• Journal of electromagnetic engineering and science
• /
• v.7 no.2
• /
• pp.64-68
• /
• 2007

An InGaP/GaAs HBT based differential Colpitts voltage control oscillator(VCO) is presented in this paper. In the VCO core, two switching transistors are introduced to steer the core bias current to save power. An LC tank with an inductor quality factor(Q) of 11.4 is used to generate oscillation frequency. It has a superior phase noise characteristics of -130.12 dBc/Hz and -105.3 at 1 MHz and 100 kHz frequency offsets respectively from the carrier frequency(1.566 GHz) when supplied with a control voltage of 0 volt. It dissipates output power of -5.3 dBm. Two pairs of on-chip base collector (BC) diodes are used in the tank circuit to increase the VCO tuning range(168 MHz). This VCO occupies the area of $1.070{\times}0.90mm^2$ including buffer and pads.

• Journal of IKEEE
• /
• v.18 no.4
• /
• pp.625-629
• /
• 2014

This study derives the asymptotic phase noise formula of the oscillators perturbed by the colored noises. Based on the derived formula, this study presents a sub-1V series-tuned differential Colpitts VCO. The ADS simulation result on the phase noise shows that the presented VCO exhibits about 3dBc/Hz lower phase noise at the 1MHz offset frequency from the oscillation frequency of 4.8GHz than the existing series-tuned differential Colpitts VCO with the inductor current sources.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.8
• /
• pp.964-969
• /
• 2007

A regulated low phase noise differential colpitts VCO(Voltage Controlled Oscillator) for mobile RFID system is presented. The differential colpitts VCO meets the dense reader environment specifications. The VCO use a $0.35{\mu}m$ technology and achieves tuning range $1.55{sim}2.053 GHz$. Measuring 910 MHz frequency divider output, phase noise performance is -106 dBcMz and -135dBc/Hz at 40 kHz and 1MHz offset, respectively. 5-bit digital coarse-tuning and accumulation type MOS varactors allow for 28.2% tuning range, which is required to cover the LO frequency range of a UHF Mobile RFID system, Optimum design techniques ensure low VCO gain(<45 MHz/V) for good interoperability with the frequency synthesizer. To the author' knowledge, this differential colpitts VCO achieves a figure of merit(FOM) of 1.93dB at 2-GHz band.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.4 no.2 s.7
• /
• pp.73-79
• /
• 2005

Various CMOS quadrature-voltage-controlled oscillators(QVCOS) are designed and fabricated for the comparison of the phase noise characteristic. The first one is that the QVCO is composed of two Colpitts oscillators cross-coupled with PMOS coupling transistors. The second and third ones are the conventional LC VCO and the balanced Colpitts VCO followed by the frequency-divide-by-two, respectively. The simulation result demonstrate that Colpitts schemes show better phase noise performance by 6 dB than that of a conventional stheme in which LC VCO is followed by the frequency-divide-by-two.

• Journal of IKEEE
• /
• v.11 no.3
• /
• pp.122-128
• /
• 2007

Sinusoidal voltage-controlled oscillators (VCOs) based on Colpitts and Hartley oscillators are presented. They consist of a LC parallel-tuned circuit connected in a negative-feedback loop with an OTA-R amplifier and two diode limiters, where the inductor is simulated one realized with temperature-stable linear operational transconductance amplifiers (OTAs) and a grounded capacitor. Prototype VCOs are built with discrete components. The Colpitts VCO exhibits less than 1% nonlinearity in its current-to-frequency transfer characteristic from 4.2 to 21.7 MHz and ${\pm}$95 ppm/$^{\circ}C$ temperature drift of frequency over 0 to $70^{\circ}C$. The total harmonic distortion (THD) is as low as 2.92% with a peak-to-peak amplitude of 0.7 V for a frequency-tuning range of 10.8-32 MHz. The Hartley VCO has the temperature drift and THD of two times higher than those of the Colpitts VCO.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.9 no.7
• /
• pp.761-766
• /
• 2014

This study performs the analytical investigation of the oscillation voltages at the tanks of the series tuned varactor incorporating balanced common-drain, and common-gate Colpitts VCO which are able to work even at the sub-1V power supply voltages. The results the investigation predicts is verified by the simulation on the circuit behaviors of the two VCOs. The analytical investigation finds that the series tuned varactor incorporating balanced common-gate VCO generates greater oscillation voltage at the tank than the series tuned varactor incorporating balanced common-drain VCO does, which in turn is more suitable for generating the low phase noise oscillation signal from the sub-1V supply voltage than the series tuned varactor incorporating balanced common-drain VCO.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.6 no.1
• /
• pp.7-12
• /
• 2011

This paper proposes a differential Colpitts-VCO circuit suitable for low phase noise oscillation at the sub-1V supply voltage. Oscillation with low phase noise at the sub-1V supply voltage is facilitated by employing inductors as the current sources of the proposed circuit. One of the two feedback capacitors of the single-ended Colpitts oscillator in the proposed circuit is replaced with the MOS varactor in order to further reduce the resonator loss. Post-layout simulation results using a $0.18{\mu}m$ RF CMOS technology show that the phase noises at the 1MHz offset frequency of the proposed circuit oscillating at the sub-1V supply voltages of 0.6 to 0.9 V are at least 7 dBc/Hz lower than those of the well-known cross-coupled differential VCO.

• Journal of the Korea Society of Computer and Information
• /
• v.7 no.3
• /
• pp.109-114
• /
• 2002

This thesis analysed the characteristics of the performance degradation due to the bias resistance on the existing Colpitts VCO and Proposed the new structure of bias which removed the effect of bias resister to degrade the performance of oscillator. Also, we designed and implemented the high efficiency and low power VCO for International Mobile Telecommunication by using this technique.

• Proceedings of the IEEK Conference
• /
• 2002.07b
• /
• pp.770-773
• /
• 2002

Two sinusoidal voltage-controlled oscillators using linear operational transconductance amplifiers are presented in this paper: One is based on the positive-feedback bandpass oscillator model and the other on the negative-feedback Colpitts model. The bandpass VCO consists of a noninverting amplifier and a current-controlled LC-tuned circuit which is realized by two linear OTA's and two grounded capacitors, while the Colpitts VCO consists of an inverting amplifier and a current-controlled LC-tuned circuit realized by three linear OTA's and three grounded capacitors. Prototype circuits have been built with discrete components. The experimental results have shown that the Colpitts VCO has a linearity error of less than 5 percent, a temperature coefficient of less than rm 100 ppm/$^{circ}C$, and a $pm1.5 Hz $frequency drift over an oscillation frequency range from 712Hz to 6.3kHz. A total harmonic distortion of 0.3 percent has been measured for a 3.3kHz oscillation and the corresponding peak-to-peak amplitude was 1V. The experimental results for bandpass VCO are also presented.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.19 no.12
• /
• pp.2439-2447
• /
• 1994

In this paper, We analyze Colpitts type voltage contrqlled oscillator(VCO) used in personal handheld phone using a nonlinear analysis with third-order model. The resul shows the non-exponentially decaying shifting bias superimposed on the oscillator output which is different with the exponentially decaying shifting bias from the linear analysis. The stable oscillation criterion during a frequency change in a design of VOC can be also determined using proposed non-linear analysis. The theory is confirmed using PSPICE simulation and the experimental result of GaAs VCO matched very well with the theory.