• Proceedings of the KIEE Conference
• /
• 2004.07d
• /
• pp.2332-2334
• /
• 2004

A high bandwidth watt-converter, based on an inexpensive, commercially available, standard IC package, is described that covers a frequency ranges from DC to 100 kHz. The new resistive shunt for a wide-band frequency current measurement of the watt-converter was developed. The converter will use application in accurate power measurement under distorted and high frequency conditions. The advantages of the watt-converter are its simplicity, low cost and fast response time.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.24 no.4
• /
• pp.618-624
• /
• 1987

This paper describes the design and fabrication of a signal processing integrated circuit required for the recording and playback of VTR audio signal. The integrated circuit was designed using 8\ulcorner design rule and its chip size is 2.5x2.5mm\ulcorner It was fabricated using SST bipolar standard process technology. The measurement analysis of the fabricated circuit proves the satisfactory DC characteristics and its proper audio signal processing funcstion.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.17 no.10
• /
• pp.2359-2368
• /
• 2013

In this paper, an IRD (internal read data) circuit preventing the reentry into the read mode while keeping the read-out DOUT datum at power-up even if noise such as glitches occurs at signal ports such as an input signal port RD (read) when a power IC is on, is proposed. Also, a pulsed WL (word line) driving method is used to prevent a DC current of several tens of micro amperes from flowing into the read transistor of a differential paired eFuse OTP cell. Thus, reliability is secured by preventing non-blown eFuse links from being blown by the EM (electro-migration). Furthermore, a compared output between a programmed datum and a read-out datum is outputted to the PFb (pass fail bar) pin while performing a sensing margin test with a variable pull-up load in consideration of resistance variation of a programmed eFuse in the program-verify-read mode. The layout size of the 8-bit eFuse OTP IP with a $0.18{\mu}m$ process is $189.625{\mu}m{\times}138.850{\mu}m(=0.0263mm^2)$.

• Journal of the Korean Applied Science and Technology
• /
• v.36 no.1
• /
• pp.226-236
• /
• 2019

In this study, functional and emulsifying properties of oil extracted by supercritical carbon dioxide from balloonflower(Platycodon grandiflorum A. DC) seeds were investigated. The oil was lower in total polyphenol content(8 mg/100 g), but higher in ${\alpha}$-tocopherol(14.15 mg/100 g), ${\beta}$-sitosterol(116 mg/100 g) and stigmasterol(8 mg/100 g) contents than seeds. Based on DPPH radical scavenging activity, the oil($IC_{50}=1235.5{\mu}g/mL$) showed similar antioxidant activity to the seeds($IC_{50}=1138.2{\mu}g/mL$). At 1%(w/w) lecithin, O/W emulsion with balloonflower seeds oil had turbidity, microscopic image, mean particle size and emulsion stability similar to emulsion with soybean oil, but had lower turbidity and emulsion stability and larger mean particle size than emulsion with perilla seeds oil. Its surface tension was similar to perilla oil emulsion.

• The Korean Journal of Food And Nutrition
• /
• v.24 no.3
• /
• pp.291-294
• /
• 2011

A lipase inhibitor from Desmodium oxyphyllum DC. was purified by methanol extraction, systematic solvent extraction, silica gel column chromatography, $C_{18}$ solid phase extraction chromatography and RP-HPLC. We obtained the purified lipase inhibitor with 182 ng($IC_{50}$) of lipase inhibitory activity for a 0.06% yield. Its molecular weight was estimated to be 655.37 Da from an instrumental analysis of MALDI-TOF-MS and it was identified copper-3,5-dibromo-2-hydroxybenzoic acid ($C_{14}H_8Br_4CuO_6$) by $^1H$, $^{13}C$ NMR analysis.

• Journal of Electrical Engineering and Technology
• /
• v.11 no.3
• /
• pp.644-652
• /
• 2016

This paper presents an improved single-stage ac-dc LED-drive flyback converter using the transformer-coupled lossless (TCL) snubber. The proposed converter is derived from the integration of a full-bridge diode rectifier and a conventional flyback converter with a simple TCL snubber. The TCL snubber circuit is composed of only two diodes, a capacitor, and a transformer-coupled auxiliary winding. The TCL snubber limits the surge voltage of the switch and regenerates the energy stored in the leakage inductance of the transformer. Also, the switch of the proposed converter is turned on at a minimum voltage using a formed resonant circuit. Thus, the proposed converter achieves high efficiency. The proposed converter utilizes only one general power factor correction (PFC) control IC as its controller and performs both PFC and output power regulation, simultaneously. Therefore, the proposed converter provides a simple structure and an economic implementation and achieves a high power factor without the need for any separate PFC circuit. In this paper, the operational principle of the proposed converter is explained in detail and the design guideline of the proposed converter is briefly shown. Experimental results for a 40-W prototype are shown to validate the performance of the proposed converter.

• Archives of Pharmacal Research
• /
• v.29 no.10
• /
• pp.834-839
• /
• 2006

Torilin was purified from Torilis japonica (Houtt.) DC., and its effects on a rapidly activating delayed rectifier $K^+$ channel (hKv1.5), cloned from human heart and stably expressed in Ltk cells, as well as the corresponding $K^+$ current (the ultrarapid delayed rectifier, $I_{KUR}$) were assessed in human atrial myocytes. Using the whole cell configuration of the patch-clamp technique, torilin was found to inhibit the hKv1.5 current in time and voltage-dependent manners, with an $IC_50$ value of $2.51{\pm}0.34\;{\mu}M$ at +60 mV. Torilin accelerated the inactivation kinetics of the hKv1.5 channel, and slowed the deactivation kinetics of the hKv1.5 current, resulting in a tail crossover phenomenon. Additionally, torilin inhibited the hKv1.5 current in a use dependent manner. These results strongly suggest that torilin is a type of open-channel blocker of the hKv1.5 channel.

• Journal of Power Electronics
• /
• v.18 no.6
• /
• pp.1642-1649
• /
• 2018

A single-stage flyback LED AC-DC converter based on primary-side control under constant current mode is proposed in this study. The proposed converter features low total harmonic distortion (THD) and high power factor (PF). It also consists of a zero-crossing distortion compensation circuit and a variable duty ratio control compensation circuit to deal with the line current distortions caused by fixed duty ratio control. The system model and layout are built in Simplis and Cadence, respectively. The feasibility and performance of the proposed circuit is verified by designing and fabricating an IC controller in the HHNEC $0.35{\mu}m$ 5 V/40 V HVCMOS process. Experimental results show that the PF can reach a level in the range of 0.985-0.9965. Moreover, the average THD of the entire system is approximately 10%, with the minimum being 6.305%, as the input line voltage changes from 85 VAC to 265 VAC.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.6 no.3
• /
• pp.154-161
• /
• 2006

This paper describes the new types of ngative differential resistance (NDR) IC applications which use a monolithic quantum-effect device technology based on the RTD/HBT heterostructure design. As a digital IC, a low-power/high-speed MOBILE (MOnostable-BIstable transition Logic Element)-based D-flip flop IC operating in a non-return-to-zero (NRZ) mode is proposed and developed. The fabricated NRZ MOBILE D-flip flop shows high speed operation up to 34 Gb/s which is the highest speed to our knowledge as a MOBILE NRZ D-flip flop, implemented by the RTD/HBT technology. As an analog IC, a 14.75 GHz RTD/HBT differential-mode voltage-controlled oscillator (VCO) with extremely low power consumption and good phase noise characteristics is designed and fabricated. The VCO shows the low dc power consumption of 0.62 mW and good F.O.M of -185 dBc/Hz. Moreover, a high-speed CML-type multi-functional logic, which operates different logic function such as inverter, NAND, NOR, AND and OR in a circuit, is proposed and designed. The operation of the proposed CML-type multi-functional logic gate is simulated up to 30 Gb/s. These results indicate the potential of the RTD based ICs for high speed digital/analog applications.

• Progress in Superconductivity and Cryogenics
• /
• v.17 no.3
• /
• pp.37-40
• /
• 2015

Recently, the electrical insulation design for electrical apparatuses is important to cope with the tendency of high voltage. The degradation characteristics of a superconducting coil due to an electrical breakdown should be considered to design a high voltage superconducting coil. In this paper, the degradation characteristics of 2G high temperature superconducting (HTS) wires are studied with respect to electrical breakdown tests. To analyze the dependency of the degradation characteristics of 2G HTS wires, the electrical breakdown tests are performed with AC(alternating current) and DC(direct current) voltage. All tests are performed by applying various magnitudes of AC and DC breakdown voltages. To verify the degradation characteristics of 2G HTS wires, the tests are performed with various 2G HTS wires with respect to stabilizer materials. The degradation characteristics of 2G HTS wires, such as Ic(critical current) and index number are measured by performing electrical breakdown tests. It is found that the characteristics such as Ic and index number can be degraded by an electrical breakdown. Moreover, it is concluded that the degradation characteristics of 2G HTS wires are affected by the stabilizer material and applied voltages. The cross-sectional view of 2G HTS wires is observed by using a scanning electron microscope (SEM). As results, it is found that the degradation characteristics of 2G HTS wires are concerned with hardness and electrical conductivity of stabilizer layers.