• Journal of Environmental Science International
• /
• v.11 no.9
• /
• pp.993-999
• /
• 2002

Waste paper cup was sulfonated to be used as ion exchanger. Removal characteristic of copper and lead ion by prepared ion exchanger was investigated. The sulfonation was conformed by the high intensity band of $SO_3H$ group around 1100~$1160cm^{-1}$. The synthesized ion exchanger had greater removal ability for copper and lead ion than the original waste paper cup. Ion exchange system reached the final equilibrium plateau within 30min. The maximum removal capacities $q_{max}$ were calculated as 9.79mg/g fur copper and 15.95mg/g for lead, respectively. The affinity of lead based on a weight was higher than that of copper. The ion exchange phenomena appeared to follow a typical Freundlich isotherm.

• Journal of Environmental Science International
• /
• v.8 no.6
• /
• pp.705-710
• /
• 1999

The fundamental experiments on the phosphorus removal from water were carried out by the batch and continuous reactors which used aluminium and copper plate. In this systems, the phosphorus was removed by aluminium ion generated with the electrochemical interaction (pitting corrosion) of aluminium and copper. In the batch experiments, the efficiencies of phosphorus removal increased when the surfaces of aluminium and copper plate were brushed. The phosphorus removal by aluminium ion was affected the copper plate and NaCI in this system. The optimal pH values were 5 and 6 for the phosphorus removal. The efficiency of phosphorus removal increased with increasing NaCI concentration, surface area of aluminium and copper plate. The $CUSO_4{\cdot}5H_2O$ instead of copper plate could be used as Cu source. The effluent $PO_4-P$ concentration as low as 2 $mg/{\ell}$ could have been obtained during the continuous experiment at HRT of 48 hrs.

• Journal of Environmental Science International
• /
• v.11 no.1
• /
• pp.75-83
• /
• 2002

The removal performance of copper ion was studied using Na-P1 zeolites synthesized from Jeju scoria. The scoria which is found in large amounts in Jeju Island, was sampled at four regions, Jeju-shi Bonggae-dong(A). Pukcheju-gun Hanlim-eup Sangmyong-ri Mangoreum(B), Pukcheju-gun Hanlim-eup Keumag-ri(C) and Namcheju-gun Andeok-myun Dongkwang-ri(D). Synthetic Na-P1 zeolites used in this study were more effective than natural zeolite and scoria for the removal of copper ion. The removal performances of copper ion decreased in the order of Na-P1(D) > Na-P1(C) > Na-P1(B) > Na-P1(A) among Na-P1 synthesized from the scoria according to region. These results showed the same trend with cation exchange capacity(CEC) for each synthetic zeolite, i.e., the synthetic Na-P1 zeolite with a higher CEC showed a higher removal performance. The effective diffusion coefficients of copper ion by synthetic Na-P1 zeolites were one hundred and ten times higher than those by a pure zeolite 4A and the zeolite A synthesized from coal fly ash, respectively.

• Resources Recycling
• /
• v.17 no.5
• /
• pp.60-65
• /
• 2008

A study on the removal of silver(Ag) in copper electrolyte was carried out to produce high purity copper by using various method such as ion exchange resin, activated carbon adsorption, copper cementation with powder and wire, CuS precipitation. Parameters, such as reaction time, reaction temperature, addition amount etc. were investigated to determine the effective condition of silver removal. CuS precipitation and ion exchange using Lewatit TP214 was found to be effective. Especially, silver content in copper electrolyte was reduced from 10 ppm to less than 0.1 ppm by ion exchange with Lewatit TP214.

• Journal of Korean Society of Water and Wastewater
• /
• v.33 no.2
• /
• pp.131-140
• /
• 2019

This study used a packed column reactor and a horizontal flow mesh reactor to examine the removal of copper ions from aqueous solutions using pine bark, a natural adsorbent prepared from Korean red pine (Pinus densiflora). Both equilibrium and nonequilibrium adsorption experiments were conducted on copper ion concentrations of 10mg/L, and the removals of copper ions at equilibrium were close to 95%. Adsorption of copper ions could be well described by both the Langmuir and Freundlich adsorption isotherms. The bark was treated with nitric acid to enhance efficiency of copper removal, and sorption capacity was improved by about 48% at equilibrium; mechanisms such as ion exchange and chelation may have been involved in the sorption process. A pseudo second-order kinetic model described the kinetic behavior of the copper ion adsorption onto the bark. Regeneration with nitric acid resulted in extended use of spent bark in the packed column. The horizontal flow mesh reactor allowed approximately 80% removal efficiency, demonstrating its operational flexibility and the potential for its practical use as a bark filter reactor.

• Carbon letters
• /
• v.11 no.2
• /
• pp.117-121
• /
• 2010

The composites of alginate, carbon nanotube, and iron(III) oxide were prepared for the removal of heavy metal in aqueous pollutant. Both alginate and carbon nanotube were used as an adsorbent material and iron oxide was introduced for the easy recovery after removal of heavy metal to eliminate the secondary pollution. The morphology of composites was investigated by FE-SEM showing the carbon nanotubes coated with alginate and the iron oxide dispersed in the alginate matrix. The ferromagnetic properties of composites were shown by including iron(III) oxide additive. The copper ion removal was investigated with ICP AES. The copper ion removal efficiency increased greatly over 60% by using alginate-carbon nanotube composites.

• Journal of Korean Society on Water Environment
• /
• v.27 no.1
• /
• pp.54-60
• /
• 2011

To evaluate the feasibility of electrodialysis for copper removal from industrial wastewater, the effect of operating parameters on the removal of copper was experimentally estimated. The limiting current density (LCD) linearly increased with the copper concentration and the flow rate. The time when the copper concentration of diluate reaches to 3 mg/L was linearly proportional to initial concentration of diluate, and the concentration of concentrate did not affect the removal rate. Increase in the flow rate gave a positive effect on the removal rate and became insignificant at flow rates greater than 2.4 L/min. The removal rate increased with the applied voltage. From the operation of the electrodialysis module used in this research, the flow rate of 2.4 L/min and the voltage corresponding to the 80~90% of LCD were found be the optimum operating condition for the copper removal from highly concentrated copper solutions.

• Journal of the Korean Electrochemical Society
• /
• v.15 no.1
• /
• pp.41-47
• /
• 2012

An annular flow type of copper electrolysis reactor was setup in order to generate the copper ions to remove algae in water. The operating characteristics of the reactor and the effect of copper ion on algae have been considered. By controling the applied current, the copper ion concentration could be obtained as desired level and the faradaic efficiency was above 90%. When the flow rate was increased, the copper ion concentration was linearly decreased due to the dilution effect and the effect of concentration overpotential was insignificant. With the increase of pH in water, the copper ion concentration was linearly decreased and not affected by the conductivity of the water. The concentration of chlorophyll-a was sharply decreased with the increase of copper ion concentration. The algae was effectively removed as the copper ion concentration was above 0.2 ppm. There was no difference between the copper ions obtained by dissolving copper sulfate and those produced by copper electrolysis. The algae removal efficiency was above 90% after 5 days as the copper ion concentration was above 0.4 ppm.

• Membrane and Water Treatment
• /
• v.7 no.5
• /
• pp.403-416
• /
• 2016

The possibility of using carica papaya leaf powder for removal of copper from wastewater as a low cost adsorbent was explored. Different parameters that affect the adsorption process like initial concentration of metal ion, time of contact, adsorbent quantity and pH were evaluated and the outcome of the study was tested using adsorption isotherm models. A maximum of 90%-94.1% copper removal was possible from wastewater having low concentration of the metal using papaya leaf powder under optimum conditions by conducting experimental studies. The biosorption of copper ion was influenced by pH and outcome of experimental results indicate the optimum pH as 7.0 for maximum copper removal. Copper distribution between the solid and liquid phases in batch studies was described by isotherms like Langmuir adsorption and Freundlich models. The adsorption process was better represented by the Freundlich isotherm model. The maximum adsorption capacity of copper was measured to be 24.51 mg/g through the Langmuir model. Pseudo-second order rate equation was better suited for the adsorption process. A dynamic mode study was also conducted to analyse the ability of papaya leaf powder to remove copper (II) ions from aqueous solution and the breakthrough curve was described by an S profile. Present study revealed that papaya leaf powder can be used for the removal of copper from the wastewater and low cost water treatment techniques can be developed using this adsorbent.

• Journal of Korean Society on Water Environment
• /
• v.22 no.4
• /
• pp.626-631
• /
• 2006

The adsorption features of copper ion have been investigated by taking the barley residue which occurring from the beer production process as an adsorbent. Under the experimental conditions, adsorption equilibrium of copper ion was attained within 30 minutes after the adsorption started and the adsorption reaction was observed to be first order. As the temperature increased, the adsorbed amount of copper ion at equilibrium was also increased, which indicated that the adsorption reaction was endothermic. Based on the experimental results which obtained by varying the temperatures, several thermodynamic parameters for copper adsorption reaction were estimated. Regarding the electrokinetic behavior of barley residue, its electrokinetic potential was observed to be positive below pH 5 and turned into negative above this pH. In the pH range from 1.5 to 4, copper adsorption was found to be increased, which was well explained by the electrokinetic behavior of barley residue in the pH range. When nitrilotriacetic acid, which is a complexing agent, was coexisted with copper ion, equilibrium adsorption of copper ion was decreased and this was presumed to be due to the formation of metal complex. In addition, the adsorbed amount of copper ion was examined to be increased when $KNO_3$ was coexisted, however, it approached a saturated value above a certain concentration of $KNO_3$.