• Journal of the Korean Society of Industry Convergence
• /
• v.7 no.1
• /
• pp.19-24
• /
• 2004

An experimental investigation was performed to study the characteristics of laminar water flow in a horizontal circular tube by using liquid crystal. A simultaneous measurement technique has been employed to measure the velocity field in a two-dimensional cross section of fluid flow. This study found the velocity distributions for Re = 1,594 ~ 2,510 along longitudinal sections and the results appear to be physically reasonable. To determine some characteristics of the laminar flow, 2D PIV technique is employed for velocity measurement by using liquid crystal in water. The experimental rig was manufactured from an acryle tube. The test tube diameter of 25mm, and a length of 1200mm. The used algorithm is the gray level cross-correlation method by using Kimura et al. in 1986.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2007.06a
• /
• pp.87-92
• /
• 2007

This work describes the installation and preliminary measurements of an electrical resistivity tomography (ERT) system to monitor the injection of recycled water into a confined aquifer in the area of Sindos (Thessaloniki N. Greece). The aim is to provide, through time-lapse ERT measurements and processing, geoelectrical images of rather increased volumetric sampling around and between the holes and to obtain improved understanding of the flow and transport of the injected water. The details about the general setting, the construction and installation of the ERT cables into the boreholes are explained in full. Preliminary measurements involving single and cross-hole ERT measurements were obtained and processed with a 2D inversion algorithm to produce images of the subsurface. Results depict a very good correlation between ERT images and the lithology and resistivity logs; an indication of the reliability of the approach.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.13 no.2
• /
• pp.1064-1079
• /
• 2019

Information security has become increasingly important with the rapid development of mobile devices and internet. An efficient encryption system is a key to this end. In this paper, we propose an image encryption method based on the cross diffusion of two chaotic maps. We use two chaotic sequences, namely the Logistic map and the Chebyshev map, for key generation which has larger security key space than single one. Moreover, we use these two sequences for further image encryption diffusion which decreases the correlation of neighboring pixels significantly. We conduct extensive experiments on several well-known images like Lena, Baboon, Koala, etc. Experimental results show that our algorithm has the characteristics of large key space, fast, robust to statistic attack, etc.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.8 no.2
• /
• pp.36-44
• /
• 2009

In this paper, we suggest a system of detecting a vehicle with lane violation, which can detect the vehicle with lane violation, by using the feature point tracking. The whole algorithm in the suggested system of detecting a vehicle with lane violation is composed of three stages such as feature extraction, register and tracking in feature for the tracking-targeted vehicle, and detecting a vehicle with lane violation. In the stage of feature extraction, the feature is extracted from the inputted image by sing the feature-extraction algorithm available for the real-time processing. The extracted features are again selected the racking-targeted feature. The registered feature is tracked by using NCC(normalized cross correlation). Finally, whether or not lane violation is finally detected by using information on the tracked features. As a result of experimenting the suggested system by using the acquired image in the section with a ban on intervention, the excellent performance was shown with 99.09% for positive recognition ratio and 0.9% for error ratio. The fast processing speed could be obtained in 34.48 frames per second available for real-time processing.

• Korean Journal of Remote Sensing
• /
• v.32 no.6
• /
• pp.589-601
• /
• 2016

Sea surface currents were estimated by applying the Maximum Cross Correlation (MCC), Zero-mean Sum of Absolute Distances (ZSAD), and Zero-mean Sum of Squared Distances (ZSSD) algorithms to Himawari-8/Advanced Himawari Imager (AHI) thermal infrared channel data, and the comparative analysis was performed between the results of these algorithms. The sea surface currents of the Kuroshio Current region that were retrieved using each algorithm showed similar results. The ratio of errors to the total number of estimated surface current vectors had little difference according to the algorithms, and the time required for sea surface current calculation was reduced by 24% and 18%, relative to the MCC algorithm, for the ZSAD and ZSSD algorithms, respectively. The estimated surface currents were validated against those from satellite-tracked surface drifter and altimeter data, and the accuracy evaluation of these algorithms showed results within similar ranges. In addition, the accuracy was affected by the magnitude of brightness temperature gradients and the time interval between satellite image data.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.9A
• /
• pp.656-663
• /
• 2009

In 3GPP LTE system downlink, PSS (primary synchronization signal) and SSS (secondary synchronization signal) sequences are used for initial cell search and synchronization. UE (user equipment) detects slot timing, frequency offset, and cell ID by using PSS. After that it should detect frame timing, cell group ID, and CP length by using SSS. But in 3GPP LTE, there are two kinds of CP length, so we should operate FFT twice. In this paper, to minimize SSS detection complexity in cell searcher, we propose a CP length pre-decision algorithm that reduces the arithmetical complexity by half at most, with negligible performance degradation.

• The Journal of the Acoustical Society of Korea
• /
• v.40 no.5
• /
• pp.460-465
• /
• 2021

In active sonar, time delay estimation is used to find the distance between the target and the sonar. Among the time delay estimation methods for active sonar, estimation in the frequency domain is widely used. When estimating in the frequency domain, the time delay can be thought of as a frequency estimator, so it can be used relatively easily. However, this method is prone to rapid increase in error due to noise. In this paper, we propose a new method which applies weighted dictionary and sparsity in order to reduce this error increase and we extend it to two receivers to propose an algorithm for estimating the time delay between two receivers. And the case of applying the proposed method and the case of not applying the proposed method including the conventional frequency domain algorithm and Generalized Cross Correlation-Phase transform (GCC-PHAT) in a white noise environment were compared with one another. And we show that the newly proposed method has a performance gain of about 15 dB to about 60 dB compared to other algorithms.

• 제어로봇시스템학회:학술대회논문집
• /
• 2004.08a
• /
• pp.1962-1965
• /
• 2004

In this paper, the new algorithm for blind adaptive decorrelating parallel interference canceller detector in direct-sequence code division multiple access (DS-CDMA) synchronous communication systems is proposed. The goal of this paper is to improve the performance of the blind adaptive decorrelating parallel interference cancellation detector (BAD/PIC). The proposed blind adaptive decorrelating detector is using optimum step-size technique bootstrap algorithm as an initial stage of PIC, which does not require a training sequence. Therefore, this algorithm has a superior view of utilizing bandwidth and reduces the complexity of computation of inversion cross-correlation matrix. The computer simulation results show that the bit error rate performance of the proposed algorithm for the new structure of detector is better than that of the other detectors such as matched filters, the conventional PIC, and the blind adaptive decorrelating PIC detector.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.7A
• /
• pp.520-528
• /
• 2003

This paper proposes a method of implementing synthetic stereo and an acoustic echo cancellation algorithm for multiple participant conference system. Synthetic stereo is generated by HRTF and two loudspeakers. A robust adaptive algorithm for synthetic stereo echo cancellation is proposed to reduce the weight misalignment due to near-end speech signals and ambient noises. The proposed adaptive algorithm is modified version of SMAP algorithm and the coefficients of adaptive filter is updated with cross correlation of input and estimation error signal normalized with sum of the autocorrelation of input signal and the power of the estimation error signal multiplied with projection order. This is more robust to projection order and ambient noise than conventional SMAP. Computer simulation show that the proposed algorithm effectively attenuates synthetic stereo acoustic echo.

• Proceedings of the KIEE Conference
• /
• 2003.11b
• /
• pp.91-94
• /
• 2003

In this paper, we achieve implementation of a Time-Frequency Domain Reflectometry(TFDR) system through comparatively low performance(100MS/s) PCI extensions for Instrumentation(PXI). The TFDR is the general methodology of Time Domain Reflectometry(TDR) and Frequency Domain Reflectometry(FDR). This methodology is robust in Gaussian noises, because the fixed frequency bandwidth is used. Moreover, the methodology can get more information of the fault by using the normalized time-frequency cross correlation function. The Arbitrary Waveform Generator(AWG) module generates the input signal, and the digital oscilloscope module acquires the input and reflected signals, while PXI controller module performs the control of the total PXI modules and execution of the main algorithm. The maximum range of measurement and the blind spot are calculated according ta variations of time duration and frequency bandwidth. On the basis of above calculations, the algorithm and the design of input signals used in the TFDR system are verified by real experiments. The correlation function is added to the TDR methodology for reduction of the blind spot in the TFDR system.