• 수산해양기술연구
• /
• 제60권3호
• /
• pp.207-216
• /
• 2024

This study conducted a marine experiment to improve the fishing system using miniaturized nets for anchovy boat seine to reduce the fleet size. As a result, the miniaturized net for anchovy boat seine properly opened the entrance of the bag net using the buoyancy of the flotation for position indication and the setting force of the ground rope without operating a separate fish detecting boat by attaching a large flotation at the entrances of the inside wing net and the bag net. This also enabled an operation type where the entrance of the bag net is confirmed using a flotation for position indication from a netting boat. The time and the number of people used for net casting and net hauling in the marine experiment were average of five minutes and 25-30 minutes, respectively, and 23-30 people for the existent net, while for the miniaturized large-scale net were average of three minutes and 23-25 minutes, respectively, and 19-25 people. This indicates that the operation time was shortened, the number of fish detecting boats was reduced by one boat, and the number of people for fishing work was decreased by four or five people due to the improvement of fishing operation system according to the reduction of fishing net size. As a result of measuring the shaft horsepower during net towing, the maximum net towing horsepower was 250 HP in comparison to the maximum RPM of the engine (1,200 RPM), indicating that the legal horsepower of 250 HP is enough to conduct net towing and the competitiveness of fishing using the net for anchovy boat seine is ensured through operation cost reduction.

• Archives of Plastic Surgery
• /
• 제33권5호
• /
• pp.676-679
• /
• 2006

Purpose: Breast volume is one of the crucial measurements in preoperative planning and postoperative evaluation of the results in mammoplasty. There are several methods suggested by different authors, but there is still no commonly accepted standard methods for measuring breast volume. To help the surgeons to base their estimation on an objective evaluation, we developed a simple method using Polyethylene bag and plaster molding. Methods: After Polyethylene bags were put in suitable size on both breasts of the patient in upright position, silk plaster was molded on the surface evenly. Then molds can be obtained after marking boundaries of breasts with a pen. Breast volume measurement can be done by filling water in the molds and measuring it. Moreover, postoperative design for natural skin brassier was possible using the molds. Results: This method was applied to 2 patients for reduction mammoplasty and the breast volume measurement was simple, hygienic and accurate, done within 10 minutes. Conclusion: This method using Polyethylene bag and plaster molding has several advantages. 1. It is comparatively accurate regardless of the size and shape of patient's breasts in upright position. 2. Measurement time is short and inconvenience and shame of patients can be reduced by making molds after putting on Polyethylene bags. 3. It is relatively economical and uses easily available hygienic materials. 4. The postoperative shape and volume of breasts can be predicted by using molds preoperatively.

• 한국자동차공학회논문집
• /
• 제17권1호
• /
• pp.176-181
• /
• 2009

The passenger airbag(PAB) designed for standard sized adults may induce unexpected results to children in out-of-position(OOP) postures. In this work, using MADYMO software, simulations of the OOP injury of children have been performed with respect to PAB design parameters and child dummy positions. The attention is focused on some details with respect to the injury of 3 and 6 year old children in two OOP postures. Among the various design parameters of the passenger airbag systems, four parameters are selected for the sensitivity analysis of the injury with the Taguchi method: bag folding pattern, vent hole size, position of the cover tear seam and the type of door tear seam. An optimal combination of the parameters is suggested.

• 대한물리치료과학회지
• /
• 제6권2호
• /
• pp.1063-1073
• /
• 1999

Objective: Poor head and neck support during sleep can exacerbate the neck pain. Based on the ideal sleep posture and pillow suggested by Cyriax, we designed a new cervical pillow and compared the degree of pain reduction, quality of sleep and pillow satisfaction with a low hospital pillow and a high pillow. Method: The newly designed pillow has a built-in pressure-adjustable air bag in the cervical area and provides normal cervical lordotic curve in supine position and maintains cervical and thoracic vertebrae to form a horizontal line in side-lying position. Thiry-four patients with cervical pain used low hospital pillows for the first week of 3-week randomized crossover design study. They were subsequently randomly assigned to use each of the other two pillows for 1-week period. Outcomes were measured using Visual analog scale, Sleep questionaire, a pillow satisfaction scale. Result: Compared with other 2 types of pillow, Subjects using the newly desinged pillow showed much reduced pain intensity, increased duration of sleep and better satisfaction. Conclustion: We desinged a cervical pillow with built-in pressure adjustable air bag and it can significantly reduce pain intensity and improve quality of sleep in patients with cervical pain.

• 수산해양기술연구
• /
• 제37권1호
• /
• pp.24-34
• /
• 2001

정치망 원통의 거동을 장기선 방식으로 측정할 수 있는 계류식 수중위치측정시스템을 제작하고, 그 실용성을 확인하기 위하여 소조기 (2000. 10. 6)와 대조기 (2000. 11. 28)에 현장실험을 실시하였다. 현장실험에서 4개의 트랜스폰더는 원통의 남북방향으로 부착시키고, 1개의 트랜스폰더는 해저에 고정시켰다. 그리고, 원통까래의 상하진동은 3개의 테이터로거를 원통의 동서방향 (원통의 길이 방향)으로 부착시켜 대조기에 관측하였다. 소조기에 측정한 원통의 동서방향, 남북방향, 상하방향의 변화폭은 각각 3.2 m, 3.4 m, 2.1 m이었고, 대조기에는 각각 7.8 m, 7.8 m, 5.0 m로 소조기보다 2.3배 이상 컸다. 원통까래의 상하진동폭은 비탈그물에 가까운 쪽이 3.2 m, 중앙부가 3.7 m, 머거리쪽이 8.4 m이었다. 전반적으로 유속이 10 cm/s 이상일 때와 흐름의 방향이 원통의 길이방향과 일치하지 않을 때에 까래의 심도 감소와 상하진동이 빈번하게 발생하였다. 해저에 고정시킨 트랜스폰더를 사용하여 수파기 좌표의 변동을 측정한 결과, 정치망 사개에 부착한 수파기라도 흐름에 의해 그 좌표가 수 m 정도 변함을 알 수 있었고, 정치망의 거동 측정시 이러한 좌표의 변동을 보정하여야 측정오차를 줄일 수 있음을 알 수 있었다. 본 연구에서 제작한 3차원 수중위치측정시스템의 위치오차는 가두리에서 측정한 결과, x축, y축, z축이 각각 0.6 m, 0.8 m, 1.2 m이었고, 기선의 내부이거나 기선에 가까울수록 작았다.

• 센서학회지
• /
• 제23권6호
• /
• pp.402-408
• /
• 2014

Heart rate is one of the most important signal to monitor the health condition of the patient or exerciser. Various wearable devices have been developed for the continuous monitoring of ECG signal from human body during exercise. Among these, ECG chest belt has been widely used. However wearing chest belt with ECG sensor is uncomfortable in normal life due to the electrode contact between metal electrodes of ECG sensor and skin of the human body. So we develop the royal healthcare backpack that can measure ECG signal without skin contact by using capacitor-type ECG sensor. The position of the measurement point is critical to collect a clear ECG signal in the capacitive ECG measurement from backpack. Various tests were conducted to find the optimal ECG measurement position which has less noise and could get strong and clear ECG signal during exercise, walking, hiking, mountain climbing and cycling.

• 대한임베디드공학회논문지
• /
• 제12권2호
• /
• pp.105-112
• /
• 2017

To control the depth of an underwater glider, a control method by using Lyapunov's direct method is proposed. The underwater glider has a torpedo-shape hull, a movable mass in the hull, and an inflatable buoyancy bag in the hull, but doesn't have large wings that increase the lift force for the conventional underwater glider. The control laws to adjust the position of the movable mass and the mass of the inflatable buoyancy bag are derived. For a selected speed and an angle of attack, we simulated the operation of the underwater glider using Matlab/Simulink. The efficiency of the proposed controller is shown in the fact that the control effort is active during only a short period of time when the zigzag trajectory is changed from downward to upward or vice versa.

• 수산해양기술연구
• /
• 제35권3호
• /
• pp.250-265
• /
• 1999

Quality and distribution of the TEA(Total Enclosed Area), TSA(Twine Surface Area), solidity ratio and resistance according to the partial nets of the midwater trawl net were examined through experiment at the sea to standardize a design of the midwater trawl net.The results can be summarized as follows;1. The TEA, TSA and resistance of the trawl net were increased definitely according to increasing the scale of the trawl net, and this is the most important factor to design the trawl net.2. As the result of analysis of the distributions of the bag net was smaller than the others. Because TEA for rear end of the wing net is decreased suddenly, we can judge that the trawl net was towed irregularly. 3. The resistance distribution of the partial net was increased suddenly from central part of the bag net and was showed large value in the codend.4. The resistance of the net from the position one of three to gab net and codened charged 75% at all resistance of net.

• 적정기술학회지
• /
• 제7권1호
• /
• pp.51-58
• /
• 2021

본 연구는 COVID-19의 대유행으로 인해 자동 인공 호흡기의 공급이 세계적인 긴급 수요에 비해 원활하지 않은 상황에 도움이 될 수있는 저가형 응급 인공 호흡기의 설계 및 구현을 제안한다. AMBU-bag과 기성용 임베디드 마이크로컨트롤러 보드를 사용하여 구현이 용이하고 비용을 최소화했다. 또한, 3D 프린팅은 전 세계 기업과 전문가들이 프로토타입 하드웨어를 구축하는 데 사용하는 반면, 주변 환경에서 쉽게 구할 수 있는 재료는 많은 첨단 기술에 접근하기 어려운 국가의 사람들이 시스템을 제조할 수 있도록 한다. 설계한 간이 인공호흡기 모형의 특징은 암부 백을 자동화했다는 점, 3d 프린팅을 사용하지 않는다는 점, 속도조절이 가능하다는 점이다. 속도 조절이 가능하게 함으로써 사용하는 환자의 상황에 맞게 환기가 가능하다. 연구 시 보완할 점으로는 첫 번째, 사용한 와이퍼 모터의 구동 시작점을 고정하기 어렵다는 것이다. 이를 보완하기 위한 방법으로 위치 피드백기능이 있는 브러시 DC모터로 교체하는 방법이 있다. 두 번째로 팔부분과 고정 틀이 나무 재질이라 암부 백을 장기적으로 압축하는 과정에서 암부백이 마모될 가능성 있다는 것이다. 이를 보완하기 위해 암부백이 닿는 틀과 팔 부분을 실리콘과 같은 재료로 감싸 마찰을 최소화해야 할 필요가 있다.

• Journal of Electrical Engineering and Technology
• /
• 제10권4호
• /
• pp.1851-1863
• /
• 2015

– In the paper, to handle the problem of traditional bag-of-features model ignoring the spatial relationship of local features in human action recognition, we proposed a Multiscale Spatial Position Coding under Locality Constraint method. Specifically, to describe this spatial relationship, we proposed a mixed feature combining motion feature and multi-spatial-scale configuration. To utilize temporal information between features, sub spatial-temporal-volumes are built. Next, the pooled features of sub-STVs are obtained via max-pooling method. In classification stage, the Locality-Constrained Group Sparse Representation is adopted to utilize the intrinsic group information of the sub-STV features. The experimental results on the KTH, Weizmann, and UCF sports datasets show that our action recognition system outperforms the classical local ST feature-based recognition systems published recently.