• Transactions of the Korean hydrogen and new energy society
• /
• v.2 no.1
• /
• pp.39-46
• /
• 1990

In order to improve the power of hydride heat pump, prototype heat pump was constructed using $Zr_{0.95}Ti_{0.05}Cr_{0.9}Fe_{1.1}$-$Zr_{0.9}Ti_{0.1}Cr_{0.6}Fe_{1.4}$ which had very good hydrogenation properties. The power changed with operating parameter such as cycle time, air flow rate, and temperature of hot air was investigated. The power shows maximum value with cycle time. The power increased with air flow rate and temperature of hot air. The power of the heat pump was $65-72 Kcal/Kg-alloy{\cdot}h$ under optimum operating condition, which was superior to that the system using $LaNi_{0.9}Al_{0.3}-MmNi_{4.15}Al_{0.66}Fe_{0.2}$ alloy pairs.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.07a
• /
• pp.809-812
• /
• 2001

We were fabricated of NiCr thin film resistors on A1$_2$O$_3$and SiO$_2$/Si substrates by dc magnetron sputtering system. The AC characteristics of resistors were studied. The cut-off frequency were found >10 MHz for the resistors with 39 ohm value of Alumina substrates, but the cut-off frequency were found 400 kHz for the resistors with 168 ohm value of SiO$_2$/Si substrates. In high frequency applications, the substrate selection is the most important factor.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2004.09a
• /
• pp.172-174
• /
• 2004

본 논문은 광산산성배수(AMD)에서 철 및 알루미늄 제거 효과가 입증되고 ARD(Acid Rock Drainage)에서의 비소제거 효과가 확인된 인회석을 침전제로 사용하여 철, 알루미늄 및 비소가 아닌 다른 중긍속의 제거효율을 알아보기 위해 도금폐수를 이용하여 실내실험을 실시하였다. 실험결과, 도금폐수의 수질분석결과에 의하면 '수질환경보존법 오염물질 배출허용기준' <가>지역 방출수 기준을 초과하는 것은 pH, Zn, Fe, Cu, Cr 및 P였다. 실험 결과 인회석 40번체 통과분-100번체 잔류분을 사용하는 것이 가장 적절할 것으로 생각되며 유속은 1kg의 인회석에 11의 도금폐수를 3시간 동안 반응시키면 경제적, 시간적 측면에서 가장 적절한 것으로 사료된다. 이 경우 pH는 1.98에서 5.30으로 증가하고 Cr, Fe, Cu 및 Zn은 각각 77.10%, 99.58%, 99.39% 및 40.77% 제거되는 것으로 나타났다. 용해율은 0.3619 g/min/kg으로 계산되었다. 그러나 3시간의 반응시간으로는 크롬 및 아연을 기준치 이하로 제거하지 못하므로 인회석 반응조를 다단계로 하는 실험을 수행해 그 결과를 평가해야 할 것이다.

• Journal of Welding and Joining
• /
• v.8 no.3
• /
• pp.39-52
• /
• 1990

The research is to insure the soundness of the stainless steel overlaid weld metal(21/4Cr-IMo steel + SUS 309L) for a pressure vessel application. Detail studies were conducted for the PWHT influence on the micrstructure and intergranular corrosion characteristics of the overlaid weld metal as well as initiation of hydrogen embrittlement crack(or Disbonding) when welded metal are exposed to the hydrogen atmosphere. Hydrogen was experimentally charged to the overlaid weld metal in order to study PWHT effect on the susceptibility of hydrogen embrittlement crack. The results of this research are as follows: 1. At the bond region, austenite grain of the stainless steel side became coarsed and Cr23C6 type carbide was precipitated at the coarsed austenitic grain boundaries. Intergranular Corrosion width(by Straiss test) increased with increasing PWHT temperature and PWHT time.

• Proceedings of the KWS Conference
• /
• 2007.11a
• /
• pp.39-41
• /
• 2007

In this study, actual scale welding were conducted at the USC thermal power plant turbine and main steam pipe casting candidate mock up material 9Cr-1.5Mo-CoVNbNB steel(CB2) and 9Cr-0.5Mo-MVNbN steel(P92). And to evaluate the welding process for the actual production, mechanical property testes were conducted for the weld metal. The Mock-up welding condition successfully led to an excellent structural welding joint between casting and pipe material.

• Proceedings of the Korean Institute of Surface Engineering Conference
• /
• 2013.05a
• /
• pp.39-42
• /
• 2013

자동차 및 에너지 산업의 적용을 목표로 고망간강의 기계적 성질 향상 연구가 활발히 진행된 반면 내식성 연구는 미비하다. 본 연구에서는 염수 환경 및 H2S 환경에서 4종의 고망간강의 내식성에 미치는 크롬 및 망간의 영향을 조사하였다. 비교재로 사용된 탄소강 대비 실험재의 부식 속도는 침지 실험을 통해 얻어졌다. 또한 내식성 기구 고찰을 위하여 상평형 프로그램을 통하여 녹 층을 예측하고, 침지실험으로부터 얻어진 녹 층을 XRD, SEM-EDS 및 TEM-EDS로 분석하였다. 3.5% NaCl 용액에서 크롬 및 망간이 모두 내식성을 향상시킨 반면, synthetic seawater에서는 크롬만이 내식성을 향상시켰다. 또한 이들 염수 환경과 달리 H2S 환경에서 크롬과 망간 모두 내식성을 향상시키지 못했다. 환경에 따라 강의 내식성에 미치는 합금 원소의 영향이 상이한 원인은 각각의 환경에서 형성된 녹층의 구성 물질의 차이에 의한 것으로 이에 대하여는 본문의 된 녹 층 분석 결과에서 자세히 설명되었다.

• Journal of Welding and Joining
• /
• v.10 no.3
• /
• pp.26-39
• /
• 1992

Diffusion bonding of Mo was performed by using the metallic coating of Cu and Cr on the surface to be bonded. Joint characteristics of Mo with or without coating layer were compared in metallurgical and fractograpical aspects. The results showed that the diffusion bonding with coating layer, especially with Cu coating, increased the bending strength of joint. Variation of heating cycle(elevation of temperature for a moment) did not affect significantly the mechanical properties of joint. Fractographical analysis showed that the fracture of joint bonded with Cr coating occurred at the coating layer, while that with Cu coating occurred at the base metal.

• Radiation Oncology Journal
• /
• v.26 no.4
• /
• pp.213-221
• /
• 2008

Purpose: The objective of this retrospective study was to identify predictive factors for the complete pathologic response and tumor downstaging after preoperative concurrent chemoradiotherapy for locally advanced rectal cancer. Materials and Methods: Between the years 2000 and 2008, 39 patients with newly diagnosed rectal cancer without prior evidence of distant metastasis received preoperative concurrent chemoradiotherapy followed by surgery. The median radiation dose was 50.4 Gy (range, $45{\sim}59.4\;Gy$)). Thirty-eight patients received concurrent infusional 5-fluorouracil and leucovorin, while one patient received oral capecitabine twice daily during radiotherapy. Results: A complete pathologic response (CR) was demonstrated in 12 of 39 patients (31%), while T-downstaging was observed in 24 of 39 patients (63%). N-downstaging was observed in 18 of 28 patients (64%), with a positive node in the CT scan or ultrasound. Two patients with clinical negative nodes were observed in surgical specimens. The results from a univariate analysis indicated that the tumor circumferential extent was less than 50% (p=0.031). Moreover, the length of the tumor was less than 5 cm (p=0.004), while the post-treatment carcinoembryonic antigen (CEA) levels were less than or equal to 3.0 ng/mL (p=0.015) and were significantly associated with high pathologic CR rates. The univariate analysis also indicated that the adenocarcinoma (p=0.045) and radiation dose greater than or equal to 50 Gy (p=0.021) were significantly associated with high T-downstaging, while a radiotherapy duration of less than or equal to 42 days (p=0.018) was significantly associated with N-downstaging. The results from the multivariate analysis indicated that the lesser circumferential extent of the tumor (hazard ratio [HR] 0.150; p=0.028) and shorter tumor length (HR, 0.084; p=0.005) independently predicted a higher pathologic CR. The multivariate analysis also indicated that a higher radiation dose was significantly associated with higher T-downstaging (HR, 0.115; p=0.025), while the shorter duration of radiotherapy was significantly associated with higher N-downstaging (HR, 0.028; p=0.010). Conclusion: The circumferential extent of the tumor and its length was a predictor for the pathologic CR, while radiation dose and duration of radiotherapy were predictors for tumor downstaging. Hence, these factors may be used to predict outcomes for patients and to develop further treatment guidelines for high-risk patients.

• Asian Pacific Journal of Cancer Prevention
• /
• v.15 no.4
• /
• pp.1703-1706
• /
• 2014

Background: The current standard treatment for patients with newly diagnosed diffuse large B cell lymphoma (DLBCL) is rituximab combined with cyclophosphamide, doxorubicin, vincristine and prednisolone (CHOP). A significant number of patients were not treated with recommended dose of rituximab due to limited financial resources in Malaysia. This study evaluates the efficacy of R-CHOP like chemotherapy in Malaysian patients with DLBCL. Materials and Methods: The study comprised a retrospective analysis of patients with DLBCL treated at a single centre. The outcome was compared with patients who were treated with R-CHOP like and CHOP like chemotherapy. Patients who were treated with lower dose of rituximab was subanalysed for outcome. Results: A total of 86 patients who had CHOP-like chemotherapy were included. Only 39 (45%) patients had rituximab and only 12 (29%) patients had the recommended dose. The overall response (OR) and complete response (CR) rates were 88% and 81% respectively. There was no significant difference in OR and CR in patients who had rituximab and those without rituxmab. Those with International Prognostic Index (IPI) score of ${\leq}2$ had significant higher CR rate, progression free survival (PFS) and overall survival (p<0.001). Conclusions: The lack of significant improvement in CR and DFS in our patients may be due to an inadequate dose of rituximab.

• Korean Journal of Materials Research
• /
• v.30 no.9
• /
• pp.447-452
• /
• 2020

In this work, α-Fe₂O₃ nanocrystals are synthesized by co-precipitation method and used as adsorbent to remove Cr⁶⁺, Cd²⁺, and Pb²⁺ from wastewater at room temperature. The prepared sample is evaluated by XRD, BET surface area, and FESEM for structural and morphological characteristics. XRD patterns confirm the formation of a pure hematite structure of average particle size of ~ 40 nm, which is further supported by the FESEM images of the nanocrystals. The nanocrystals are found to have BET specific surface area of ~ 39.18 m² g^-1. Adsorption experiments are carried out for the different values of pH of the solutions, contact time, and initial concentration of metal ions. High efficiency Cr⁶⁺, Cd²⁺, and Pb²⁺ removal occur at pH 3, 7, and 5.5, respectively. Equilibrium study reveals that the heavy metal ion adsorption of the α-Fe₂O₃ nanocrystals followed Langmuir and Freundlich isotherm models. The Cr⁶⁺, Cd²⁺, and Pb²⁺ adsorption equilibrium data are best fitted to the Langmuir model. The maximum adsorption capacities of α-Fe₂O₃ nanocrystals related to Cr⁶⁺, Cd²⁺, and Pb²⁺ are found to be 15.15, 11.63, and 20 mg g^-1, respectively. These results clearly suggest that the synthesized α-Fe₂O₃ nanocrystals can be considered as potential nano-adsorbents for future environmental and health related applications.