• Membrane and Water Treatment
• /
• 제12권2호
• /
• pp.83-93
• /
• 2021

In this study, defluoridation efficiency by aluminium sulphate (alum) and polyaluminium chloride (PACl) were compared for recommended Nalgonda dose (100%) and 80% of this dose in both batch and continuous modes. The residual turbidity was found to be higher in case of alum as compared to PACl with 80% dose representing lesser efficient settling of suspensions, which primarily comprise alumino-fluoro complexes that result in high residual aluminium in the treated water and this was confirmed by TEM and Zeta analysis. Moreover, the application of PACl also resulted in much lesser addition to the TDS and also required lesser lime for pH compensation due to its lower acidity. Hence this reduced dose was recommended for defluoridation. It was also observed that in case of alum, residual aluminium in treated water was 0.88 mg/L (100% dose) & 0.72 mg/L (80% dose) and in case of PACl, it was 0.52 mg/L(100% dose) & 0.41 mg/L(80% dose). After subsequent microfiltration, residual aluminium was 0.28 & 0.21 mg/L for 100% & 80% dose respectively and in case of alum and in case of PACl, it was 0.16 & 0.11 for 100% & 80% dose respectively, which conform to the Al standards(<0.2 mg/L).

• 한국환경보건학회지
• /
• 제49권1호
• /
• pp.1-10
• /
• 2023

Low-dose radiation exposure has received considerable attention because it reflects the general public's type and level of exposure. Still, controversy remains due to the relatively unclear results and uncertainty in risk estimation compared to high-dose radiation. However, recent epidemiological studies report direct evidence of health effects for various types of low-dose radiation exposure. In particular, international nuclear workers' studies, CT exposure studies, and children's cancer studies on natural radiation showed significantly increased cancer risk among the study populations despite their low-dose radiation exposure. These studies showed similar results even when the cumulative radiation dose was limited to an exposure group of less than 100 mGy, demonstrating that the observed excess risk was not affected by high exposure. A linear dose-response relationship between radiation exposure and cancer incidence has been observed, even at the low-dose interval. These recent epidemiological studies include relatively large populations, and findings are broadly consistent with previous studies on Japanese atomic bomb survivors. However, the health effects of low-dose radiation are assumed to be small compared to the risks that may arise from other lifestyle factors; therefore, the benefits of radiation use should be considered at the individual level through a balanced interpretation. Further low-dose radiation studies are essential to accurately determining the benefits and risks of radiation.

• Nuclear Engineering and Technology
• /
• 제55권1호
• /
• pp.215-221
• /
• 2023

Proton treatment may deliver a larger dose to a patient's skin than traditional photon therapy, especially when a range shifter (RS) is inserted in the beam path. This study investigated the effects of an RS on skin dose while considering RS with different thicknesses, airgaps and materials. First, the physical model of the scanning nozzle with RS was established in the TOol for PArticle Simulation (TOPAS) code, and the effects of the RS on the skin dose were studied. Second, the variations in the skin dose and isocenter beam size were examined by reducing the air gap. Finally, the effects of different RS materials, such as polymethylmethacrylate (PMMA), Lexan, polyethylene and polystyrene, on the skin dose were analysed. The results demonstrated that the current RS design had a negligible effect on the skin dose, whereas the RS significantly impacted the isocenter beam size. The skin dose was increased considerably when the RS was placed close to the phantom. Moreover, the magnitude of the increase was related to the thickness of the inserted RS. Meanwhile, the results also revealed that the secondary proton primarily contributed to the increased skin dose.

• 대한방사선기술학회지:방사선기술과학
• /
• 제46권6호
• /
• pp.501-508
• /
• 2023

This study used a adult absorption dose phantom (CIRS model 701-G, USA) made of human equivalent material and the vascular imaging equipment Allura Xper FD 20 (Philips, Netherlands). Optically stimulated luminescent dosimeters (OSLD) were inserted into the anatomical positions corresponding to each organ, and the exposure dose was measured. Dose area product (DAP) and air kerma (AK) measured by the dose meter in the equipment were compared. Continuous imaging was performed at two angles for a total of 20 minutes, with a frame per seconds of 3.75 and 7.5 fps and an FOV of 42 cm, 37 cm, and 31 cm, respectively, under the conditions of fluoflavor I, II, and III, each selected for 5 repetitions. This study was found that selecting a lower fps was the most effective way to reduce patient exposure dose, and adjusting the fluoflavor was a good alternative method for reducing patient exposure dose at high fps. Therefore the method of condition change with the greatest dose reduction effect is to set the minimum FPS and can reduce patient exposure dose according to geometric conditions and fluoflavor characteristics.

• 대한방사선치료학회지
• /
• 제26권1호
• /
• pp.11-19
• /
• 2014

목 적 : 최적화 알고리즘에 적용되는 최적화 인자들의 영향을 고려하여, 가장 적합한 인자 값을 도출함으로써 이상적인 치료계획을 쉽게 설계할 수 있도록 하고자 한다. 대상 및 방법 : 본 연구의 세기조절방사선치료에서 선량계산 알고리즘은 PBC(Pencil Beam Convolution)이고, 최적화 알고리즘은 DVO(Dose Volume Optimizer 10.0.28)이다. 두경부 환자의 세기조절방사선치료에서 치료계획용적의 처방선량은 동시에 2.2 Gy와 2.0 Gy가 될 수 있도록 하였다. 치료계획은 6 MV, 7개의 조사야로 역선량계산방법으로 수립하였다. 최적화 알고리즘 인자는 용적선량-조건강도(Priority, Constrain), 선량부 드럼강도(Smooth)로 선정하고, 각 인자들의 변화량에 따른 치료계획의 영향을 분석하였다. 용적선량-조건강도는 기준 조건강도를 정하고, 비율은 같지만 절대 값은 다른 최적화 과정을 실시하였다. 또한 조건강도의 절대 값에 변화에 따른 치료용적과 주변 정상장기들을 평가하였다. 선량부드럼강도는 기준 조건의 단순 변화와 용적선량-조건강도와 관련시킨 변화를 치료계획에 반영시켰다. 치료계획은 처방선량지수(Conformal Index, CI), 처방선량포함지수(Paddick's Conformal Index, PCI), 선량균질지수(Homogeneity Index, HI)와 각 장기의 평균선량으로 평가하였다. 결 과 : 용적선량-조건강도의 비율을 동일하게 하고 절대 값을 변화 시켰을 때 CI값은 다르지만, PCI는 $1.299{\pm}0.006$, HI는 $1.095{\pm}0.004$, D5%/D95%는 $1.090{\pm}1.011$으로 처방선량에 대한 영향은 유사하였다. 이하선의 평균선량은 용적선량-조건강도의 절대 값이 40, 60, 70, 90으로 증가될 때, 67.4, 50.3, 51.2, 47.1 Gy로 감소하였다. 각각의 치료계획에서 선량부드럼강도를 증가시켰을 때, PCI는 $1.338{\pm}0.006$로 증가된 값을 보였다. 결 론 : 용적선량-조건강도는 절대적인 값보다 각 조건의 비율에 따라 최적화 알고리즘에 영향을 주었다. 절대 값이 다르더라도 같은 비율을 유지하면 유사한 치료계획이 수립되었다. 성공적인 치료계획을 수립하기 위해 특히 보호해야할 정상장기의 용적선량-조건강도는 치료용적의 용적선량-조건강도의 50%이상 되어야한다. 선량부드럼강도는 용적선량-조건강도에 따라 비례하여 증가하거나 감소하여야 한다. 단순히 절대 값으로 적용하면 용적선량-조건강도는 그 조건을 충분히 만족시키지 못한다.

• 대한방사선기술학회지:방사선기술과학
• /
• 제21권2호
• /
• pp.43-46
• /
• 1998

When a patient was irradiated with prosthetic hip, the dose distribution was changed according to inhomogeneous materials. The density, effective atomic number, and the composition of material had influence on absorbed dose distribution. In this study, the influence of inhomogeneous material(Ti) was measured using a polyethylene phantom, which consisted of various diameter of titanium, with film dosimetry. As a result, the backward dose showed 29.5% increas by backscattering, the forward dose showed 28% decreas by absorption, and the side dose showed 7% increas by scattering, when 25 mm diameter Ti was used. In addition forward dose was in inverse proportion to the thickness of prosthetic material. When the prosthetic hip of patient is in an irradiated field, we must carefully study the absorbed dose distribution.

• Nuclear Engineering and Technology
• /
• 제52권8호
• /
• pp.1807-1816
• /
• 2020

In this work, a Gaussian Process (Kriging) approach is proposed to provide efficient dose mapping for complex radiation fields using limited number of responses. Given a few response measurements (or simulation data points), the proposed approach can help the analyst in completing a map of the radiation dose field with a 95% confidence interval, efficiently. Two case studies are used to validate the proposed approach. The First case study is based on experimental dose measurements to build the dose map in a radiation field induced by a D-D neutron generator. The second, is a simulation case study where the proposed approach is used to mimic Monte Carlo dose predictions in the radiation field using a limited number of MCNP simulations. Given the low computational cost of constructing Gaussian Process (GP) models, results indicate that the GP model can reasonably map the dose in the radiation field given a limited number of data measurements. Both case studies are performed on the nuclear engineering radiation laboratories at the University of Sharjah.

• 한국환경성돌연변이발암원학회지
• /
• 제19권2호
• /
• pp.108-111
• /
• 1999

Correlation between the tumorigenic dose (TD) and the maximum tolerated dose (MTD) was examined to search for the most relevant TD values related to the MTD. Using benzo(a)pyrene (B(a)P) 2-yr bioassay data, correlation coefficients between values of $TD_{1-}$50/ and the MTD were estimated from linearized or non-linearlized dose-response curves. The highest correlation coefficients (0.9966-1.0000) were obtained from T $D_{1-}$10/ in linearized dose-response curves while the highest (0.9966-1.0000) were estimated from $TD _{5-}$10/ in non-linearized dose-response eurves. These data suggest that TDs-lo were more closely related to the MTD than the ,$TD_{5-}$10/ in B(a)P 2-yr bioassay and that in lieu of the $TD_{50}$ they could be efficiently applicable to risk assessment and management.ent.

• 한국의학물리학회:학술대회논문집
• /
• 한국의학물리학회 2002년도 Proceedings
• /
• pp.121-122
• /
• 2002

The main principle of radiation therapy is to deliver optimum dose to tumor to increase tumor cure probability while minimizing dose to critical normal structure to reduce complications. RTP system is required for proper dose plan in radiation therapy treatment. The main goal of this research is to develop dose model for photon, electron, and brachytherapy, and to display dose distribution on patient images with optimum process. The main items developed in this research includes: (l) user requirements and quality control; analysis of user requirement in RTP, networking between RTP and relevant equipment, quality control using phantom for clinical application (2) dose model in RTP; photon, electron, brachytherapy, modifying dose model (3) image processing and 3D visualization; 2D image processing, auto contouring, image reconstruction, 3D visualization (4) object modeling and graphic user interface; development of total software structure, step-by-step planning procedure, window design and user-interface. Our final product show strong capability for routine and advance RTP planning.

• Journal of Radiation Protection and Research
• /
• 제34권3호
• /
• pp.144-150
• /
• 2009

This study examines how much the radiation dose rate around it varies if a crack occurs on the spent nuclear fuel rod. The spent nuclear fuel rod to be examined is that of Kori unit 3&4. The source terms are evaluated using the ORIGEN-ARP that is part of the version 5.1 of the SCALE package. The radiation dose rate is assessed using the TORT. To check if the structure of a fuel rod is appropriately modeled in the TORT calculation, the calculation results by the TORT are compared with those by the ANISN for the same case. From the code simulation, it is known that if a crack occurs on the spent nuclear fuel rod, the neutron dose rate varies depending on what material is the crack filled with, but the gamma dose rate varies irrespective of type of the material that the crack is filled with.