• Environmental Engineering Research
• /
• v.16 no.2
• /
• pp.61-67
• /
• 2011

The water quality from nonpoint source run off results from different land use types has been studied. The construction of a buffer strip is one method of nonpoint source pollutant control. The Soil and Water Assessment Tool (SWAT) model has been applied to estimate the pollutant removal through the buffer strip. When the non-business land has been changed into grass to form a buffer-strip, the change of land use effects the results of the model according to measures of the water quality. The data from a water level station within the watershed in the years 2006 and 2007 was used for calibration and validation of the model. Under the rainfall conditions in 2007, the removal rates of SS, BOD, TN, TP were 11.5%, 9.5%, 1.2%, and 4.5%, respectively. During the rainy days, the removal rates at the buffer strip were 92.3% of SS, 91.2% of BOD, 82.4% of TN, and 83.5% of TP. The pollutants from nonpoint sources were effectively removed by over 80% as they passed through the buffer strips. Rainfall resulted in soil erosion, which led to an increase in the SS concentration, therefore, the construction of buffer strips protected the streams from SS inflows. Since TN concentrations are affected by the inflows of ground water and the N concentration of the rainfall, the removal rate of TN was relatively lower than for the other pollutants.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.9 no.5
• /
• pp.22-31
• /
• 2006

AnnAGNPS model would be applied to simulate the pollutant removal capacity with the buffer strip in the Deachung reservoir watershed. In 2002, 2,270 tons of TN and 221 tons of TP were discharged from the nonpoint source pollutants in this watershed. During the rainy season, from June to September, 66.4% of TN and 71.9% of TP resulted from nonpoint source loads. AnnAGNPS model was also used to simulate the nutrients removal capacity from the buffer strip under the condition that the present landuse would be changed to forest. As the result of simulation, the removal rates of nutrients from the buffer strip of Daecheong reservoir watershed are 406 tons of TN, 39 tons of TP, which means reduction rates are TN 17.9%, TP 17.8%, respectively.

• Journal of the Korean Society of Hazard Mitigation
• /
• v.8 no.4
• /
• pp.111-118
• /
• 2008

Riparian buffer zone prevents sediment entry into drainage channels or as a protection from runoff and wind erosion. However, Studies about its removing effect according to Riparian buffer zone are shorted now. In this study, using the SWAT model, Byongseong watershed is built on the Arcview GIS. Using the function of the filter strip in SWAT model, it is also examined about the variation of sediment yield. As a simulation result, the case of constructing riparian buffer zones at subbasins near the outlet shows generally high efficiency on removing sediment yield. In addition, according to the scenario analysis of changing riparian buffer zone width, it is thought that 5-10m riparian buffer zone width is the highest efficiency on removing sediment yields generated from Byeongseong watershed.

• International Journal of CAD/CAM
• /
• v.4 no.1
• /
• pp.47-53
• /
• 2004

The subdivision surface is the limit of recursively refined polyhedral mesh. It is quite intuitive that the multi-resolution feature can be utilized to simplify generation of NC (Numerical Control) tool paths for rough machining. In this paper, a new method of parallel NC tool path generation for subdivision surfaces is presented. The basic idea of the method includes two steps: first, extending G-Buffer to a strip buffer (called S-Buffer) by dividing the working area into strips to generate NC tool paths for objects of large size; second, generating NC tool paths by parallel implementation of S-Buffer based on MPI (Message Passing Interface). Moreover, the recursion depth of the surface can be estimated for a user-specified error tolerance, so we substitute the polyhedral mesh for the limit surface during rough machining. Furthermore, we exploit the locality of S-Buffer and develop a dynamic division and load-balanced strategy to effectively parallelize S-Buffer.

• KSBB Journal
• /
• v.24 no.3
• /
• pp.253-258
• /
• 2009

In this study, the optimization of fabrication conditions was accomplished to make immuno-strip biosensor by the combination of enzyme linked immunosorbent assay (ELISA) and immuno-chromatographic strip techniques for the detection of Escherichia coli O157 : H7. Optimal fabrication conditions of capture antibody concentration, detection antibody concentration, and additive composition of running buffer solution were determined. Optimal concentration was determined as 1.0 mg/mL for both of capture antibody and detection antibody. A composition of 0.5% Tween20 and 3% BSA were selected as optimal additive for buffer solution to prevent non-specific binding.

• Journal of the Korean Chemical Society
• /
• v.6 no.1
• /
• pp.29-31
• /
• 1962

Paper electrophoresis of aluminium ion was studied using a closed horizontal type apparatus. The optimal conditions of voltage, pH of electrolytic supporting solution and migration time were determined for the electrophoretic migration of the ion on the paper strip saturated by Michaelis buffer solution. The mobility of the ion and the isoelectric point of $Al(NO_3)_3$ solution were $(1.004{\pm}0.0020){\times}10^{-4}\;cm^2\;sec^{-1}\;volt^{-1}$ at pH = 2.38 and pH = 3.23 respectively.

• Journal of computational fluids engineering
• /
• v.4 no.2
• /
• pp.17-30
• /
• 1999

The unsteady transitional boundary layer due to rotor-stator interaction was studied at two operation points, the design and one off design points. The off design point leads to lower blade loading and lower Reynolds number. A Navier-Stokes code developed in the previous study was parallelized to expedite computations. A low Reynolds number turbulence model was used to close the momentum equations. All computations show good agreement with experimental data. The wake induced transitional strip on the suction side of the stator is clearly captured at design point operation. There is no noticeable change in shape and phase angle of the wake induced strip even in the laminar sublayer. The wake induced transitional strip at off design point shows more complex structure. The wake induced transitional strip is observed only in the turbulent layer, and becomes obscure in the laminar sublayer and buffer layer. This behavior is probably consequent upon that the transition is governed by both wake induced strip and natural transition mechanism by Tollmien-Schlichting wave.

• Proceedings of the KSRS Conference
• /
• v.1
• /
• pp.436-440
• /
• 2006

Diffuse pollution has been considering as a major source of the quality deterioration of water resources. The establishment of riparian vegetation strips of buffers along those areas of water bodies is used to reduce the threat of diffuse pollution. Remote sensing offers a means by which critical areas could be identified, so that subsequent action toward the establishment of riparian zones can be taken. Even though the principal purpose of this research comes from the feasibility of the imagery of KOMPSAT-2 satellite, Landsat TM satellite data, which has 7 bands, are used to characterize the land cover for the study area on the behalf of KOMPSAT-2. This investigation focuses on the assessment of the existing riparian buffer zones for a portion of the upper Geum river watershed from the viewpoint of pollution mitigation by riparian vegetation strip establishment. Through comparing the delineation of riparian buffer zones developed with the existing zones established by the government, we can find the critical distortion points of the existing riparian buffer zone.

• Journal of Environmental Impact Assessment
• /
• v.25 no.6
• /
• pp.369-383
• /
• 2016

A distributed watershed model CAMEL(Chemicals, Agricultural Management and Erosion Losses) was applied to a part of grazing grassland and vegetation buffer strip(VBS) located in Daegwanryeong, Korea. A set of scenario analyses was carried out for grassland and VBS with various combinations of VBS widths, soil textures and ground surface slopes. The simulation results indicate that annual direct runoff decreases with wider VBS and the removal efficiency of pollutants generally decrease with steeper slopes. The removal efficiency of sediment is not significantly different with VBS widths. For gentle and medium slopes($10^{\circ}$, $20^{\circ}$), the removal efficiency of TOC and TN is not significantly different with VBS widths. As for a steep slope($30^{\circ}$), however, the removal efficiency of TOC and TN increases with narrower VBS. The removal efficiency of TP is generally high except for medium and steep slope of sandy loam where the removal efficiency of TP increases with wider VBS. This result of TP is contrary to the results of TOC and TN due to the adsorption characteristics of phosphorus associated with fine sediment particles. It is expected that CAMEL can be used for evaluating the effectiveness of VBS to reduce non-point source pollution discharges.

• Research in Plant Disease
• /
• v.20 no.1
• /
• pp.15-20
• /
• 2014

A rapid, user-friendly and simple immune-chromatographic dipstick kit named 'rapid immune-gold strip' (RIGS) kit was developed in a novel single strip format to detect on-site detection of Tomato spotted wilt virus (TSWV). Immunoglobulin G (IgG) from polyclonal antisera raised in rabbits against TSWV was purified through protein-A affinity chromatography and then the purified TSWV-IgG was conjugated to colloidal gold nano-particles which served as a test line on nitrocellulose membrane. Protein A that non-specifically binds to TSWV antibody was used as a control line on the same strip. The diagnosis process with the TSWV-RIGS involves simply grinding the suspect plant sample in a bag that contains the extraction buffer and inserting the strip the bag. Results can be seen in 2-5 minutes. The flow of the complexes of gold particles coated with TSWV-IgG and a crude sap from TSWV-infected pepper, tobacco and tomato plants resulted in intensive color formed on the test lines proportional to the concentrations of TSWV. The RIGS-TSWV kit did not show any cross-reactions against other tomato-infecting viruses unrelated to TSWV. These results indicate that the TSWV-RIGS kit is highly sensitive and is not required for laboratory training and experience prior to testing. The TSWV-RIGS kit is suitable for on-site detection of suspect TSWV-infected plants as well as for laboratory diagnosis.