• The KIPS Transactions:PartC
• /
• v.15C no.6
• /
• pp.573-586
• /
• 2008

The improved performance and miniaturization of computer and the improvement of wireless communication technology have enabled the emergence of many high quality services. Among them multicast services are receiving much attention and their usage is increasing due to the increase of Internet multimedia services such as video conference, multimedia stream, internet TV, etc. Security plays an important role in mobile multicast services. In this paper, we proposed a secure multicast protocol for a hierarchical micro-mobility environment. The proposed secure multicast protocol provides security services such as authentication, access control, confidentiality and integrity using mechanisms including symmetric/asymmetric key crypto-algorithms and capabilities. To provide forward/backward secrecy and scalability, we used sub-group keys based on the hierarchical micro-mobility environment. With this security services, it is possible to guard against all kinds of security attacks performed by illegal mobile nodes. Attacks executed by internal nodes can be thwarted except those attacks which delete packet or cause network resources to be wasted. We used simulator to measure the performance of proposed protocol. As a result, the simulation showed that effect of these security mechanisms on the multicast protocol was not too high.

• Journal of Korea Society of Industrial Information Systems
• /
• v.19 no.1
• /
• pp.13-18
• /
• 2014

Sensor nodes are used for monitoring and collecting the environmental data via wireless sensor network. The wireless sensor network with various sensor nodes draws attention as a key technology in ubiquitous computing. Sensor nodes has very small memory capacity and limited power resource. Thus, it is essential to have energy efficient strategy for the sensor nodes. Since the sensor nodes are operating on the same frequency bands with ISM frequency bands, the interference by the devices operating on the ISM band degrades the quality of communication integrity. In this paper, the convolutional code is proposed instead of ARQ for the error control for the sensor network. The proposed convolutional code was implemented and the BER performance is measured. For the fixed transmitting powers of -19.2 dBm and -25dBm, the BER with various communication distances are measured. The packet loss rate and the retransmission rate are calculated from the measured BER. It is shown that the porposed method obtained about 9~12% and 12-19% reduction in retransmission rate for -19.2 dBm and -25 dBm respectively.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2000.10a
• /
• pp.451-454
• /
• 2000

Invasive methode and Non-invasive methode are used in blood pressure measurement. The Invasive methode can Set the correct measured blood pressure but, it has patient feels uncomfortable. So most of cases use Non-invasive methode. The Oscillometric method is commonly apply to modem electric sphygmomanometer and using various algorithm. In this paper describe about a algorithm it control and to determinate the cuff pressure, and filtering that data for measure the blood pressure. The communicating with personal computer can pressure deflation is by Solenoid valve and it uses RS-232 system in packet communication. The main using algorithm for blood pressure measurements are maximum amplitude algorithm and oscillometric algorithm. MAA(maximum amplitude algorithm) has various measured oscillation it depend on patient's age, height, weight and arm circumference size. In this paper, 1 studied the various measured oscillation apply to characteristic ratio and can get the result of systolic blood pressure, diastolic blood pressure, mean blood pressure. It was not used same ratio to measuring oscillation. In the MAA(maximum amplitude algorithm), we hope for reduce the difference with the real blood pressure and the measured blood pressure, when it applied with various specific ratio.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.9A
• /
• pp.702-709
• /
• 2003

In this paper, we propose an efficient and QoS-aware MAC scheduling algorithm for Bluetooth, which considers both throughput and delay performance of each Master-Slave pair in scheduling decisions, and thus, attempts to maximize overall performance. The proposed algorithm, MTDPP (Modified Throughput-Delay Priority Policy), makes up for the drawbacks of T-D PP (Throughput-Delay Priority Policy) proposed in [6] and improves the performance. Since Bluetooth employs a master-driven TDD based scheduling algorithm, which is basically operated with the Round Robin policy, many slots may be wasted by POLL or NULL packets when there is no data waiting for transmission in queues. To overcome this link wastage problem, several algorithms have been proposed. Among them, queue state-based priority policy and low power mode-based algorithm can perform with high throughput and reasonable fairness. However, their performances may depend on traffic characteristics, i.e., static or dynamic, and they require additional computational and signaling overheads. In order to tackle such problems, we propose a new scheduling algorithm. Performance of our proposed algorithm is evaluated with respect to throughput and delay. Simulation results show that overall performances can be improved by selecting suitable parameters of our algorithm.

• The KIPS Transactions:PartA
• /
• v.16A no.3
• /
• pp.189-198
• /
• 2009

The traditional interrupt-based protocol processing at end hosts has two priority-inversion problems. First, low-priority packets may interrupt and delay high-priority process executionssince interrupts have the highest priority in most operating systems. Second, low-priority packet may delay high priority packets when they arrive almost simultaneously since interrupt processing is performed in a FCFS (first come, first served) order. These problems can be solved by a priority-based protocol processing policy and implementation. However, general priority-based schemes commonly have the problem of starvation and cannot support the each network flow requiring the mutually exclusive QoS since the packets are processed in the FCFS order. Therefore, the priority-based schemes are not appropriate for different QoS-demanding applications. In this paper, we present a bottom-half-based approach that relies on priority- and budget-based processing. The proposed approach allows us to solve both the starvation and priority-inversion problems, and further enables effective QoS isolation between different network connections. This feature also enables bounding the protocol processing time at an end host. We finally show through experiments that the proposed approach achieves QoS isolation and control.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.1
• /
• pp.1-12
• /
• 2004

In this paper, we take advantage of the characteristics of optical burst switching (OBS) to support service-differentiation in optical networks. With the offset time between control packet and burst data, the proposed scheme uses different offset time of each service class. As contrasted with the Previous method, in which the high Priority service use only long offset time, it derives the burst loss rate as a QoS parameter in consideration of conservation law and given service-differential ratios and decides a reasonable offset time for this QoS finally Firstly proposed method classifies services into one of high or low class and is an algorithm deciding the offset time for supporting the required QoS of high class. In order to consider the multi-classes environment, we expand the analysis method of first algorithm and propose the second algorithm. It divides services into one of high or low group according to their burst loss rate and decides the offset time for high group, and lastly cumulates the offset time of each class. The proposed algorithms are evaluated through simulation. The result of simulation is compared with that of analysis to verify the proposed scheme.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.7
• /
• pp.741-753
• /
• 2008

This paper explores the throughput performance of CSMA/CA-based DCF protocol over both ideal channels and fading channels with payload size at the MAC layer in the 802.11a wireless LAN. In the ideal channel, there are no errors and at the transmission cycle there is one and only one active station which always has a packet to send and other stations can only accept packets and provide acknowledgements. In the fading channel, bit errors appear in the channel randomly and the number of stations is assumed to be fixed. And each station always has packets for transmission. In other words, we operate in saturation conditions. Up to now conventional research work about DCF throughput analysis of IEEE 802.11 a wireless LAN has been done over the ideal channel, but this paper is done over the Rayleigh/Ricean fading channel. So, the ratio of received average energy per bit-to-noise power spectral density $E_b/N_o$ is set to 25 dB and the ratio of direct-to-diffuse signal power in each sub-channel $\xi$ is set to 6 for combined Rayleigh/Ricean fading channel. In conclusion, it is shown that the saturation throughput is always less than the maximum throughput at all the payload size and the higher the transmission rate be, the higher the decreasing rate of saturation throughput compared to the maximum throughput be.

• Journal of KIISE:Information Networking
• /
• v.32 no.1
• /
• pp.20-28
• /
• 2005

TCP(Transmission Control Protocol) is one of the most important Internet protocols, which is widely used in wireless networks as well as wired networks. However, when TCP is deployed for wireless networks, it takes severe performance degradation because TCP was designed for wired network. To overcome this drawback, a number of TCP variants have been proposed in the literature. However, most previous schemes did not consider TCP enhancement over heterogeneous networks. In heterogeneous networks, an mobile node (MN) may move from one access network to another(i.e., vertical handover). In the case of vertical handover, an MN experiences a TCP performance degradation caused by the packet loss and the sudden change of link characteristics between two different access networks. In this work, we investigate the TCP performance degradation occurred in vortical handover across heterogeneous networks. First, we have conducted the measurement study over GPRS-WLAN testbed. In the measurement study. we observed the TCP performance degradation in the case of handover from WLAN to GPRS. In order to study more different TCP behaviors during vertical handover, we performed comprehensive simulations using a network simulator 2(ns-2). Based on measurement and simulation results, we investigated how to improve TCP performance in vertical handover and we concluded that the existing mechanisms cannot be perfect solutions and new mechanisms are strongly required.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.40 no.8
• /
• pp.1631-1636
• /
• 2015

With the advance of wireless communication technology in terrestrial area, underwater communication is also evolving very fast from a simple point-to-point transmission to an elaborate networked communications. Underwater acoustic channel has quite different features comparing with the terrestrial radio channel in terms of propagation delay, Doppler shift, multipath, and path loss. Thus, existing technologies developed for terrestrial communication might not work properly in underwater channel. Especially medium access control (MAC) protocols which highly depend on propagation phenomenon should be newly designed for underwater network. CSMA/CA has drawn lots of attention as a candidate of underwater MAC protocol, since it is able to resolve a packet collision and the hidden node problem. However, a received signal could be degraded by the interferences from the nodes locating outside the receiver's propagation radius. In this paper, we study the effects of interference on the CSMA/CA based underwater network. We derived the SNR with the interference using the sonar equation and analyzed the degradation of the RTS/CTS effects. These results are compared with the terrestrial results to understand the differences. Finally we summarized the design considerations in CSMA/CA based underwater network.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.407-408
• /
• 2011

Natural boron consists of two stable isotopes 10B and 11B with natural abundance of 18.8 atom percent of 10B and 81.2 atom percent of 11B. The thermal neutron absorption cross-section for 10B and 11B are 3837 barn and 0.005 barn respectively. 10B enriched specific compounds are used for control rods and as a reactor coolant additives. In this work 2 methods for boron enrichment were analysed: 1) Gas irradiation in static conditions. Dissociation occurs due to multiphoton absorption by specific isotopes in appropriately tuned laser field. IR shifted laser pulses are usually used in combination with increasing the laser intensity also improves selectivity up to some degree. In order to prevent recombination of dissociated molecules BCl3 is mixed with H2S 2) SILARC method. Advantages of this method: a) Gas cooling is helpful to split and shrink boron isotopes absorption bands. In order to achieve better selectivity BCl3 gas has to be substantially rarefied (~0.01%-5%) in mixture with carrier gas. b) Laser intensity is lower than in the first method. Some preliminary calculations of dissociation and recombination with carrier gas molecules energetics for both methods will be demonstrated Boron separation in SILARC method can be represented as multistage process: 1) Mixture of BCl3 with carrier gas is putted in reservoir 2) Gas overcooling due to expansion through Laval nozzle 3) IR multiphoton absorption by gas irradiated by specifically tuned laser field with subsequent gradual gas condensation in outlet chamber It is planned to develop software which includes these stages. This software will rely on the following available software based on quantum molecular dynamics in external quantized field: 1) WavePacket: Each particle is treated semiclassicaly based on Wigner transform method 2) Turbomole: It is based on local density methods like density of functional methods (DFT) and its improvement- coupled clusters approach (CC) to take into account quantum correlation. These models will be used to extract information concerning kinetic coefficients, and their dependence on applied external field. Information on radiative corrections to equation of state induced by laser field which take into account possible phase transition (or crossover?) can be also revealed. This mixed phase equation of state with quantum corrections will be further used in hydrodynamical simulations. Moreover results of these hydrodynamical simulations can be compared with results of CFD calculations. The first reasonable question to ask before starting the CFD simulations is whether turbulent effects are significant or not, and how to model turbulence? The questions of laser beam parameters and outlet chamber geometry which are most optimal to make all gas volume irradiated is also discussed. Relationship between enrichment factor and stagnation pressure and temperature based on experimental data is also reported.