• Journal of Ocean Engineering and Technology
• /
• v.13 no.4 s.35
• /
• pp.55-62
• /
• 1999

Cold rolled steel has much plastic strain in the material surface produced by manufacturing process. The strain causes the variation of surface residual stress, in which influences the fatigue behavior under repeated loading. As experimental results, it was confirmed that the behavior of residual stress ${\sigma}_r$, with cycle N consisted of three stages except stress amplitude near fatigue limit in SPCC steel. On the first stage compressive residual stress decreased rapidly, on the second stage gradually, and on the last stage slightly. The relation between ${\sigma}_r$, and log N appeared linear behavior except the early part of cycle ratio $N/N_f$. The average gradient of ${\sigma}_r$, with respect to log N seemed to take a constant value without initial cycle ratio. On the other hand, the $N_f$ line was regressed by the first-order polynomial equation on ${\sigma}_r-log\;N_f$ diagram. Therefore, this study showed that both the gradient of ${\sigma}_r$, with respect to log N and the $N_f$ line was useful in predicting the cycle ratio $N/N_f$.

• The Korean Journal of Physiology
• /
• v.14 no.1
• /
• pp.7-13
• /
• 1980

In the previous experiment, authors have shown that during the latter half of estrous cycle there was an increase in plasma testosterone level in the rats stimulated with hCG. To determine the physiologic significance of elevated plasma testosterone, changes of the plasma concentrations of TeBG and testosterone following hCG stimulation were analyzed in the rats having a regular 5 day cycle. The rats were divided into three groups; the control, the rats stimulated with single hCG on the day of proestrus and stimulated with hCG throughout the entire cycle. Blood samples were obtained once a day for an estrous cycle and analyzed for the binding capacity of TeBG using ammonium sulphate precipitation method and testosterone concentration by means of radioimmunoassay. Followings were the results; 1) There was no significant variation in the binding capacity of TeBG in peripheral blood during the estrous cycle of the control rats. 2) No cyclic variation in the binding capacity of TeBG was observed in the rats stimulated with single hCG on proestrus. although the levels tended to be higher in the rats with stimulation than in the control rats. 3) Continual stimulation of hCG produced a marked increase in the binding capacity of TeBG especially on the day of metaestrus. 4) The changes in the plasma level of testosterone followed the same basic pattern seen in the TeBG binding capacity. 5) From above results, the followings were suggested. a. hCG related increase of the binding capacity of TeBG is probably secondary to a modest increase in estrogen as well. b. hCG related increase of plasma testosterone in female rats is not entirely due to excess production rather in part due to decreased metabolism induced by the rise in TeBG. c. It seems likely that most of elevated testosterone shown in the rat stimulated with hCG is bound to TeBG and only small portion is unbound form which influence cellular activity. It is rather possible that an increase in TeBG could augment estrogen activity.

• Journal of the Korea Institute of Building Construction
• /
• v.7 no.3
• /
• pp.107-113
• /
• 2007

This study is to investigate adhesive properties depending on the temperature, humidity, and freeze-thraw of the Steel plate adhesive strengthening method by the epoxy resin. The results are summarized as following. For the temperature variation, the debonding failure appear only after 1 cycle of temperature varoation because the coefficient of thermal expansion of the epoxy resin is comparatively large, and the bonding strength is decreased. The deformation properties and ultrasonic pulse velocity on each materials are similar until 4 cycles on the dry and moisture test. As the freeze-thraw test, the epoxy resin is degraded easily subjected to freeze-thaw cycle, comparatively easy, so the debonding failure may occur in short term because of the freeze-thaw repeatition.p

• Culinary science and hospitality research
• /
• v.2
• /
• pp.59-87
• /
• 1996

This study has been done by giving the guide when development of menu or doing marketing strategy in Hotel Restaurant. All products and service has a regular course from induction in market to disappear, so it shall be come out Products Life Cycle theory. In eating business, under the tendency and existing cycle to change menu by taste of customers, liking variation, change of periodic status (environment), MLC(Menu Life Cycle) shall be advised by application PLC(Products Life Cycle) in the process of induction of some menu first and spreading the same business field and then deletion (disappearance) from menu because of no popular. In Emergence Stage, it shall be tried to inform new menu through Cooking Contest, presentation of new menu, free sampling party and others. In Growth Stage, it shall be changed package menu or set menu. In Maturity Stage, it shall be provided complimentary ticket, gift coupon or discount for the customers with some degree of selling record in order to increase using frequency and selling amount after insure new customers. In Decline Stage, it shall be groped for entry underdeveloped country or less advance nation, but there is no possibility to devote in enterprise, it shall be planned substitute menu development in order to withdraw. By inducting MLC concept, it shall be provided the available informations such as“how could some menu be circulate in some restaurant”“Accordingly do strengthen promotion activities or go to low developed area or overseas, or delete it from menuitems and so on”. In the time of decline some menu, it is judged to the time of plan(preparation) of new menu development. In the broad view, when consideration of the concept of menu life cycle, it shall be possible to know which menu is decayed and which menu is developed newly or grown-up, so it shall be provided the important information to estimate the tendency of changing menu and set-up a menu development plan.

• Journal of the korean Society of Automotive Engineers
• /
• v.14 no.6
• /
• pp.39-47
• /
• 1992

The engine combustion is one of the most important process affecting performance and emissions. One effective way to improve the engine combustion is to control motion of the charge inside a cylinder by means of optimum induction system design, because the flame speed is mainly determined by the turbulence in a gasoline engine. This paper describes the measurement and characterization of mean velocity and turbulence intensity inside the cylinder of a 4-valve gasoline engine using laser Doppler velocimeter(LDV) under motoring(non-firing) conditions. Since the measured LDV data in each cycle show small cycle variation during compression stroke in the tested engine, the mean velocity and turbulence intensity are calculated by ensemble averaging method neglecting cycle variation effects. In the ensemble averaging method, the effects of the calculation window, in which velocities are assumed as the same crank angle, on mean velocity and turbulence intensity are fully investigated. In addition, the effects of measuring point on the flow characteristics are studied. With large calculation window, the mean velocity is shown to be less sensitive with respect to crank angle and turbulence intensity decrease in its absolute amplitude. When the piston approch to the top dead center of compression, the turbulence intensity is found to be homogeneous in the cylinder.

• Journal of Ocean Engineering and Technology
• /
• v.11 no.3
• /
• pp.76-88
• /
• 1997

Constant .DELTA.K fatigue crack growth rate experiments were performed by applying an intermediate single and multiple overload for structural steel, SM45C. The purpose of the present study is to investigate the influence of multiple overloads at various stress intensity factor ranges and the effect of statistical variability of crack retardation behavior. The normalized delayed load cycle, delayed crack length and the minimum crack growth rate are increased with increasing baseline stress intensity factor range when the overload ratio and the number of overload application were constant. The crack retardation under low baseline stress intensity factor range increases by increasing the number of overload application, but the minimum crack growth rate decreases by increasing the number of overload application. A strong linear correlation exists between the minimum crack growth rate and the number of overload applications. And, it was observed that the variability in the crack growth retardation behavior are presented, the probability distribution functions of delayed load cycle, delayed crack length and crack growth life are 2-parameter Weibull. The coefficient of variation of delayed load cycle and delayed crack length for the number of 10 overload applications data are 14.8 and 9.2%, respectively.

• Journal of the Korean Society of Laryngology, Phoniatrics and Logopedics
• /
• v.19 no.2
• /
• pp.113-116
• /
• 2008

Baekgroud and Objectives: The study was purposed to evaluate the relationship between the voice change and the menstrual cycle by measuring the variation of subjective and objective parameters. Materials and Methods: Prospective study of 13 healthy women during 2 mentrual cycles. Their voices were recorded at follicular phase and then luteal phase of the menstrual cycle. We used both single vowel /a/ and sentences for evaluate acoustic parameters. Aerodynamic parameters were also evaluated. Voice handicap index (VHI), and the presence of premenstrual syndromes (PMS) were checked at each period. We used Wilcoxon's signed rank test to compare the parameters of two periods. Results: VHI were 5.1 at both periods (p=0.146) and 92.3% of women were diagnosable with PMS. There were no significant differences in acoustic parameters and aerodynamic parameters between the two periods. Conclusion: This study shows that not only the subjective but also the objective changes of the voice parameters did not exist during the menstrual cycle in women.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.5 no.3
• /
• pp.198-206
• /
• 1993

Experimental results of two stage Gifford-McMahon cryorefrigerator are described. In-prototype experiments, drive mechanism is Scotch Yoke type driven by stepping motor, copper meshes and lead balls are used for regenerator's materials in the first stage and the second stage, respectively. To find optimal conditions of the cryopump, no load temperature and refrigeration capacity according to the variation of cycle frequency and operating pressure are measured, and the cool down and load characteristics at particular cycle frequencies are presented. In general, as the cycle frequency is lowered, no load temperature is dropped but refrigeration capacity is diminished. As the representative result, in a case that the cycle frequency is 70rpm and steady state pressure is 14 atm, no load temperature of second stage is lowered to 10.5K in 55 minuters, and in this situation the refrigeration capacity of the first stage is 42W at 80K, that of the second stage is 11 W at 20K.

• Asian Pacific Journal of Cancer Prevention
• /
• v.13 no.3
• /
• pp.775-780
• /
• 2012

8-isoprostane (8-$isoPGF_{2{\alpha}}$) is a reliable marker and considered a gold standard for lipid peroxidation. There are very few reports of 8-isoprostane levels in cancer patients, and in patients undergoing chemotherapy. Oxidative stress is however expected and has been observed in patients with cancer. This study measured 8-isoprostane levels in urine by ELISA of 25 patients undergoing chemotherapy for advanced non-small cell lung cancer, at cycles 1, 2, and 3 of treatment. It considers the creatinine clearance of the patients, and correction of 8-isoprostane levels by creatinine clearance, and overnight urine volume methods. The average 8-isoprostane levels in urine increased more than 6 to 12 fold on chemotherapy treatment, from $532{\pm}587$ pg/mL at cycle $1,6181{\pm}4334$ at cycle 2, and $5511{\pm}2055$ at cycle 3. Similar results were obtained if 8-isoprostane levels were corrected for overnight urine volume, giving averages of $285{\pm}244{\mu}g$ at cycle $1,4122{\pm}3349$ at cycle 2, and $3266{\pm}1200$ at cycle 3. No significant difference was seen in average total overnight urine volume or number of urinations between chemotherapy cycles except for a large variation in urine volume between cycle 2 and 3. Creatinine levels were significantly different only between cycles 1 and 2 (p=0.016). In conclusion, cisplatin therapy has been shown to induce high levels of lipid peroxidation in lung cancer patients and can be assessed from the 8-isoprostane marker in overnight urine, with or without urine volume correction.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39B no.10
• /
• pp.691-699
• /
• 2014

In order to increase network lifetime, duty-cycle MAC protocols which can reduce energy consumption caused by idle listening is proposed for WSNs. In common duty-cycle MAC protocols, each sensor node calculates its duty-cycle interval based on the current amount of residual energy. However, in WSNs with the capability of energy harvesting, existing duty-cycle intervals based on the residual energy may cause the sensor nodes which have high energy harvesting rate to suffer unnecessary sleep latency. Therefore, a duty-cycle scheduling scheme which adjust the duty-cycle interval based on both of the residual energy and the energy harvesting rate was proposed in our previous work. However, since this duty-cycle MAC protocol overlooked the performance variation according to the change of duty-cycle interval and adjusted the duty-cycle interval only linearly, the optimal duty-cycle interval could not be obtained to meet application requirements. In this paper, we propose three methods which calculate the duty-cycle interval and analyse their results. Through simulation study, we verify that network lifetime, end-to-end delay and packet delivery ratio can be improved up to 23%, 44% and 31% as compared to the existing linear duty-cycle scheduling method, respectively.