• KSBB Journal
• /
• v.11 no.3
• /
• pp.303-310
• /
• 1996

The marine microalga Isochrysis galbana Parke was studied to optimize its growth conditions in flask culture. Important medium components studied include nitrogen source, buffer, trace elements and vitamins. Environmental conditions include pH, temperature, light intensity, mixing extent and working volume. The medium prepared from natural sea-waters gave a higher final cell density than the medium prepared from synthetic sea-water Nitrate was a better source than ammonium. In the range of 0.4∼2mM, the final cell density was proportional to the initial nitrate concentration and the cell yield was estimated to be 8.5g dry cell wt/g N. For phosphate, optimal growth was observed in 0.1∼1.0mM but a considerable variation in pH was resulted. The addition of Tris at 5mM or 7mM could stabilize the medium pH, but this significantly reduced both growth rate and final cell density, The effect of trace elements and vitamins was negligible. Optimal temperature and initial pH were $20^{\circ}C$ and 8. When the intensity of incident light was varied in the range of 400∼2100 lux, the growth rate increased from 10mL to 70mL, the final cell density decreased although the initial growth rate did not change. Optimal agitation speed was 100rpm when working volume was 30mL. With optimal conditions, the maximum specific growth rate obtained was 0.021hr-1 and the final cell density was 1.1g/L.

• Journal of the Korean Applied Science and Technology
• /
• v.36 no.1
• /
• pp.355-361
• /
• 2019

The red pigment extracted from Serratia marcescens 2354 (ATCC 25419) was prodigiosin (PG), which was dissolved in methanol and measured for ultraviolet and visible light absorption spectra. It was the typical absorption spectrum of PG in an acid solution with ${\lambda}_{max}=537nm$. When the concentration of PG was increased from $1.0{\times}10-5M$ to $9.0{\times}10-5M$ in the methanol solution, the absorption intensity at 537 nm was increased, the absorption intensity at 467 nm was decreased, and the isosbestic point at 500 nm was observed. This phenomenon can be regarded as a result of reversible acid-base equilibrium reaction considering 537 nm and 467 nm of PG absorption band in acid and base solution respectively and isosbestic point of 500 nm. On the other hand, when the concentration of PG was reduced from $6.0{\times}10-4$ to $1.0{\times}10-4M$ in acetic acid buffer solution at pH 4.75, a new absorption band with ${\lambda}$ max at 500 nm appeared. This absorption band appears only in the aqueous solution of pH 4.75 and does not appear in the pure methanol solution of the same pH. This is due to the conversion of the PG molecule from the ${\alpha}$-isomer to the ${\beta}$-isomer by $H_2O$. In other words, it was confirmed that the color change of the PG can be caused by the concentration of the solution and the characteristics of the solvent.

• The Korea Journal of Herbology
• /
• v.33 no.5
• /
• pp.105-110
• /
• 2018

Objectives : We tried to observe the fluorescence anisotropy and intensity of ethidium ion in the intercalating binding interaction between DNA and ethidium ions in the presence of berberine, and then tried to explain the effect of berberine on the intercalating interaction of ethidium ion with DNA. Methods : DNA(calf thymus DNA), berberine and ethidium bromide(EtBr) were purchased from Sigma-Aldrich Co. Proper amount of each compound was dissolved in 20 mM sodium phosphate buffer(pH 7.0) containing 100 mM of NaCl to prepare stock solutions. Collections of the fluorescence anisotropy and intensity data were performed on JASCO FP-8300 spectrofluorometer equipped with a polarizer and a Peltier temperature controller. The excitation of ethidium ion was done at 550 nm and the emission data were collected at 600 nm. For Stern-Volmer plot, the fluorescence data were collected at $18^{\circ}C$ and $30^{\circ}C$. Results : According to the results of this research, the weak competitive binding pattern between ethidium ion and berberine appeared in binding with DNA at low ratio of DNA to ethidium ion. But at high ratio of DNA to ethidium ion, this weak competition disappeared. Instead, berberine might bind to DNA by intercalating way. In other words, berberine could de-intercalate ethidium ion from DNA at low concentration of DNA relative to ethidium ion, but could not at high concentration of DNA relative to ethidium ion. In addition, the mechanism of fluorescence quenching of ethidium ion could also proceed differently, depending on the ratio of the amount of DNA to that of ethidium ion. Conclusions : The effect of berberine on the DNA-ethidium ion intercalating interaction could work differently, depending on the relative ratio of the amount of DNA to that of ethidium ion. This study also showed that fluorescence anisotropy analysis is very useful method to obtain detailed information for investigation of the complex binding interactions. In order to fully understand the mechanism of action of the pharmacological effect by berberine, studies on the effect of berberine on the action of proteins such as various enzymes closely related to berberine-induced medicinal effects should be continued.

• Journal of Life Science
• /
• v.13 no.1
• /
• pp.67-72
• /
• 2003

Helicobacter pylori is the etiologic agent of human gastritis and peptic ulceration and produces urease as the major protein component on its surface. H. pylori urease is known to serve as a major virulence factor and a potent immunogen. Recombinant H. pylori urease expressed in E. coli was purified by simple purification procedures utilizing (CNBr-activated Sepharose-anti-urease IgG immunoaffinity chromatography or epoxy- activated Sepharose-urea affinity chromatography. Urease was apparently bound so tightly to the anti-urease IgG resin that it could not be eluted at various elution conditions except at certain extreme pH 1, including 100 mM carbonate (pH 10.5) buffer solution, which was shown to elute slightly inactivated but relatively pure enzyme. Urease eluted from the epoxy-activated Sepharose-urea affinity column showed higher activity, but the smaller UreA subunit of the enzyme appeared as a Fainter band of diminished intensity when subjected to SDS-polyamide gel electrophoresis.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.11 no.8
• /
• pp.3112-3118
• /
• 2010

The pH control agent in PWRs, to insure the integrity of steam generator, was changed from ammonia to ethanolamine(ETA) which decreased pH at condensate system and low pressure feedwater heater drain system, so that several amines were investigated for the selection of the optimum amine. There was no single alternative amine to meet the optimum condition. The more volatile ammonia provides the higher pH in condensate, while the less volatile ETA increases the pH in wet steam area. Thus, the combined amine of ammonia and ETA is able to equally raise the pH in both region so that the flow accelerated corrosion be reduced in the every system of the secondary side and the integrity of steam generator be also improved in pressurized water reactors (PWRs).

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 1997.05a
• /
• pp.8-11
• /
• 1997

Current methods of evaluating soil contamination by heavy metals rely on analyzing samples for total contents of metals or quantities recovered in various chemical extracting solutions. Results from these approaches provide only an index for evaluation because these methodologies yield values not directly related to bioavailability of soil-borne metals. In addition, even though concentrations of metals may be less than those required to cause toxic effects to biota, they may cause substantial effects on soil chemical parameters that determine soil quality and sustainable productivity. The objective of this research was to characterize effects of Cu or Cd additions on soil solution chemistry of soil quality indices, such as pH, EC, nutrient cation distribution and quantity/intensity relations (buffer capacity). Metals were added at rates ranging from 0 to 400 mg/kg of soil. Soil solution was sequentially extracted from saturated pastes using vacuum. Concentrations of Cu or Cd remaining in soil solutions were very low as compared to those added to the soils, warranting that most of the added metals were recovered as nonavailable (strongly adsorbed) fractions. Adsorption of the added metals released cations into soil solution causing increases of soluble cation contents and thus ionic strength of soil solution. At metal additions of 200~400 mg/kg, EC of soil solution increased to as much as 2~4 dS/m; salinity levels considered high enough to cause detrimental effects on plant production. More divalent cations (Ca+Mg) than monovalent cations (K+Na) were exchanged by Cu or Cd adsorption. The loss of exchangeable nutrient cations decreased long-term nutrient supplying capacity or each soil. At 100 mg/kg or metal loading, the buffering capacity was decreased by 60%. pH of soil solution decreased linearly with increasing metal loading rates, with a decrement of up to 1.3 units at 400 mg Cu/kg addition. Influences of Cu on each of these soil quality parameters were consistently greater than those of Cd. These effects were of a detrimental nature and large enough in most cases to significantly impact soil productivity. It is clear that new protocols are needed for evaluating potential effects of heavy metal loading of soils.

• Journal of the Korean Ceramic Society
• /
• v.31 no.12
• /
• pp.1429-1436
• /
• 1994

We have prepared Ba0.5Sr0.5TiO3 thin films on Si substrate without buffer layer. Deposition was carried out by off-axis rf magnetron sputtering method using Ba0.5Sr0.5TiO3 stoichiometric target. The substrate temperature was changed from 40$0^{\circ}C$ to $700^{\circ}C$ during deposition. As the substrate temperature increased, relative intensity of (110) peak increased up to $600^{\circ}C$, however preferred orientation changed from (110) to (h00) beyond $650^{\circ}C$ of substrate temperature. Deposited films showed microstructures with fine grains whose diameters are less than 100 nm, and columnar structure was observed in the cross-sectional SEM micrograph. AES depth profile showed no significant diffusion at the interfacial reaction area. The effective dielectric constant of films showed maximum value at $600^{\circ}C$, and the leakage current increased with increasing substrate temperature, which may be ascribed to the crystallization of amorphous phases at grain boundary.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.12
• /
• pp.3509-3513
• /
• 2014

Phospholipase D (PLD) catalyzed the generation of phosphatidic acid (PA) from phosphatidylcholine (PC) at the outer layer of the vesicles prepared through layer by layer via a double emulsion technique. The generation induced a curvature change in the vesicles, which eventually led them to fuse each other. The ratio of two-fatty-acid-tail ethanolamine (PE) to one-fatty-acid-tail ethanolamine (PE) was found to acquire the condition where the mixed-phospholipid vesicles were stable identically with pure two-fatty-acid-tail PC. The effect of the outer-layer mixture on the PLD-induced vesicle fusion was investigated using the fluorescence intensity change. 8-Aminonaph-thalene-1,3,6-trisulfonic acid disodium salt (ANTS) and p-Xylene-bis(N-pyridinium bromide) (DPX) were encapsulated in the vesicles, respectively, for the quantification of the fusion. The fluorescence scale was calibrated with the fluorescence of a 1/1 mixture of ANTS and DPX vesicles in NaCl buffer taken as 100% fluorescence (0% fusion) and the vesicles containing both ANTS and DPX as 0% fluorescence (100% fusion), considering the leakage into the medium studied directly in a separate experiment using vesicles containing both ANTS and DPX. The fusion data for each composition were acquired with the subtraction of the leakage from the quenching. From the monitoring, the vesicle fusion caused by the PLD reaction seems dominantly to occur rather than the vesicle lysis, because the composition effect on the fusion was observed identically with that on the change in the vesicle structure. Furthermore, the diameter measurements also support the fusion dominancy.

• The Journal of Korean Physical Therapy
• /
• v.14 no.4
• /
• pp.147-162
• /
• 2002

Transdermal permeation enhancer has been used to increased skin absorption. External control of drug release and skin absorption can also be achieved by iontophoresis or phonophoresis. However, because several problems with iontophoresis are that it has a risk to skin damage because of the change of pH and the increase of current density in applying it and that it can be applied only in the form of water solution, This study is to enhance drug permeation via skin following application of ultrasound. For this goal, in gel containing piroxicam, the degree of skin permeation in vitro and anti-inflammatory effect in in vivo were investigated. Permeation study using hairless mouse skin was performed at 37 $^{\circ}C$ using buffer saline as the receptor solution. The amount of piroxicam were quantified using a HPLC system consisting of solvent delivery system. Following adoption of ultrasound 1 MHZ, it showed relatively high permeation rate where it was compared with non treated by ultrasound. The influence of duty cycle having an effect on skin permeation rate was slight higher in the case of using pulsed mode. Skin permeation increase attended by intensity of ultrasound, the permeation of trice was accelerated at 2.0 W/$cm^{2}$ than 1.0 W/$cm^{2}$. The skin permeation of piroxicam was substantially influenced by ultrasound. Anti-inflammatory effects were determined using carrageenan-induced paw swelling method in SD rat. Paw swelling tests showed that pulsed phonophoresis group was more effective than control group and only gel application group. The conclusion of phonophoresis was found to improve significantly the skin permeation in vitro and the anti-inflammatory effect in vivo.

• Journal of Embryo Transfer
• /
• v.27 no.1
• /
• pp.37-43
• /
• 2012

This study evaluated a method of sorting X and Y chromosomes based on size using the forward angle light scatter related refractive index (FSC) of a flow cytometer. Hanwoo bulls sperm were separated to X and Y chromosomes by the parameters of FSC or Hoechst 33342 intensity. As a result, using monitor program linked flow cytometry during sorting processing, the purities were $97{\pm}0.57$ or $96{\pm}0.67%$ for the X-fraction and $96{\pm}0.33$ or $97{\pm}1.33%$ for the Y-fraction in the two sperm sorting methods. There were no differences in the X and Y ratios (X and Y %) between the sperm sorting methods based on FSC or DNA content. The proportions of female and male embryos used for in vitro fertilization and development were $66.03{\pm}3.31$ or $69.37{\pm}1.41%$, and $70.56{\pm}2.42$ or $56.11{\pm}3.09%$ when sperm were processed using the sex sorting method by FSC or Hoechst 33342. In conclusion, further study is needed to determine the optimum procedure and improve the nozzle to enhancing sorting accuracy or efficiency. Also, the findings of this study do not negate the possibility that the difference method of sperm sorting cannot use a UV laser beam.