• 한국재난정보학회 논문집
• /
• 제18권4호
• /
• pp.746-753
• /
• 2022

연구목적: 본 연구에서는 1960~70년대에 굴착한 식품 저장용 소규모 터널에 대한 안전성 검토와 소규모 터널의 안정성 향상을 위한 방안을 연구목적으로 한다. 연구방법:안전성 시험을 진행하고자 육안검사와 해머테스트를 이용하였으며, 육안검사는 비파괴검사에 실시되는 시험 중 하나이며, 해머테스트는 반발경도법의 타격법 종류 중의 하나이다. 연구결과:조사지역 자료를 통합 분석한 결과 대체로 외관상 양호한 상태를 보이나 파쇄대와 균열된 풍화대가 많으며 또한 작은 균열이 많고 지질 상태가 복잡하여 지속적인 관찰과 주의가 요구되며, 23개의 터널 중 7개는 안전진단이 필요하며, 1개는 붕괴상태, 1개는 안전하며, 14개는 지속적인 관찰과 주의가 필요하다. 결론: 수시로 소규모 터널의 모든 부분을 점검하고 기록으로 남겨야 하며, 본 연구에서 제안한 소규모 터널의 보강 진행시 안정성이 향상될 것으로 기대한다.

• 대한기계학회논문집B
• /
• 제21권10호
• /
• pp.1294-1302
• /
• 1997

For the purpose of investigating the impulsive noise at the exit of high-speed railway tunnel and the pressure transients inside the tunnel, experiments were carried out using a shock tube with an open end. A great deal of experimental data were obtained and explored to analyze the peak pressures and maximum pressure gradients in the pressure waves. The effects of the distance and cross-sectional area ratio between two-continuous tunnels on the characteristics of the pressure waves were investigated. The peak pressure inside the second tunnel decreases for the distance and cross-sectional area ratio between two tunnels to increase. Also the peak pressure and maximum pressure gradient of the pressure wave inside the second tunnel increase as the maximum pressure gradient of initial compression wave increases.

• 한국화재소방학회논문지
• /
• 제33권2호
• /
• pp.124-131
• /
• 2019

도로터널에서 화재가 발생하면 밀폐된 구조적 특성상 대형재난으로 발전할 가능성이 높기 때문에 각종 방재시설이 잘 설치되어 화재예방과 대응에 제 기능을 발휘해야 한다. 연속터널의 연장 및 방음터널을 고려하지 않아 필수 방재시설의 설치가 누락되어 법령의 개정이 필요한 것으로 판단된다. 이에 따라 본 논문에서 도로터널의 방재시설과 관련한 국내 법령들의 변천사항을 검토하고, 각 법령 간 비교분석을 통해 소방관계법령에서 개정이 필요한 부분을 연구한 결과는 다음과 같다. 첫째, 연속터널은 개별터널의 연장의 합을 고려하도록 하고 방음터널이 터널의 범주에 포함되도록 하여 필수 방재시설이 설치가 되지 않는 일이 없도록 해야 한다. 둘째, 터널 내 방재시설 설치의 법적 당위성 확보가 필요하므로 터널에 설치가 제외된 시설인 미분무소화설비, 비상방송설비, 유도등이 법령에 명시될 필요가 있다. 셋째, 현장대응의 입장에서 터널 내에 공기호흡기를 비치하도록 명시하여 소방대원들의 진압활동 및 인명구조에 크게 기여할 수 있도록 한다.

• Geomechanics and Engineering
• /
• 제6권3호
• /
• pp.263-275
• /
• 2014

The development of transportation in large cities requires the construction of twin tunnels located at shallow depth. As far as twin tunnels excavated in parallel are concerned, most of the cases reported in literature focused on considering the effect of the ground condition, tunnel size, depth, surface loads, the relative position between two tunnels, and construction process on the structural lining forces. However, the effect of the segment joints was not taken into account. Numerical investigation performed in this study using the $FLAC^{3D}$ finite difference element program made it possible to include considerable influences of the segment joints and tunnel distance on the structural lining forces induced in twin tunnels. The structural lining forces induced in the first tunnel through various phases are considerably affected by the second tunnel construction process. Their values induced in a segmental lining are always lower than those obtained in a continuous lining. However, the influence of joint distribution in the second tunnel on the structural forces induced in the first tunnel is insignificant. The critical influence distance between two tunnels is about two tunnel diameters.

• Earthquakes and Structures
• /
• 제5권2호
• /
• pp.161-205
• /
• 2013

We study seismically induced, anti-plane strain wave motion in a non-homogeneous geological region containing tunnels. Two different scenarios are considered: (a) The first models two tunnels in a finite geological region embedded within a laterally inhomogeneous, layered geological profile containing a seismic source. For this case, labelled as the first boundary-value problem (BVP 1), an efficient hybrid technique comprising the finite difference method (FDM) and the boundary element method (BEM) is developed and applied. Since the later method is based on the frequency-dependent fundamental solution of elastodynamics, the hybrid technique is defined in the frequency domain. Then, an inverse fast Fourier transformation (FFT) is used to recover time histories; (b) The second models a finite region with two tunnels, is embedded in a homogeneous half-plane, and is subjected to incident, time-harmonic SH-waves. This case, labelled as the second boundary-value problem (BVP 2), considers complex soil properties such as anisotropy, continuous inhomogeneity and poroelasticity. The computational approach is now the BEM alone, since solution of the surrounding half plane by the FDM is unnecessary. In sum, the hybrid FDM-BEM technique is able to quantify dependence of the signals that develop at the free surface to the following key parameters: seismic source properties and heterogeneous structure of the wave path (the FDM component) and near-surface geological deposits containing discontinuities in the form of tunnels (the BEM component). Finally, the hybrid technique is used for evaluating the seismic wave field that develops within a key geological cross-section of the Metro construction project in Thessaloniki, Greece, which includes the important Roman-era historical monument of Rotunda dating from the 3rd century A.D.

• 한국화재소방학회논문지
• /
• 제25권5호
• /
• pp.119-127
• /
• 2011

70년대 이후 고속도로의 건설이 급격히 확대하고 있으며, 국토의 70 %가 산악지역인 국내의 지리적 여건상 반드시 터널의 건설이 포함된다. 현재는 607개의 고속도로 터널이 설치, 운영되고 있으며, 향후 2015년까지 440여개를 추가로 건설할 계이다. 이중 1,000 m 이상의 장대터널도 256개소로 대폭 증가될 예정이다. 고속도로 터널은 반밀폐 지하공간으로 차량운전자의 각별한 주의 또한 요구되고 있으나 터널내 과속통제시스템이 없어 추돌 또는 충돌로 인한 차량화재 사례가 급격히 증가하고 있는 추세다. 도로터널내 대형차량화재의 원인을 살펴보면 주로 과속에 의한 전방추돌에 의한 차량화재의 확률이 높다. 추돌사건을 줄이기 위해 터널 및 교량에 과속방지단속 시스템을 설치하여 원천적으로 운전자의 과속 등 이용자 측면의 주의를 고양시킬 경우 대형재난으로 이어질 수 있는 차량화재를 방지할 수 있다는 사실이 입증됨에 따라 향후 위험도가 높은 1,000 m 이상의 장대터널 내에서의 화재사고 등 재난예방을 위해 구간과속 단속시스템 설치를 법적인 시설로 포함하여 재형재난을 방지할 수 있다.

• Geomechanics and Engineering
• /
• 제28권4호
• /
• pp.421-435
• /
• 2022

The necessity of estimating the time and cost required for tunnel construction has led to extensive research in this regard. Since geological conditions are significant factors in terms of time and cost of road tunnels, considering these conditions is crucial. Uncertainties about the geological conditions of a tunnel alignment cause difficulties in planning ahead of the required construction time and costs. In this paper, the continuous-space, discrete-state Markov process has been used to predict geological conditions. The Monte-Carlo (MC) simulation (MCS) method is employed to estimate the construction time and costs of a road tunnel project using the input data obtained from six tunneling expert questionnaires. In the first case, the input data obtained from each expert are individually considered and in the second case, they are simultaneously considered. Finally, a comparison of these two modes based on the technique presented in this article suggests considering views of several experts simultaneously to reduce uncertainties and ensure the results obtained for geological conditions and the construction time and costs.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2004년도 춘계학술대회 논문집
• /
• pp.1168-1173
• /
• 2004

Bridges and tunnels mainly compose the structural system of Kyung-bu high-speed railway in Korea and the prestressed concrete box girder bridges are applied for the most part of bridge structures. Precast full span construction method was practiced in the construction of many prestressed concrete box girder bridges in Kyung-bu high speed railway for the high quality, great construction speed, low construction cost and construction safety. However, there have been no application of this method in continuous bridges until now. Therefore, a new advanced precast full span construction method is developed using pre-tensioning for precast and post-tensioning in alternating the simple span into a continuous bridge system. since the high-speed railway trains can cause dynamic problems in a continuous bridge. This study shows the structural behavior and the construction process of the new advance method.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2001년도 춘계학술대회 논문집
• /
• pp.401-407
• /
• 2001

Out of 412km long Kyung-bu high-speed railway, 302km was designed in tile form of either bridges or tunnels. Most of bridges were designed to be prestressed concrete box girder type. The precast span method was selected because of good quality of bridge section secured by factory manufacturing, fast construction speed, low construction cost with mechanized construction and the safety fur field workers. The precast span method has been mainly utilized in bridges consisted of repeated simple spans. However, we applied the precast span method to continuous bridge for high-speed railway Since it was the first attempt to apply ate precast span method to a continuous bridge for high-speed railway, many design and construction details were studied and implemented in the construction. Design and construction processes of a continuous bridge construction using tile precast span mettled are briefly described in this paper.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 1994년도 가을 학술발표회 논문집
• /
• pp.231-234
• /
• 1994

Concentrated stresses due to the tunnel excavation easily cause failure around opening in the soft rock mass layer. Thus, while excavatng tunnel in the soft rock mass layerm it is very important to predict the possibility of failure or yielding zones around tunnel boundary. There are two typical methods to predict these; 1) the analysis of field monioring data and 2) numerical analysis. In this study, it was attempted to describe the time-dependent or progressive rock mass manner due to the continuous failure and fracturing caused by surrounding underground openings using the second method. In order to apply the effects of progressive failure underground, an iterative technique was used with the Hoek and Brown rock mass failure theory. By developing and simulating, three different shapes of twin tunnels, this research simulated and estimated the proper size of critical pillar width between tunnels, distributed stresses on the tunnel sides, and convergences of tunnel crowns. Moreover, results out progressive failure technique based on the Hoek and Brown theory were compared with the results out of Mohr-Coulomb theory.