• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.4 no.4
• /
• pp.751-758
• /
• 2000

In this paper, we discuss frequency allocation and sharing for high speed radio access network in domestic 5GHz the band. In order to evaluate the possibility of frequency sharing between meteorological radar and high speed radio access network, we analyses radio interference of meteorological radar by means of minimum coupling loss method and Monte Carlo simulation. And simulations show that it is necessary to use DFS(Dynamic Frequency Selection) scheme for frequency sharing between meteorological radar and high speed radio access network.

• Proceedings of the KIEE Conference
• /
• 2007.07a
• /
• pp.1502-1503
• /
• 2007

In this paper, inductive coupled LC balun has been desi gned and simulated for embedding into an organic packaging substrate. Inductive coupling method was applied to obtain wide band characteristics, and high dielectric film was utilized to reduce a size of the balun. The proposed balun has a novel scheme which consists of three embedded LC resonators with inductive coupling. This proposed balun has relatively small inductance and capacitance values which can be easily embedded into the organic packaging substrate. Furthermore, it has a good phase imbalance characteristic. The simulated results of proposed balun are an insertion loss of 1.2 dB, a return loss of 10 dB, a phase imbalance of 1 degree at frequency bandwidth of 750 MHz ranged from 1.8 GHz to 2.55 GHz, respectively. This balun has an area of $2mm{\tims}3.5mm{\times}0.66mm$ (height).

• ETRI Journal
• /
• v.45 no.4
• /
• pp.581-593
• /
• 2023

This paper proposes four-ring slot resonator-based MIMO antennas of 75×150 mm² without and with CSRR structures in the sub-6-GHz range. These orthogonal-fed antennas have shown diverse characteristics with dual polarization. L-shaped parasitic structures have increased the isolation (i.e., >40 dB) in the single-element antenna over the band of 3.4 GHz-3.8 GHz. A set of three CSRR structures in the MIMO antenna reduced the coupling between antenna ports placed in an inline arrangement and enhanced the isolation from 12 dB to 20 dB and the diversity characteristics. The S-parameters of both MIMO antennas are measured and used to evaluate MIMO parameters like ECC, TARC, MEG, and channel capacity loss. The simulation results show the variations in the gain and directivity on exciting linear and dual polarizations. The diversity performance of the reported MIMO antennas is suitable for 5G applications.

• Progress in Superconductivity and Cryogenics
• /
• v.13 no.2
• /
• pp.13-16
• /
• 2011

This paper describes the reduction method of eddy current loss generated into a retaining ring installed in wound-field superconducting machine. In order to suggest the reduction method of eddy current loss of the retaining ring, this paper is divided into three parts. Firstly, eddy current loss of prototype model is calculated. Secondly, eddy current loss versus material and shape of the retaining ring is compared. Finally, the material and the shape of the retaining ring to reduce coupling loss generated by a time-varying magnetic field are proposed. In this paper, eddy current loss is calculated by 3-dimensional transient analysis.

• Bulletin of the Korean Chemical Society
• /
• v.34 no.7
• /
• pp.2099-2104
• /
• 2013

We present here an efficient and simple method for preparation of highly active Pd heterogeneous catalyst (CNT-Pd), specifically by reaction of dichlorobis(triphenylphosphine)palladium ($Pd(PPh_3)_2Cl_2$) with thiolated carbon nanotubes (CNTs). The as-prepared CNT-Pd catalysts demonstrated an excellent catalytic activity for the carbon-carbon (C-C) cross-coupling reactions (i.e. Suzuki, Stille, and decarboxylative coupling reactions) under mild conditions. The CNT-Pd catalyst could easily be removed from the reaction mixture; additionally, in the decarboxylative coupling of iodobenzene and phenylpropiolic acid, it showed a six-times recyclability, with no loss of activity. Moreover, once its activity had decreased by repeated recycling, it could easily be reactivated by the addition of phosphine ligands. The remarkable recyclability of the decarboxylative coupling reaction is attributable to the high degree of dispersion of Pd catalysts in CNTs. Aggregation of the Pd catalysts is inhibited by their strong adhesion to the thiolated CNTs during the chemical reactions, thereby permitting their recycling.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.12 no.3
• /
• pp.445-450
• /
• 2017

In this paper, the directional coupler with half-power division is designed and fabricated by using the vertical coupling structure based on the CPW transmission-line. Even-mode and odd-mode of the vertical coupling structure can be analyzed by the conventional CPW-line and the CBCPW-line, respectively, with half thickness of the substrate. The directional coupler is designed by using the tefron substrate with the dielectric constant of 2.55 and the thickness of 0.76mm. Manufactured directional coupler has the center frequency of 2.45 GHz and the bandwidth of 66.1%. Also, the return loss and isolation are 19.52dB and 19.47dB, respectively, at the center frequency.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.36 no.2
• /
• pp.126-131
• /
• 2000

Capability and performance of the pliers type coupling device for connection of sea eel pots to loop of main line and automatic separating system were investigated at sea as first trial of developing automatic operating system for sea eel pot fishing boat. Obtained main results are as follows. 1. Maximum tensile load of the pliers type coupling device when connection with high twist PP dan-line as a loop of main line was 1603 N, higher than when connection with low twist PP twine 1379 N. 2. A retention ratio of sea eel pots from main line by connecting with coupling device was successful 100% with high performance without any loss in the sea. 3. A ratio of automatic disconnection between sea eel pots using coupling device and loop of main line was perfect 100% without any trouble.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.17 no.4
• /
• pp.187-192
• /
• 2017

Rigorous longitudinal modal transmission-line theory (L-MTLT) is applied to analyze maximum power transfer in asymmetric grating-assisted directional couplers(A-GADC). By defining a coupling efficiency amenable to rigorous analytical solutions and interference between symmetric and asymmetric supermodes, the power exchange of TE modes as a function of propagation distance is numerically evaluated. The numerical result reveals that maximum power transfer occurs at a grating period ${\Lambda}_{eq}$, in which the insertion loss of supermodes is equal to each other. That is, it is generally different from conventional phase-matching condition of GADC. Furthermore, as the asymmetric profile of grating change to symmetrical profile, the coupling length decreases and the coupling efficiency for power transmission increases.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2000.06a
• /
• pp.309-313
• /
• 2000

A structural-acoustic coupling problem involving fluid in a cavity divided with flexible walls and porous materials is investigated in this paper. In many practical problems, the use of finite elements to discretize the fluid region leads to large stiffness and mass matrices. But, since the acoustic boundary element discretization requires to put elements only on the surface of structure, the size of matrices is reduced considerably. Here, we developed a numerical analysis program for the structural-acoustic coupling problems of the multi-region cavity, using boundary elements for the fluid regions and finite elements for the structure. By considering sound transmission through layered systems placed in a cavity, the accuracy of the coupled acoustical-structural finite element model has been verified by comparing its transmission loss predictions with analytical sloutions. Example problems are included to investigate the characteristics of the multi-region structural-acoustic coupling system with porous material.

• Journal of the Korean Institute of Telematics and Electronics D
• /
• v.36D no.9
• /
• pp.50-55
• /
• 1999

In this paper we proposed a variable optical attenuator using the side polished fiber coupled with a refractive index matching liquid. Small variation of refractive index of matching liquid can induce very large change of optical loss due to the coupling between the fiber mode and radiation mode. The thermo-optic effect of matching liquid was used to ontrol the optical attenuation. The side polished fiber block was fabricated using the silicon V gloove. Experimental results showed that $5^{\circ}C$ temperature variation was enough to adjust full range attenuation. The polarization dependent loss and insertion loss of the fabricated devices were 0.5dB and 0.2dB respectively.