwhile, normal weight (rS=0.437, p<0.05) and class III obesity (rS=0.384, p<0.05) demonstrated lower statistical significance. These findings raise the possibility that infection with O. viverrini may contribute to fat deposition and thereby have long-term consequences on human health. Further studies are needed to better understand whether O. viverrini contributes directly to fat deposition and possible mechanisms.

• Journal of Korean Society of Forest Science
• /
• v.97 no.3
• /
• pp.266-273
• /
• 2008

The effects of soil acidification on the seedling growth and nutrition of Pinus densiflora and Quercus acutissima were investigated. The relationship between the seedling growth and molar (Ca+Mg+K)/Al ratio of in soil solution was examined. The results suggested that growth inhibition of seedling Pinus densiflora and Quercus acutissima was due to the low pH of soil solution, which was followed by leach of Al into soil solution, and decrease of essential elements, such as Ca in aerial pant of the seeding caused by the increase of Al concentration in subterranean pant of the seedlings. The level of growth inhibition was determined not only by Al concentration, but also by the balance of inorganic elements, Al, Ca, Mg and K. The growths of two species in total dry weight were clearly inhibited when molar (Ca+Mg+K)/Al ratio of the soil was lower than 6.0. The growth in dry weight, in the condition of the molar ratio was 0.8, was decreased 60% or 50% for the seedling of Pinus densiflora or Quercus acutissima respectively. It was concluded that the molar (Ca+Mg+K)/ Al ratio could be an important index for evaluation of the effects of soil acidification, due to acid deposition such as acid rain, on growth of trees and nutrition. And it might be a more useful indicator for evaluation of critical load of acid deposition on forest ecosystems.

• Toxicological Research
• /
• v.34 no.3
• /
• pp.221-229
• /
• 2018

Tenofovir nanoparticles are novel therapeutic intervention in human immunodeficiency virus (HIV) infection reaching the virus in their sanctuary sites. However, there has been no systemic toxicity testing of this formulation despite global concerns on the safety of nano drugs. Therefore, this study was designed to investigate the toxicity of Tenofovir nanoparticle (NTDF) on the liver and kidney using an animal model. Fifteen adult male Sprague-Dawley (SD) rats maintained at the animal house of the biomedical resources unit of the University of KwaZulu-Natal were weighed and divided into three groups. Control animals (A) were administered with normal saline (NS). The therapeutic doses of Tenofovir (TDF) and nanoparticles of Tenofovir (NTDF) were administered to group B and C and observed for signs of stress for four weeks after which animals were weighed and sacrificed. Liver and kidney were removed and fixed in formal saline, processed and stained using H/E, PAS and MT stains for light microscopy. Serum was obtained for renal function test (RFT) and liver function test (LFT). Cellular measurements and capturing were done using ImageJ and Leica software 2.0. Data were analysed using graph pad 6, p values < 0.05 were significant. We observed no signs of behavioural toxicity and no mortality during this study, however, in the kidneys, we reported mild morphological perturbations widening of Bowman's space, and vacuolations in glomerulus and tubules of TDF and NTDF animals. Also, there was a significant elevation of glycogen deposition in NTDF and TDF animals when compared with control. In the liver, there were mild histological changes with widening of sinusoidal spaces, vacuolations in hepatocytes and elevation of glycogen deposition in TDF and NTDF administered animals. In addition to this, there were no significant differences in stereological measurements and cell count, LFT, RFT, weight changes and organo-somatic index between treatment groups and control. In conclusion, NTDF and TDF in therapeutic doses can lead to mild hepatic and renal histological damage. Further studies are needed to understand the precise genetic mechanism.

• Journal of the Korean Society of Food Science and Nutrition
• /
• v.21 no.6
• /
• pp.595-600
• /
• 1992

This study was performed to investigate the effects of dietary protein levels(5% and 15% PEP), caffeine or green tea powder on body fat deposition in rats. Male weanling Wistar rats weighting the average of 90g were allotted into 6 experimental groups, each of which was fed two different levels of dietary protein with or without caffeine or green tea powder(5p+0.15% caffeine ; 5p+6.1% green tea powder ; 15p+0.15% caffeine ; 15p+6.1% green tea powder) during 8 weeks of the experimental period. Caffeine and green tea powder were supplemented at the levels of 0.15% and 6.1% of experimental diets. The rats fed 5% PEP diet which had received caffeine or green tea powder showed significantly(p<0.01) reduced gain in body weight. The food efficiency of which rats fed both 5% and 15% PEP diet supplemented with 6.1% green tea powder was significantly low(p<0.05, respectively) compared with the control group. Rats fed diets containing 0.15% caffeine and 6.1% green tea powder showed the significant reduction(p<0.01) of hite adipose tissue weight, triglycerides levels of liver and plasma. The addition of 0.15% caffeine or 6.1% green tea powder to 5% PEP diet resulted in significantly(p<0.01) higher levels of plasma total cholesterol, free cholesterol, cholesterol ester, but HDL-cholesterol levels were significantly(p<0.01, in 5% PEP group) high. The atherogenic index(Tchol-HDLchol/HDLchol) in rats fed 6.1% green tea powder diets decreased especially compared with the control group.

• Korean Journal of Materials Research
• /
• v.9 no.12
• /
• pp.1245-1251
• /
• 1999

Phase-change optical disk very rapid recording, high densification of data, resulting in high feedback rate and good C/N(carrier to noise) ratio of a feedback signal. However, repetitive thermal energy may cause the deformation of a disk or the lowering of an eliminability and a cyclability of the recording. The lowering of the cyclability can be reduced by insertion of thin layer of ZnS-$SiO_2$ dielectric thin film in appropriate disk structure between the upper and lower part of the recording film. Using the Taguchi method, optimum conditions satisfying both the optimized quality characteristic values and the scattering values for film formation were found to be the target R.F. power of 200W, the substrate R.F. power of 20W, the Ar pressure of 6mTorr, and the electrode distance of 6cm. From the refractive index data, the existence of the strong interaction between the electrode distance and Ar pressure was confirmed, and so was the large effect of the electrode distance on transmittance. According to the analysis of TEM and XRD, the closer the electrode distance was, the finer was the grain size due to the high deposition rate. However, the closer electrode distance brought the negative effect on the morphology of the film and caused the reduction of transmittance. AFM and SEM analyses showed that the closer the electrode distance was, the worse was the morphology due to the high rate of the deposition. Under optimum condition, the deposited thin film showed a good morphology and dense microstructure with less defects.

• Journal of the Korean Vacuum Society
• /
• v.19 no.5
• /
• pp.341-346
• /
• 2010

In this paper, anti-reflection coating was investigated for decreasing the reflection in visible range of 400~650 [nm] through four staked layers of $Si_xO_y$ and $Si_xN_y$ thin films prepared by reactive sputtering method. Si single crystal of 6 [inch] diameter was used as a sputtering target. Ar and $O_2$ gases were used as sputtering gases for reactive sputtering for the $Si_xO_y$ thin film, and Ar and $N_2$ gases were used for reactive sputtering for the $Si_xN_y$ thin film. DC pulse power of 1900 [W] was used for the reactive sputtering. Refractive index and deposition rate were 1.50 and 2.3 [nm/sec] for the $Si_xO_y$, and 1.94 and 1.8 [nm/sec] for the $Si_xN_y$ thin film, respectively. Considering the simulation of the four layer anti-reflection coating structure with the above mentioned films, the $Si_xO_y-Si_xN_y$ stacked four-layer structure was prepared. The reflection measurement result for that structure showed that a "W" shaped anti-reflection was obtained successfully with a reflection of 1.7 [%] at 550 [nm] region and a reflection of 1 [%] at 400~650 [nm] range.