• Journal of Conservation Science
• /
• v.23
• /
• pp.73-80
• /
• 2008

This article aims to turn out the authentication of archaeological materials by using the paleodose measurement to fine sand-size quartz grains obtained by micro sampling technique. We firstly revealed the validity of micro sampling technique from the paleodoses of two bricks related to Muryong Royal Tomb of Baekje Kingdom. For the purpose of authentication test, four archaeological materials were selected, because they have been insisted that they were manufactured in Goguryeo Kingdom era. After obtaining very few quartz grains by micro sampling technique, each paleodose was evaluated by using SGR (single grain regenerative dose method). All values were very low below 0.2Gy and the reliability was found from those values by using SAR (single aliquot regenerative dose method). Considering the archaeological situation and the general paleodose, the burial time for 1,000 years generally corresponds to about 3.5Gy in Korea, it is concluded that these archaeological materials are all modern counterfeits.

• Korean Journal of Soil Science and Fertilizer
• /
• v.29 no.3
• /
• pp.249-254
• /
• 1996

This research was carried out to find the suitable improvement ways of the potential acid sulfate soil(PASS) for rice cultivation through the physical applications such as surface drainage. drainage. soil dressing with common paddy soil, and burial of PASS. In reclamation of PASS the practices of surface drainage and drainage were not effective, but soil dressing with common paddy soil with same ratio and covering with common paddy soil in 30cm deep were effective for rice cultivation without growth injury. Daily drainage practice was most effective for physical reclamation of PASS.

• Journal of Radiation Protection and Research
• /
• v.41 no.2
• /
• pp.173-178
• /
• 2016

Background: In situ gamma spectrometry has been used to measure environmental radiation, assumptions are usually made about the depth distribution of the radionuclides of interest in the soil. The main limitation of in situ gamma spectrometry lies in determining the depth distribution of radionuclides. The objective of this study is to develop a method for subsurface characterization by in situ measurement. Materials and Methods: The peak to valley method based on the ratio of counting rate between the photoelectric peak and Compton region was applied to identify the depth distribution. The peak to valley method could be applied to establish the relation between the spectrally derived coefficients (Q) with relaxation mass per unit area (${\beta}$) for various depth distribution in soil. The in situ measurement results were verified by MCNP simulation and calculated correlation equation. In order to compare the depth distributions and contamination levels in decommissioning KRR site, in situ measurement and sampling results were compared. Results and Discussion: The in situ measurement results and MCNP simulation results show a good correlation for laboratory measurement. The simulation relationship between Q and source burial for the source layers have exponential relationship for a variety depth distributions. We applied the peak to valley method to contaminated decommissioning KRR site to determine a depth distribution and initial activity without sampling. The observed results has a good correlation, relative error between in situ measurement with sampling result is around 7% for depth distribution and 4% for initial activity. Conclusion: In this study, the vertical activity distribution and initial activity of $^{137}Cs$ could be identifying directly through in situ measurement. Therefore, the peak to valley method demonstrated good potential for assessment of the residual radioactivity for site remediation in decommissioning and contaminated site.

• Proceedings of the Korean Association of Geographic Inforamtion Studies Conference
• /
• 2010.06a
• /
• pp.9-18
• /
• 2010

This study investigated the cadastral non-coincidence between real land using and cadastral book using Google Earth Web for difficult area to access that is more efficient method compared with field survey for saving time and money. An reading error has occurred eight parcels about dry field and paddy field but this method is more powerful in case of a danger area of steep, unregistered cemeteries of cadastral book using Google Earth Web of image interpretation that method takes 1 day, the accuracy is 96% and improved 20% more than field survey takes 5 days by 40 parcels. It's possible to reduce the manpower, time and budget could be minimized. In particular, it is need to land alteration of forests and fields category that finds 47 locations a burial ground of non register cadastre book. Google Earth Web method is enabling easy visual analysis of the future land administration of local governments to improving the reliability of temporal and economic costs can be very useful to reduce.

• Proceedings of the Korean Association of Geographic Inforamtion Studies Conference
• /
• 1999.12a
• /
• pp.47-51
• /
• 1999

Geo-features play a key role in object-oriented or feature-based geo-processing system. So the strategy for how-to-model and how-to-manage the geo-features builds the main architecture of the entire system and also supports the efficiency and functionality of the system. Unlike the conventional 2D geo-processing system, geo-features in 3D GIS have lots to be considered to model regarding the efficient manipulation and analysis and visualization. When the system is running on the Web, it should also be considered that how to leverage the level of detail and the level of automation of modeling in addition to the support for client side data interoperability. We built a set of 3D geo-features, and each geo-feature contains a set of aspatial data and 3D geo-primitives. The 3D geo-primitives contain the fundamental modeling data such as the height of building and the burial depth of gas pipeline. We separated the additional modeling data on the geometry and appearance of the model from the fundamental modeling data to make the table in database more concise and to allow the users more freedom to represent the geo-object. To get the users to build and exchange their own data, we devised a fie format called VGFF 2.0 which stands for Virtual GIS File Format. It is to describe the three dimensional geo-information in XML(extensible Markup Language). The DTD(Document Type Definition) of VGFF 2.0 is parsed using the DOM(Document Object Model). We also developed the authoring tools for users can make their own 3D geo-features and model and save the data to VGFF 2.0 format. We are now expecting the VGFF 2.0 evolve to the 3D version of SVG(Scalable Vector Graphics) especially for 3D GIS on the Web.

• Journal of the Korean Society of Clothing and Textiles
• /
• v.25 no.1
• /
• pp.173-182
• /
• 2001

The physical properties and biodegradability of cellulose fabrics, such as cotton and rayon, are expected to vary with textile care. In this study cotton and rayon fabrics were washed repeatedly with detergents, bleaches, or softeners. The changes of physical properties were investigated by measuring retention of breaking strength, shrinkage, handle, and the fiber surface was observed by SEM. The biodegradability of fabrics was also estimated by soil burial test. The results were as follows. Cotton fabrics laundered repeatedly by detergents and bleaches lost virtually no strength. The breaking strength of the rayon fabrics decreased by about 17%∼25% after repeated launderings. Shrinkage in weft direction was much larger than that in warp direction. Bending rigidities of both fabrics decreased remarkably within 10 wash cycles. Shear rigidity in cotton fabrics increased continuously with repeated washing cycles, however, that in rayon fabrics did not show any change as washing went on. Friction coefficient increased in both fabrics after 10 wash cycles, and this is thought to be attributed to the wrinkle, interlocking of hairs, surface damage resulted from repeated washings. In cotton fabrics made of staple yarns, short hairs on the yarn surface entangled together with repeated launderings. This resulted in the continuous increase in % shrinkage, shear rigidity, friction coefficient. Rayon fabrics made of filament yarns, however, did not show this phenomenon. Softener treated fabrics showed the lowest values in bending rigidity, shear rigidity and friction coefficient because the cationic surfactants adsorbed on the fiber surface behaved like lubricants. The biodegradability of fabrics was noticeably affected by the composition of washing solutions. The fabrics washed with detergents and bleaches were decomposed faster than those washed with the others were and the cotton fabrics washed with detergents and softeners hardly degraded. The fabrics soiled with milk were decomposed almost completely and those soiled with Palmitic acid did not degrade greatly.

• 한국해양학회지
• /
• v.30 no.3
• /
• pp.216-226
• /
• 1995

Stable isotopic and elemental compositions were analyzed for well- preserved calcareous skeletons (gastropods, pectenids, brachiopods, a scaphopod, and other bivalves) of the Pleistocene Seoguipo Formation from Cheju Island, Korea. Mineralogically and texturally, aragonitic and calcitic fossils still retain their original mineralogy and microstructure. High $\delta$$\^$18/O and $\delta$$\^$13/C contents indicate that the shells have not been altered by the post-burial diagenesis. Also, this is supported by high Na and Sr contents as well as low Mn and Fe compositions of the shells. Oxygen isotopic compositions of the well preserved fossils show that the organisms had lived under the lower paleotemperature or within the isotopically enriched paleo-seawater during the deposition of the Seoguipo Formation. This result strongly implies that the Seoguipo Formation was deposited during a glacial period. The paleotemperature variation throughout the sequence during the deposition of the Sewguipo Formation was negligible.

• Journal of architectural history
• /
• v.21 no.1
• /
• pp.119-134
• /
• 2012

Balhae(698~926) was the ancient state which opened the Nambuk-guk period with the Unified Silla. But Balhae architecture began to included in the history of Korean architecture only about 15 years ago, such as the books written by Yun Jang-seop or Ju Nam-cheol. I discussed four issues related to Balhae architecture in this paper. First, I criticized the excavation report of 24 stones remains at Jiangdong in Duhua city, and I asserted the ondol site belonged to different period. Second, I also interpreted that the building found on the tombs no.13 and no.14, in the Longhai burial area in Helong city must be a wooden stupa. Third, Balhae played some important roles in the history of ondol. It developed Koguryeo ondol in terms of structure, gave an opportunity to the ruling class to adopt ondol for the first time, and passed the heating system down to the Jurchen, the ancestor of the modern Manchurian. Fourth, the Russian-Korean joint research team excavated seven building sites in Koksharovka 1 fortress from Russian territory these four years, and it is reasonable to assume the fortress was the center of Anbyeon-bu, one of 15 local government districts in Balhae. I guess this buildings were the royal shrine built by resisters after the fall of Balhae, and the vessel stands found there must be used for ancestral memorial ceremony inside them.

• Journal of Environmental Health Sciences
• /
• v.7 no.2
• /
• pp.73-87
• /
• 1981

Generation of Solid Wastes grew rapidly with the increase of living standard of the people in Korea recently and their composition was more complicate. The weight of Solid wastes generated in Seoul into year of 1979 was about 420 million tons which required 1.5 million $m^2$ of burial land and daily generation for person was 1.6kg. The Composition of more than 80% ash contents was suitable for sanitary landfill but recently ash was decreasing while paper, synthetic materials, glass etc, increasing and alternative method had to be found to dispose the wastes properly. Weight and Composition of Wastes by season and living standard were surveyed for one year from June 1980 to May 1981 in Seoul. Disposal mathods by waste composition was studied. Results were summarized as follows: 1) Each component stored separately at generation point was to be collected and to be reused or disposed by public organization or private company. Some incentives have to be arranged. 2) Wastes collected from household were transfeted to about 420 temporally storing places and transported to two dumping areas by about 700, 4-8 tons trucks which droped litters on the streets. Large dumping lots should constructed along the western coasts and the wastes would be transported through big container trucks or trains to the lots. 3) Ash contents decreased to 40-70% while garbage, synthetic materials, paper increased and they are two to three times in summer of those in winter. Ash in affluent residential areas is less than 50% of whole wastes while that in poor apartment and residential areas is 60-70%. 4) Large dumping places should be constructed along the western coasts which are not far from Seoul because no suitalbe lands are available, and proper leakage protection arrangements should be made.

• Journal of the Korean Institute of Gas
• /
• v.12 no.1
• /
• pp.7-12
• /
• 2008

In order to estimate the integrity and identify the dynamic characteristics of buried gas pipelines subjected to vehicle loads, FE analysis is performed based on the 'Highway and Local Road Design Criteria' and the 'KOGAS Guideline for Pipeline Management'. The FE model describes the current burial condition of Korea properly, and the DB-24 load model is adopted for this research. This study considers a varying velocity in the range of $40{\sim}160\;km/h$ and $P_i=8$ MPa(internal pressure) with depth cover, Z=1.5 m. Maximum stress occurs at v=80 km/h and decreases after v=80 km/h. The maximum induced stress by DB-24 loads is about 10 MPa. Under the design pressure, however, the analysis results show that API 5L Gr. X65 pipelines have sufficient integrity to withstand the vibration of vehicle loads.