• Journal of Korean Society of Transportation
• /
• v.23 no.8 s.86
• /
• pp.101-111
• /
• 2005

Various urban transport policies have an effect on urban transit riderships and accessibility. This study reports variations of metropolitan subway travel patterns affected by an enormous change in bus routes and transfer discount fare policy between subway and bus mode conducted by Seoul city in July 1st of 2004. In an effort to see the difference between the before and the after policies, two data sets are prepared. Firstly, on a daily bassis. an origin-destination trip table of May of 2004 is used. Secondly, on a daily bassis, an origin-destination trip table of August-September of 2004 is used as a counter measure. Even if seasonal variation was not considered, Seoul metropolitan area have experienced increasing riderships and accessibility. Finally, the effects of accessibility in spatial interaction model by rall service changes such as random shocks were scrutinized and interpreted in detail.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.36D no.2
• /
• pp.81-89
• /
• 1999

Among various wavelength conversion technologies, that using the cross-gain modulation in laser diode makes it possible to deal with the high speed signal quite simply and efficiently. In this paper, presented was the applicability of an improved time-domain large-signal dynamic model as a CAD tool to analyzed the characteristics of SSGDBR(Superstructure Grating Distributed Bragg Reflector) laser diodes used for wavelength converters. Using this model, it was shown that this kind of wavelength converter can provide the widely tunable wavelength conversion of the high speed data above 10 Gbps. We also investigated the effect of input optical power and the bias current on the characteristics of the device such as extinction ration and eye diagram. The modeling results show very similar trend to the experimental reports.

• International Commerce and Information Review
• /
• v.19 no.3
• /
• pp.107-127
• /
• 2017

This paper aims to analyze comparing the international competitiveness of Korea and China of ICT 10 goods in ASEAN Big 6 countries.(Malaysia, Indonesia, Vietnam, Singapore, Thailand, Philippines). In this study, we investigate major trends in Korea's ICT goods through various data analysis and evaluate. From 2009 to 2016, As analyzed by ESI, CTB, and EMS, This paper showed Korea has increased its export, EMS and Export Competitiveness to ASEAN. However, due to rapid imports, the trade balance deteriorated and ESI decreased. China showed signs of improvement in international competitiveness, although exports, ESI and EMS were declining. Compared to South Korea, China has seen less export bias to ASEAN. ASEAN is becoming an increasingly important trade partner in Korea's ICT exporting. This paper points out several policy implications drawn from its analyses and findings.

• Survey Research
• /
• v.8 no.1
• /
• pp.55-79
• /
• 2007

This article attempts to provide an overview of the exit polls for the 2006 local elections in Korea. The sampling method, sampling error, non-response rate, and prediction error of the exit polls are reviewed. Also, we explore the fact that the propensity to vote varies according to age and gender of voters. In terms of age and gender, the representativeness of the sample is investigated by comparing to the data released by the National Election Commission. Through this empirical research, we show that the exit poll samples are unbalanced in terms of age and this unbalance may be one of the causes of bias occurred in the prediction of the 2006 local election results. The design effects of the sample design implemented for the exit polls are also examined.

• Fashion & Textile Research Journal
• /
• v.17 no.4
• /
• pp.613-625
• /
• 2015

This research was conducted to provide basic data to improve expressivity required for virtual clothing to replace actual clothing. For the experiment, 6 materials were selected and 12(2 kinds of length) actual flared skirts were made. At the same time, simulations were carried out on OptiTex Runway 12.0 for 36(12 kinds of skirts $\times$ KES, FTU, KES weight/10) kinds of virtual flared skirts, which were applied with the measured property values (thickness, weight, bending, shear, friction, and stretch). Also, the study compared and analyzed the wearing images, silhouette overlapping images, and skirt length measurements of the actual and virtual skirts put on a dummy. As a result, the actual skirts showed clear distinction for each material. In contrast, virtual 1 and 2 expressed fabric 3 in the most similar way, but could not recreate the uniform, soft, and natural flare shape of the actual skirts in general. Virtual 3 formed natural flares as those of the actual skirts, and expressed fabric 1, 5, and 6 in a similar way. However, virtual 3 had too much volume and barely showed any distinction for each material. All of virtual 1, 2, and 3 expressed different flare shapes on the front and back sides of the skirt similarly to the actual skirts, and had a good visual expression for the color and texture of the materials. However, they could not effectively express the elasticity and fabric sagging in the bias direction.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.36 no.5
• /
• pp.403-412
• /
• 2018

Recently, GNSS (Global Navigation Satellite System)-derived orthometric height determination has been studied to improve the time and cost-effectiveness of traditional leveling surveying. However, the accuracy of this new survey method was evaluated when unknown points are located lower than control points. In this study, the accuracy of GNSS-derived orthometric height was examined using TPs (Triangulation Points) to verify the stability of surveying in mountainous areas. The GNSS survey data were obtained from Mungyeong, Unbong/Hadong, Uljin, and Jangseong. Three unknown points were surrounded by more than three UCPs (Unified Control Points) or BMs (Benchmarks) following the guideline for applying GNSS-derived orthometric height determination. A newly developed national geoid model, KNGeoid17 (Korean National Geoid 2017), has been applied for determining the orthometric height. In comparison with the official orthometric heights of the TPs, the heights of the unknown points in Mungyeong and Unbong/Hadong differ by more than 20 cm. On the other hand, TPs in Uljin and Jangseong show 15-16 cm of local bias with respect to the official products. Since the precision of official orthometric heights of TPs is known to be about 10 cm, these errors exceed the limit of the precision. Therefore, the official products should be checked to offer more reliable results to surveyors. As an alternative method of verifying accuracy, three different GNSS post-processing software were applied, and the results from each software were compared. The results showed that the differences in the whole test areas did not exceed 5 cm. Therefore, it was concluded that the precision of the GNSS-derived orthometric height was less than 5 cm, even though the unknown points were higher than the control points.

• Korean Journal of Remote Sensing
• /
• v.29 no.3
• /
• pp.275-291
• /
• 2013

Monitoring the global Gross Primary Pproduction (GPP) is relevant to understanding the global carbon cycle and evaluating the effects of interannual climate variation on food and fiber production. GPP, the flux of carbon into ecosystems via photosynthetic assimilation, is an important variable in the global carbon cycle and a key process in land surface-atmosphere interactions. The Moderate-resolution Imaging Spectroradiometer (MODIS) is one of the primary global monitoring sensors. MODIS GPP has some of the problems that have been proven in several studies. Therefore this study was to solve the regional mismatch that occurs when using the MODIS GPP global product over Korea. To solve this problem, we estimated each of the GPP component variables separately to improve the GPP estimates. We compared our GPP estimates with validation GPP data to assess their accuracy. For all sites, the correlation was close with high significance ($R^2=0.8164$, $RMSE=0.6126g{\cdot}C{\cdot}m^{-2}{\cdot}d^{-1}$, $bias=-0.0271g{\cdot}C{\cdot}m^{-2}{\cdot}d^{-1}$). We also compared our results to those of other models. The component variables tended to be either over- or under-estimated when compared to those in other studies over the Korean peninsula, although the estimated GPP was better. The results of this study will likely improve carbon cycle modeling by capturing finer patterns with an integrated method of remote sensing.

• The Korean Journal of Applied Statistics
• /
• v.19 no.3
• /
• pp.421-430
• /
• 2006

In sample survey sample designs are performed by geographically-based domain such as countries, states and metropolitan areas. However mostly statistics of interests are smaller domain than sample designed domain. Then sample sizes are typically small or even zero within the domain of interest. Shin and Lee(2003) mentioned Spatial Autoregressive(SAR) model in small area estimation model-based method and show the effectiveness by MSE. In this study, Bayesian Auto-Poisson Model is applied in model-based small area estimation method and compare the results with SAR model using MSE ME and bias check diagnosis using regression line. In this paper Survey of Disability, Aging and Cares(SDAC) data are used for simulation studies.

• Communications for Statistical Applications and Methods
• /
• v.18 no.4
• /
• pp.507-516
• /
• 2011

Comparative studies on generalized binomial models (Moon, 2003; Ng, 1989; Paul, 1985; Kupper and Haseman, 1978; Griffiths, 1973) are restrictive in that the models compared are rather limited and MSE of the estimates is the only measure considered for the model adequacy. This paper is aimed to report simulation results which provide possible guidelines for selecting a proper model. We examine Pearson type of goodness-of-fit statistic to its degrees of freedom and AIC for the overall model quality. MSE and Bias of the individual estimates are also considered as the component fit measures. Performance of some models varies widely for a certain range of the parameter space while most of the models are quite competent. Our evaluation shows that the Extended Beta-Binomial model (Prentice, 1986) turns out to be particularly favorable in the point that it provides consistently excellent fit almost all over the values of the intra-class correlation coefficient and the probability of success.

• Survey Research
• /
• v.10 no.2
• /
• pp.1-21
• /
• 2009

The purpose of this study is to compare the estimates of housework time by gender using two representative methods of time use study: Time Diary and Stylized Survey Questionnaire. Our analysis is based on the data from the Lifetime Use Survey(2004), which used time-diary questions, and the Korean Labor & Income Panel Study(KLIPS 2004), which used stylized questions on housework hours. The results show that men over-report their housework time in the stylized time use questions. In contrast, women under-report their housework time, which is unusual in the previous studies on response errors and reporting gap. Subgroup analysis shows that widowed/divorced men tend to over-report their contribution to housework more than other groups whereas among women, groups burdened with employed work, caring and housework underestimate their housework time. This reporting gap is explained by gendered norm and perception of time pressure. The theory to explain under-reporting of the housework time has been undeveloped in the previous studies. Our study suggests that perceptions of time pressure be an important factor to explain women's reporting gap of housework estimates.