• Journal of the Korea Computer Graphics Society
• /
• v.6 no.3
• /
• pp.35-40
• /
• 2000

There are two problems in H.26X compression technique. One is compressing time in encoding process and the other is degradation of the decoded video quality due to high compression rate. For transferring moving pictures in real-time, it is required to adopt massively high compression. In this case, there are a lot of losses of an original video data and that results in degradation of quality. Especially degradation called by blocking artifact may be produced. The blocking artifact effect is produced by DCT-based coding techniques because they operate without considering correlation between pixels in block boundaries. So it represents discontinuity between adjacent blocks. This paper describes methods of quality compensation for H.26x decoded data and enhancing encoding speed for real-time operation. Our goal of the quality compensation is not to make the decoded video identical to a original video but to make it perceived better through human eyes. We suggest an algorithm that reduces block artifact and clears decoded video in decoder. To enhance encoding speed, we adopt new four-step search algorithm. As shown in the experimental result, the quality compensation provides better video quality because of reducing blocking artifact. And then new four-step search algorithm with $MMX^{TM}$ implementation improves encoding speed from 2.5 fps to 17 fps.

• IEIE Transactions on Smart Processing and Computing
• /
• v.5 no.2
• /
• pp.129-142
• /
• 2016

In Wyner-Ziv coding, video signals are reconstructed by correcting side information generated by block-based motion estimation/compensation at the decoder. The correction is not always accurate due to the limited number of parity bits and early stopping of low-density parity check accumulate (LDPCA) decoding in distributed video coding, or due to the limited number of measurements in distributed compressive video sensing. The blocking artifacts caused by block-based processing are usually conspicuous in smooth areas and degrade the perceptual quality of the reconstructed video. Conventional deblocking filters try to remove the artifacts by treating both sides of the block boundary equally; however, coding errors generated by block-based processing are not necessarily the same on both sides of the block boundaries. Such a block-wise difference is exploited in this paper to improve deblocking for Wyner-Ziv frameworks by designing a filter where the deblocking strength at each block can be non-identical, depending on the reliability of the reconstructed pixels. Test results show that the proposed filter not only improves subjective quality by reducing the coding artifacts considerably, but also gains rate distortion performance.

• Journal of the Society of Naval Architects of Korea
• /
• v.51 no.5
• /
• pp.356-361
• /
• 2014

Accurate block shape assessment is critical for ship manufacturing and a careful assessment of the shape of a fabricated block against the design shape is a core issue. However, in current fabrication practice, the shape of each block is evaluated manually using rigid body transformation. This manual evaluation process entirely depends on workers' experiences and knowledge and makes automation of block shape assessment difficult. In this paper we propose a computation method on the registration for shape assessment of a block during the fabrication process and for evaluation of its completion against the design shape. A conversion on matching method by adding DOF(degree of freedom) restriction is required to reach the goals. We test our method using a real block quality assessment data to demonstrate its applicability to real ship manufacturing process.

• The KIPS Transactions:PartB
• /
• v.15B no.5
• /
• pp.383-390
• /
• 2008

Block based transform coding is most popular approach for image and video compression. However it suffers from severe quality degradation especially from blocking artifacts. The subjective quality degradation caused by such blocking artifacts in general does not agree well with an objecive quality measurement such as PSNR. Hence new quality evaluation technique is necessary. We propose a new image quality assessment method by measuring blocking artifacts for block based transform coded images. In order to characterize blocking artifacts, proposed method utilizes the facts that, blocking artifacts, when occur, have different pixel values along the block boundaries and such differences usually continuously span along the whole boundaries. This method does not require the original uncompressed image. It operates on single block boundary and quantifies the amount of blocking artifacts on it. Experiments on various compressed images various bitrates show that proposed quantitative measure of blocking artifacts matches well with the subjective quality of them judged by human visual system.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.22 no.1
• /
• pp.115-122
• /
• 2018

In order to conduct the "A Study on Experiment for Improvement of Water Quality in Concrete Block Using illite and $TiO_2$ Powder", as a result of the preliminary mortar experiment, water quality purification characteristic test, pollution-resistance test, fish poison test, and the related KS-equivalent tests after manufacturing the actual concrete block, the following conclusion were deduced. As a result of the concrete block functional evaluation equivalent to KS, all the conditions showed higher compressive strength. Even though increase of absorption rate, according to illite replacement in vesicular structure, was expected as a problem, it was replaced after mixing with Titanium dioxide, and then Titanium dioxide was settled in large pores of illite so there was no problem in absorption rate.

• Journal of Korean Society for Quality Management
• /
• v.13 no.2
• /
• pp.66-72
• /
• 1985

The objective of mixture experiments with process variables is to find experimental blends and conditions that produce the product of highest quality. In this paper, designs for mixture experiments with process variables are presented, where the emphasis is on using only a fraction of the total number of possible design points and the fitting of reduced models for measuring the effects of the mixture components and process variables.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.15 no.12
• /
• pp.2568-2574
• /
• 2011

31 December 2012 will be the end of terrestrial analog broadcasting. Digital broadcasting will begin. The picture quality on analog broadcasting, was not a problem. but, In digital broadcasting, is a problem. Service for streaming on the digital broadcasting MPEG video compression. And the content is added block noise. These block noise measured by people's eyes. but, people's eyes is subjective. In this paper, the on-reference methods to detect block noise. And detected by measuring the distribution of block noise, to quantify the levels of block-noise. With this study, block noise by visual inspection using an automated tool, by being objective measure of information and communication will contribute to the development of the video.

• Special Issue of the Society of Naval Architects of Korea
• /
• 2005.06a
• /
• pp.165-170
• /
• 2005

The weight of a ship depends on the size of the ship. Normal lightweight of a ship is over 10,000 tons. So it is inevitable to divide a ship into about more than hundreds of lumps. Each of lumps is called as a block in shipbuilding. The sizes of blocks are decided by a yard's facilities. Among them lifting cranes are most decisive facilities. By block's size the productivity of a yard is decided very much. So it is very important to have a proper block division during shipbuilding. This paper refers to the recent trend of block division among yards. This paper would give an idea how to decide boundaries of blocks. Block division also decides both quality of a ship and work volume of it. These days the block erection method is changed dramatically due to use sea barge mounted crane for erection of a grand ring block. This paper explains the new trend of block division in shipbuilding.

• Journal of Korea Multimedia Society
• /
• v.10 no.11
• /
• pp.1439-1445
• /
• 2007

In this paper, we propose a fast motion estimation algorithm using initial matching errors by sorting square sub-blocks to find complex sub-block area adaptively based on partial calculation of SAD(sum of absolute difference) while keeping the same prediction quality compared with the PDE(partial distortion elimination) algorithm. We reduced unnecessary calculations with square sub-block adaptive matching scan based initial SAD calculation of square sub-block in each matching block. Our algorithm reduces about 45% of computations for block matching error compared with conventional PDE(partial distortion elimination) algorithm without any degradation of prediction quality, and for algorithm will be useful to real-time video coding applications using MPEG-4 AVC or MPEG-2.

• Proceedings of the Korean Society of Broadcast Engineers Conference
• /
• 2009.01a
• /
• pp.612-617
• /
• 2009

In a DCT coding, degradations called block artifact and mosquito noise are appeared in reconstructed pictures. They should be reduced in post processing after decoding without superabundant processing. However, an estimation of mosquito noise is rare because of its difficulty. To realize an estimation of mosquito noise level, we extract a block that mosquito noise will be easy to occur. Mosquito noise level is calculated at a selected side of the block. In this processing, only the sides of high probability block are used. Then, a block value is taken by averaging. Finally, the picture value is calculated by averaging of this. Estimation method is evaluated by using the MPEG-4 decoded pictures. Quantization scale of coding and the estimated mosquito noise level are compared. As the results, we recognize the proposed method gives almost reasonable mosquito block and absolute level. Father, adaptive filter is controlled by the estimated mosquito noise level. It is recognized that the high quality of decoded picture is kept and the mosquito noise is reduced effectively at the picture with degradation.