• Transactions of the Korean Society of Automotive Engineers
• /
• v.3 no.1
• /
• pp.13-19
• /
• 1995

The objective of this study is do obtain the relationship between the acoustic mode and cavity tone induced in a perforated tube exhaust muffler. First, the modal frequency for the axisymmetric radial mode and the mode shape have been computed using the impedance model for the perforated tube. Then, experiment has been perfonned for the onset frequencies of the cavity tone for various design parameters and through-flow. The theoretically obtained modal frequencies are well consistent with the measured onset frequencies of the cavity tone, showing that the cavity tone is induced by the axisymmetric radial mode. And it is found that the modal frequency of a perforated tube muffler is much lower than that of a simple expansion chamber.

• Proceedings of the KSME Conference
• /
• 2002.08a
• /
• pp.775-778
• /
• 2002

In order to analyse the mechanism of a flow tone around a cavity, the correlations between the flow in the cavity and the boundary layer flow in front of the cavity are studied experimentally in this paper. The instability In the boundary layer forms the vortex at the front edge of the cavity and the flow tone is occurred by the vortex breakdown at the rear edge of the cavity Therefore, the boundary layer measurement is important in the cavity flow control. We measure the velocity of the boundary layer at the entrance of the cavity using hot-wire anemometry and the flow tone around the cavity by microphone. The boundary layer characteristic is changed by the various angle of the flap on the front edge of the cavity, while it is less influenced by the ratio of length and depth of the cavity.

• Proceedings of the KSME Conference
• /
• 2004.04a
• /
• pp.1921-1926
• /
• 2004

The tone generation mechanism and aeroacoustic characteristics have been investigated for flow over open cavities using direct acoustic numerical simulations. Physically the tone generation mechanism of open cavity is more complicated when flow instabilities are excited by the correlation effects of flow parameters. From non-dimensional parameter studies in very low Mach number range, it is shown that characteristics of cavity resonance inherently involve typical acoustic pattern at each discrete tone frequency, and especially in laminar flow the fundamental tone frequency is determined within flow instability criterion of laminar shear layer as well as cavity geometry, length to depth ratio.

• Journal of the Korean Society of Visualization
• /
• v.9 no.4
• /
• pp.35-40
• /
• 2011

An experimental investigation of the characteristic of non-premixed lifted flames with nozzle hole-tone of high-frequency has been performed. Before the fuel was supplied to nozzle, the fuel was supplied through a burner cavity which was located under the nozzle. The fuel passed through the excitation cavity under the influence of the high-frequency affects the lifted flame characteristics. The measurements were performed in flow range that occurs lifted flame and blow out. When the high-frequency is generated from burner cavity, the lifted length became shorter, and noise reduced comparing to unexcitation case. Additionally, operating flow range was increased and diameter of flame base became smaller with high-frequency effect. Through this experiments, it's ascertained that the high-frequency excitation can be adopted with effective method for flame stability and noise reduction.

• The Journal of the Acoustical Society of Korea
• /
• v.2 no.1
• /
• pp.1-10
• /
• 1983

The presence of the sound tube and resonance cavity is unique in Korea Brahman Bells which is no examples in other country bells in the world. The sound tube erected in the crown is effective to emit the fundamental tone of the bell when the condition of resonant transmissibility is satisfied. The results of our analysis shows that the optimum length of the sound tube in the Bell Emile is 96cm but is not the present length, 77cm. The resonance cavity erected underneath the lip of the Bell Emile is found to be for the resonance of standing waves in the space including both bell cavity and resonance cavity and resonance cavity to the fundamental tone of the bell itself, in order that the strongest vibration can last long by least energy and lengthen the reverberation of the bell. Some historical remarks are also made on the magic flute, MANPASIKJUK, which was in existence in Shilla that can lull all evil waves, such as plagues, storms, droughts, famines and even enemies. The sound tube erected in the crown of the bell was originated in this magic flute. Finally, a strong proposal is advanced on the new national symbol of Korean traditional cultural assets. Indeed, it should be highly recommended that the Great King's Bell Emile would be the only real symbol of our national cultural assets by its own right of excellency and richness in every aspect of arts and sciences.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2004.05a
• /
• pp.843-846
• /
• 2004

Cavity tone is generated due to the feedback between flow and acoustic wave. It is recognized that the period is determined by the time required for the flow convection in one direction, the time required for the acoustic propagation in the other direction and the time for phase shift depending on the flows and mode. Most of the phenomena have been investigated by experiments and a simple but fundamental theory. But the cause of the phase shift and the correctness of the theory have not been clearly explained so far. In this paper, the phenomena are calculated numerically to obtain detail information of flow and acoustic wave to explain the mechanism including the phase. High order high resolution scheme of optimized high order compact is used to resolve the small acoustic quantities and large flow quantities at the same time. The data are reduced using cross correlation function in space and time and cross spectral density function which has phase information. Abrupt change in pressure near corner in cavity is observed and is relate to phase variation. The time required for the feedback between the flow and acoustic wave is calculated after the numerical simulation f3r various modes. The periods based on the time calculated using the above method and direct observation from the acoustic waves generated and propagated in the numerical simulation are compared. It is found that no phase shift is required if we examine the time required carefully. Rossiter's formula for the cavity tone used for quick estimation needs to be modified far some modes.

• Progress in Superconductivity
• /
• v.4 no.2
• /
• pp.137-143
• /
• 2003

In measuring the microwave surface resistance of high-Tc superconductor (HTS) films using the dielectric-loaded cavity resonator method, one of the most important factors that limit the measurement sensitivity is the measurement error in the loss tangent ($tan\delta$) of the dielectric rod placed inside the cavity. We have measured the effective surface resistance ( $R_{S}$ $^{eff}$) of$ YBa_2$$_Cu3$$_{7-{\delta}}$ (YBCO) films and the $tan\delta$ of rutile ($TiO_2$) using the 'two-tone'method suggested by Kobayashi et at. [IEEE, MTT-S Digest, 495, (2001)], which enables simultaneous measurements of both the $R_{S}$ $^{eff}$ fof HTS films and the $tan\delta$ of the rutile with high sensitivity. A rutile-loaded cavity resonator with the $TE_{012}$ and $TE_{021}$ resonant frequencies at 13.67 - 14.01 GHz is used for this purpose. At temperatures where the two modes do not couple with other modes, the $R_{S}$ $^{eff}$ of YBCO films and $tan\delta$ of rutile measured by the two-tone method appear to match well with the corresponding values measured using the reported $tan\delta$ values of sapphire within 10 %. Usefulness of the 'two-tone' method for microwave characterization of HTS films and dielectrics is discussed.d.ielectrics is discussed.ussed.

• Proceedings of the Acoustical Society of Korea Conference
• /
• 1993.06a
• /
• pp.17-20
• /
• 1993

The acoustic mode of a perforated tube muffler was investigated both theoretically and experimentally to explain the cavity-tones induced by through-flow. The cutoff frequencies for the axisymmetric modes were obtained and confirmed experimentally. It was found that the cutoff frequencies are decreased significantly by the perforated tube. The onset frequencies of the cavity-tones were compared with the cutoff frequencies of the acoustic mode and it was found that the cavity-tones are induced by the radial acoustic modes and their frequency stages are coincident with the discrete cutoff frequencies.

• Journal of Mechanical Science and Technology
• /
• v.17 no.4
• /
• pp.590-598
• /
• 2003

A computational aero-acoustic (CAA) method is used to predict the tonal noise generated from a cavity of automobile door seals or gaps at low flow Mach numbers (A$\_$$\infty$/=0.077 and 0.147) In the present method, the acoustically perturbed Euler equations are solved with the acoustic source term obtained from the unsteady incompressible Navier-Stokes calculations of the cavity flow in self-sustained oscillations. The aerodynamic and acoustic fields are computed for the Reynolds numbers based on the displacement thickness, Re$\_$$\delta$*/=850 and 1620 and their fundamental mode characteristics are investigated. The present method is also verified with the experimentally measured sound pressure level (SPL) spectra.

• Journal of the Korean Institute of Intelligent Systems
• /
• v.11 no.6
• /
• pp.510-515
• /
• 2001

Generally, there are (1)Words for conversation (2)Tone (3)Pitch (4)Formant frequency (5)Speech speed, etc as the element for emotional recognition from speech signal. For human being, it is natural that the tone, vice quality, speed words are easier elements rather than frequency to perceive other s feeling. Therefore, the former things are important elements fro classifying feelings. And, previous methods have mainly used the former thins but using formant is good for implementing as machine. Thus. our final goal of this research is to implement an emotional recognition system based on pitch, formant, speech speed, etc. from speech signal. In this paper, as first stage we foun specific features of feeling angry from his words when a man got angry.