• Proceedings of the Membrane Society of Korea Conference
• /
• 2004.11a
• /
• pp.233-236
• /
• 2004

• Biotechnology and Bioprocess Engineering:BBE
• /
• v.10 no.3
• /
• pp.284-288
• /
• 2005

Baker's yeast was disrupted in a 1.4-L stainless steel horizontal bead mill under a continuous recycle mode using 0.3 mm diameter zirconia beads as abrasive. A single pass in continuous mode bead mill operation liberates half of the maximally released protein. The maximum total protein release can only be achieved after passaging the cells 5 times through the disruption chamber. The degree of cell disruption was increased with the increase in feeding rate, but the total protein release was highest at the middle range of feeding rate (45 L/h). The total protein release was increased with an increase in biomass concentration from 10 to $50\%$(w/v). However, higher heat dissipation as a result of high viscosity of concentrated biomass led to the denaturation of labile protein such as glucose 6-phosphate dehydrogenase (G6PDH). As a result the highest specific activity of G6PDH was achieved at biomass concentration of $20\%$(ww/v). Generally, the degree of cell disruption and total protein released were increased with an increase in impeller tip speed, but the specific activity of G6PDH was decreased substantially at higher impeller tip speed (14 m/s). Both the degree of cell disruption and total protein release increased, as the bead loading increased from 75 to $85\% (v/v)$. Hence, in order to obtain a higher yield of labile protein such as G6PDH, the yeast cell should not be disrupted at biomass concentration and impeller tip speed higher than $20\%(w/v)$ and 10 m/s, respectively.

• Journal of Korean Society for Atmospheric Environment
• /
• v.30 no.3
• /
• pp.251-260
• /
• 2014

Biomass burning is one of the significant emission source of PM and CO, but a few studies are reported in Korea. Air pollutants emission from biomass burning such as wood stove and boiler, and wood-pellet stove and boiler were estimated in this study. Activity levels related to biomass burning such as fuel types, amount of fuel loading, and location and temporal variation were investigated by field survey over Korea. Fuel loadings were 14.9 kg/day for wood stove, 31.3 kg/day for wood boiler, 12.8 kg/day for wood-pellet stove, 32.5 kg/day for wood-pellet boiler during the season of active use. These were mostly burned in winter season from october to april of next year. Estimated annual emissions from wood stove & boiler were CO 76,677, $NO_x$ 710, $SO_x$ 70, VOC 20,941, TSP 6,605, PM10 2,921, PM2.5 1,851, and NH3 7 ton/yr, respectively. Emissions from wood-pellet stove and boiler were CO 32,798, $NO_x$ 1,830, $SO_x$ 25, VOCs 5,673, TSP 629, PM10 457, PM2.5 344, and $NH_3$ 2 ton/yr, respectively. When the emission estimates are compared with total emissions of the national emission inventory (CAPSS: Clean Air Policy Support System), Those occupy 12.5%, 2.8% of total national emission for CO and PM10, respectively. These results show wood and wood-pellet burning appliances were one of the major source of air pollution in Korea. In future, these types of heaters need to be regulated to reduce air pollution, especially in suburb area.

• Journal of Animal Science and Technology
• /
• v.65 no.5
• /
• pp.939-950
• /
• 2023

This study was conducted to assess the impact of growing condition variables on alfalfa (Medicago sativa L.) productivity. A total of 197 alfalfa yield results were acquired from the alfalfa field trials conducted by the South Korean National Agricultural Cooperative Federation or Rural Development Administration between 1983 and 2008. The corresponding climate and soil data were collected from the database of the Korean Meteorological Administration. Twenty-three growing condition variables were developed as explaining variables for alfalfa forage biomass production. Among them, twelve variables were chosen based on the significance of the partial-correlation coefficients or potential agricultural values. The selected partial correlation coefficients between the variables and alfalfa forage biomass ranged from -0.021 to 0.696. The influence of the selected twelve variables on yearly alfalfa production was summarized into three dominant factors through factor analysis. Along with the accumulated temperature variables, the loading scores of the daily mean temperature higher than 25℃ were over 0.88 in factor 1. The sunshine duration at temperature between 0℃-25℃ was 0.939 in factor 2. Precipitation days were 0.82, which was the greatest in factor 3. Stepwise regression applied with the three dominant factors resulted in the coefficients of factors 1, 2, and 3 for 0.633, 0.485, and 0.115, respectively, and the R-square of the model was 0.602. The environmental conditions limiting alfalfa growth, such as daily temperature higher than 25℃ or daily mean temperature affected annual alfalfa production most substantially among the growing condition variables. Therefore, future cultivar selection should consider the capability of alfalfa to be tolerant to extreme summer weather along with biomass production potential.

• Journal of Korean Society on Water Environment
• /
• v.26 no.1
• /
• pp.81-88
• /
• 2010

This study was conducted to find the capability of comparison of overall oxygen transfer coefficient in the membrane coupled high performance reactor (MPHCR) in treating high organic loading wastewater. Effluent quality had been analyzed while the influent organic loading rate was changed from 2 to $7kg\;COD/m^3{\cdot}day$. The oxygen transfer coefficients had been investigated using two-phase nozzle for operating variables which were internal circulation flowrate (5~8 L/min), air flow rate (0.0125~0.2 L/min), liquid temperature ($10{\sim}20^{\circ}C$), and pure-oxygen flow rate (0.0125~0.2 L/min). The overall oxygen transfer coefficient was increased with flowrate of internal circulation and air and high temperature. Especially, internal circulation flow rate showed distinct effect on overall oxygen transfer coefficient due to an increase of gas holdup and air-liquid contract area by two-phase nozzle. In the high range of organic loading rate from 4 to $7kg\;COD/m^3{\cdot}day$, the removable efficiency of COD was 91%. Conventional activated sludge process usually treat organic loading from 0.32 to $0.64kg\;COD/m^3{\cdot}day$ however, the MPHCR can treat 10 to 20 times higher if it would be compared to the conventional activated sludge process. Foaming problem often happened and caused biomass wash out of the reactor, therefore, the foaming should be controlled for the enhanced operation.

• Journal of environmental and Sanitary engineering
• /
• v.13 no.1
• /
• pp.185-194
• /
• 1998

Laboratory-scale investigation into initial anaerobic biofilm development was carried out by circulating mixed liquor from a steady-state anaerobic reactor through silicone tubing and then rerurning the mixed liquor to the reactor. The wall of the silicone tubing was the surface upon which anaerobic biofilm accumulation or development was monitored. Methanogenic bacteria accumulation was monitored by F$_{420}$ fluorescence (picomoles F$_{420}$/cm$^{2}$) of the extracted biofilm material. Biofilm accumulation was measured by the increase in COD of the extracted material ($\mu $g COD/cm$^{2}$). Experiments were conducted for 25 days, and biofilm analyses were performed at 5 days intervals. The results indicated that the initial rates of methangen and anaerobic biofilm accumulation increased with increasing organic loading rate and higher initial rates were observed for 15 days than 15 day liquid HRT or SRT. When the initial rates were plotted against the corresponding mixed liquor volatile suspended solids the difference between the results at the two HRT's became much less significant. Thus, the concentration of mixed liquor volatile suspended solids was found to be a very important parameter affecting initial anaerobic biofilm development. The ratio of methanogens to anaerobic biofilm was also investigated. The results showed that the ratio remained constant through the 25 days of each experiment and for high organic loading rates. Based on the results of this research, a reduction, a reduction of start-up period of anaerobic fixed film reactors might be achieved by maintaining a high organic loading and a large concentration of anaerobic microorganisms in the mixed liquor during the start-up period.

• Environmental Engineering Research
• /
• v.11 no.3
• /
• pp.134-142
• /
• 2006

The treatment of high-strength swine wastewater by anaerobic digestion combined with an aquatic plant system was investigated. Anaerobic digestion of swine wastewater gave volatile solids (VS) removal efficiencies of 43.3%, 52.1% and 54.5% for hydraulic retention times (HRTs) of 20, 30, 40 days, respectively. The removal efficiencies of VS, total chemical oxygen demand (TCOD) and soluble chemical oxygen demand (SCOD) decreased with increasing VS volumetric loading rate (VLR). Higher organic removal efficiency was observed at longer HRTs for the same VS volumetric loading rate. As VS volumetric loading rate increased, biogas production increased and the methane content of the biogas decreased. Experiments using duckweed (Lemna species) as an aquatic macrophyte gave the following results. In the case of nitrogen, removal efficiency was above 60% and effluent concentration was below 10.0 mg/L when the influent ammonia-N loading was about $1.0\;g/m^2/day$. In the case of phosphorus, removal efficiency was above 55% and effluent concentration was below 2.0 mg/L when the influent $PO_4$-P loading was about $0.15\;g/m^2/day$. In addition, crude protein and phosphorus content of duckweed biomass increased from 15.6% to 41.6% and from 0.8% to 1.6%, respectively, as the influent nutrient concentration increased. The treatment of high-strength swine wastewater by anaerobic digestion combined with an aquatic plant system offers good performance in terms of organics and nutrient removal for relatively low operation and maintenance costs. The results indicate that under appropriate operational conditions, the effluent quality is within the limits set by Korean discharge criteria.

• Ocean Science Journal
• /
• v.40 no.1
• /
• pp.1-10
• /
• 2005

Variations in species diversity and abundance of polychaete taxocenes that occurred in 1980-1989 under different contamination levels of bottom sediments were studied in three areas of Peter the Great Bay. The most polluted area was shown to be the Golden Horn Inlet where contaminant contents in the bottom sediments exceed the threshold values of negative biota alterations. Amursky Bay is characterized by a moderate level of contamination, while Ussuriysky Bay has the lowest level of contamination. Pollutant contents vary considerably within the same areas and their separate patches are polluted differently. An integral index characterizing the contamination of bottom sediments is proposed. This index is an average grade of the rank value of contaminant contents in sediments. The index was used to compare the contamination level and data on polychaete species diversity and abundance. The highest species diversity of polychaetes is found in the least affected zones. Monotonous decrease of the species number, as well as decrease in the indices of diversity and evenness, is correlated with pollution level increases. Significant growth of the average polychaete biomass and polychaete density is observed in the case of an increase of contamination from low to moderate levels. Conversely, the biomass and abundance of polychaetes decline following an increase in contamination.

• Journal of Environmental Science International
• /
• v.10 no.4
• /
• pp.259-267
• /
• 2001

Investigations were carried out to observe the seasonal succession of phytoplankton, and viable counts of bacteria from the mid to lower reaches of Nakdong Fiver. An intensive monitoring was conducted from May to December 1999 biweekly at 6 sites in a main channel and 3 tributaries. Although there are several sites with high nutrient loading from the basin, all of study sites showed mesotrophic states owing to high discharge(June~September). Relatively low algal biomass and CFUs(mean of chi. a, $12.3{\pm}$11.5 $\mu\textrm{g}${\el}l$, CFUs : 1.8${\times}10^7$) were observed during the rainy season. The diatom population was dominant(over 85% of total community) year-long with peaks(Stephanodiscus hantzchii) in the fall and winter. Dominance of blue-green algal groups during the summer was not observed in the summer. Microorganisms peaked in the summer and fall(June~September), affected mainly by the inputs of phytoplankton and nutrients. Biomass of phytoplankton and CFU counts were higher in the Kumho River than other tributaries and main channel.

• Journal of Korean Society for Atmospheric Environment
• /
• v.30 no.6
• /
• pp.538-544
• /
• 2014

A traditional fireplace has been used, but not much, for heating and cooking in rural area, Korea. Traditional fireplace as one type of biomass burnings is also emitting various air pollutants. Air pollutants emission from traditional fireplace was estimated in this study. There are two types of traditional fireplace, one for combined heating and cooking, the other one for cooking only. Types of fuels mostly used in traditional fireplace were wood, agricultural residue, solid waste. Activity levels such as fuel types, amount of fuel loading, and temporal variation were investigated by field survey over Korea. Estimated annual emissions from traditional fireplace were CO 6,335.0, NOx 555.0, SOx 9.6, VOC 1,771.7, TSP 181.4, $PM_{10}$ 119.9, $PM_{2.5}$ 96.2, $NH_3$ 1.4 ton/yr respectively. When emissions compared with the national emission inventory (CAPSS: Clean Air Policy Support System) of 2010 year, CO and $PM_{10}$ occupy 0.8% and 0.1% of total national emission, respectively.