• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.57 no.1
• /
• pp.128-136
• /
• 2008

In this paper, we propose a new cache structure for effective error correction of soft error. We added check bit and SEEB(soft error evaluation block) to evaluate the status of cache line. The SEEB stores result of parity check into the two-bit shit register and set the check bit to '1' when parity check fails twice in the same cache line. In this case the line where parity check fails twice is treated as a vulnerable to soft error. When the data is filled into the cache, the new replacement algorithm is suggested that it can only use the valid block determined by SEEB. This structure prohibits the vulnerable line from being used and contributes to efficient use of cache by the reuse of line where parity check fails only once can be reused. We tried to minimize the side effect of the proposed cache and the experimental results, using SPEC2000 benchmark, showed 3% degradation in hit rate, 15% timing overhead because of parity logic and 2.7% area overhead. But it can be considered as trivial for SEEB because almost tolerant design inevitably adopt this parity method even if there are some overhead. And if only parity logic is used then it can have $5%{\sim}10%$ advantage than ECC logic. By using this proposed cache, the system will be protected from the threat of soft error in cache and the hit rate can be maintained to the level without soft error in the cache.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.25 no.1
• /
• pp.108-114
• /
• 2021

AVTE(Air Vehicle Test Equipment) is a device to check status of on-board aircraft equipment before and after flight for performing successful UAV(Unmanned Aerial Vehicle) missions. This paper describes software design and test sequence of the AVTE for enabling easy-manual check by the operator and convenient automatic check of on-board electric equipment respectively. The proposed AVTE inspects BIT(Built-In Test) results of on-board LRUs(Line Replacement Units) including avionics and sensor sub-system devices. Also, it monitors all the LRU status and check the normality of aircraft equipment by means of setting specific values of the LRUs and confirming the expected test results. The AVTE prints the test results as a form of report to easily check the normal conditions of the aircraft equipment and operates automatically without operator interaction, thus being thought to effectively reduce workload of the operator.

• Proceedings of the Acoustical Society of Korea Conference
• /
• 1991.06a
• /
• pp.78-81
• /
• 1991

Digital radio data is composed of groups which are divided into 4 blocks of 26 bits. And each block is made up of information word and check word. Check word of digital radio data that is composed ofcode word and offset word is used for group/block synchronization and error correction. In this paper, we have investigated the group/block synchronizer using offext word and shortened cyclic decoder for correcting error produced during the radio data transimission. Also, we have simulated the decoding process of the proposed decoder. From the simulation results, we have confirmed that the proposed decoder most with the required coding capcbility.

• Proceedings of the Safety Management and Science Conference
• /
• 1999.11a
• /
• pp.183-189
• /
• 1999

Nowadays advanced manufacturing companies are trying to find a way to check the performance of their production equipments and plants from remote sites. However, it is hard to monitor the status of machine or to check the performance of the processes because the regional limitation of distributed environment. This paper presents research results in the real time monitoring of machining processes and internet_based operation of machining centers via internet, which is implemented using VRML and JAVA.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2019.05a
• /
• pp.153-154
• /
• 2019

There are many jobs, not actually sleeping. Sleepy driving is one of the biggest problems in modern society. In this paper, we propose a system to control underwater guns by using deep learning (YOLO) to check eyes and to check drowsiness. So let your mind be clear.

• The Magazine of the Society of Air-Conditioning and Refrigerating Engineers of Korea
• /
• v.11 no.1
• /
• pp.1-10
• /
• 1982

The water-hammer phenomena caused by pump power failure are analysed by digital computer. Asan cool ins water pipe system has been chosen as a model. It is Shown that after power failure the pressure at the pump outlet drops sharply, and to prevent reverse flow, either butterfly valve or check valve can be used. After the valve closure, pressure oscillates behind the valve. To weaken the pressure wave, it is recommended to install a servo-operated valve in a bypass Line around the pamp and the check valve.

• Proceedings of the IEEK Conference
• /
• 2004.06a
• /
• pp.55-58
• /
• 2004

This this paper, we propose vertical Bell laboratories layered space time (V-BLAST) system based on variable rate Low-Density Parity Check (LDPC) codes to improve performance of receiver when QR decomposition interference suppression combined with interference cancellation is used over independent Rayleigh fading channel. The different rate LDPC codes can be made by puncturing some rows of a given parity check matrix. This allows to implement a single encoder and decoder for different rate LDPC codes. The performance can be improved by assigning stronger LDPC codes in lower layer than upper layer because the poor SNR of first detected data streams makes error propagation. Keeping the same overall code rates, the V-BLAST system with different rate LDPC codes has the better performance (in terms of Bit Error Rate) than with constant rate LDPC code in fast fading channel.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2010.06a
• /
• pp.95-95
• /
• 2010

Because of the environmental matters the importance of the city railroad is as time goes by increasing. The case of obstacle of the power equipment which supplies electric power to city railroad will occur social and economical enormous loss. Thus, I studied on the preventing method in advance which makes it possible for us to maintain facilities efficiently. The main check points of the power facilities are voltage, current, humidity, partial discharge, move current. These points are gathered by sensor and transmitting to data acquisition device. These data are used to check equipment status in real time. In this paper I described in brief test process and results of the detection system.

• Proceedings of the IEEK Conference
• /
• 2009.05a
• /
• pp.332-334
• /
• 2009

This thesis puts forward a suggestion of measuring inner crack and center segregation in steel processing by using scanner and image processing with sulfur printer. This is a system to scan according to the program, to choose the size of the specimen and to press the 'Measurement' button, come to a check result, to send the result to the server, and to save the data and check the measurement result in web. To sum up, there are three points in this system.

• International journal of advanced smart convergence
• /
• v.1 no.1
• /
• pp.38-42
• /
• 2012

Automobilist in South Korea in order to provide car driving information to the insurance company uses 'car driving information device'. They provide car driving information of device to insurers for their premium discount. Currently these devices are used in Korea has inconvenience that this device Installation and the process for send this information to insurance companies. In this paper, Korean smart car driving information system designed using Smart phone and local-range network as a basis the 'Certification Regulations of Driving Information Check Device' of the Korea Insurance Development Institute.