• 한국세라믹학회지
• /
• 제31권4호
• /
• pp.457-463
• /
• 1994

The growth condition of highly oriented textured diamond film on a (100) Si substrate was investigated as a function of texture orientation. The growth process consisted of biased enhanced nucleation (BEN) and texture growth. The substrate was under the plasma of 6% CH4-94% H2 with negative bias of 200V during the BEN which grounded during the texture growth. The texture orintation changed from <100> to <110> by increasing substrate temperature. The nearly perfect match between textured diamond grains and the Si substrate could be obtained under the condition of <100> texture. The degree of tilt mismatch increased with the increase of deviation of texture orientation from <100>. The degree of twist mismatch appeared to increase abruptly beyond the critical deviation of texture orientation from <100> because the nuclei having the same orientation as the substrate were no more preferred grains for texture formation.

• Journal of Astronomy and Space Sciences
• /
• 제1권1호
• /
• pp.23-34
• /
• 1984

A bubble trapped in the liquid manifold of INTELSAT IV F-7 spacecraft caused a mass imbalance between the System 1 propellant tanks and a wobble half angle of 0.38 degree to 0.48 degree. A maneuver on May 14, 1980 passed the bubble through the axial jet and allowed propellant to redistribute. A 0.2 rpm change in sin rate was observed with an exponential decay time constant of 6 minutes. In this paper, moment of inertia, tank geometry and hydrodynamic models are derived to match the observed spin rate data. The values of the total mass of propellant considered were 16, 19 and 20 kgs with corresponding mass imbalances of 14.3, 15 and 15.1 Kgs, respectively. The result shows excellent agreement with observed spin rate data but it was necessary to assume a greater mass of hydrazine in the tanks than propellant accounting indicated.

• International Journal of Advanced Culture Technology
• /
• 제7권1호
• /
• pp.64-69
• /
• 2019

With the advent of the fourth industry, the need for office automation with automatic character recognition capabilities is increasing day by day. Therefore, in this paper, we study a character recognition algorithm that effectively recognizes a new experimental data character by using learning data characters. The proposed algorithm computes the degree of similarity that the structural regions of learning data characters match the corresponding regions of the experimental data character. It has been confirmed that satisfactory results can be obtained by selecting the learning data character with the highest degree of similarity in the matching process as the final recognition result for a given experimental data character.

• 한국축산식품학회지
• /
• 제34권4호
• /
• pp.543-551
• /
• 2014

The aim of this study was to evaluate the effect of proteolytic (Serratia liquefaciens, match %: 99.39) or lipolytic (Acinetobacter genomospecies 10, match %: 99.90) psychrotrophic bacteria (bacterial counts, analysis of free fatty acids (FFA) and analysis of free amino acids) on the microbial and chemical properties (yogurt composition), and sodium dodecyl sulfate polyacrylamide gel electrophoresis (SDS-PAGE) of yogurt during storage. Yogurts were prepared with raw milk preinoculated with each psychrotrophic bacteria. The total solid, fat, and protein content were not affected by preinoculation, but the pH of yogurt preinoculated with psychrotrophic bacteria was higher than in control. There was a dramatic increase in short chain free fatty acids among FFA in yogurt with Acinetobacter genomospecies 10. For 14 d of cold storage condition, SCFFA was 25.3 mg/kg to 34.4 mg/kg (1.36 times increased), MCFFA was 20.4 mg/kg to 25.7 mg/kg (1.26 times increased), and LCFFA was 240.2 mg/kg to 322.8 mg/kg (1.34 times increased). Serratia liquefaciens (match %: 99.39) in yogurt caused a greater accumulation of free amino acids (FAA), especially bitter peptides such as leucine, valine, arginine, and tyrosine, but SDS-PAGE showed that the inoculation of Serratia liquefaciens did not affect the degree of casein degradation during storage. Taken together, the excessive peptides and FFA in yogurt generated from psychrotrophic bacteria could develop off-flavors that degrade the quality of commercial yogurt products.

• 대한치과기공학회지
• /
• 제42권3호
• /
• pp.281-289
• /
• 2020

Purpose: This study analyzes the self-efficacy and CAD/CAM practice of dental technology students with the aim of providing data that will be useful for improving CAD/CAM education. Methods: A questionnaire survey on self-efficacy and CAD/CAM practice was given to students who participated in face-to-face classes in the Department of Dental Technology at a college in Daegu and Gyeongsangnam-do. The survey period was two weeks long (June 15, 2020 to July 2, 2020), and 84 students completed the questionnaire. Results: The higher the self-efficacy, the fewer difficulties or mistakes students made in CAD/CAM practice. The most difficult parts of the scanning process were the top and bottom arc operation and the bite match arc insertion. The most difficult part of the design work was the use of (multiple) tools. The difference between the degree of difficulty and the degree of mistakes during the practical course was shown as the margin line setting in the design work. Setting the margin line was not difficult, but the degree of mistakes was nonetheless high. In the CAM process, height control was the most difficult part, but the degree of mistakes did not differ according to students' self-efficacy. Conclusion: Given that higher self-efficacy correlated with fewer difficulties or mistakes in CAD/CAM practice, students should be encouraged to enhance their self-efficacy. This may be done by improving their satisfaction with their major course of study, forming friendly relations with their colleagues, and increasing the ratio of performance rather than observation in CAD/CAM practice.

• 한국농공학회논문집
• /
• 제65권6호
• /
• pp.51-63
• /
• 2023

To improve the problem that the settlement curve of the consolidation theory of Terzaghi does not match well with the actual settlement curve, we included a secondary compression settlement and analyzed it by varying the beginning point and then obtained the following results. The current methods of calculating the compression index from the  log𝜎 curve and the coefficient of consolidation from the time-dependent settlement curve for each consolidation pressure proved that the final settlement amount will be consistent after a long time, but the actual settlement amount will always be smaller than the predicted settlement amount during the settlement progress stage. The consolidation factors estimated by the curve fitting with the condition that the secondary compression begins in the second half of the primary compression showed similar values to the consolidation factors estimated by the curve fitting for the primary compression only, and the settlement curves were in better agreement throughout the compression. It showed different values, showing low validity. It can be inferred that secondary compression acts from the point when a significant portion of the excess pore water pressure is dissipated, and the loading stress begins to have more influence on the skeletal structure of the soil. Analysis results show that secondary compression begins at the range of 91 % to 98 % on the average degree of primary consolidation.

• 제어로봇시스템학회논문지
• /
• 제11권1호
• /
• pp.84-91
• /
• 2005

In this paper, we describe the real-time parallel processing simulator developed for the use of performance analysis of rolling missiles. The real-time parallel processing simulator developed here consists of seeker emulator generating infrared image signal on aircraft, real-time computer, host computer, system unit, and actual equipments such as auto-pilot processor and seeker processor. Software is developed from mathematic models, 6 degree-of-freedom module, aerodynamic module which are resided in real-time computer, and graphic user interface program resided in host computer. The real-time computer consists of six TIC-40 processors connected in parallel. The seeker emulator is designed by using analog circuits coupled with mechanical equipments. The system unit provides interface function to match impedance between the components and processes very small electrical signals. Also real launch unit of missiles is interfaced to simulator through system unit. In order to apply the real-time parallel processing simulator to performance analysis equipment of rolling missiles it is essential to perform the performance verification test of simulator.

• 한국국방경영분석학회지
• /
• 제26권2호
• /
• pp.55-74
• /
• 2000

A knowledge-based with production rules is a representation of static knowledge of an expert. On the other hand, a real system such as the stock market is dynamic in nature. Therefore we need a method to reflect the dynamic nature of a system when we make inferences with a knowledge-based system. This paper suggests a strategy of dynamic inference that can be used to take into account the dynamic behavior of decision-making with the knowledge-based system consisted of fuzzy production rules. A degree of match(DM) between actual input information and a condition of a rule is represented by a value [0,1]. Weights of relative importance of attributes in a rule are obtained by the AHP(Analytic Hierarchy Process) method. Then these weights are applied as exponents for the DM, and the DMs in a rule are combined, with the Min operator, into a single DM for the rule. In this way, the importance of attributes of a rule, which can be changed from time to time, can be reflected in an inference with fuzzy production systems.

• 산업경영시스템학회지
• /
• 제36권2호
• /
• pp.56-62
• /
• 2013

Control chart is representative tool of Statistical Process Control (SPC). But, it is not given information about the economic loss that occurs when a product is produced characteristic value does not match the target value of the process. In order to manage the process, we should consider not only stability of the variation also produce products with a high degree of matching the target value that is most ideal quality characteristics. There is a need for process control in consideration of economic loss. In this paper, we design a new control chart using the quadratic loss function of Taguchi. And we demonstrate effectiveness of new control chart by compare its ARL with ${\overline{x}}-R$ control chart.

• 전기학회논문지
• /
• 제57권1호
• /
• pp.20-24
• /
• 2008

A bid-based pool(BBP) model is representative of energy market structure in a number of restructured electricity markets. Supply function equilibrium(SFE) models of interaction better match what is explicitly required in the bid formats of typical BBP markets. Many of the results in the SFE literature involve restrictive parametrization of the bid cost functions. In the SFE models, two parameters, intercept and slope, are available for strategic bidding. This paper addresses the realistic competition format that players can choose both parameters arbitrarily. In a fixed demand function, equilibrium conditions for generation company's profit maximization have a degree of freedom, which induces multi-equilibrium. So it is hard to choose a convergent equilibrium. However, consideration of stochastic demand function makes the equilibrium conditions independent each other based on the amount of variance of stochastic demand function. This variance provides the bidding players with incentives to change the slope parameter from an equilibrium for a fixed demand function until the slope parameter equilibrium.