• 동력기계공학회지
• /
• 제13권1호
• /
• pp.39-45
• /
• 2009

The attenuation of the fundamental non-torsional modes that propagate down buried steel water pipes has been studied. The mode shapes, mode attenuation due to leakage into the surrounding medium and the scattering of the modes as they interact with pipe joints and fittings have been investigated. In the low frequency region the mode predicted to dominate over significant propagation distances approximates a plane wave in the water within pipe. The established acoustic technique used to locate leaks in buried steel water pipes assumes that leak noise propagates as a single non-dispersive mode at a velocity related to the low frequency asymptote of this water borne mode.

• Corrosion Science and Technology
• /
• 제11권1호
• /
• pp.20-28
• /
• 2012

Since buried pipes contact the soil directly, corrosion by the soil could be occurred. Recently, some stainless steel pipes after 8 years burial at G area were corroded and leaked. In order to elucidate highly corroded phenomena(its rate was about 0.175 mm/y) of these pipes, the investigation for corrosion environment, soil, stray current's effect, and chemical analysis on the pipes were performed. Most of investigated sites were close to traditional water-closet and showed high moisture and thus those areas could be highly corrosive. In the investigation by two kinds of soil evaluation methods, it was revealed that the soils at G areas were highly corrosive, and moreover the contents of sulfate reducing bacteria in the soils were high. Also, open circuit potentials of many pipes showed different values and its potentials were high positive. Therefore, it was considered that corrosion of buried pipes at G area could be affected by high corrosive soil's environment and stray current corrosion.

• 융합정보논문지
• /
• 제9권5호
• /
• pp.21-26
• /
• 2019

도심지에는 상 하수관로, 가스관, 수소관 등 필요에 따라 여러 가지 배관이 매설된다. 매설된 배관은 시간이 경과됨에 따라 균열 등으로 노후화되면서 폭발, 누수 등의 사고 발생 위험을 가지게 된다. 이러한 위험을 방지하기 위해 많은 노후 배관 수리, 교체되지만, 배관의 위치 또한 변경될 수 있다. 변경된 배관의 위치를 확인하지 못하면 배관을 건드려서 사고가 발생할 수 있다. 본 논문에서는 GPR을 사용하여 지하 단면 영상을 얻고, Faster R-CNN을 활용하여 지하 배관의 위치를 추정해보고, augmentation을 적용하여 부족한 데이터를 늘려서 실험을 진행하였다.

• 동력기계공학회지
• /
• 제10권1호
• /
• pp.65-70
• /
• 2006

A study of the possible axisymmetric modes that propagate at low frequencies in buried, water-filled iron pipes is presented. It is well known that for a vacuum-pipe-vacuum system the sole non-torsional axisymmetric mode that exists at low frequencies is the fundamental L(0,1) mode. When a pipe is filled with water and still surrounded by a vacuum it is also known that another mode then appears which at low frequencies is characterized by predominantly axial water-borne displacements. In addition to these modes, this paper explores two other, less well known axisymmetric modes whose existence depends on the acoustic properties of the outer medium that surrounds a pipe. In this paper the predicted characteristics of these modes are presented.

• Corrosion Science and Technology
• /
• 제14권1호
• /
• pp.12-18
• /
• 2015

Since the operation period of nuclear power plants has increased, the degradation of buried pipes gradually increases and recently it seems to be one of the emerging issues. Maintenance on buried pipes needs high quality of management system because outer surface of buried pipe contacts the various soils but inner surface reacts with various electrolytes of fluid. In the USA, USNRC and EPRI have tried to manage the degradation of buried pipes. However, there is little knowledge about the inspection procedure, test and manage program in the domestic nuclear power plants. This paper focuses on the development and build-up of real-time monitoring and control system of buried pipes. Pipes to be tested are tape-coated carbon steel pipe for primary component cooling water system, asphalt-coated cast iron pipe for fire protection system, and pre-stressed concrete cylinder pipe for sea water cooling system. A control system for cathodic protection was installed on each test pipe which has been monitored and controlled. For the calculation of protection range and optimization, computer simulation was performed using COMSOL Multiphysics (Altsoft co.).

• 상하수도학회지
• /
• 제31권1호
• /
• pp.7-12
• /
• 2017

Most of existing buried pipes are composed of reinforced concrete. Reinforced concrete pipes have many problems such as aging, corrosion, leaking, etc. The polyethylene (PE) pipes have advantages to solve these problems. The plastic pipes buried underground are classified into a flexible pipe. National standard that has limited the long-term vertical deformation of the pipe to 5% for flexible pipes including PE pipe. This study presents a prediction for the long-term behavior of the polyethylene pipe based on ASTM D 5365. This prediction method is presented to estimate by using the statistical method from the initial deflection measurement data. We predict the behavior of long-term performance on the double-wall pipe and multi-wall pipe. As a result, it was found that the PE pipe will be sound enough more than 50 years if the compaction of soil around the pipe is more than 95% of the standard soil compaction density.

• 상하수도학회지
• /
• 제32권5호
• /
• pp.435-443
• /
• 2018

Most of aged water supply pipes have been replaced by the open cut method. However, this method has some limitations because water pipes, in many cases, are buried together with other underground facilities or are buried in the middle of high-traffic roads or in narrow alleyways where boring machines cannot be used. This research developed a pipe bursting device for small diameter pipes that enables pipe replacement without excavating the ground, by the busting of existing buried pipes followed by the traction and insertion of new pipes. As a results of examining the field applicability of the developed device, PE pipes and PVC pipes required the tractive force of 413.65~665.69 kgf and 457.43~791.35 kgf respectively, plus an additional 30 % tractive force per elbow. The proper number of bursting head was demonstrated that the connection of more than 2 heads could secure a stable bending radius of 15D. The developed device can be improved through field experiments involving various pipe types and pipe diameters, as well as presence/absence of elbow, so as to be utilized regardless of diverse variables according to the conditions of the soils surrounding existing pipes.

• 한국지반환경공학회 논문집
• /
• 제22권11호
• /
• pp.31-37
• /
• 2021

매설관으로부터의 누수에 의한 지반 내 공동 및 이완구간 형성에 따른 사고를 사전에 방지하기 위하여 매설관의 파손 및 누수와 동반한 지반 내 함수상태 변화의 평가가 요구된다. 흙의 함수상태 평가를 위한 기법으로써 시계열반사계(TDR)의 적용이 고려될 수 있으나 표준 TDR 프로브의 경우 세장비가 매우 큰 전극을 이용하므로 지반 내 설치 시 전극의 변형 및 파손이 발생할 수 있다. 본 연구에서는 지반 내에서 안정적으로 형태를 유지하며 함수상태를 평가할 수 있는 매립형 TDR 모듈을 개발하였다. 매립형 TDR 모듈은 동축케이블의 내부도체 및 외부도체에 연결되는 세 개의 전극과 지반 내에서 전극의 변형방지 및 평행배열 유지를 위한 MC Nylon 재질의 케이싱으로 구성된다. 매립형 TDR 모듈로부터 획득된 유도전자기파의 신뢰도 검증을 위하여 표준 TDR 프로브로부터 획득한 유도전자기파와 상호비교 하였으며 보정실험을 통하여 체적함수비와 유도전자기파의 전파시간 상관관계가 수립되었다. 매립형 TDR 모듈의 현장적용 적정성을 평가하기 위하여 실내 모형실험이 수행되었으며, 모형 매설관으로부터의 누수에 따른 흙 시료의 체적함수비 변화가 명확히 관찰되었다. 그러므로 본 연구에서 개발된 매립형 TDR 모듈은 도심지 포장 하부에 설치된 매설관의 건전도 평가 및 매설관 주변부 지반의 함수상태 평가에 효과적으로 이용될 수 있을 것이라 판단된다.

• 동력기계공학회지
• /
• 제17권1호
• /
• pp.36-41
• /
• 2013

A study of the possible axisymmetric modes that propagate at low frequencies in buried, water-filled pipes is presented. It is well known that for a vacuum-pipe-vacuum system the sole non-torsional axisymmetric mode that exists at low frequencies is the fundamental L(0,1) mode. When a pipe is filled with water and still surrounded by a vacuum it is also known that another mode then appears which at low frequencies is characterized by predominantly axial water-borne displacements. In addition to these modes. this paper explores two other, less well known axisymmetric modes whose exitence depends on the acoustic properties of the outer medium that surrounds a pipe. The predicted characteristics of these modes are presented and the likelihood of them propagating over any significant distance in a buried water pipe is discussed.

• 복합신소재구조학회 논문집
• /
• 제1권1호
• /
• pp.27-33
• /
• 2010

Static analyses and buckling analyses were carried out for buried GFRP pipes by using finite element method. Vehicle loads, vertical and lateral soil pressures were considered as external loads, and supplying water pressure was considered as an internal load. Nine types of the factory-manufactured GFRP pipes were analyzed. Their maximum stresses and displacements were compared with the limit displacements and ultimate stress. Additionally, stress analysis on an enhanced flange, which was designed to reduce stress concentration, was performed. A cantilever analysis was carried out to know the maximum stress on the neck of the flange, which is the critical part. And a static analysis was carried for the buried flange. The test results showed that GFRP pipes were safe and stable against the external loads. And they showed that the enhanced flange decreased about 35% of the stress concentration.