• 지질공학
• /
• 제31권2호
• /
• pp.149-163
• /
• 2021

특성이 서로 다른 화강암, 대리암 그리고 사암에 대하여 일축압축시험과 반복재하시험을 실시하여 암석의 손상특성을 분석하였다. 일축압축시험으로 암석들의 강도, 탄성상수 그리고 손상기준응력을 결정하였고 이를 반복재하시험의 결과와 비교하였다. 반복재하시험으로 측정된 암석들의 평균 강도는 일축압축시험으로 측정된 값보다 약간 작거나 유사였다. 특히 강도가 높고 공극률이 낮은 암석들이 공극률이 매우 큰 연약한 암석들에 비해 반복하중에 의한 피로현상에 더 민감하였다. 반복 재하-제하 과정에서 발생되는 암석의 영구변형률은 암종에 따라 약간의 차이는 있으나 암석의 손상상태를 파악할 수 있는 유용한 도구로 활용할 수 있다는 것을 확인하였다. 특히 응력-누적영구변형률 곡선은 화강암과 대리암에 대하여 균열손상응력을 추정할 수 있는 가능성을 보여주었다. 시험과정에 미소파괴음을 측정하여 암석의 손상상태를 판단할 수 있는 펠리시티 비를 계산하였다. 공극이 매우 많고 연약한 사암은 미소파괴음의 방출이 매우 미약하여서 펠리시티 비의 계산에 어려움이 있었다. 반면 공극이 적고 취성의 특성을 보이는 화강암과 대리임의 경우 반복재하단계에서 계산된 펠리시티 비를 통하여 암석의 균열손상응력을 추정할 수 있는 가능성을 보여주었다. 향후 더 많은 시료와 다양한 종류의 암석을 대상으로 추가적인 시험을 진행하여 공통적인 결과를 도출한다면 유사한 조건을 갖는 암반의 손상과 변형 거동을 파악하는 데 도움이 될 수 있을 것으로 판단된다.

• 대한기계학회논문집A
• /
• 제20권6호
• /
• pp.1903-1912
• /
• 1996

A quantitative study of impact damage of a soda-lime glass was carried out. An initiation and a propagation of cracks by the impact of two inds of steel ball was investigated. The fron, side and rear view of cracks were observed by a stereo-microscope. And the lowering of the benidng strength due to the impact of steel balls was examined through the 4-point bending test. A transparent glass is very helpful to understand and analyze the impact damage behavior of another brittle matereial. A deagdram about crack patterns according to the threshold impact velocity was sketched. A ring crack and a cone crack were formed at the low impact velocity. And as the impact velocity was higher, initial lateral crack was generated on the slanting surface of cone crack, and radial cracks were generated from the outermost ring crack. When the impact velocity of steel balls exceed a critical velocity, the contact site of specimens were crushed. According to the propagation of a cone crack, a rapid strength degradation occurred. In the specimen having crushed region, a bending strength was converged to a constant value instead of strength degradation.

• 한국산학기술학회논문지
• /
• 제11권9호
• /
• pp.3148-3154
• /
• 2010

본 논문에서는 충격손상 복합재료의 피로수명 저하 특성과 이의 변동성을 통계적으로 분석하였다. 충격손상 복합재료의 잔류강도는 2모수 Weibull 분포에 잘 적합되었으며 충격에너지의 증가에 따라 잔류강도의 변동성은 감소 하였다. 복합재료의 피로수명은 충격손상에 의하여 크게 저하되었으며 또한 이의 피로수명에 대한 충격손상의 영향은 작용 응력진폭에 따라 변화함을 알 수 있었다. 또한 2모수 Weibull 분포를 이용하여 충격손상 복합재료의 피로수명의 변동성을 추정하였으며 충격에너지의 증강 및 응력진폭의 감소에 따라 피로수명의 변동성은 점차 감소하였다.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2016년도 춘계 학술논문 발표대회
• /
• pp.203-204
• /
• 2016

In this research, it used cement power and reduction slag, which generates high hydration heat in hydration reation without heat cure below -5℃ degree. Purpose of final research is preventing freezing and thawing by making the compressive strength 5MPa in 3days below zero temperature due to own heat of concrete. and it is the result of physical characteristic and thermal property evaluation of reduction slag. Because reduction sag generates high hydration heat, compressive strength development is excellent. By generating highly Hydration heat by C₁₂A₇ and C₃A in reduction slag, compressive strength is developed in low temperature. In case of displacing only reduction slag without SO₃, it is indicated that quick-setting occurs by shortage of SO₃. For preventing quick-setting, gypsum is used essentially. According to this research result, in case of using reduction slag and gypsum as a ternary system, Compressive strength developed 5MPa in 3days below zero temperature. It is identified to prevent early frost damage of concrete below zero temperature.

• 한국공간구조학회논문집
• /
• 제5권3호
• /
• pp.109-115
• /
• 2005

본 논문에서는 강도를 향상시키기 위하여 탄소섬유쉬트를 압축하여 제작된 탄소섬유 판재을 이용하여 철근 콘크리트 보의 휨내력 향상과 이력거동에 미치는 영향을 규명하기 위하여 실험을 수행하였다. 실험의 주된 변수는 탄소섬유판재의 단면의 크기, 보강전에 철근콘크리트 보의 손상정도이다. 특히 보의 손상정도는 보가 과하중에 의해 손상을 받은 경우를 대상으로 하고 있으며 손상정도는 보의 최대 휨 내력의 30%, 60%, 100%로 하고 있으며 비교를 위하여 손상받지 않은 보도 실험하였다. 얻어진 결론은 탄소섬유판으로 보강한 경우는 보강하지 않은 보에 비해 강도는 상승하나 최대하중점에서의 변형은 감소하고 있으며, 연성에 있어서는 대등한 값을 나타내고 있다.

• 한국소성가공학회:학술대회논문집
• /
• 한국소성가공학회 2008년도 추계학술대회 논문집
• /
• pp.292-296
• /
• 2008

A new method of evaluating critical damage values of commercial materials is presented in this paper. The method is based on the previous study of the methodology [1] of acquisition of true stress-strain curves or flow stress curves over large strain from the tensile test in which the flow stress is described by the Hollomon law-like form, that is, by the strain dependent strength coefficient and the strain hardening exponent. The strain hardening exponent is calculated from the true strain at the necking point to meet the Considere condition. The strength coefficient is assumed to be constant before necking and represented by a piecewise linear function of strain after necking. With the predicted flow stress, a tensile test is simulated by a rigid-plastic finite element method with higher accuracy of less than 0.5% error between experiments and predictions. The instant when the fracture begins and thus the critical damage is obtained is determined by observing the stress variation at the necked region. It is assumed that the fracture due to damage begins when the pattern of stress around the necked region changes radically. The method is applied to evaluate the critical damage of a low carbon steel.

• Computers and Concrete
• /
• 제19권3호
• /
• pp.315-323
• /
• 2017

Within the context of continuum mechanics, inelastic behaviours of constitutive responses are usually modelled by using phenomenological approaches. Elasto-plastic damage modelling is extensively used for concrete material in the case of progressive strength and stiffness deterioration. In this paper, a review of the main features of elasto-plastic damage modelling is presented for uniaxial stress-strain relationship. It has been reported in literature that the influence of Alkali-Silica Reaction (ASR) can lead to severe degradations in the modulus of elasticity and compression strength of the concrete material. In order to incorporate the effects of ASR related degradation, in this paper the constitutive model of concrete is based on the coupled damage-plasticity approach where degradation in concrete properties can be captured by adjusting the yield and damage criteria as well as the hardening moduli related parameters within the model. These parameters are adjusted according to results of concrete behaviour from the literature. The effect of ASR on the dynamic behaviour of a beam and a column are illustrated under moving load and cyclic load cases.

• Earthquakes and Structures
• /
• 제5권3호
• /
• pp.297-319
• /
• 2013

Two destructive earthquakes occurred on October 23 and November 9, 2011 in Van province of Turkey. The damage in residential units shows significant deviation from the expectation of decreasing damage with increasing distance to epicenter. The most damaged settlement Ercis has the same distance to the epicenter with Muradiye, where no damage occurred while relatively less damage observed in Van having half distance. These three cities seem to have resembling soil conditions. If the damages are evaluated: joint failures and insufficient lap splice lengths are observed to be the main causes of the total collapses in RC buildings. Additionally, low concrete strength, reinforcement detailing mistakes, soft story, heavy overhang, pounding and short columns are among other damage reasons. Examples of damages due to non-structural elements are also given. Remarkable points about seismic damages are: collapsed buildings with shear-walls, heavily damaged buildings despite adequate concrete strength due to detailing mistakes, undamaged two-story adobe buildings close to totally collapsed RC ones and undamaged structural system in buildings with heavily damaged non-structural elements. On the contrary of the common belief that buildings with shear-walls are immune to total collapse among civil engineers, collapse of Gedikbulak primary school is a noteworthy example.

• Advances in concrete construction
• /
• 제5권5호
• /
• pp.539-561
• /
• 2017

In this study, the effects of initial damage of concrete columns on the post-repair performance of reinforced concrete (RC) columns strengthened with carbon-fiber-reinforced polymer (CFRP) composite are investigated experimentally. Four kinds of compression-damaged RC cylinders were reinforced using external CFRP composite wraps, and the stress-strain behavior of the composite/concrete system was investigated. These concrete cylinders were compressed to four pre-damaged states including low -level, medium -level, high -level and total damage states. The percentages of the stress levels of pre-damage were, respectively, 40, 60, 80, and 100% of that of the control RC cylinder. These damaged concrete cylinders simulate bridge piers or building columns subjected to different magnitudes of stress, or at various stages in long-term behavior. Experimental data, as well as a stress-strain model proposed for the behavior of damaged and undamaged concrete strengthened by external CFRP composite sheets are presented. The experimental data shows that external confinement of concrete by CFRP composite wrap significantly improves both compressive strength and ductility of concrete, though the improvement is inversely proportional to the initial degree of damage to the concrete. The failure modes of the composite/damaged concrete systems were examined to evaluate the benefit of this reinforcing methodology. Results predicted by the model showed very good agreement with those of the current experimental program.

• Steel and Composite Structures
• /
• 제34권1호
• /
• pp.1-15
• /
• 2020

This paper presents experimental and numerical studies on effects of local damages on the in-plane elastic-plastic buckling and strength of a fixed parabolic steel tubular arch under a vertical load distributed uniformly over its span, which have not been reported in the literature hitherto. The in-plane structural behaviour and strength of ten specimens with different local damages are investigated experimentally. A finite element (FE) model for damaged steel tubular arches is established and is validated by the test results. The FE model is then used to conduct parametric studies on effects of the damage location, depth and length on the strength of steel arches. The experimental results and FE parametric studies show that effects of damages at the arch end on the strength of the arch are more significant than those of damages at other locations of the arch, and that effects of the damage depth on the strength of arches are most significant among those of the damage length. It is also found that the failure modes of a damaged steel tubular arch are much related to its initial geometric imperfections. The experimental results and extensive FE results show that when the effective cross-section considering local damages is used in calculating the modified slenderness of arches, the column bucking curve b in GB50017 or Eurocode3 can be used for assessing the remaining in-plane strength of locally damaged parabolic steel tubular arches under uniform compression. Furthermore, a useful interaction equation for assessing the remaining in-plane strength of damaged steel tubular arches that are subjected to the combined bending and axial compression is also proposed based on the validated FE models. It is shown that the proposed interaction equation can provide lower bound assessments for the remaining strength of damaged arches under in-plane general loading.