• 대한기계학회논문집B
• /
• 제28권10호
• /
• pp.1210-1218
• /
• 2004

Experimental study was performed to investigate the flow behavior in boundary layer on the blade suction surface of a multi-stage axial flow compressor, which was focused on the third stage of the 4-stage Low Speed Research Compressor. Flow measurements in the boundary layer were obtained using a boundary layer hot wire probe, which was traversed normal to the blade suction surface at small increments by the probe traverse specially designed. Detailed boundary layer flow measurements covering most of the stator suction surface were taken and are described using time mean and ensemble averaged velocity profiles. Amplitude of the velocity fluctuation and turbulence intensity in the boundary layer flow are also discussed. At midspan, narrow but strong wake zone due to passing wake disturbances is generated in the boundary layer near the blade leading edge for the rotor blade passing period. Corner separation is observed at the tip region near the trailing edge, which causes to increase steeply the boundary layer thickness.

• 대한원격탐사학회:학술대회논문집
• /
• 대한원격탐사학회 2006년도 Proceedings of ISRS 2006 PORSEC Volume II
• /
• pp.598-601
• /
• 2006

Satellite imagery may contain large regions covered with atmospheric aerosol. A high-resolution satellite imagery affected by non-homogenous aerosol cover should be processed for land cover study and perform the radiometric calibration that will allow its future application for Korea Multi-Purpose Satellite (KOMPSAT) data. In this study, aerosol signal was separated from high resolution satellite data based on the reflectance separation method. Since aerosol removal has a good sensitivity over bright surface such as man-made targets, aerosol optical thickness (AOT) retrieval algorithm could be used. AOT retrieval using Look-up table (LUT) approach for utilizing the transformed image to radiometrically compensate visible band imagery is processed and tested in the correction of satellite scenery. Moderate Resolution Imaging Spectroradiometer (MODIS), EO-1/HYPERION data have been used for aerosol correction and AOT retrieval with different spatial resolution. Results show that an application of the aerosol detection for HYPERION data yields successive aerosol separation from imagery and AOT maps are consistent with MODIS AOT map.

• 한국항해항만학회지
• /
• 제44권2호
• /
• pp.110-118
• /
• 2020

With the expansion of the shipping and port logistics industry in the 21st century, the traffic density is continuously increased because of the increase in volumes of world sea freight and fleets, as well as the increase in the causes of potential marine accidents, such as ship collisions and stranding. Accordingly, the International Maritime Organization (IMO) has requested that the installation and operation of VTS should be applied in areas with high risk of marine traffic, and the request should be included as one of the Safety of Life at Sea (SOLAS) regulations. In this paper, the fundamental requirements of the radar system for vessel traffic services were analyzed and the analyzing factors were based on the IALA guideline.s This paper also includes results for the requirement and recommendation analysis on detection distance, target separation, and the target position accuracy of X-band radar. Also, to check if it satisfies the requirement of detection distance, range and azimuth separation of small point targets, and target position accuracy from the IALA guidelines, the test was conducted through the radar image acquired at the VTS center, and hence, the validity of the technical performance requirements was confirmed.

• 대한원격탐사학회지
• /
• 제22권5호
• /
• pp.379-383
• /
• 2006

Satellite imagery may contain large regions covered with atmospheric aerosol. A highresolution satellite imagery affected by non-homogenous aerosol cover should be processed for land cover study and perform the radiometric calibration that will allow its future application for Korea Multi-Purpose Satellite (KOMPSAT) data. In this study, aerosol signal was separated from high resolution satellite data based on the reflectance separation method. Since aerosol removal has a good sensitivity over bright surface such as man-made targets, aerosol optical thickness (AOT) retrieval algorithm could be used. AOT retrieval using Look-up table (LUT) approach for utilizing the transformed image to radiometrically compensate visible band imagery is processed and tested in the correction of satellite scenery. Moderate Resolution Imaging Spectroradiometer (MODIS), EO-l/HYPERION data have been used for aerosol correction and AOT retrieval with different spatial resolution. Results show that an application of the aerosol detection for HYPERION data yields successive aerosol separation from imagery and AOT maps are consistent with MODIS AOT map.

• 한국표면공학회지
• /
• 제52권5호
• /
• pp.258-264
• /
• 2019

Assembling heterostructures by combining dissimilar oxide semiconductors is a promising approach to enhance charge separation and transfer in photoelectrochemical (PEC) water splitting. In this work, the CuO nanorods array/$Cu_2O$ thin film bilayered heterostructure was successfully fabricated by a facile method that involved a direct electrodeposition of the $Cu_2O$ thin film onto the vertically oriented CuO nanorods array to serve as the photoelectrode for the PEC water oxidation. The resulting copper-oxide-based heterostructure photoelectrode exhibited an enhanced PEC performance compared to common copper-oxide-based photoelectrodes, indicating good charge separation and transfer efficiency due to the band structure realignment at the interface. The photocurrent density and the optimal photocurrent conversion efficiency obtained on the CuO nanorods/$Cu_2O$ thin film heterostructure were $0.59mA/cm^2$ and 1.10% at 1.06 V vs. RHE, respectively. These results provide a promising route to fabricating earth-abundant copper-oxide-based photoelectrode for visible-light-driven hydrogen generation using a facile, low-cost, and scalable approach of combining electrodeposition and hydrothermal synthesis.

• JSTS:Journal of Semiconductor Technology and Science
• /
• 제1권1호
• /
• pp.40-49
• /
• 2001

We have developed a repeatable process of forming uniform, small-size and high-density self-assembled Si nano-crystals. The Si nano-crystals were fabricated in a conventional LPCVD (low pressure chemical vapor deposition) reactor at $620^{\circ}c$ for 15 sec. The nano-crystals were spherical shaped with about 4.5 nm in diameter and density of $5{\times}l0^{11}/$\textrm{cm}^2$. More uniform dots were fabricated on nitride film than on oxide film. To take advantage of the above-mentioned characteristics of nitride film while keeping the high interface quality between the tunneling dielectrics and the Si substrate, nitride-oxide tunneling dielectrics is proposed in n-channel device. For the first time, the single electron effect at room temperature, which shows a saturation of threshold voltage in a range of gate voltages with a periodicity of ${\Delta}Ｖ_{GS}\;{\approx}\;1.7{\;}V$, corresponding to single and multiple electron storage is reported. The feasibility of p-channel nano-crystal memory with thin oxide in direct tunneling regime is demonstrated. The programming mechanisms of p-channel nano-crystal memory were investigated by charge separation technique. For small gate programming voltage, hole tunneling component from inversion layer is dominant. However, valence band electron tunneling component from the valence band in the nano-crystal becomes dominant for large gate voltage. Finally, the comparison of retention between programmed holes and electrons shows that holes have longer retention time.

• 한국위성정보통신학회논문지
• /
• 제9권1호
• /
• pp.74-78
• /
• 2014

본 논문에서는 AMI시스템과 전기차 충전시스템 간의 발생하는 간섭을 억제하는 기법을 제안하고 분석하였다. 한전에서 진행하고 있는 AMI 시스템에 사용되는 PLC 기술인 IEC12139-1와 전기자동차 충전 시스템에 사용되는 HomePlug GP, 두 통신기술 모두 2-30Mhz 주파수 대역을 사용하는 고속 PLC 기술이다. 두 방식이 같은 주파수 대역을 사용하면서 서로의 시스템에 간섭이 발생되게 된다. 본 논문에서는 Walsh code를 이용한 채널 분리를 통하여 간섭을 억제 시키는 방식을 실험하였다. 본 논문의 실험 결과는 스마트 그리드에서 사용하는 다양한 전력선 통신기술에 적용될 수 있다.

• ETRI Journal
• /
• 제28권6호
• /
• pp.770-776
• /
• 2006

This paper presents a hyperspectral imaging technique based on laser-induced fluorescence for non-invasive detection of tumorous tissue on mouse skin. Hyperspectral imaging sensors collect image data in a number of narrow, adjacent spectral bands. Such high-resolution measurement of spectral information reveals contiguous emission spectra at each image pixel useful for the characterization of constituent materials. The hyperspectral image data used in this study are fluorescence images of mouse skin consisting of 21 spectral bands in the visible spectrum of the wavelengths ranging from 440 nm to 640 nm. Fluorescence signal is measured with the use of laser excitation at 337 nm. An acousto-optic tunable filter (AOTF) is used to capture images at 10 nm intervals. All spectral band images are spatially registered with the reference band image at 490 nm to obtain exact pixel correspondences by compensating the spatial offsets caused by the refraction differences in AOTF at different wavelengths during the image capture procedure. The unique fluorescence spectral signatures demonstrate a good separation to differentiate malignant tumors from normal tissues for rapid detection of skin cancers without biopsy.

• 한국통신학회논문지
• /
• 제25권10B호
• /
• pp.1675-1689
• /
• 2000

We present CReMeS a CORBA-compliant design and implementation of a new real-time communication service. It provides for efficient predictable and scalable communication between information producers and consumers. The CReMeS architecture is based on MidART's Real-Time Channel-based Reflective Memory (RT-CRM) abstraction. This architecture supports the separation of QoS specification between producer and consumer of data and employs a user-level scheduling scheme for communicating real-time tasks. These help us achieve end-to-end predictability and allows our service to scale. The CReMeS architecture provides a CORBA interface to applications and demands no changes to the ORB layer and the language mapping layer. Thus it can run on non real-time Off-The-Shelf ORBs enables applications on these ORBs to have scalable and end-to-end predictable asynchronous communication facility. In addition an application designer can select whether to use an out-of-band channel or the ORB GIOP/IIOP for data communication. This permits a trade-off between performance predictability and reliability. Experimental results demonstrate that our architecture can achieve better performance and predictability than a real-time implementation of the CORBA Even Service when the out-of-band channel is employed for data communication it delivers better predictability with comparable performance when the ORB GIOP/IIOP is used.

• 한국통신학회논문지
• /
• 제33권3A호
• /
• pp.296-303
• /
• 2008

오늘날의 다양한 무선 시스템을 통한 서비스의 공존은 간섭 문제를 야기시킬 수 있으며, 제한된 주파수 대역을 효율적으로 활용하기 위해서는 보다 정확하고 효과적인 주파수 공유 기술에 대한 연구가 필수적이라고 할 수 있다. 특히 위성시스템이 가지는 광역성으로 인하여 지상시스템과의 주파수 공유는 필수적이다. Ka 대역 주파수를 사용하는 위성 시스템은 지향성 안테나를 사용하게 되므로 위성의 방위각을 고려한 주파수 공유 결과에 대한 분석은 주파수 효율성을 높이는데 매우 큰 역할을 할 수 있다. 본 논문에서는 위성망과 지상망과의 간섭을 안테나의 방위각을 고려하여 분석한 결과를 제시하고, 주파수 공유 시 요구되는 망간 최소 이격 거리를 분석한 결과를 제시함으로써 분석 결과가 실제 시스템 설계 및 구현에 활용될 수 있도록 하고 있다.