• 조명전기설비학회논문지
• /
• 제26권3호
• /
• pp.31-39
• /
• 2012

This paper presents a high efficiency coupled inductor boost DC-DC converter that uses a simple clamp circuit and the coupled inductor and thus overcomes output voltage limit of the conventional boost converter. The proposed converter solves problems of voltage stress of the power semiconductor switch and reverse recovery of the output diode using a simple clamp circuit composed of a diode and a capacitor, and thus the converter improves its total efficiency. In this paper, the operational principle of the proposed converter is explained by each mode and then a design example for the prototype converter based on the explanation is shown. And good performance of the proposed converter is verified through experimental results of the prototype converter that is implemented with the designed circuit parameters.

• Journal of international Conference on Electrical Machines and Systems
• /
• 제3권4호
• /
• pp.465-471
• /
• 2014

This paper proposes a new switching algorithm for an active clamp snubber to improve the efficiency of a module integrated converter system. This system uses an active clamp method for the snubber circuit for the efficiency and reliability of the system. However, the active clamp snubber circuit has the disadvantage that system efficiency is decreased by switch operating time because of heat loss in resonance between the snubber capacitor and leakage inductance. To address this, this paper proposes a new switching algorithm. The proposed algorithm is a technique to reduce power consumption by reducing the resonance of the snubber switch operation time. Also, the snubber switch is operated at zero voltage switching by turning on the snubber switch before main switch turn-off. Simulation and experimental results are presented to show the validity of the proposed new active clamp control algorithm.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 하계학술대회 논문집 B
• /
• pp.1193-1195
• /
• 2002

This paper presents Active-clamp Class-E high frequency resonant inverter with single-stage. The proposed circuit is integrated Active-c class-E circuit to boost converter with the funct power factor correction. Boost converter is opera positive and negative half cycle respectively at frequency(60Hz), operating in Discontinuous Con Mode(DCM) of boost converter performs high p factor. By adding active-clamp circuit in Cl inverter, main switch of inverter part is operat only ZVS(Zero Voltage Switch), but also reduce switching voltage stress of main switch. Simulation result using Psim4.1 show that the p prove the validity of theoretical analysis. This proposed inverter will be able to be pract used as a power supply in various fields are ind heating applications, DC-DC converter etc.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2002년도 학술대회논문집
• /
• pp.287-291
• /
• 2002

This paper presents active-clamp class-E high frequency resonant inverter with single-stage. The proposed circuit is integrated active-clamp class-E circuit to boost converter with the function of power factor correction. Boost converter is operated in positive and negative half cycle respectively at line frequency(60Hz), Such a operating in discontinuous conduction mode(DCM) of boost converter performs high power factor. By adding active-clamp circuit in class-E inverter, main switch of inverter part is operated not only ZVS(Zero Voltage Switch) but also reduced the switching voltage stress of main switch. This paper shows that simulation result using Psim 4.1 prove the validity of theoretical analysis. This proposed inverter will be able to be practically used as a power supply in various fields as induction heating applications, DC-DC converter etc.

• 반도체디스플레이기술학회지
• /
• 제17권4호
• /
• pp.56-61
• /
• 2018

In this paper, a new type of active snubber was proposed to lower the excessive rated voltage of the clamp capacitor which was a problem in the conventional circuit by applying auxiliary winding into the active snubber. A simplified equivalent circuit of the proposed snubber was derived by applying it to QR flyback converter, and the equivalent circuits for each switch state was shown under the steady-state condition. In addition, the maximum voltage of the clamp capacitor as well as the main switch was found by using the steady-state equations. In particular, it was found that the clamp capacitor voltage could be controlled by the auxiliary winding ratio. In order to verify the utility and practicality of the proposed converter with auxiliary winding type active snubber circuit, a prototype with an output voltage of 19V and a maximum load current of 6A was produced and the results were reported.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제8권3호
• /
• pp.227-231
• /
• 2008

A latchup-free design based on the lateral diffused MOS (LDMOS) adopting the "Darlington" approaches was designed. The use of Darlington configuration as the trigger circuit results in the reduction of the size of the circuit when compared to the conventional inverter driven RC-triggered MOSFET ESD power clamp circuits. The proposed clamp was fabricated using a $0.35{\mu}m$ 60V BCD (Bipolar CMOS DMOS) process and the performance of the proposed clamp was successfully verified by TLP (Transmission Line Pulsing) measurements.

• 조명전기설비학회논문지
• /
• 제29권5호
• /
• pp.57-64
• /
• 2015

This paper proposes a new switching algorithm for an controllable clamp snubber to improve the efficiency of a fly-back converter system. This system uses an controllable clamp method for the snubber circuit for the efficiency and reliability of the system. However, the active clamp snubber circuit has the disadvantage that system efficiency is decreased by switch operating time because of heat loss in resonance between the snubber capacitor and leakage inductance. To address this, this paper proposes a new switching algorithm. The proposed algorithm is a technique to reduce power consumption by reducing the resonance of the snubber switch operation time. Also, the snubber switch is operated at zero voltage switching by turning on the snubber switch before main switch turn-off. Experimental results are presented to show the validity of the proposed controllable clamp control algorithm.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1996년도 하계학술대회 논문집 A
• /
• pp.453-457
• /
• 1996

DC/DC converter is widely used in computer, electronic communication and industrial apparatus where the regulated dc supply is needed. FB-ZVS converter is suitable for high-power, high-frequency and constant frequency control. Because the voltage stress of the diode rectifier is high due to the ring effect, the clamp circuit is essential to reduce the voltage stress. The nondissipative active clamp circuit eliminates ring effect. Analysis of FB-ZVS converter and the validity of the active clamp circuit are studied through the simulation, and the experimental results show the superior characterics of the proposed system.

• 전자공학회논문지SC
• /
• 제40권5호
• /
• pp.350-354
• /
• 2003

본 논문에서는 능동 클램프 스위치를 위한 별도의 구동 회로가 생략된 새로운 자기 구동 능동 클램프 포워드 컨버터를 제안하였다. 능동 클램프 스위치의 구동에는 컨버터 자체의 변압기의 보조 권선을 이용하였고, 두 스위치 구동 신호 사이의 데드 타임을 설정하기 위하여 간단한 R-C지연 회로를 추가하였다. 제안된 컨버터의 동작 원리를 제시하였고 실험 결과를 가지고 이론적인 결과를 입증하였다. 출력 100W(5V/20A)의 컨버터를 제작하였으며 입력이 50V일 때 능동 클램프 스위치의 구동에 단지 1.5T의 보조 권선의 권선수로 충분하다는 점을 보였다. 끝으로 제안된 컨버터의 측정 효율을 제시하였고 91%의 최대 효율을 달성하였다.

• 전력전자학회논문지
• /
• 제18권5호
• /
• pp.477-484
• /
• 2013

This paper proposes a novel switching method of active clamp snubber for efficiency improvement of PV module integrated converter(MIC) system. Recently, MIC solar system is researched about the efficiency and safety. PV MIC system is used active clamp method of snubber circuit for the price and reliability of the system. But active clamp snubber circuit has the disadvantage that system efficiency is decreased for switch operating time because of heat loss of resonant between snubber capacitor and leakage inductance. To solve this problem, this paper proposes a novel switching method of the active clamp. The proposed method is a technique to reduce power consumption by reducing the resonance of the snubber switch operation time and through simulations and experiments proved the validity.