• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.6
• /
• pp.52-58
• /
• 2008

In this paper, electrically small square loop antenna with SRR (Split Ring Resonator) cover structure is built and tested. The proposed antenna has very small size, ka = 0.34 by Chu limit. The experimental result shows that the resonant frequency and impedance bandwidth($VSWR{\leq}2$) are 906MHz and 5.8MHz (901.7 - 907.5MHz), respectively. The proposed antenna is matched and designed by equivalent circuit model. The proposed antenna is fabricated simple structure without additional matching network and printed on a Teflon substrate without ground plane. Therefore, it has advantages of low cost, small size, and light weight and will be applied to wireless communication systems where small antennas are required.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.11
• /
• pp.83-93
• /
• 2014

It is a widespread concern that electrical interconnection based network-on-chip (NoC) will ultimately face the limitation in communication bandwidth, transmission latency and power consumption in the near future. With the development of silicon photonics technology, a hybrid optical network-on-chip (HONoC) which embraces both electrical- and optical interconnect, is emerging as a promising solution to overcome these problems. Today's leading edge systems-on-chips (SoCs) comprise heterogeneous many-cores for higher energy efficiency, therefore, extended study beyond regular topology based NoC is required. This paper proposes an energy and latency optimization topology design technique for HONoC taking into account the traffic characteristics of target applications. The proposed technique is implemented with genetic algorithm and simulation results show the reduction by 13.84% in power loss and 28.14% in average latency, respectively.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.41 no.7
• /
• pp.9-19
• /
• 2004

WLAN (Wireless Local Area Networks) needs error recovery and flow control schemes to support reliable multicast protocol. Limited wireless bandwidth, as well as queuing losses caused by the asymmetric wired/wireless interactions, demands more effective approaches for reducing packet losses. Moreover, since the wireless channel is a shared broadcast medium, if sender receives feedback information simultaneously from several receivers, the feedback delays data frame transmission of forward direction by introducing channel congestion and burden at the sender. Therefore, it is important to minimize the amount of feedback information from receivers. In this paper, we propose an ARS(Adaptive Redundancy Scheme) that combines FEC(Forward Error Correction) using channel state estimation and ARQ(Automatic Repeat Request) both to reduce the amount of feedback information and the number of retransmissions and to guarantee high data reliability in a WLAN multicast environment. Performance of the proposed scheme is evaluated by means of analysis and simulations in AWGN and Rayleigh fading channels. The results show that the proposed scheme reduces the amount of feedback information and the number of retransmissions and guarantees high data reliability, while keeping throughput efficiency similarly with the conventional FEC and ARQ scheme.

• Convergence Security Journal
• /
• v.9 no.4
• /
• pp.7-12
• /
• 2009

It is very difficult to completely block the DDoS attack, which paralyzes services by depleting resources or occupying the network bandwidth by transmitting a vast amount of traffic to the specific website or server from normal users' PCs that have been already infected by an outside attacker. In order to defense or endure the DDoS attack, we usually use various solutions such as IDS (Intrusion Detection System), IPS (Intrusion Prevention System), ITS (Intrusion Tolerance System), FW (Firewall), and the dedicated security equipment against DDoS attack. However, diverse types of security appliances cause the cost problem, besides, the full function of the equipments are not performed well owing to the unproper setting without considering connectivity among systems. In this paper, we present the effective connectivity of security equipments and countermeasure methodology against DDoS attack. In practice, it is approved by experimentation that this designed methdology is better than existing network structure in the efficiency of block and endurance. Therefore, we would like to propose the effective security control measures responding and enduring against discriminated DDoS attacks through this research.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.30 no.6B
• /
• pp.338-348
• /
• 2005

Currently, IEEE 802.11 Wireless LAN (WLAN) is rising as the most popular means for the broadband wireless access network. In this thesis, we propose a QoS(Quality of Service)-Oriented mechanism using handshaking method of scanning phase in IEEE 802.11 handoff. In conventional process for handoff, the major criterion to select the best AP(Access Point) among candidates is normally based on the RSS(Received Signal Strength), which does not always make the selected network guarantee the maximum achievable performance. Even though the link quality with a neighboring AP is excellent, the AP may not be a good candidate to handoff to simply because MAC(Medium Access Control) protocol of IEEE 802.11 standard is contention-based such as CSMA/CA. Therefore, if we apply network level information to AP selection criteria, we can achieve better handoff efficiency rather than before. The analysis and simulation results applied to our new mechanism show clearly better performance than AP selection based on traditional handoff method.

• Journal of Communications and Networks
• /
• v.18 no.3
• /
• pp.476-483
• /
• 2016

Super Wi-Fi is a Wi-Fi-like service exploiting TV white space (WS) which is expected to achieve larger coverage than today's Wi-Fi thanks to its superior propagation characteristics. Super Wi-Fi has been materialized as an international standard, IEEE 802.11af, targeting indoor and outdoor applications, and is undergoing worldwide field tests. This paper demonstrates the true potential of indoor Super Wi-Fi, by experimentally comparing the signal propagation characteristics of Super Wi-Fi and Wi-Fi in the same indoor environment. Specifically, we measured the wall and floor attenuation factors and the path-loss distribution at 770MHz, 2.401 GHz, and 5.540 GHz, and predicted the downlink capacity of Wi-Fi and Super Wi-Fi. The experimental results have revealed that TVWS signals can penetrate up to two floors above and below, whereas Wi-Fi signals experience significant path loss even through a single floor. It has been also shown that Super Wi-Fi mitigates shaded regions of Wi-Fi by providing almost-homogeneous data rates within its coverage, performs comparable to Wi-Fi utilizing less bandwidth, and always achieves better spectral efficiency than Wi-Fi. The observed phenomena imply that Super Wi-Fi is suitable for indoor applications and has the potential of extending horizontal and vertical coverage of today's Wi-Fi.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.38B no.10
• /
• pp.785-800
• /
• 2013

In MANET, AODV(Ad hoc On-demand Distance Vector) has its advantages as on-demand approach but it also has a disadvantage that the control packet overhead is high compared to other routing protocols. This paper improves the problem caused by Hello messages that are broadcasted periodically to detect the local connectivity and maintain neighbor list. Periodic hello messages reduce the Packet delivery ratio and the efficiency in the limited bandwidth. And its increased Control packet overhead leads to decrease the Residual battery capacity and the Network lifetime. Further, non-reactive nature of periodic hello messages in AODV has also been the source of numerous controversies. In order to solve these problems, this paper improves the performance by using the interrupt driven approach which removes periodic hello messages and decreases the Control packet overhead. Performance comparisons between the traditional AODV and proposed mod_AODV done with network simulator QualNet 5.0 show that the mod_AODV performs better in most performance metrics under scenarios with various values of simulation parameters.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.7
• /
• pp.1182-1190
• /
• 2001

In this paper, microstrip photonic bandgap (PBG) structure with special perforation patterns etched on the line itself is analyzed and optimized in shape, then used for harmonic tuning of power amplifier. This PBG has an advantage in being fabricated and grounded. The dimension of unit lattice is enlarged vertically, but its input and output line maintain 50 Ω using tapered line. This modification from original structure can lessen possible error in etching PCB. The analysis and design of PBG structure are acquired from using EM simulation. The measured insertion loss of the final structure is 0.3 ∼0.4 dB, and its bandwidth of stopband is 6∼7 GHz. Measured results of improved characteristics by using PBG structure at the output of the power amplifier are 0.72∼0.99 dB in output power, 1.14∼7.8 % in PAE, and 1 dBc in the third IMD.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.3
• /
• pp.273-279
• /
• 2009

In this paper, an antenna which has dipole-like radiation pattern and low profile is proposed. The antenna is composed of four elements slot array based on L-shaped 0.43 $\lambda_g$ slot element. It presents a omni-directional radiation patter in the azimuth plane and has a null toward broad-side direction. In the design, a small mono-pole antenna which acts as a large capacitance element, combined with the partially removed ground plane by four L-shaped slots. As a result, these structure act as a LC resonator for radiation. The measured result shows, the impedance bandwidth(VSWR$\leq$2) of the proposed antenna is 60 MHz(2.35$\sim$2.41 GHz). The measured maximum radiation gain and efficiency of proposed antenna is 0.02 dBi, 56.7 % at center frequency 2.38 GHz, respectively. The proposed antenna can be applied to wireless tan access point system.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.10
• /
• pp.941-944
• /
• 2016

This paper proposes 24 GHz power amplifier for automotive collision avoidance and surveillance short range radar using Samsung 65-nm CMOS process. The proposed circuit has a 2-stage differential power amplifier which includes common source structure and transformer for single to differential conversion, impedance matching, and power combining. The measurement results show 15.5 dB maximum voltage gain and 3.6 GHz 3 dB bandwidth. The measured maximum output power is 13.1 dBm, input $P1_{dB}$ is -4.72 dBm, output $P1_{dB}$ is 9.78 dBm, and maximum power efficiency is 17.7 %. The power amplifier consumes 74 mW DC power from 1.2 V supply voltage.