• Journal of Mechanical Science and Technology
• /
• v.19 no.11
• /
• pp.1998-2006
• /
• 2005

The lane departure avoidance systems have been considered promising to assist human drivers in AVCS (Advanced Vehicle Control System). In this paper, a lane departure monitoring and control system is developed and evaluated in the hardware-in-the-loop simulations. This system consists of lane sensing, lane departure monitoring and active steering control subsystems. The road image is obtained based on a vision sensor and the lane parameters are estimated using image processing and Kalman Filter technique. The active steering controller for avoiding the lane departure is designed based on the lane departure metric. The proposed lane departure avoidance system is realized in a steering HILS (hardware-in-the-loop simulation) tool and its performance is evaluated with a driver in the loop.

• Journal of Institute of Control, Robotics and Systems
• /
• v.15 no.2
• /
• pp.240-248
• /
• 2009

Modem version of supersonic jet fighter aircraft must have been guaranteed appropriate controllability and stability in HAoA(High Angle of Attack). The HAoA flight control law have two parts, one is control law of departure prevention and the other is control law of departure recovery support. The control laws of departure prevention for advanced jet trainer consist of HAoA limiter, roll command limiter and rudder fader. The control laws of departure recovery support are consist of yaw-rate limiter and MPO(Manual Pitch Override) mode. The guideline of pitch rocking using MPO mode is simple, but operating skill of pitch rocking is very difficult by the pilot with inexperience of departure situation. Therefore, automatic deep stall recovery system is necessary. The system called the "Automatic Pitch Rocker System" or APRS, provided a pilot initiated automatic maneuver capable of an aircraft recoveries in situations of deep stall, speed and altitude. This paper addresses the design and validation for APRS to recovery of an deep stall without manual pitch rocking by the pilot. Also, this system is designed to recovery of speed, attitude and altitude after deep stall recovery using ATCS (Automatic Thrust Control System) and autopilot. Finally, this system is verified by real-time pilot evaluation using HQS (Handling Quality Simulator).

• 제어로봇시스템학회:학술대회논문집
• /
• 2000.10a
• /
• pp.216-216
• /
• 2000

In this paper, we introduce a new roadway-departure prevention algorithm and the developed Hardware-in-the-Loop-Simulator (HiLS) for applying the new algorithm. A sliding-mode controller is used for lateral position control. And, the HiLS consists of real car elements, a micro-control board, and a self-aligning torque generator Finally from the display module, the perspective view and bird view of the animated vehicle can be seen simultaneously.

• Journal of Institute of Control, Robotics and Systems
• /
• v.13 no.1
• /
• pp.6-14
• /
• 2007

Modem version of supersonic jet fighter aircraft must have been guaranteed appropriate controllability and stability in HAoA(High Angle of Attack). Limit value of aircraft entering into the departure in HAoA is related to aircraft configuration design. But, the control law such as AoA and yaw-rate limiter is implemented in digital Fly-By-Wire flight control system of supersonic jet fighter to guarantee the aircraft's safety in HAoA. The HAoA flight control law have two parts, one is control law of departure prevention and the other is control law of departure recovery support. The control laws of departure prevention for advanced jet trainer consist AoA limiter, roll command limiter and rudder fader. The control laws of departure recovery support are consist yaw-rate limiter and MPO(Manual Pitch Override) mode. The guideline of pitch rocking using MPO mode is simple, but operating skill of pitch rocking is very difficult by the pilot with inexperience of departure situation. This paper addresses the design and validation of APR(Automatic Pitch Rocker) control law instead of MPO in order to automatic recovery without manual pitch rocking by the pilot. And, recovery characteristic with APR verifies by the nonlinear analysis and pilot evaluation.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.11 no.6
• /
• pp.222-228
• /
• 2003

Lane departure avoidance system is one of the key technologies for the future active-safety passenger cars. The lane departure avoidance system is composed of two subsystems; lane sensing algorithm and active-steering controller. In this paper, the road image is obtained by vision sensor and the lane parameters are estimated using image processing and Kalman Filter technique. The active-steering controller is designed to prevent the lane departure. The developed active-steering controller can be realized by steer-by-wire actuator. The lane-sensing algorithm and active-steering controller are implemented into the steering HILS(Hardware-In-the-Loop Simulation) and their performance is evaluated with a human driver in the loop.

• Proceedings of KOSOMES biannual meeting
• /
• 2017.04a
• /
• pp.47-48
• /
• 2017

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.24 no.7
• /
• pp.858-862
• /
• 2018

The purpose of this study is to improve the current vessel departure control regulations to prevent traffic congestion after the lifting of vessel departure controls due to restricted visibility. AIS data was collected to analyze the traffic volume of normal traffic flow and after departure control. A statistical test was conducted to confirm the difference in traffic volume at peak hours according to whether or not departure control was used. The results of the t-test showed that there was a significant difference in traffic volume among groups of less than 10,000 tons in gross tonnage. However, the Mann-Whitney test showed no difference in traffic volume regardless of vessel control. Small and medium-sized vessels of less than 10,000 tons after departure control increased in traffic volume by 142% over normal traffic, and it was concluded that traffic congestion resulted as these small and medium-sized vessels were departing at the same time as large vessels of more than 10,000 tons. In order to prevent vessel collision accidents due to traffic congestion, it is suggested that the navigability of vessels less than 160 m or less than 10,000 tons should be improved.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.29 no.4
• /
• pp.307-315
• /
• 2023

Korea controls the departure of vessels based on the Maritime Safety Act such that only ships with seaworthiness can navigate in bad weather, but scientific evaluation results and quantitative basis for the designation of ships subject to control are insufficient. Opinions for improvement are being raised for a reasonable departure control operation. The purpose of this study is to evaluate the adequacy of the current departure control standards through actual measurement of tugboats, which are the type of vessels subject to control when a wind and wave advisory is effective, and to present quantitative grounds for improvement of controls. A sensor was installed on the tugboat to measure the ship's three-axis motion and hull acceleration, and the hull motion performance was measured by operating in the sea area with a significant wave height of 3 m. The measured values were compared and analyzed based on seaworthiness evaluation factors and limit value standards. The actual ship was excluded from the current control standard according to tonnage, but as a result of the analysis, the pitch value exceeded the operation standard, and a risk to navigation safety existed. The results of this study suggest the need for additional actual measurement studies that can represent various ship types and specifications and review ship departure control targets.

• Journal of Korean Society for Quality Management
• /
• v.38 no.2
• /
• pp.171-179
• /
• 2010

Pearn et al.(2002) supposed the $C_{pp}$ multiple process performance analysis chart. This chart displays multiple processes with the process variation and process departure on one single chart. But, this chart can not display the distribution of the process variation and process departure and is inappropriate for processes with non-normal distributions. With bootstrapping method, we can display the distribution of the process variation and process departure on the $C_{pp}$ multiple process performance analysis chart.

• 제어로봇시스템학회:학술대회논문집
• /
• 2002.10a
• /
• pp.110.3-110
• /
• 2002

$\textbullet$ Lane detection by TFALDA $\textbullet$ SVM for large scale data and multiclass classification problem $\textbullet$ TLC Classification $\textbullet$ Lateral offset estimation by IPT $\textbullet$ Lane departure warning by a fuzzy system $\textbullet$ Experimental results by HiLS $\textbullet$ Conclusion