• Journal of Power Electronics
• /
• 제18권2호
• /
• pp.418-431
• /
• 2018

This paper presents a new asymmetrical multilevel inverter with a reduced number of power electronic components. The proposed multilevel inverter is analyzed using two different configurations: i) First Configuration (with a switched diode) and ii) Second Configuration (without a switched diode). The presented topologies are compared with recent multilevel inverter topologies in terms of number of switches, gate driver circuits and blocking voltages. The proposed topologies can be cascaded to generate the maximum number of output voltage levels and they are suitable for high voltage applications. Various power quality issues are addressed for both of the configurations. The proposed 11-level inverter configuration is simulated using MATLAB and it is validated with a laboratory based experimental setup.

• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제51권11호
• /
• pp.645-651
• /
• 2002

In this paper, a multilevel PWM inverter employing a cascaded transformer is presented to reduce the harmonics of output voltage and load currents. The proposed PWM inverter consists of two full-bridge modules and their corresponding transformers. The secondarics of each transformer are series-connected. So continuous output voltage levels can be synthesized from the suitable selection of the turns ratio of trasformer. And it appears an integral ratio to input DC source. Because of the cascaded connection of transformers, output filter inductor is not necessary. The operational principles and analysis are explained, and it is compared with a conventional isolated H-bridge PWM inverter. The validity of proposed multilevel inverter is verified through simulated and experimental waveform and their FFT results.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2015년도 전력전자학술대회 논문집
• /
• pp.323-324
• /
• 2015

Recently, asymmetrical cascaded H-bridge multilevel inverter started to be highlighted as an alternative for the symmetrical cascaded H-bridge. The topology has a small number of part count compared to the symmetrical with higher number of levels. However, it has a drawback of the modulation index limitation which is relatively higher than its symmetrical counterpart, which causes a necessity of an extra voltage pre-regulator. In this paper, the single-sourced pre-regulator is unified with an inner single switch DC/DC converter isolated by coupled inductor. It leads to cost and size reduction. The proposed topology is verified using simulation results.

• Journal of Power Electronics
• /
• 제16권6호
• /
• pp.2272-2283
• /
• 2016

This paper proposes a power conditioning system (PCS) for distributed photovoltaic (PV) applications using an asymmetric cascaded multilevel inverter with a single PV source. One of the main disadvantages of the cascaded multilevel inverters in PV systems is the requirement of multiple isolated DC sources. Using multiple PV strings leads to a compromise in either the voltage balance of individual H-bridge cells or the maximum power point tracking (MPPT) operation due to localized variations in atmospheric conditions. The proposed PCS uses a single PV source with a flyback DC-DC converter to facilitate a reduction of the required DC sources and to maintain the voltage balance during MPPT operation. The flyback converter is used to provide input for low-voltage H-bridge cells which processes only 20% of the total power. This helps to minimize the losses occurring in the proposed PCS. Furthermore, transient analyses and controller design for the proposed PCS in both the stand-alone mode and the grid-connection mode are presented. The feasibility of the proposed PCS and its control scheme have been tested using a 1kW hardware prototype and the obtained results are presented.

• Journal of Power Electronics
• /
• 제11권5호
• /
• pp.632-638
• /
• 2011

This paper presents a cascaded coil flux control based on a Current Source Parallel Resonant Push-Pull Inverter (CSPRPI) for Induction Heating (IH) applications. The most important problems associated with current source parallel resonant inverters are start-up problems and the variable response of IH systems under load variations. This paper proposes a simple cascaded control method to increase an IH system's robustness to load variations. The proposed IH has been analyzed in both the steady state and the transient state. Based on this method, the resonant frequency is tracked using Phase Locked Loop (PLL) circuits using a Multiplier Phase Detector (MPD) to achieve ZVS under the transient condition. A laboratory prototype was built with an operating frequency of 57-59 kHz and a rated power of 300 W. Simulation and experimental results verify the validity of the proposed power control method and the PLL dynamics.

• 전기전자학회논문지
• /
• 제28권3호
• /
• pp.432-439
• /
• 2024

본 논문은 재생배터리 에너지저장장치의 신뢰성과 전력품질 향상시키기 위해 개선된 단상 캐스케이드 H-브리지 기반 다중레벨 인버터의 선택적 고조파 제거 기법을 제안한다. 푸리에 급수에서 유도된 비선형 초월 방정식을 오프라인으로 풀어 선택적 고조파 제거 펄스 폭 변조 기법의 구현을 위한 최적의 스위칭 각도를 결정하며, 동작 중에 이 각도는 룩업 테이블을 통해 적용된다. 반복법인 Levenberg-Marquardt 알고리즘을 MATLAB에서 사용하여 방정식을 풀고 스위칭 각도를 얻었다. PLECS 시뮬레이션 소프트웨어를 통해 다중레벨 인버터에 사용되는 다른 기존의 펄스 폭 변조 기법들과 비교를 진행했으며, 제안된 방법의 유효성을 검증했다.

• Journal of Power Electronics
• /
• 제15권6호
• /
• pp.1508-1516
• /
• 2015

A single phase H-bridge inverter is employed in conventional Inductive Power Transfer (IPT) systems as the primary side power supply. These systems may not be suitable for some high power applications, due to the constraints of the power electronic devices and the cost. A high-frequency cascaded multi-level inverter employed in IPT systems, which is suitable for high power applications, is presented in this paper. The Phase Shift Pulse Width Modulation (PS-PWM) method is proposed to realize power regulation and selective harmonic elimination. Explicit solutions against phase shift angle and pulse width are given according to the constraints of the selective harmonic elimination equation and the required voltage to avoid solving non-linear transcendental equations. The validity of the proposed control approach is verified by the experimental results obtained with a 2kW prototype system. This approach is expected to be useful for high power IPT applications, and the output power of each H-bridge unit is identical by the proposed approach.

• 전력전자학회논문지
• /
• 제9권4호
• /
• pp.334-340
• /
• 2004

본 논문에서는 캐스케이드 변압기를 이용하는 멀티레벨 인버터의 변압기 크기를 동일화시키기 위한 효과적인 스위칭 패턴을 제안한다. 제안된 스위칭 방식은 기존의 SHEPWM 스위칭 방식을 기초로 하여 각 변압기에 인가되는 최대 자속을 동일하게 함으로서 캐스케이드 변압기의 위치에 상관없이 동일한 설계가 가능하다. 따라서 동일한 풀-브리지 모듈의 이용이 가능하고, 모듈화 특성을 개선시키며, 제작의 용이성을 쾌할 수 있다. 제안된 스위칭 기법의 기본 아이디어를 이론적으로 분석하며, 타당성을 실험을 통하여 입증한다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2011년도 제42회 하계학술대회
• /
• pp.1163-1164
• /
• 2011

Cascaded H-bridge 멀티레벨인버터의 구동을 위해서는 독립된 입력전압원의 확보가 필요하다. 본 논문에서는 이러한 Cascaded H-bridge 멀티레벨 인버터의 구조적 제약을 극복하기 위해 Buck-boost 컨버터와 Flyback 컨버터의 결합을 이용한 단일입력전원 구동 방법을 제안한다. 제안된 회로의 이론적 분석을 수행하고 시뮬레이션을 통하여 타당성을 검증한다.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2017년도 전력전자학술대회
• /
• pp.387-388
• /
• 2017

Cascaded H-bridge 멀리레벨인버터는 출력전압 레벨 수를 증가시켜 고전압 응용이 가능하도록 하는 전력변환장치로 모듈화 특성이 우수하여 그 활용 범위를 넓혀가고 있다. 출력 전압레벨 수를 증가시켜 보다 정현파에 가까운 양질의 출력전압을 생성하기 위해서는 스위칭 소자와 입력 전압원 개수의 증가로 인해 회로구조와 제어방법이 복잡해지는 문제가 발생한다. 하지만 스위칭 여유율(Redundancy)에 따른 대체 스위칭 패턴의 적용으로 전체 시스템의 신뢰성을 개선시킬 수도 있다. 본 논문에서는 고장나무 분석을 통해 Cascaded H-bridge 멀티레벨 인버터의 위험도를 계산하고 스위칭 여유율과의 관련성을 분석하고자 한다.