• 한국정보디스플레이학회:학술대회논문집
• /
• 2000.01a
• /
• pp.47-48
• /
• 2000

Parameters of a biaxial compensation film and a liquid crystal cell for the optically compensated bend mode LCD with wide viewing angle were optimized. For practical approach, we calculated the optical refractive indices of a retardation film when thickness of a retardation film was fixed at 50 ${\mu}m$. Furthermore, we also optimized optical parameters of LC cell when parameters of a retardation film were different with designed values, because the biaxial compensation film with exact designed values was very difficult to fabricate. In experiments, we achieved the wide viewing angle of over the ${\pm}$ 60 degrees by using a biaxial compensation film with a practical thickness value.

• Journal of Electrical Engineering and information Science
• /
• v.2 no.4
• /
• pp.46-52
• /
• 1997

In this paper th use of compensation based on a combination of active plus reactive power at distribution model system is proposed. The basic voltage-power relationships for the linearized case on an infinite bus are used and the compensation angle is defined based on the voltage magnitude response to small power injection. Compensation is supplied at several locations, and the system is subjected to varying fault scenarios, with its response observed under different system conditions. As number of control issues for a storage-based active/reactive power compensator as a bus voltage regulator are explored to compare the effectiveness of active/reactive again reactive-only compensation.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.16 no.3
• /
• pp.365-372
• /
• 2013

The multibeam surveillance radar is a state-of-art of 3D radar technology. It applies the stacked beams realized by a digital beamformer. In this paper, a hybrid compensation technique on elevation angle errors for low elevation angle targets over the sea in multipath radar environments is proposed. The proposed method can be applied to stacked beam radars. Double null algorithm based on maximum likelihood method in 3-D beamspace domain works well unless the phase difference between the two rays(direct and specular path) is close to $0^{\circ}$ and the magnitude of reflection coefficient is close to 0. To overcome these problems, we propose a hybrid compensation technique which uses the selective double null algorithm and the beam-ratio compensation technique for low-elevation errors on a log scale. Results of computer simulation show that the proposed method outperform conventional monopulse method and double null algorithm only under various multipath environments.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.58 no.8
• /
• pp.1526-1531
• /
• 2009

In this paper, for the first time a new type of narrow-range angle sensor based on inductive effect is introduced and studied. A prototype steering angle sensor is also designed and fabricated to compare the characteristics of the four methods from the viewpoints of sensitivity, linearity and resolution, angle range of the sensor output. This sensor is designed to be sensitive to very small resolution in angle with detected range is scaled down to about 12bit. An intensive investigation has been carried out to study the behaviors of the sensor and optimize its performance by signal compensation. These behaviors are discussed and explained using an analytical and experimental testings. Moreover, Application possibility of the sensor are proposed and a demo device based on the sensor is presented.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.13 no.10
• /
• pp.883-886
• /
• 2000

We have developed a novel vertical-alignment(VA) - 1/6$\pi$ mode that provides a wide viewing angle for nematic liquid crystal (NLC) with negative dielectric anisotropy on a homeotropic polyimide (PI) surfaces. Good voltage-transmittance curves were achieved with the new VA - 1/6$\pi$ cell model without a negative compensation film. The viewing angle of a new VA -1/6$\pi$ cell without a negative compensation film was wider than that of a conventional VA cell. Finally, the wide viewing angle using the new VA-1/6$\pi$ cell mode can be achieved.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1999.11a
• /
• pp.549-552
• /
• 1999

We have developed an novel vertical-alignment (VA) - $\pi$ cell mode that provides a wide viewing angle and fast response times for negative dielectric anisotropy nematic liquid crystal (NLC) on a homeotropic polyimide (PI) surfaces. We had the good voltage-transmittance curves and low driving voltages were achieved with the novel VA - $\pi$ cell mode without negative compensation film. Iso-viewing angle characteristics using the novel VA - $\pi$ cell mode without negative compensation film of NLC was also successfully observed. As well a fast response time of 31.7ms for the novel VA - $\pi$ cell mode was measured. Consequently, It is seen that by using the novel VA - $\pi$ cell mode the iso-viewing angle, fast response time, and low driving voltage characteristics can be achieved.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.25 no.3
• /
• pp.209-212
• /
• 2012

In this paper, we have studied on the optimal design of the optical compensation film for the TN-LCDs. To have wide viewing angle panels, several methods such as multi-domain method, optical path method, and phase compensation method have been proposed. Among these methods, this paper focused on the phase compensation method. In the phase compensation method, the phase retardation generated from the optical birefringence for the off-axis incident is compensated by using optical films with refractive anisotropy. To compensate the phase retardation of the TN-LCDs, we have proposed design concept for the biaxial optical films and analyzed the optical performance for the proposed structures. The calculation of the dynamic motion of the liquid crystals was based on the Ericksen-Leslie theory and the optical performance of the TN-LCD was calculated from the Extended Jones Matrix Method. From the results, we have confirmed that the optical characteristics of the TN-LCDs with the biaxial films have been improved considerably compared with the TN-LCDs compensated by the combination of the uniaxial films.

• Journal of Korean Society for Quality Management
• /
• v.41 no.3
• /
• pp.405-412
• /
• 2013

Purpose: In this paper, the improvement of the image quality is investigated. The image quality is degraded by the drift phenomenon of EO/IR (Electro-Optical/Infrared) device on UAV. The drift phenomenon means that the image of EO/IR equipment on UAV(Unmanned Aerial Vehicle) moves to the unintended direction. This phenomenon should be improved for successful flight mission. Methods: To improve the drift phenomenon, the drift compensation method, the combination algorithm of FMC(Forward Motion Compensation) and AMC(Angular Motion Compensation) method, are introduced to calculate pitch and azimuth angle. Result values of pitch and azimuth angle are used for the improvement of image quality in EO/IR control logic. Results: The image quality is quantitatively improved more than 15 times through field test data of flight. Conclusion: Using the drift compensation technique, the image quality for EO/IR equipment is improved over 15 times than existing methods. This means the user of UAV with EO/IR device can perform a successful mission by keeping the line of sight for the target accurately.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.25 no.1
• /
• pp.1-6
• /
• 2015

In this paper, a fuzzy control method is used for balancing a single-wheel robot. A single-wheel robot controlled by the PD control method becomes easily unstable since the flywheel tends to lean against one direction. In the previous research, we have used the gain scheduling method. To remedy this problem, in this paper, a fuzzy compensation technique is proposed to compensate for the balancing angle. The fuzzy control method compensates offset values at the balancing angle to prevent the gimbal from falling against one direction. Experimental studies of the balancing control performance of a single-wheel mobile robot validate the proposed control method.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.21 no.1
• /
• pp.155-162
• /
• 2020

In this paper, we present a radiation compensation method and experiment method for two-dimensional direction finding by elevation and azimuth angles of broadband GPS signal, and then produce experimental results. Previous studies have performed direction finding by only using the azimuth angle of the detected signal. So, the compensation table utilizes compensation data by azimuth angles only. However, the presented method in this study has compensation data by azimuth and elevation angles for two-dimensional direction finding. Because of direction finding systems and applications are diversified, recently. So, we present a two-dimensional radiation compensation method. For evaluation of the presented compensation method, we calculate the ideal phase differences on the antenna for two-dimensional direction finding and simulate phase differences using a FEKO EM simulator. Subsequently, we analyze experimental data by radiation compensation experiments using the presented compensation method in an anechoic chamber.