• Korean Chemical Engineering Research
• /
• v.47 no.6
• /
• pp.734-739
• /
• 2009

Characteristics of pyrolysis, partial oxidation, combustion of chlorella, which is one species of micro-algae, were determined by using thermobalance reactor(I.D. 5.5 cm, Height 1 m). Effect of reaction temperature($500{\sim}800^{\circ}C$), water content in chlorella(0~60%), and oxygen content(0~21vol%) on thermal decomposition of chlorella were also determined and analyzed to investigate the kinetic characteristics of pyrolysis, partial oxidation and combustion. As the temperature and partial pressure increases, the carbon conversion increases. In case of pyrolysis, carbon conversion and reactivity sharply decreased with increasing moisture content. However, carbon conversion and reactivity decreased at 60% water content in case of partial oxidation and combustion. As reaction temperature and oxygen content increased, carbon conversion increased and the combustion reaction rate equation for chlorella has been presented. $\frac{dX}{dt}=(7.41{\times}10^{-1})$exp$\left(-\frac{19600}{RT}\right)(P_{O_{2}})^{0.209}(1-X)^{2/3}$.

• Transactions of the Korean hydrogen and new energy society
• /
• v.20 no.3
• /
• pp.245-255
• /
• 2009

Effect of CO$_2$ concentration on reduction reactivity of oxygen carrier particles for chemical-looping combustor were investigated. Four particles, NiO/bentonite, OCN601-650, OCN702-1100, OCN702-1250, were used as oxygen carrier particles and two kinds of gases (CH$_4$, 5%, N$_2$ balance and CH$_4$ 5%, CO$_2$ balance) were used as reactants for reduction. For all oxygen carrier particles, higher maximum conversion, reduction rate, oxygen transfer capacity, and oxygen transfer rate were achieved when we used N$_2$ balance gas. OCN601-650 particle showed higher oxygen transfer rate for all gases than other particles, and therefore we selected OCN601-650 particle as the best candidate. For all particles, lower carbon depositions were observed when we used CO$_2$ balance gas.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.10 no.3
• /
• pp.93-100
• /
• 2002

For natural gas and LPG fuel, measurements on the concentrations of individual exhaust hydrocarbon species have been made as a function of air-fuel ratio in a 2-liter four-cylinder engine using a gas chromatography. NMHC in addition to the species of HC, other emissions such as CO$_2$, CO and NOx were examined for natural gas and LPG at 1800rpm far two compression ratios (8.6 and 10.6). Fuel conversion efficiencies were also investigated together with emissions to study the effect of engine parameters on the combustion performances in gas engines especially under the lean bum conditions. It was found that CO$_2$ emission decreased with smaller C value of fuel, leaner mixture strength and the higher compression ratio. HC emissions from LPG engine consisted primarily of propane (larger 60%), ethylene and propylene, while main emissions from natural gas were mothane (larger than 60%), ethane, ethylene and propane on the average. The natural gas was proved to give the less ozone formation than LPG fuel. This was accomplished by reducing the emissions of propylene, which has relatively high MIR factor, and propane that originally has large portion of LPG. In addition, natural gas shows a benefit in other emissions (i.e. NMHC,NOx, CO$_2$and CO), SR and BSR values except fuel conversion efficiency.

• Nuclear Engineering and Technology
• /
• v.52 no.2
• /
• pp.238-247
• /
• 2020

The Burnable Poison (BP) is very important for all Light Water Reactors in order to hold-down the initial excess reactivity and to control power peaking. The use of BP is even more essential as the excess reactivity increases significantly with a longer operation cycle. In this paper a feasibility study was conducted in order to investigate the benefits of a new combinational BP concept designed for 24-month cycle PWR core. The reference designs in this study are based on the two Korean fuel assemblies; 17 × 17 Westinghouse (WH) design and 16 × 16 Combustion Engineering (CE) design. A modification was done on these two designs to extend their cycle length from 18 months into 24 months. DeCART2D-MASTER code system was used to perform assembly and core calculations for both designs. A preliminary test was conducted in order to choose the best BP suitable for 24-month as a representative for single BP concept. The comparison between the results of two concepts (combinational BP concept and single BP concept) showed that the combinational BP concept can replace the single BP concept with better performance on holding down the initial excess reactivity without violating the design limitations.

• Journal of the Korean Society of Combustion
• /
• v.21 no.2
• /
• pp.22-28
• /
• 2016

High efficient and environment friendly combustion technologies are used to be operated an extreme condition, which results in unintended flame instability such as extinction and oscillation. The use of electromagnetic energy is one of methods to enhance the combustion stability and a microwave as electromagnetic wave is receiving increased attention recently because of its high performance and low-cost system. In this study, an experiment was performed with jet diffusion flames induced by microwave. Micro jet was introduced to simulate the high velocity of industrial combustor. The results show that micro jet flames had three different modes with increasing oxidizer velocity; attached yellow flame, lifted flame, and lifted partially premixed flame. As a microwave was induced to flames, the overall flame stability and blowout limit were extended with the higher microwave power. Especially the interaction between a flame and a microwave was shown clearly in the partially premixed flame, in which the lift-off height decreased and NOx emission measured in post flame region increased with increasing microwave power. It might be attributed to increase of reactivity due to the abundance of radical pool and the enhanced absorption to thermal energy.

• Transactions of the Korean hydrogen and new energy society
• /
• v.33 no.1
• /
• pp.77-84
• /
• 2022

The experimental work has been carried out for the study of pyrolysis of oil samples used in industrial and utility boilers in Korea. For five oil samples, the characteristics of pyrolysis have been investigated with a thermogravimetric analyzer (TGA), and their kinetic parameters were obtained and compared each other. The rate order of pyrolysis rate for five oils were as follows: by-product fuel oil, pyrolysis oil, diesel, a heavy oil and refined oil. The pyrolysis of refined oil has been successfully described by the three step, first order reaction model while the single step reaction model has been used for other oils. For the reaction temperature over 550 K, the reactivity of refined oil was very poor compared with other oils.

• Journal of Energy Engineering
• /
• v.17 no.3
• /
• pp.153-160
• /
• 2008

The combustion behaviors of the blends of Korean anthracite, bituminous coal and their blends were studied with a thermogravimetric analyzer. Concerning the burning profiles of the anthracite-bituminous coal blends in TGA, it has been observed the independent burning of two coals without any interaction between two coals. With the blends of 50% anthracite with 50% bituminous coal in weight basis, the combustion tests in a utility boiler have been carried out for the analysis of the combustion and operational characteristics by increasing the power output from 134 MW to 197 MW. The stable combustion has been observed in a boiler. With the increase of power output, the exhaust gas temperature was exceeded the design value of $430^{\circ}C$, so the combustion air was taken from atmosphere instead of the boiler penthouse.

• Journal of the Korean Institute of Gas
• /
• v.26 no.3
• /
• pp.45-53
• /
• 2022

In order to improve the emission of diesel engines, natural gas-diesel dual fuel combustion compression ignition engines are in the spotlight. In particular, a reactivity controlled compression ignition (RCCI) combustion strategy is investigated comprehensively due to its possibility to improve both efficiency and emissions. With advanced diesel direct injection timing earlier than TDC, it achieves spontaneous reaction with overall lean mixture from a homogeneous mixture in the entire cylinder area, reducing nitrogen oxides (NOx) and particulate matter (PM) and improving braking heat efficiency at the same time. However, there is a disadvantage in that the amount of incomplete combustion increases in a low load region with a relatively small amount of fuel-air. To solve this, sensitive control according to the diesel injection timing and fuel ratio is required. In this study, experiments were conducted to improve efficiency and exhaust emissions of the natural gas-diesel dual fuel engine at low load, and evaluate combustion stability according to the diesel injection timing at the operation point for power generation. A 6 L-class commercial diesel engine was used for the experiment which was conducted under a 50% load range (~50 kW) at 1,800 rpm. Two injectors with different spray patterns were applied to the experiment, and the fraction of natural gas and diesel injection timing were selected as main parameters. Based on the experimental results, it was confirmed that the brake thermal efficiency increased by up to 1.3%p in the modified injector with the narrow-angle injection added. In addition, the spray pattern of the modified injector was suitable for premixed combustion, increasing operable range in consideration of combustion instability, torque reduction, and emissions level under Tier-V level (0.4 g/kWh for NOx).

• Proceedings of the Korea Society for Energy Engineering kosee Conference
• /
• 1998.10a
• /
• pp.115-120
• /
• 1998

• Proceedings of the Korea Society for Energy Engineering kosee Conference
• /
• 2003.05a
• /
• pp.621-625
• /
• 2003

최근 지구온난화 문제와 관련하여 국제적으로 이슈가 되고 있는 $CO_2$ 저감 및 처리기술 중에서 연소 후 처리가 아닌 신개념 연소기술로서 NO$_{x}$가 배출되지 않고 $CO_2$의 고농도 원천분리가 가능하여 새로운 연소 및 발전기술로 부상하고 있는 매체순환식 가스연소기술(Chemical-Looping Combustion Technology, CLC)에 대한 연구가 국내외적으로 활발하게 진행되고 있다.(중략)