• 한국유가공학회:학술대회논문집
• /
• 2003.11a
• /
• pp.3-16
• /
• 2003

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2003.05a
• /
• pp.3-6
• /
• 2003

• Applied Chemistry for Engineering
• /
• v.33 no.2
• /
• pp.179-187
• /
• 2022

In this study, the synthesis of 1,2-dodecylaminopropanediol (1,2-DDAP) having a 12 carbon chain length and an amine group was designed to improve the preservation and hydrophilicity of 1,2-alkanediol-based compounds. 1,2-DDAP was prepared by reacting dodecylamine (DDA) with 3-monochloro-1,2-propanediol (3-MCPD) in an ethanol solvent at 40 ℃, and its yield and purity were about 56% and 98%, respectively, under a reaction condition of 2 h and a DDA:3-MCPD molar ratio of 1:0.8. The antimicrobial effect of 1,2-DDAP showed the values of the minimum inhibitory concentration (MIC) and minimum bactericidal concentration (MBC) against microorganisms at concentrations of 10 to 100 times lower than those of 1,2-octanediol(1,2-ODIOL) or 1,2-decanediol (1,2-DDIOL). Based on the hydrophilic properties of 1,2-DDAP, mixed preservatives were prepared by adding small amounts of 1,2-ODIOL or 1,2-DDIOL, which are poorly soluble in water, with 1,2-DDAP. Mixed preservatives exhibited an effect of inhibiting microorganisms equal to or greater than that of 1,2-DDAP alone in antimicrobial activity tests. As a result of confirming the preservation effect in lotion (cosmetic formulation) for application, 1,2-DDAP showed similar antimicrobial activity at concentrations of 0.3 to 0.6 times lower than that of 1,2-ODIOL or 1,2-DDIOL. Therefore, it is considered that the use of 1,2-DDAP alone and the mixed use with small amounts of 1,2-ODIOL or 1,2-DDIOL can be a good alternative to preservatives in the product.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.44 no.3 s.357
• /
• pp.26-34
• /
• 2007

This Paper describes a chip design technique for body composition analyzer based on the BIA (Bioelectrical Impedance Analysis) method. All the functions of signal forcing circuits to the body, signal detecting circuits from the body, Micom, SRAM and EEPROMS are integrated in one chip. Especially, multi-frequency detecting method can be applied with selective band pass filter (BPF), which is designed in weak inversion region for low power consumption. In addition new full wave rectifier (FWR) is also proposed with differential difference amplifier (DDA) for high performance (small die area low power consumption, rail-to-rail output swing). The prototype chip is implemented with 0.35um CMOS technology and shows the power dissipation of 6 mW at the supply voltage of 3.3V. The die area of prototype chip is $5mm\times5mm$.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.43 no.4 s.310
• /
• pp.53-59
• /
• 2006

This paper describes the new design technique of full wave rectifier (FWR) for precise measurement instrument and the chip implementation of this FWR circuit with measurement results. Conventional circuits have some problems of complex design and limited output range( $VDD/2{\sim}VLIIV1IT+$). Proposed FWR circuit was simply designed with two 2x1 MUXs, one high speed comparator, and one differential difference amplifier(DDA). One rail-to-rail differential difference amplifier(DDA) performs the DC level shifting to VSS and 2X amplification simultaneously, and enables the full range ($Vss{\sim}VDD$) operation. The proposed FWR circuits shows more than 50% reduction of chip area and power consumption compared to conventional one. Proposed circuit was implemented with 0.35um 1-poly 2-metal CMOS process. Core size is $150um{\times}450um$ and power dissipation is 840uW with 3.3V single supply.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.19 no.3
• /
• pp.67-72
• /
• 2019

This paper evaluates the performance of CCA (Compact Constellation Algorithm) adaptive equalization algorithm by varying the step size for minimization of the distortion effect in the communication channel. The CCA combines the conventional DDA and RCA algorithm, it uses the constant modulus of the transmission signal and the considering the output of decision device by the power of compact slice weighting value in order to improving the initial convergence characteristics and the equalization noise by misadjustment in the steady state. In this process, the compact slice weight values were fixed, and the performance of CCA adaptive equalization algorithm was evaluated by the varing the three values of step size for adaptation. As a result of computer simulation, it shows that the smaller step size gives slow convergence speed, but gives excellent performance after at steady state. Especially in SER performance, the small step size gives more robustness that large values.

• 제어로봇시스템학회:학술대회논문집
• /
• 1996.10b
• /
• pp.520-522
• /
• 1996

The Direct Drive Arm(DDA) is a SCARA typed direct drive manipulator with two degrees-of-freedom(DOF) using the direct drive motor of the NSK company. A controller system for the SCARA robot of DDA is designed using a DSP (TMS32Oc3O), which has the highest performance among the third DSP chips in the TI company. The design objective of the system is to implement dynamic control algorithms and neural control algorithms for real time learning which require a lot of calculations and large memory and have been tested only by simulations so far. The controller uses a DSP, a high speed D/A, 32-bit Counter and a large DRAM to implement advanced robot control algorithms.

• Geomechanics and Engineering
• /
• v.12 no.4
• /
• pp.723-738
• /
• 2017

Rock is a heterogeneous material, which introduces complexity in the analysis of rock slopes, since both the existing discontinuities within the rock mass and the intact rock contribute to the degradation of strength. Rock failure is often catastrophic due to the brittle nature of the material, involving the sliding along structural planes and the fracturing of rock bridge. This paper proposes an advanced discretization method of rock mass based on block theory. An in-house software, GeoSMA-3D, has been developed to generate the discrete fracture network (DFN) model, considering both measured and artificial joints. Measured joints are obtained from the photogrammetry analysis on the excavation face. Statistical tools then facilitate to derive artificial joints within the rock mass. Key blocks are searched to provide guidance on potential reinforcement measures. The discretized blocky system is subsequently implemented into a discontinuous deformation analysis (DDA) code. Strength reduction technique is employed to analyze the stability of the slope, where the factor of safety can be obtained once excessive deformation of slope profile is observed. The combined analysis approach also provides the failure mode, which can be used to guide the choice of strengthening strategy if needed. Finally, an illustrated example is presented for the analysis of a rock slope of 20 m height inclined at $60^{\circ}$ using combined GeoSMA-3D and DDA calculation.

• Bulletin of the Korean Chemical Society
• /
• v.24 no.11
• /
• pp.1605-1608
• /
• 2003

To development an immunodetection method for DDT, 1,1,1-trichloro-2,2-bis(4-chorophenyl)ethane (p,p'-DDT) and its metabolites (p,p'-DDA, p,p'-DDE, p,p'-DDD), five derivatives of DDT haptens have been synthesised and characterized as coating ligands for antibody evaluation. The appropriate lengths of linkers were introduced to investigate a matching pair of coating ligand and antibody. Among these hapten derivatives, 2,2-bis(4-chlorophenyl)acetic acid (DDA), 5,5-bis(4-chlorophenyl)-5-hydroxypentanoic acid (DDHP) and 5,5-bis(4-chlorophenyl)-5-chloropentanoic acid (DDCP) were conjugated with keyhole limpet hemocyanin (KLH) for its use as an immunogen. The bovine serum albumin (BSA) conjugates of these derivatives were prepared as a coating ligand for monoclonal antibody screening. Fifteen monoclonal antibody clones were screened using these probes. 6,6-Bis(4-chlorophenyl)-6-hydroxyhexanoic acid (DDHH) and 3-[6,6-Bis(4-chlorophenyl)-6-hydroxyhexanoylamino]propanoic acid (DDHHAP), in addition to the above hapten derivatives, were conjugated to ovualbumin (OVA) and bovine serum albumin (BSA) for their use as coating ligands to measure the titration level of the antibody and the displacement of free analytes. The indirect competitive ELISA results indicate that the titration level and free analyte displacement were greatly influenced by the DDT derivatives and carrier proteins used. Three matching pairs of monoclonal antibodies and coating ligands were selected for the DDT immunoassay: antibody clone 1A3 and coating ligand DDA-OVA, 1A1 and DDHHAP-BSA, and 1A4 and DDHP-OVA.

• Environmental and Resource Economics Review
• /
• v.13 no.3
• /
• pp.519-547
• /
• 2004

This paper analyze problems about scope of specific trade obligations(STOs), principle of dispute settlement procedure, and non-parties in context of the Cartagena Protocol on Biosafety(POB), which based on sub-paragraph 31(i) of DDA WTO Ministrial Declaration. The implications based on result of this study are as follows. First, to accept the wider scope of STOs under POB in Korea, importing country, won't be harmful to LMOs and Bioindustry. Instead, it will ensure a high level of biosafety concerning the import of LMOs. Exporters can take different kinds of trade measures to countervail adverse effect on the export of LMOs in this case. Therefore importer will endure the aftereffect. However, if korea were in exporter's place, to accept the wider scope STOs under POB will not have a good influence on the export of LMOs. Korea, therefore, should devise scheme for responding to debate about the STOs in MEAs, which have to be based on cost-benefit analysis and scenarios taking into account of speed and level in biotechology progress, status and trend of LMOs R&D and production, and condition of other industries. Second, it is not easy to agree with applying to what's rule between the POB and WTO for settlement dispute. Because there is the incompatibility between the POB characterized according to social rationality and WTO's rules for safety and environmental protection characterized according to scientific rationality. This issue have to be discussed for long period due to gap like that. Accordingly Korea, one of major LMOs importing countries, should suggest continuously that the effort is needed to ensure an adequate level of protection in transboundary movements of LMOs and scientific, environmental and socio-economic study. Third, in case of dispute between party and non-party of the POB, the duties under the WTO of non-party of the POB(if WTO member country) is valid. The country, therefore, will try to settle dispute based on WTO's rules. However, international society have to ensure for sound and safe use of LMOs in the field of transboundary movements. Accordingly Korea should devise scheme for preventing the possibility of dispute between party and non-party of the POB(if WTO member country), which is supported by policy options under the POB.