• Korean Journal of Heritage: History & Science
• /
• v.53 no.4
• /
• pp.170-187
• /
• 2020

Dolmens bearing the burial layout and stone coffin tombs of the late Bronze Age were excavated from Samdeok-ri, Goseong, Gyeonsangnsamdo, and grave items such as red-burnished pottery, arrowheads, and stone swords were also discovered. In the case of the red-burnished pottery that was found, it retains a pigment layer with a thickness of about 50 to 160㎛, but with most of the other items, exfoliation and peeling-off of pigment layers can be observed on the surface. The raw materials of the red-burnished pottery contained moderately sorted minerals such as quartz, feldspar, and hornblende, and partly opaque iron oxide minerals were also identified. In particular, the raw materials of the red-burnished pottery from stone coffin tomb #6 were different from those of the other pottery, containing large amounts of hornblende and feldspar. The pottery's red pigment was identified as hematite and showed similar mineral content of raw materials such as fine grained quartz, feldspar, and hornblende. The firing temperature is estimated to have been approximately 900℃, based on their mineral phase. The possibility exists that the raw materials had been collected from the Samdeok-ri area, because diorite and granite diorite with dominant feldspar and hornblende have been identified within 3km of that area. During the pottery manufacturing process, it is estimated that the pigment was painted on the entire surface of the red-burnished pottery after it had been molded and then finished using the abrasion technique. In other words, the red-burnished pottery was made by the process of vessel forming - semi drying - coloring - polishing. The surface and cross-section of the pottery appears differently depending on the concentration of the pigment and the coloring method used after vessels were formed. Most of the excavated pottery features a distinct boundary between pigment and body fabric. However, in the case of pottery in which fine-grained pigments penetrate the body fabric so that layers cannot be distinguished, there is the possibility that the fine-grained pigment layer was applied at a low concentration or immediately after vessel forming. Many cracks can be seen on the surface pigments in thickly painted pottery items, and in many cases, only a small portion of the pigment layers remain due to surface exfoliation and abrasion in the burial environment. It is reported that pottery items may be more easily damaged by abrasion if coated with pigment and polished, so it is believed that the red-burnished pottery of the Samdeok-ri site suffered from weathering in the burial environment. This damage was more extensive in the potsherds that were scattered outside the tomb.

• Journal of Conservation Science
• /
• v.36 no.1
• /
• pp.1-14
• /
• 2020

This study investigates the crystallinity distribution of ancient silk. Owing to the inherent multi-hierarchical structure of silk protein and the complicated structural changes that occur due to various burial environments, it is challenging but worthwhile to study ancient silk ageing behavior, which is based on the fact that ageing begins with a single fiber and then spreads to a whole fabric. Crystallinity was one of the most effective indicators found to reveal the ageing status of silk. Therefore, a synchrotron radiation-based X-ray diffraction(SR-XRD) method was employed to study the crystallinity distribution of single fibers of ancient silk unearthed from seven archaeological sites in China from historical periods including the warring states, Han dynasty, Song dynasty, and Ming dynasty. In comparison, the conventional X-ray diffraction method, which uses large amounts of samples, was also performed to determine the integral crystallinity of ancient silk. Thermal stability experiments by thermogravimetry(TG) as well as morphology observations by scanning electron microscopy(SEM) and optical microscopy(OM) all confirmed the deterioration of ancient silk. Moreover, the ageing mechanism of ancient silk was proposed with the assistance of an artificial ageing study. The results confirmed the effectiveness of SR-XRD as an ageing indicator, revealing the crystallinity distribution. This research could provide motivation to determine the deterioration status of ancient silk, and would also aid in explaining the fragility of ancient silk due to ageing.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.13 no.5
• /
• pp.413-430
• /
• 2011

Consideration on the explosion resistant design of infrastructure has increased in the recent years. The explosion load is caused by gas explosion or bomb blast. In this study an analytical model is developed, whereby the tunnel structure is divided in several elements that are schematized as single degree of freedom mass-spring-dashpot systems on gas explosion. Using this simple model a sensitivity analysis has been carried out on tunnel structure design parameters such as explosive peak pressure, duration of the load, thickness of structure, burial depth. Finite element method was used to investigate the dynamic response and plastic zone of a tunnel under gas explosion. And it was found from the comparison of the analysis results that there are slight differences in the response of the intermediate wall between the single degree of freedom mass-spring-dashpot model and FEM.

• Conservation Science in Museum
• /
• v.20
• /
• pp.1-12
• /
• 2018

In February 1986, a high-school student reported the discovery of fragments of gilt-bronze burial goods on a mountainside behind a village in Ipjeom-ri, Ungpo-myeon in Iksan. The National Research Institute of Cultural Heritage immediately undertook an excavation. Unfortunately, gilt-bronze relics including a band and vertical decorations for a crown, a hat, and shoes had already been collected from Ipjeom-ri Tomb 1 by the student who found them before they could be properly excavated. Also, the interior of the stone chamber of the tomb had been severely disturbed by the time of excavation, making it difficult to identify the precise original locations of the relics within the tomb and hindering the reassembly of the fragments of the gilt-bronze crown. After conservation treatment, the gilt-bronze hat, shoes, and other relics were restored to their original forms and researchers were able to identify incised designs of a three-legged bonghwang(鳳凰), fish scales, lotus flowers, and other motifs. This study presents the major features of the fragments of gilt-bronze relics from Ipjeom-ri Tomb 1 and the methods of their production in order to provide basic material for their restoration and allow the eventual restoration of the giltbronze crown to its original condition.

• Earthquakes and Structures
• /
• v.23 no.3
• /
• pp.259-269
• /
• 2022

In this study, we introduce a canonical correlation analysis method to accurately assess the tunnel damage potential of ground motion. The proposed method can retain information relating to the initial variables. A total of 100 ground motion records are used as seismic inputs to analyze the dynamic response of three different profiles of tunnels under deep and shallow burial conditions. Nine commonly used ground motion parameters were selected to form the canonical variables of ground motion parameters (GMP_CCA). Five structural dynamic response parameters were selected to form canonical variables of structural dynamic response parameters (DRP_CCA). Canonical correlation analysis is used to maximize the correlation coefficients between GMP_CCA and DRP_CCA to obtain multivariate ground motion parameters that can be used to comprehensively assess the tunnel damage potential. The results indicate that the multivariate ground motion parameters used in this study exhibit good stability, making them suitable for evaluating the tunnel damage potential induced by ground motion. Among the nine selected ground motion parameters, peck ground acceleration (PGA), peck ground velocity (PGV), root-mean-square acceleration (RMSA), and spectral acceleration (Sa) have the highest contribution rates to GMP_CCA and DRP_CCA and the highest importance in assessing the tunnel damage potential. In contrast to univariate ground motion parameters, multivariate ground motion parameters exhibit a higher correlation with tunnel dynamic response parameters and enable accurate assessment of tunnel damage potential.

• Korean Journal of Heritage: History & Science
• /
• v.46 no.3
• /
• pp.134-149
• /
• 2013

The Sudang-ri Site in Geumsan is considered the historic site where Baekje dominated the inland traffic route to Gaya through Geumsan and Jinan in the 5th Century. This study identified the production techniques of iron by conducting an analysis of metallographical microstructure of the artifacts such as an iron sword and an iron sickle that were excavated in Sudang-ri Site, Geumsan, one of the regions ruled by Baekje, and tried to figure out the characteristics and the technical systems of Baekje's ironmaking around the 5th Century by comparing them with other iron artifacts produced around the same time. The analysis showed that various production techniques were applied to the artifacts excavated in Sudang-ri Site, Geumsan. Depending on the production techniques, they can be divided largely into three methods: the simple shape-forging method, the steel manufacture method after forging, and the steel manufacture & heat-treatment method after forging. The iron sickle from the stone chamber tomb No. 1, which was produced only through forging, is mostly composed of soft ferrite at both edges of the blade and at the rear making the use of the weapon impractical. From this fact, it is presumed that they were produced as burial objects or ceremonial accessories for the person buried. The iron axe from the outer stone coffin tomb No. 1 and the iron swords and sickle from the outer stone coffin tomb No. 12, which were produced through the steel manufacture method after forging such as carburizing, did not go through the heat treatment such as quenching, but applied different production processes to each part. Therefore, it is deemed that they were produced as daily tools for cultivation rather than burial objects or ceremonial accessories. The production techniques following the forging process - carburizing and heat treatment - can be found on the iron swords from the outer stone coffin tomb No. 5 and the outer stone coffin tomb No. 12. The sturdy structure of the blade part and the durable structure of the rear processed with heat are deemed to have been produced as weaponry and used by the person buried. Based on the analysis of the iron artifacts excavated from Sudang-ri Site in Geumsan, the characteristics of iron production techniques were investigated by comparing them with the artifacts from Yongwon-ri Site in Cheonan, Bongseon-ri Site in Seocheon, and Bujang-ri Site in Seosan that were made around the same time as the cluster of Baekje tombs examined by the metallographical microstructure analysis of this study. For the iron artifacts analyzed here, the changes in the techniques were investigated using the iron swords common in all of the tombs. In the case of the iron swords, it was identified the heat treatment technique called tempering was applied from the 4th Century.

• Journal of Conservation Science
• /
• v.25 no.1
• /
• pp.49-60
• /
• 2009

Outdoor iron artefacts are easily corroded by salts, especially $Cl^-$ion, from environmental pollutants and acid rain because of their location, so that they need conservational treatments such as stabilization. However the conservation of outdoor iron artefacts are limited to be consolidated for the present and there are a few the studies for the desalinization. The general desalinization method is that objects are immersed in reagent such as alkaline corrosion inhibiting solutions targeting on buried iron artefacts, thus they are not available for outdoor iron artefacts. In this study, concerning those difficulties, the different desalting method is experimented that materials soaked in alkaline solutions attach to objects and they are packed by waterproof to avoid evaporation. This paper experiment burial iron artefacts at first in order to fine out an adaptable method for outdoor iron artefacts. The soaking materials are Korean traditional paper, gauze, cotton wipers, spill pads and the desalting regent is NaOH 0.1M. Additionally the exiting desalinization method which is to immerse objects in solution is performed to compare. The analyses are microscopes, SEM-EDS, X-ray diffraction, pH meter and Ion chromatography. The result is that spill pads show the best desalting effect out of other materials similar to immersing desalting method.

• Journal of Environmental Health Sciences
• /
• v.7 no.2
• /
• pp.73-87
• /
• 1981

Generation of Solid Wastes grew rapidly with the increase of living standard of the people in Korea recently and their composition was more complicate. The weight of Solid wastes generated in Seoul into year of 1979 was about 420 million tons which required 1.5 million $m^2$ of burial land and daily generation for person was 1.6kg. The Composition of more than 80% ash contents was suitable for sanitary landfill but recently ash was decreasing while paper, synthetic materials, glass etc, increasing and alternative method had to be found to dispose the wastes properly. Weight and Composition of Wastes by season and living standard were surveyed for one year from June 1980 to May 1981 in Seoul. Disposal mathods by waste composition was studied. Results were summarized as follows: 1) Each component stored separately at generation point was to be collected and to be reused or disposed by public organization or private company. Some incentives have to be arranged. 2) Wastes collected from household were transfeted to about 420 temporally storing places and transported to two dumping areas by about 700, 4-8 tons trucks which droped litters on the streets. Large dumping lots should constructed along the western coasts and the wastes would be transported through big container trucks or trains to the lots. 3) Ash contents decreased to 40-70% while garbage, synthetic materials, paper increased and they are two to three times in summer of those in winter. Ash in affluent residential areas is less than 50% of whole wastes while that in poor apartment and residential areas is 60-70%. 4) Large dumping places should be constructed along the western coasts which are not far from Seoul because no suitalbe lands are available, and proper leakage protection arrangements should be made.

• Journal of the Mineralogical Society of Korea
• /
• v.22 no.2
• /
• pp.115-127
• /
• 2009

Mineral quantification was performed on sediments of the Ulleung basin by X-ray powder diffraction and the computer software based on Rietveld quantification method. The sediments are dominated by amorphous opal-A with quartz, feldspars, micas, clays, calcite, and pyrite. The opal-A shows iterative variation in abundance with increasing burial depth. In addition, the relative abundance of opal-A is coincident with abundance of organic carbon contents, indicating that the Ulleung sediment consists mostly of amorphous silica derived from organism in the pelagic environment. Upward increase in the abundance of opal-A is markedly shown in the cores located in the slope region. On the other hand, there is a distinct tendency that the abundance of calcite is inversely proportional to that of opal-A. This indicates that the abundance of opal-A increases during the rise of sea level. Also, the fall of sea level lowers the abundance of opal-A.

• Journal of Energy Engineering
• /
• v.17 no.4
• /
• pp.204-211
• /
• 2008

Polyethylene(PE) pipes have been widely used as they are easy to construct and suitable for economical efficient when they are compared with metal pipelines. This paper studied the effect of various external loadings on stress and deflection of the buried PE pipes using Finite Element Method(FEM). For this purpose, stresses of buried PE pipes were calculated according to the loading condition such as pipe types(pipe diameter $50{\sim}400mm$), burial depths($0.6{\sim}1.2m$) and internal pressures($0.4{\sim}4bar$). As a result, it was founded the effect and relation with each of loading conditions under the buried condition.