• 한국전기전자재료학회논문지
• /
• 제34권5호
• /
• pp.386-392
• /
• 2021

Multiferroics exhibiting the coexistence and a possible coupling of ferromagnetic and ferroelectric order are attracting widespread interest in terms of academic interests and possible applications. However, room-temperature single-phase multiferroics with soft ferromagnetic and displacive ferroelectric properties are still rare owing to the contradiction in the origin of ferromagnetism and ferroelectricity. In this study, we demonstrated that sizable ferromagnetic properties are induced in the ferroelectric bismuth ferrite-barium titanate system simply by introducing Co ions into the A-site. It is noted that all modified compositions exhibit well-saturated magnetic hysteresis loops at room temperature. Especially, 70Bi_0.95Co_0.05FeO₃-30Ba_0.95Co_0.05TiO₃ manifests noticeable ferroelectric and ferromagnetic properties; the spontaneous polarization and the saturation magnetization are 42 µC/cm² and 3.6 emu/g, respectively. We expect that our methodology will be widely used in the development of perovskite-structured multiferroic oxides.

• 한국자기학회:학술대회 개요집
• /
• 한국자기학회 2008년도 Asian Magnetics Conference
• /
• pp.103.2-103.2
• /
• 2008

• E2M - 전기 전자와 첨단 소재
• /
• 제8권5호
• /
• pp.640-647
• /
• 1995

In this study, the BaTiO$\sub$3/ capacitor add to MnO$\sub$2/ like depressor and shifter were investigated for temperature or voltage compensation by structural and electrical analysis. The relative density of BCTM, generating poly crystall and formation of lattice defect, has a 90[%] over as the CaTiO$\sub$3/ come out to control grain size. The current density of BCTM2 increased non-ohmic in high-electric field but that BCTM3 and BCTM4 had a few changing. The BCTM3 and BCTM4 unformated grain boundary shown temperature compensation properties, so that the dielectric constant was low value. The curie point was near 140[.deg. C] in BCTM1 and BCTM4, but BCTM3 and BCTM4 not shown the curie point. It is found that the charging energy of BCTM4 was changed 6[%] according to rising temperature from room temperature to 417[K]. The formation of BaMnO$\sub$3/ was low dielectric constant to change frequency and temperature.

• 한국전기전자재료학회논문지
• /
• 제15권6호
• /
• pp.504-510
• /
• 2002

Recently, thin film capacitors of high dielectric constant and low leakage current are applied to integrated devices. In this study, (Ba, Sr)$TiO_3$ (BST) thin films for low cost were prepared by Sol-Gel method. BST solution was spin-coated on Pt/$SiO_2$/Si substrate at 4,000 rpm for 10 seconds. Coating process was repeated 3 times and then sintered at $700^{\circ}C$ for 30 minutes. Structural and electrical characteristics of each specimen were analyzed by TG-DTA, SEM, fractal phenomenon, voltage-current and dielectric factor. Thickness of BST ceramics thin films are about 2,600~2,800 ${\AA}$ at depositing 3 times. Dielectric constant of thin films was decreased in 1 kHz~1 MHz. Dielectric constant and loss to frequency were 250 and 0.02 in $(Ba_{0.7}Sr_{0.3})TiO_3$ (BST3). Leakage current of BST3 was $10^{-9}\sim10^{-11}$/ A under 3 V.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1994년도 춘계학술대회 논문집
• /
• pp.25-33
• /
• 1994

Temperature dependences of the remanent polarization $P_{\gamma}$/(T), effective birefringence ㅿｎ(T). dielectric constant K(T) and quadratic electro-optic coefficient R(T) of the two-stage sintered xBa(La$_{1/2}$Nb$_{1/2}$)O$_3$Pb$(Zr_{y}Ti_{1-y})O-{3}$(x=0.085, 0.09, 0.40$\leq$y$\leq$0.70)ceramics were investigated. Increasing the PbZrO$_3$ contents, the crystal structure of a specimen was varied from tetragonal and rhombohedral to cubic, and the phase transition was showed a diffuse phase transition(DPT) characteristics. Especially. in the compositions which located on the PE-FE phase boundary were showed a discrepancy between curie temperature and temperature range which a macroscopic polarization and a effective birefringence were disappeared.

• E2M - 전기 전자와 첨단 소재
• /
• 제3권4호
• /
• pp.339-346
• /
• 1990

미소변위소자에 적합한 전왜세라믹스를 제조하기 위하여 0.85Pb(Zn$_{1}$3-x/MgxNb$_{2}$3/) $O_{3}$-0.10BaTi $O_{3}$-0.05PbTi $O_{3}$조성으로 Mg(mol%)를 변화시키면서 시편을 제조하고 구조적, 유전적, 전기적 특성 및 온도 안정성을 관찰하였다. 큐리온도는 Mg(mol%)가 증가함에 따라 감소하였고 Mg(mol%)가 0.15일 때 유전상수가 가장 높았으며 완만도는 -3.9, 산만도.DELTA.Tc는 21로 가장 컸다. 전계에 따른 유전상수는 감소하였고 Mg(mol%)가 증가할수록 압전정수 d$_{31}$은 감소하였으나 0.05, 0.10, 0.15일 때는 거의 일정하였다. Mg(mol%)가 0.15까지 증가함에 따라 전왜정수 Q$_{31}$은 감소하였고 그 이상에서는 Mg(mol%)가 1/3일때 가장 컸으며 ES-1시편에서의 AC 60(Hz), 11(kV/cm) 전계(electric field)에 의한 왜형을 253*$10^{-6}$을 나타냈다.

• 한국세라믹학회지
• /
• 제40권4호
• /
• pp.350-353
• /
• 2003

Millimeter-wave dielectric ceramics have been used like applications for ultrahigh speed wireless LAN because it reduces the resources of electromagnetic wave, and Intelligent Transport System (ITS) because of straight propagation wave. For millimeterwave, the dielectric ceramics with high quality factor (Q$.$f), low dielectric constant($\varepsilon$), and nearly zero temperature coefficient of resonant frequency ($\tau$) are needed. No microwave dielectric ceramics with these three properties exist except Ba(Mg$\_$1/3/Ta/sub1/3/)O$_3$ (BMT), which has a little high s: In this paper, alumina (Al$_2$O$_3$) and fosterite (Mg$_2$SiO$_4$), candidates for millimeter-wave applications, were studied with an objective to get high q$.$f and nearly zero $\tau$$\_$f/ For alumina ceramics, q$.$f more than 680,000 GHz was obtained but it was difficult to obtain nearly zero Qf. On the other hand, for forsterite ceramics, q$.$f was achieved from 10,000 GHz of commercial for sterite to 240,000 GHz of highly purified MgO and SiO$_2$ raw materials, and $\tau$$\_$f/ was reduced a few by adding TiO$_2$ with high positive $\tau$$\_$f/.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 하계학술대회 논문집
• /
• pp.377-380
• /
• 2001

The BST thin films to composite (Ba$\sub$x/Sr$\sub$l-x/)TiO$_3$ using sol-gel method were fabricated on Pt/Ti/SiO$_2$/Si substrate. The thin film capacitor to be ferroelectric materials was investigated by structural and electrical properties. BST solution was composited by moi ratio, and then spin-coated (from 3 times to 5 times coating on Pt/SiO$_2$/Si substrate. Thickness of BST ceramics thin films are about 2600∼2800[${\AA}$] in 3 times deposition. The property of leakage current was stable when the applied voltage was 3[V]. Leakage current of 3 times coated BST thin film was 10$\^$-9/∼10$\^$-11/[A] at 0∼3[V].

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2007년도 하계학술대회 논문집 Vol.8
• /
• pp.297-297
• /
• 2007

The $(B_{0.5},Sr_{0.5})TiO_3$ ceramics, which added with low sintering materials $Li_2CO_3$ and ZnBO, was investigated for LTCC(low temperature co-fired ceramic) applications. To compare sintering temperature of $(B_{0.5},Sr_{0.5})TiO_3$ respectively, we added 1, 2, 3, 4, and 5wt% of $Li_2CO_3$ and ZnBO to $(B_{0.5},Sr_{0.5})TiO_3$. For confirming the sintering temperature, the respective specimens were sintered from $750^{\circ}C$ to $1200^{\circ}C$ by $50^{\circ}C$. The case of $Li_2CO_3$ greatly lowered the sintering temperature of $(B_{0.5},Sr_{0.5})TiO_3$ ($1350^{\circ}C$) below $900^{\circ}C$. The addition of ZnBO improved the loss tangent of $(B_{0.5},Sr_{0.5})TiO_3$. The crystalline structure of $LiCO_3$ doped $(B_{0.5},Sr_{0.5})TiO_3$ and ZnBO doped $(B_{0.5},Sr_{0.5})TiO_3$ was analyzed with the X-ray diffraction (XRD) analysis. The dielectric permittivity and loss tangent of $Li_2CO_3$ doped BST and ZnBO doped BST were measured with the HP 4284A precision. From the electrical characterization, we respectively obtained the dielectric permittivity 1361, loss tangent $6.94{\times}10^{-3}$ at $Li_2CO_3$ doped $(B_{0.5},Sr_{0.5})TiO_3$ (3wt%) and the dielectric constant 1180, loss tangent $3.70{\times}10^{-3}$ at ZnBO doped $(B_{0.5},Sr_{0.5})TiO_3$(5wt%).

• 한국재료학회지
• /
• 제13권12호
• /
• pp.846-849
• /
• 2003

Doping effect of various ions in Bi-layered ferroelectric $SrBi_2$$Nb_2$$O_{9}$ (SBN) ceramics was studied. Undoped SBN ceramic and SBN ceramics doped with $Ba^{2＋}$, $Pb^{2＋}$,$ Ca^{2＋}$ , $Bi^{3＋}$ , $La^{3＋}$ , $Ti^{4＋}$ , $Mo^{6＋}$ , and $W^{6＋}$ ions were made by a solid state reaction. Dielectric constants were measured with temperature. Ferroelectric transition temperature decreased with $Pb^{2＋}$ , $Ba^{2＋}$ , $La^{3＋}$ doping, but the transition temperature increased with $Ca^{2＋}$ , $Bi^{3＋}$ , $Ti^{4＋}$, $Mo^{6＋}$ , or$ W^{6＋}$ ionic doping. These results show that the ion size plays an important role in the ferroelectricity of SBN ceramic.