• Korean Journal of Remote Sensing
• /
• v.39 no.5_2
• /
• pp.827-835
• /
• 2023

Drone light detection and ranging (LiDAR) is a state-of-the-art surveying technology that enables close investigation of the top of the mountain slope or the inaccessible slope, and is being used for field surveys in mountainous terrain. To build topographic information using Drone LiDAR, a preprocessing process is required to effectively separate ground and non-ground points from the acquired point cloud. Therefore, in this study, the point group data of the mountain topography was acquired using an aerial LiDAR mounted on a commercial drone, and the application and accuracy of the cloth simulation filtering algorithm, one of the ground separation techniques, was verified. As a result of applying the algorithm, the separation accuracy of the ground and the non-ground was 84.3%, and the kappa coefficient was 0.71, and drone LiDAR data could be effectively used for landslide field surveys in mountainous terrain.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.23 no.2
• /
• pp.69-78
• /
• 2024

Recently, the use of CCTV to prevent crowd accidents has been promoted, but research is needed to compensate for the spatial limitations of CCTV. In this study, pedestrian density was measured using drone footage, and based on a review of existing literature, a threshold of 6.7 people/m² was selected as the cutoff risk level for crowd accidents. In addition, we conducted a preliminary study to determine drone parameters and found that the pedestrian recognition rate was high at a drone altitude of 20 meters and an angle of 60°. Based on a previous study, we selected a target area with a high concentration of pedestrians and measured pedestrian density, which was found to be 0.27~0.30 per m². The study shows it is possible to measure risk levels by determining pedestrian densities in target areas using drone images. We believe drone surveillance will be utilized for crowd safety management in the near future.

• Aerospace Engineering and Technology
• /
• v.4 no.2
• /
• pp.7-14
• /
• 2005

This paper describes development of automatic flight control system for an unmanned target drone. Current target drone is operated by pilot control of on-board servo motor via remote control system. Automatic flight control system for the target drone greatly reduces work load of ground pilot and can increase application area of the drone. Most UAVs being operated nowdays use high-priced sensors as AHRS and IMU to measure the attitude, but those are costly. This paper introduces the development of low-cost automatic flight control system with low-cost sensors. The integrated automatic flight control system has been developed. The performance of automatic flight control system is verified by flight test.

• Corrosion Science and Technology
• /
• v.18 no.6
• /
• pp.253-257
• /
• 2019

A deep learning based real-time painting surface inspection algorithm is proposed herein, designed for developing an autonomous inspection drone. The painting surface inspection is usually conducted manually. However, the manual inspection has a limitation in obtaining accurate data for correct judgement on the surface because of human error and deviation of individual inspection experiences. The best method to replace manual surface inspection is the vision-based inspection method with a camera, using various image processing algorithms. Nevertheless, the visual inspection is difficult to apply to surface inspection due to diverse appearances of material, hue, and lightning effects. To overcome technical limitations, a deep learning-based pattern recognition algorithm is proposed, which is specialized for painting surface inspections. The proposed algorithm functions in real time on the embedded board mounted on an autonomous inspection drone. The inspection results data are stored in the database and used for training the deep learning algorithm to improve performance. The various experiments for pre-inspection of painting processes are performed to verify real-time performance of the proposed deep learning algorithm.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.45 no.10
• /
• pp.825-835
• /
• 2017

This paper aims to build a drone platform based on an optimum design of its single arm. Its single arm is assumed as a cantilevered beam with a tip mass. Based on the numerical optimization theory, validation and optimization of a new design is conducted by comparing the results with the similar ones obtained by ANSYS. Finally, this design is reflected in the control simulation, and the requirement of an optimum structural design considering the resonance situation is satisfied.

• Journal of Satellite, Information and Communications
• /
• v.12 no.4
• /
• pp.157-161
• /
• 2017

Effective management of ULD (Unit Load Device) in Air Cargo Transportation is one of the Airline's main concerns. At present, the way of management of ULD which has the ID tag based on RFID is carried by cargo control staff with PDA. However, the activity of ULD management is limitted due to complexity of cargo terminal facilities. In this study, we offer the effective way of management of ULD by the DRONE equipped by LED-ID & RFID READER at the higher altitude in Air Cargo Terminal to recover the difficulty of identification due to complexity of terminal facilities. Further to the above, we suggest the operational effectiveness, limitation, and the direction of future research.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.33 no.6
• /
• pp.605-614
• /
• 2015

Drone imaging, which is more cost-effective and controllable compared to airborne LiDAR, requires a low-cost camera and is used for capturing color images. From the overlapped color images, we produced two high-resolution digital surface models over different test areas. After segmentation, we performed tree identification according to the method proposed by , and computed the tree height and the canopy crown size. Compared with the field measurements, the computed results for the tree height in test area 1 (coniferous trees) were found to be accurate, while the results in test area 2 (deciduous coniferous trees) were found to be underestimated. The RMSE of the tree height was 0.84 m, and the width of the canopy crown was 1.51 m in test area 1. Further, the RMSE of the tree height was 2.45 m, and the width of the canopy crown was 1.53 m in test area 2. The experiment results validated the use of drone images for the extraction of a tree structure.

• Journal of Satellite, Information and Communications
• /
• v.10 no.3
• /
• pp.32-37
• /
• 2015

Unmaned Aerial Vehical(UAV) is a flight which is automatically flying by remote control on th ground. However UAV has an advantage of control that is easy, but has an disadvantage of not hovering. By comparison, quadcopter which is one of the UAV is easily operated. Also quadcopter has hovering function and high stability. In this paper, we propose stable flight algorithm associated PID(proportional-integral-derivative) control with fuzzy contorl to implement stable quadcopter system. After getting a positioning information of the drone, This proposed system is implemented for stable flight through flight attitude control using gyro and acceleration sensor. We also propose the flight mode system to hover drone with GPS sensor.

• Journal of Satellite, Information and Communications
• /
• v.12 no.1
• /
• pp.22-27
• /
• 2017

In this paper, A heightened interest in the latest drone, yet steady increase in the field to exploit them. The next market is expected to be vastly improved, and use drone also increasingly will be strengthened. But also not a few side effects of him. In order to use safer and more commonly a drone safety and privacy protection, and there are many issues that need to be considered. Violating privacy laws, such as relations caused by the drone flight and review this study ways to resolve the breach. The flight due to a draw at peace with human life and behavior and enjoy it, but this problem created by new outbreak.

• Journal of Digital Contents Society
• /
• v.18 no.1
• /
• pp.109-114
• /
• 2017

In our modern society, the utilization of the advanced drone which is capable of performing variety of tasks has been gradually increasing. In this paper, we present an application, similar to the prototype "Skycall" that had been introduced in the MIT Senseable City. To assess this concept, we have implemented a prototype of drone-based pedestrian navigation depending on the Android smartphone. Our system is not only able to guide the user in a very complicated place, where buildings are compacted, but also to block unauthorized visitors from accessing the facilities. And we discuss some problems we found and suggest the direction to address them.