• Journal of the Korean Ceramic Society
• /
• v.48 no.3
• /
• pp.246-250
• /
• 2011

Effects on sintering and electrical properties of $La_{0.7}Ca_{0.3}Cr_{0.9}Co_{0.1}O_{3-{\delta}}$ system, a interconnect material for cylindrical and flat tubular solid oxide fuel cells (SOFC), have been investigated by Ca-source when using $CaCO_3$ and $CaF_2$. When using $CaCO_3$ and $CaF_2$ was mixing as Ca-source, single phased perovskite solid solution was observed for each sample. The sintering temperature was decreased by $CaF_2$ contents was increased. When using 0.1 mole $CaF_2$ was densely sintered at $1400^{\circ}C$ and relative density was 93.8%. Also, electrical conductivity in oxidation and reducing atmosphere was 47, 4.3 S/cm, respectively, due to $F^-$ ion enhance the electrical conductivity in reducing atmosphere.

• The Korean Journal of Community Living Science
• /
• v.16 no.1
• /
• pp.135-148
• /
• 2005

This study was conducted to investigate the bioavailability of calcium derived from starfish as a new calcium source. Four-week old Sprague-Dawley female rats were divided 6 groups. The rats were received experimental diets containing two kinds of Ca sources, CaCO₃ or starfish, and three levels of Ca, low (0.1 %), medium (0.5%) and high (1.0%), respectively, for 6 weeks. The parameters which related to Ca bioavailability were measured : Serum Ca concentration, Alkaline phosphatase(ALP) and GOT activities ; tissue Ca contents, bone dimension and Ca, P, Mg contents; Ca retention and apparent absorption. Starfish Ca-fed rats did not show any difference from CaCO₃-fed rats in terms of growth, food intake and FER. Serum Ca, ALP and GOT activities as well as tissue Ca contents were not different between CaCO₃- and starfish Ca-fed groups. Although dimension of femur and lumbar was not different between CaCO₃- and starfish Ca-fed rats, ash content was high in starfish Ca-fed rats. Ca and P contents of femur and lumbar were not different between both groups. Starfish Ca-fed groups showed higher Mg contents than CaCO₃-fed groups in both femur and lumbar. Ca absorption rate and retention rate were significantly higher in starfish Ca-fed rats. These results indicate that Ca derived starfish did not show any negative effect on growth and Ca metabolism of rats compared to calcium carbonate. Starfish Ca can be recommended as a good Ca source on the basis of higher Ca absorption and bioavailability.

• Journal of Korean Society for Atmospheric Environment
• /
• v.14 no.1
• /
• pp.11-23
• /
• 1998

The purpose of this study was to survey chemical distribution of inorganic elements and ions in the submicron particles, to characterize qualitatively emitting sources by factor analysis, and finally to reveal existing patterns in terms of chemical compounds by a stepwise multiple regression analysis. Total of 141 samples were collected by a cascade impactor from 1989 to1996. Fifteen chemical species (Al, Ba, Cd, K, Pb, Cu, Fe, Ni, $Cl^-, NO_3^-, SO_4^{2-}, K^+, Mg^{2+}, Ca^{2+}, and Na^+$) were characterized by AAS and IC. The study showed that average seasonal levels of submicron particulate matters $(d_p<0.43 \mum)$ were 18.7 $\mug/m^3$ in spring, 15.5 $\mug/m^3$ in summer, 15.7 $\mug/m^3$ in fall, and 24.5 $\mug/m^3$ in winter, respectively. All of the anion concentrations in the particle were highest in the winter season. By applying a factor analysis, 5 source patterns were qualitatively obtained, such as sulfate related source, nitrate related source, oil burning source, calcium related source, and coal combustion source. Finally, when applying a stepwise multiple regression analysis, the results clearly showed that $Na^+ and Ca^{2+}, K^+ and Ca^{2+}, NO_3^-$ and relative humidity, $Cl^-$ and ambient temperature, $Ca^{2+} and Cl^-, Mg^{2+} and SO_4^{2-}, Na^+ and NO_3^-, and Ca^{2+} and NO_3^-$, respectively, are negatively contributed to each other. As a result of those statistical analysis, we could suggest that some chemical compounds in the submicron particles such as$NaNO_3, MgSO_4, Ca(NO_3)_2, and CaCl_2$ may not exist on the filter as final composing products; however, other compounds may possibly exist in the form of $Mg(NO_3)_2, CaSO_4, Na_2SO_4, K_2SO_4, MgCl_2, NaCl, and KCl$. Thus, it must be necessary to identify differences between the results of above statistical analysis and of the real world by laboratory experiments.

• Journal of Nutrition and Health
• /
• v.43 no.4
• /
• pp.351-356
• /
• 2010

This study was done to evaluate the effect of Ca source using fish (Tilapia mossambica) scales on the bone metabolism. Male Sprague-Dawley rats, 4 weeks of age, were fed low-calcium diet (0.15% Ca) for 2 weeks. The rats on the low-calcium diet were further assigned to one of following three groups for an additional 4 weeks: 1) Ca-depletion group (LoCa) given 0.15% Ca diet ($CaCO_3$), 2) Ca-repletion group (AdCa) given 0.5% Ca diet ($CaCO_3$), 3) Ca-repletion diet (AdFa) received 0.5% Ca diet (Ca source from Tilapia mossambica scales). Serum parathyroid (PTH) and calcitonin showed no differences among experimental groups. Whereas LoCa group elevated the turnover markers, serum ALP and osteocalcin, and urinary deoxypyridinoline (DPD), AdCa and AdFa groups reduced their values. Elevation in the femoral weight, ash and Ca contents was observed in AdCa and AdFa groups. Bone mineral density was increased in AdCa and AdFa groups by 25-26% compared with LoCa group. These data demonstrate that Ca repletion with either Ca source from Tilapia mossambica scales or $CaCO_3$ is similarly effective in the improvement of bone turnover markers and BMD, suggesting the usefulness of Tilapia mossambica scales in the prevention of bone loss compared with $CaCO_3$.

• Journal of Nutrition and Health
• /
• v.36 no.7
• /
• pp.684-690
• /
• 2003

This study has investigated the bioavailability of calcium in eggshell powder (ESP) for the purpose of reutilizing eggshells as the calcium source. The experiment was designed 2 ${\times}$ 2 factorial method with two sources, CaCO$_3$ and ESP, and two levels, 0.2% and 0.4% calcium. Weanling SD rats were assigned randomly to one of 4 groups and provided by one of the isocaloric, 20% casein based 4 different experimental diets for 4weeks. Deionized water was given and environment was kept from any contamination of minerals. The body weight, diet intake, feed efficiency ratio (FER), bone growth, Ca contents of bones, and apparent absorption were measured. FER (0.38 - 0.40) and kidney weight were not different among groups and the weight and length, Ca content, strength of two bones Tibia and Femur were not affected by Ca sources except Femur Ca content. Ca content of Femur was greater in ESP groups than that of CaCO$_3$ groups. The body weight gain, bone growth, the Ca contents and strength of bones were significantly greater in 0.4% calcium groups suggesting 0.2% calcium is not sufficient for the optimum growth in the growing rats. These results indicate that ESP be a proper Ca source comparable or superior to CaCO$_3$. However the apparent absorption rate of final 3 days of feeding did not support the observed results showing lower rate in ESP than CaCO$_3$ groups. Further study be needed in the absorption aspect.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2016.10a
• /
• pp.117-118
• /
• 2016

This paper evalutes properties of extruding cement panel using Ca-extracted convert slag and air-cooled blast furnace slag. Flexural strength of extruding cement panel has measured in air dry and autoclave curing as basic study for use as silicious source. As a result, when Ca-extracted converter slag replaces 25% in autoclave curing, flexural strength measures 13.1MPa better than panel control mix. In result of using air-cooled blast furnace slag, Ca-extracted air-cooled blast furnace slag dose not show increase of flexural strength.

• Journal of Korean Society for Atmospheric Environment
• /
• v.14 no.6
• /
• pp.631-642
• /
• 1998

Fall-out particles were collected by the modified British deposit gauges at 35 sampling sites in Suwon area from January to November, 1996. Twenty chemical species (Al. Ba, Cd, Cr, K, Pb, Sb, Zn, Cu, Fe, Ni, V, F-, Cl-, NO3-, 5042-, Na+, NH4+, Mg2+, and Ca2+) were analyzed by AAS and If. The purposes of this study were to estimate qualitatively various emission sources of the fell-out particle by applying multivariate statistical techniques such as factor analysis, multiple regression analysis, and discriminant analysis. During the study, outlier sites were determined by a z-score method. Cl-, Na+, Mg2+, and SO42- were highly correlated due to their common marine related source. Wind speed was the most influential factor for the deposition fluxes of the particle itself and all the chemical species as well. When applying the factor analysis, 8 source patterns were qualitatively obtained, such as marine source, soil source, oil burning source, Cr related source, tire source, Cd related source, agriculture source, and F- related source. As a result of the multiple regression analysis, we could suggest that some chemical compounds may possibly exist in the form of CaSO4, NaN03, NaCl, MgC12, (NH4)2SO4, NaF, and CaCl2 in the fall-out particles. Finally, spatial and seasonal classification study performed by a discriminant analysis showed th.at SO42-, Ca2+, Cl-, and Fe were dominant in the group of spatial pattern; however, SO42-, Cl-, Al, and V were in the group of seasonal pattern.

• Animal Bioscience
• /
• v.36 no.7
• /
• pp.1044-1058
• /
• 2023

Objective: The objective of this study was to characterize physiochemical and nutrient profiles of feedstock and co-products from canola bio-oil processing that were impacted by source origin. The feedstocks and co-products (mash, pellet) were randomly collected from five different bio-oil processing plants with five different batches of samples in each bio-processing plant in Canada (CA) and China (CH). Methods: The detailed chemical composition, energy profile, total digestible nutrient (TDN), protein and carbohydrate subfractions, and their degradation and digestion (CNCPS6.5) were determined. Results: The results showed that TDN_1x was similar in meals between CA and CH. CH meals and feedstock had higher, truly digestible crude protein (tdCP) and neutral detergent fiber (tdNDF) than CA while CA had higher truly digestible non-fiber carbohydrate (tdNFC). The metabolizable energy (ME_3x), net energy (NE_Lp3x, NE_m3x, and NE_g3x) were similar in meals between CA and CH. No differences were observed in energy profile of seeds between CA and CH. The protein and carbohydrate subfractions of seeds within CH were similar. The results also showed that pelleting of meals affected protein sub-fractionation of CA meals, except rapidly degradable fractions (PB1), rumen degradable (RDPB1) and undegrdable PB1 (RUPB1), and intestinal digestible PB1 (DIGPB1). Canola meals were different in the soluble (PA2) and slowly degradable fractions (PB2) between CA and CH. The carbohydrate fractions of intermediately degradable fraction (CB2), slowly degradable fraction (CB3), and undegradable fraction (CC) were different among CH meals. CH presented higher soluble carbohydrate (CA4) and lower CB2, and CC than CA meals. Conclusion: The results indicated that although the seeds were similar within and between CA and CH, either oil-extraction process or meal pelleting seemed to have generated significantly different aspects in physiochemical and nutrient profiles in the meals. Nutritionists and producers need to regularly check nutritional value of meal mash and pellets for precision feeding.

• 한국전산유체공학회:학술대회논문집
• /
• 2008.03b
• /
• pp.304-307
• /
• 2008

Two-dimensional Stokes flow due to the line source and line sink of same strength in semi-infinite flow region with free surface is analysed using complex variable theory and conformal mapping. Surface tension effects are included while gravity is neglected. From the results of analysis, flow pattern and free surface shape are obtained and velocity distribution on the free surface is determined with 2 independent parameters Ca (capillary number) and h (non-dimensionalized distance between source and sink). When the location of the sink is above the source, velocity on the free surface converges and a cusp occurs on the free surface for the value of Ca above some critical capillary number.

• Journal of Korea Technical Association of The Pulp and Paper Industry
• /
• v.46 no.5
• /
• pp.19-26
• /
• 2014

In-situ $CaCO_3$ formation on recycled wood pulp was studied to improve optical property and filler attachment to the fiber furnish in papermaking. We tried to attach calcium oxide (CaO) to the recycled fibers, old newspaper (ONP) in this case, by using selected polymers before in-situ $CaCO_3$ formation reaction on fibers, and then, $CO_2$ was injected to the furnish until all the CaO on fiber surfaces was consumed. It was found that the attachment of newly formed $CaCO_3$ to recycled fibers became stronger by attaching CaO to the fibers before in-situ $CaCO_3$ formation reaction. It was expected that the polymers used for the attachment of calcium source to the fiber furnishes helped to keep the newly formed $CaCO_3$ strongly attached to the fiber surface as well as to retain the impurities associated with calcium source and recycled fibers, if any. In-situ $CaCO_3$ formation gave higher brightness and much less ERIC value in ONP sheet than the case when the equivalent amount of GCC was added to the furnish.