• 한국막학회:학술대회논문집
• /
• 한국막학회 1999년도 춘계 총회 및 학술발표회
• /
• pp.39-41
• /
• 1999

• 한국세라믹학회지
• /
• 제51권4호
• /
• pp.265-270
• /
• 2014

Among the Ruddlesden-Popper series, $La_4Ni_3O_{10}$ has received widespread attention as a promising cathode material by reason of its favorable properties for realizing high performance of intermediate temperature solid oxide fuel cells (IT-SOFCs). The $La_4Ni_3O_{10}$ cathode is prepared using the facile sol-gel method by employing tri-blockcopolymer (F127) to obtain a single phase in a short sintering time. There are no reactions between the $La_4Ni_3O_{10}$ cathode and the $Ce_{0.9}Gd_{0.1}O_{2-\delta}$ (GDC) electrolyte upon sintering at $1000^{\circ}C$, indicating that the $La_4Ni_3O_{10}$ cathode has good chemical compatibility with the GDC electrolyte. The maximum electrical conductivity of $La_4Ni_3O_{10}$ reaches approximately 240 S $cm^{-1}$ at $100^{\circ}C$ and gradually decreases with increasing temperaturein air atmosphere. The area specific resistance value of $La_4Ni_3O_{10}$ composite with 40 wt% GDC is $0.435{\Omega}cm^2$ at $700^{\circ}C$. These data allow us to propose that the $La_4Ni_3O_{10}$-GDC composite cathode is a good candidate for IT-SOFC applications.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2013년도 제44회 동계 정기학술대회 초록집
• /
• pp.276-276
• /
• 2013

Time-Of-Flight Secondary Ion Mass Spectrometry (TOF-SIMS) and Atomic Force Microscopy (AFM) are the useful instruments to measure nanostructures of material surfaces. Surface pattern formation in blending homopolymer and diblock copolymer films was investigated as a function of film thickness and annealing conditions. In this study, surface structures of blending homopolymer [deuterated polystyrene (Mn 20,000), poly (methyl methacrylate) (Mn 18,000)] and diblock copolymer [Poly (deuteratedstyrene(d8)-b-methyl methacrylate) (Mn 19,500-18,100)] films were observed. The AFM result indicated that the nanostructures and film thickness depended on temperature, concentration and solvent. TOF-SIMS depth profiling was obtained for the lamellar morphology of symmetric dPS-b-PMMA which is found to orient parallel to the surface of the substrate. Elemental and molecular depth profiles measured in the negative ion mode by a Cs+ primary ion beam demonstrate variations in hydrogen, deuterium, carbon, oxygen, hydrocarbons and deuterated hydrocarbons within the diblock copolymer according to the depth.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2007년도 추계학술대회 논문집
• /
• pp.63-64
• /
• 2007

Polystyrene-block-polymethyl methacrylate (PS-b-PMMA) can pattern nanoscale structures over large areas. However these patterns have a short-range order. These short-range order limits their utility in some applications. Consequently, we have to overcome this limitation of block-copolymer. In this study we added a electrical field to the standard block-copolymer patterning method for long-range ordered arrays of nanostructures. This method is conformed by annealing a block copolymer with applied voltages. It is very simple method that do not have any additional hour. In this reason it can be applied easily for other nanostructure fabrications. This method opens up a new route to the controlled phase separation of block copolymers with precise place of the nanostructures.

• 한국수소및신에너지학회논문집
• /
• 제28권2호
• /
• pp.144-149
• /
• 2017

A proton-conducting bisphenylpropaned sulfonated fluorinated blockcopolymer (BPSFBC) was synthesized. Five kinds of polymer electrolyted composite membranes were preparated by incorporating silica ($SiO_2$) with various weight ratio. And their characteristics were investigated by FT-IR (fourier transform infrared), $^1H-NMR$ ($^1H$ nuclear magnetic resonance), TGA (thermogravimetric analysis), water uptake, FE-SEM (field emission scanning electron microscopes), and ion conductivity properties. The water uptake and ion conductivity were increased until 9 wt% $SiO_2$, and then decreased. The maximum proton conductivity equal to $52mScm^{-1}$ was measured for the BPSFBC/$SiO_2$-9 composite membrane at $90^{\circ}C$ and 100% relative humidity. From the measured results, it is distinct that the manufactured composite membrane BPSFBC/$SiO_2$-9 can be considered as a polymer membrane suitable for a fuel cell electrolyte.

• Journal of Pharmaceutical Investigation
• /
• 제30권4호
• /
• pp.259-266
• /
• 2000

Vitamin A palmitate, an oily drug which has low chemical stability and is poorly absorbed in the intestine, was formulated into a novel powdered dosage form. This is designated as a redispersible dry emulsion by freeze-drying technique. Before preparing a dry emulsion, vitamin A palmitate oil in solid in water (O/S/W) emulsion with soybean oil and coconut oil using Aerosil 200 as an emulsion stabilizer and polyoxyethylene-polyoxypropylene-blockcopolymer (Pluronic F68) as a surfactant was prepared. The resultants of the stability tests indicated that vitamin A palmitate O/S/W emulsion was improved on increasing the oil content of the formulation. The resultant dry emulsion particles have a good stabilities and free flow properties and readily released the oily droplets to form stable emulsions on rehydration. The drug releasing property from the resultant dry emulsion particles was dependent on factors such as amount of oily carrier(soybean oil) and surfactant(Pluronic F68) formulated. Above 80% of vitamin A palmitate content was released from the dry emulsion for 1 hour. It was deduced that vitamin A palmitate dry emulsion was definitely suitable for oral administration, since small droplets of vitamine A palmitate from the dry emulsion may alter the drug absorption profile resulting in bioavailability enhancement.

• Korean Chemical Engineering Research
• /
• 제46권4호
• /
• pp.727-731
• /
• 2008

계면활성제(P123)를 주형물질로 사용하여 메조포러스 구조의 Pt-Au 합금박막을 전기화학적 증착법에 의해 ITO가 코팅된 유리 위에 합성하였다. 전해질은 각각 10 mM의 $H_2PtCl_6$와 $HAuCl_4$의 혼합용액에 일정량의 계면활성제를 첨가하여 사용하였다. TEM(Transmission Electron Microscopy) 분석을 통하여 기공구조를 확인하였고, SEM(Scanning Electron Microscopy) 분석을 통하여 합성된 박막의 표면입자의 형태를 확인하였다. 합성된 메조포러스 구조의 Pt-Au 합금박막의 입자 함량비는 EDS(Energy Dispersive X-ray Spectroscopy) 분석으로 조사하였다. 메탄올 산화에 대한 전기화학적 촉매활성과 박막의 안정성을 평가한 결과 메조포러스 구조일 때, 넓은 표면적으로 인해 산화전류밀도가 월등히 증가함을 알 수 있었으며, 순수한 Pt박막과 비교하였을 때 소량의 Au입자의 첨가로 촉매적 안정성이 향상됨을 확인하였다.