• Journal of Power Electronics
• /
• 제16권3호
• /
• pp.894-904
• /
• 2016

This study examines the zero-voltage switching (ZVS) operation of an active-clamped forward converter (ACFC) with a current-doubler rectifier (CDR). The ZVS condition can be obtained with a much smaller leakage inductance compared to that of a conventional ACFC. Due to the significantly reduced leakage inductance, the design is optimized and the circulating loss is reduced. The operation of the ACFC with a CDR is analyzed, and a detailed ZVS analysis is conducted on the basis of a steady-state analysis. From the results, a design consideration for ZVS improvement is presented. Loss analyses of the converters shows that enhanced soft-switching contributes to an efficiency improvement under light-load condition. Experimental results from a 100-W (5-V/20-A) prototype verify that the ACFC with a CDR can attain ZVS across an extended load range of loads and achieve a higher efficiency than conventional ACFCs.

• 한국전자통신학회논문지
• /
• 제13권4호
• /
• pp.875-880
• /
• 2018

4차 산업혁명 이후, 전 세계적으로 소프트웨어가 산업과 사회 전반에 접목되어 새로운 가치를 창출하는 소프트웨어 혁명이 진행 중이다. 이를 대비하여 선진국들은 기존 컴퓨터 활용 중심에서 컴퓨터 과학 기본 원리와 코딩을 포함하는 소프트웨어 교육을 실시한다. 본 논문에서는 드론을 활용한 블록 프로그램을 제안한다. 이를 통하여 창의융합교육과 연계하여 창의력 사고 및 문제해결능력 신장을 위한 다양한 교육이 가능하다.

• Journal of Electrical Engineering and Technology
• /
• 제13권4호
• /
• pp.1407-1418
• /
• 2018

Novel mechanism of customized adequacy formulation is proposed in order to enhance micro grids system reliability. The mechanism accounts for 2-levles of load curtailment, and is mainly based on probabilistic load profile and hybrid Distributed Generation (DG) units modeling. The two load curtailments are needed in order to ensure adequate technical constraints at steady state condition during islanding mode of operation. The effectiveness of the proposed formulation has been verified using system independent analytical expressions for the evaluation of both reliability and Expected Energy Not Served (EENS) indices. The evaluation has examined the impact of different penetration levels of Hybrid DG Units in case study islands. Results show the enhancement of the overall distribution system reliability and the recommended conditions for successful islanding mode of operation.

• Journal of Power Electronics
• /
• 제10권4호
• /
• pp.396-404
• /
• 2010

This paper presents simple schemes used to estimate the initial rotor position and the d- and q-axis inductances for effective Maximum Torque per Ampere (MTPA) operation in a wind-power system using an IPMSM (Interior Permanent Magnet Synchronous Machine). An IPMSM essentially requires an exact coordinate transformation and accurate inductance values to use a reluctance torque caused by the saliency characteristic. In the proposed high-frequency voltage testing method, there is no voltage drop caused by the resistance and the electromotive force. The initial rotor position and the inductance can be measured through an analysis of the stator current without turning the rotor. The experimental results are presented in order to illustrate the feasibility of the proposed method.

• Journal of the Optical Society of Korea
• /
• 제6권2호
• /
• pp.27-32
• /
• 2002

An integrated optical 2$\times$2 add/drop multiplexer in X-cut, Y-propagating LiNbO$_3$ has been demonstrated. The device consists of passive polarization splitters and acousto-optical mode converters with weighted coupling utilizing tapered acoustical directional couplers; their specific design and properties are discussed. The insertion loss has been measured to be about -8.16 ㏈ and -8.6 ㏈ for TE and TM polarizations, respectively. The device shows a 3 ㏈ bandwidth of 2.3 nm, a tuning rate 8.34 nm/MHz around λ = 1554 nm, and a sidelobe suppression of about 14.5 ㏈. Optimum operation is achieved with a RF drive power of about 43 ㎽. Multi-wavelength operation has been demonstrated.

• 한국멀티미디어학회논문지
• /
• 제20권5호
• /
• pp.740-747
• /
• 2017

A fast cell contour extraction method using CUDA parallel processing technique is presented. The cell contour extraction is one of important processes to analyze cell information in pathology. However, conventional sequential contour extraction methods are slow for a huge high-resolution medical image, so they are not adequate to use in the field. We developed a parallel morphology operation algorithm to extract cell contour more quickly. The algorithm can create an inner contour and fail to extract the contour from the concave part of the cell. We solved these problems by subdividing the contour extraction process into four steps: morphology operation, labeling, positioning and contour extraction. Experimental results show that the proposed method is four times faster than the conventional one.

• 한국컴퓨터정보학회논문지
• /
• 제24권1호
• /
• pp.129-135
• /
• 2019

This paper is part of research and development for stand-alone solar system without commercial power supply. It implements firmware of controller for operation of stand-alone solar system by applying IoT technology and also develops communication modules that allow multiple solar lamps to send and receive data through wireless network. The controller of the developed stand-alone solar system can effectively charge the power generated by the solar module, taking into account the battery's charge and discharge characteristics. It also has the advantage of attaching wireless communication modules to solar lamp posts to establish wireless communication networks without incurring communication costs. In addition, by establishing IoT gateway middleware platform for each installation site, it forms a foundation to operate multiple solar lamp posts into multiple clusters. And, it is expected that the data collected in each cluster will be used to enable configuration and control of operational information, thereby inducing convenience and efficiency of remote operation and management.

• 한국컴퓨터정보학회논문지
• /
• 제21권5호
• /
• pp.1-10
• /
• 2016

Magnetic disks have been used for decades in auxiliary storage devices of computer systems. In recent years, the use of NAND flash memory, which is called SSD, is increased as auxiliary storage devices. However, NAND flash memory, unlike traditional magnetic disks, necessarily performs the erase operation before the write operation in order to overwrite data and this leads to degrade the system lifetime and performance of overall NAND flash memory system. Moreover, NAND flash memory has the lower endurance, compared to traditional magnetic disks. To overcome this problem, this paper proposes EPET (Enhanced Prediction and Elapsed Time) wear leveling technique, which is especially efficient to portable devices. EPET wear leveling uses the advantage of PET (Prediction of Elapsed Time) wear leveling and solves long-term system failure time problem. Moreover, EPET wear leveling further improves space efficiency. In our experiments, EPET wear leveling prolonged the first bad time up to 328.9% and prolonged the system lifetime up to 305.9%, compared to other techniques.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제17권4호
• /
• pp.524-533
• /
• 2017

This paper presents a novel reset scheme for mm-scale sensing systems with stringent volume and area constraints. In such systems, multi-layer structure is required to maximize the silicon area per volume and minimize the system size. The multi-layer structure requires wirebonding connections for power delivery and communication among layers, but the area overhead for wirebonding pads can be significant. The proposed reset scheme exploits already existing power wires and thus does not require additional wires for system-wide reset operation. To implement the proposed reset scheme, a power management unit is designed to impose reset condition, and a reset detector is designed to interpret the reset condition indicated by the power wires. The reset detector uses a coupling capacitor for the initial power-up and a feedback path to hold the developed supply voltage. The prototype reset detector is fabricated in a $180-{\mu}m$ CMOS process, and the measurement results with the prototype mm-scale system confirmed robust reset operation over a wide range of temperatures and voltages.

• 한국정보디스플레이학회:학술대회논문집
• /
• 한국정보디스플레이학회 2006년도 6th International Meeting on Information Display
• /
• pp.1038-1041
• /
• 2006

We report low operating voltage and long lifetime organic light-emitting diodes (OLEDs) with a vanadium oxide $(V_2O_5)-doped$ N,N'-di(1-naphthyl)- N,N'-diphenylbenzidine $({\alpha}-NPD)$ layer between indium tin oxide and ${\alpha}-NPD$. At a luminance of $1000\;cd/m^2$, $V_2O_5$ doped ${\alpha}-NPD$ device shows a operation voltage of 5.1V, while the device without $V_2O_5$ shows 5.8V. The $V_2O_5$ doped $({\alpha}-NPD)$ device also shows a longer lifetime and smaller operation voltage variation over time. It is suggested that the improved device performance can be attributed to the higher hole-injection efficiency and stability of the $V_2O_5$ doped $({\alpha}-NPD)$ layer.